调频式电涡传感器微机实现的探讨     

林菁 《广东海洋大学学报》1996,(1)

分析了分频和ＣＴＣ计数采样中误读数的原因和解决方法，并利用微机软件实现非线性校正。此传感器用于位移测量系统中，具有０．０１ｍｍ的分辨率及优于１％的精度，可在－２０～６０℃温度范围内工作。  相似文献   

REMOTE SENSING FOREST BIOMASS: AN EVALUATION USING HIGH RESOLUTION REMOTE SENSOR DATA AND LOBLOLLY PINE PLOTS     

John R. Jensen  Michael E. Hodgson 《The Professional geographer》1985,37(1):46-56

Eight-year-old Loblolly pine (Pinus taeda) plots located in South Carolina were evaluated using high resolution aircraft multispectral scanner data to determine if biomass could be accurately measured. Sixteen pine plots located on both sandy and clay soils were treated with 0, 180, or 360 kg. (approximately 0, 400, or 800 lb.) of nitrogen per plot. Indices of biomass from remote sensing data were significantly correlated with in situ biomass measurements made in each plot. A ratio of infrared (.9–1.1 μm) and red (.65–.70 μm) channels yielded the best correlation. The indices were not sensitive to differences in soil type (sandy or clay).  相似文献   

On least squares estimation of generalized covariance functions     

Angelika van der Linde 《Mathematical Geology》1993,25(1):1-7

Least squares estimation (LSE) is theoretically related to quadratic unbiased estimation of variance components. It is argued that these methods of estimation of variance components essentially generalize LSE though they are not formally equivalent.  相似文献   

变形分析的Bayes估计与检验     

寇新建 《大地测量与地球动力学》1994,(3)

由于观测条件的变化，观测值方差将产生随机波动。本文根据Ｂａｙｅｓ估计理论，推导了线性模型待估参数的分布函数及观测值方差估计公式，并将其用于位移检验。计算结果表明，在同样的置信度下，本方法更符合实际。文中还对参数估值的统计性质进行了讨论。  相似文献   

Combined mine tremors source location and error evaluation in the Lubin Copper Mine (Poland)     

Andrzej Leniak  Grzegorz Pszczo&#x;a 《Tectonophysics》2008,456(1-2):16

A modified method of mine tremors location used in Lubin Copper Mine is presented in the paper. In mines where an intensive exploration is carried out a high accuracy source location technique is usually required. The effect of the flatness of the geophones array, complex geological structure of the rock mass and intense exploitation make the location results ambiguous in such mines. In the present paper an effective method of source location and location's error evaluations are presented, combining data from two different arrays of geophones. The first consists of uniaxial geophones spaced in the whole mine area. The second is installed in one of the mining panels and consists of triaxial geophones. The usage of the data obtained from triaxial geophones allows to increase the hypocenter vertical coordinate precision. The presented two-step location procedure combines standard location methods: P-waves directions and P-waves arrival times. Using computer simulations the efficiency of the created algorithm was tested. The designed algorithm is fully non-linear and was tested on the multilayered rock mass model of the Lubin Copper Mine, showing a computational better efficiency than the traditional P-wave arrival times location algorithm. In this paper we present the complete procedure that effectively solves the non-linear location problems, i.e. the mine tremor location and measurement of the error propagation.  相似文献   

基于群桩基础沉降估算确定压缩层厚度的探讨     

宁文务 《探矿工程》2008,35(8):44-46

在现行规范中,由于桩基沉降估算模式的不同,压缩层厚度的确定方法也不完全相同。对这些方法进行归纳、总结,并通过具体的工程实例,对由不同估算模式确定的压缩层厚度及沉降估算结果进行探讨与分析,认为对于工程场地地质资料掌握较为翔实的情况下,压缩层厚度可采用变形比法确定,否则,宜根据应力比法确定。  相似文献   

粗颗粒悬移质测验误差分析   总被引：2，自引：0，他引：2  

韩其为 《水文》2008,28(1):1-6,20

本文根据流速与含沙量分布,研究了悬移质积点法对粗颗粒含沙量测验误差.首先指出无论从输沙率还是从悬浮高度看,粗颗粒悬移质集中于河底,致使水文测验中的一些测验方法(如一点法、二点法、三点法等)带有较大的误差.进而分析了各种测法对粗颗粒的相对误差,并且随着颗粒变粗,误差愈来愈大,以致不能接受.这种情况在水库下游河道冲刷过程中,会在一定程度上出现,必须重视研究和调整测验方法.最后通过与长江委水文局在沙市及监利两水文站试验结果对比,证明本文理论上的分析是可信的.  相似文献   

流场散度的误差估计     

麻娜 《海洋科学》2006,30(8):13-16

按照误差传递原理,推导出流场散度的误差估计式,并将其应用于赤道中东太平洋上升流区域水平散度误差的估计。应用结果表明:赤道中东太平洋上升流区多年平均流场的散度稳定,平均散度约为3.0×10-7s-1;和通常采用的误差估计公式相比,该估计公式降低了散度误差,从而提高了散度的可信度。  相似文献   

动态水平-海面辐照度测量的新理念     

钟其英  柯天存 《海洋技术学报》2007,26(3):55-57

目前海面辐照度的测量,在消除天空光影响的同时,却引入了仪器接收面倾斜的误差。作者经过多年的实践,提出动态水平的理念和一整套技术方法,解决了这一问题。动态水平技术的应用,需应用最新技术的发展,而且必然引起海洋光学测量仪器、特别是海洋光学浮标的一系列变革,对海洋水色遥感具有重要的意义和影响。  相似文献   

压力传感器的自动标定技术     

王莉娜  赵先龙  阮锐  严晓明 《海洋测绘》2007,27(4):78-80

针对压力测量设备生产和维护过程中,对关键部件压力传感器标定处于手工操作状态、效率低、操作人员不易掌控、标定结果处置复杂的现状,开发了针对压力传感器的自动标定技术。该技术将计算机控制、智能化、曲线拟合和误差分析引入到压力传感器的标定过程中,大幅度提高了标定的效率和可靠性。经此技术标定过的压力探头,在使用中具有互换性,减轻了数据后处理工作的难度。  相似文献