Fe(OH)_3胶体与铜离子作用的研究     

张恩仁  田玉红  张正斌  刘莲生 《热带海洋学报》2001,(4)

使用切向流超滤系统得到粒度较均匀的Fe(OH)3胶体,进而对Fe(OH)3胶体粒子与Cu2 的作用进行了研究,并将实验结果与南沙群岛海区表层水中铜与胶体物质结合状况的调查数据进行了比较分析,得到如下结果:(1)在海水介质中,铜在Fe(OH)3胶体上结合的百分率(pH>5)随pH的升高而下降,随着Fe(OH)3胶体浓度的减小而下降?(2)在天然海水介质中,使铜在Fe(OH)3胶体上结合的百分率在50%-70%的有机物浓度为1.0mg·L-1,有机物浓度的增大使铜与无机胶体结合的百分率有下降的趋势?  相似文献   

Remote estimation of surficial seafloor properties through the application Angular Range Analysis to multibeam sonar data   总被引：2，自引：2，他引：2  

Luciano Fonseca  Larry Mayer 《Marine Geophysical Researches》2007,28(2):119-126

The variation of the backscatter strength with the angle of incidence is an intrinsic property of the seafloor, which can be used in methods for acoustic seafloor characterization. Although multibeam sonars acquire backscatter over a wide range of incidence angles, the angular information is normally neglected during standard backscatter processing and mosaicking. An approach called Angular Range Analysis has been developed to preserve the backscatter angular information, and use it for remote estimation of seafloor properties. Angular Range Analysis starts with the beam-by-beam time-series of acoustic backscatter provided by the multibeam sonar and then corrects the backscatter for seafloor slope, beam pattern, time varying and angle varying gains, and area of insonification. Subsequently a series of parameters are calculated from the stacking of consecutive time series over a spatial scale that approximates half of the swath width. Based on these calculated parameters and the inversion of an acoustic backscatter model, we estimate the acoustic impedance and the roughness of the insonified area on the seafloor. In the process of this inversion, the behavior of the model parameters is constrained by established inter-property relationships. The approach has been tested using a 300 kHz Simrad EM3000 multibeam sonar in Little Bay, NH. Impedance estimates are compared to in situ measurements of sound speed. The comparison shows a very good correlation, indicating the potential of this approach for robust seafloor characterization.  相似文献   

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin   总被引：1，自引：1，他引：1  

Michael Riedel 《Marine Geophysical Researches》2007,28(4):355-371

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.  相似文献   

Geoacoustic Characterisation of Fine-grained Sediments using Single and Multiple Reflection Data     

J.-P. Hermand  C.W. Holland 《Marine Geophysical Researches》2005,26(2-4):267-274

Fine-grained sediments commonly occur in areas of the continental shelf where wave and current energy are weak. Bulk density, compressional wave speed and attenuation are fundamental physical properties of these sediments required for predicting the response of the seabed for diverse branches of marine science. The traditional coring approach is time and labor-intensive, with large uncertainties associated with sediment disturbance in the sampling phase. Acoustic methods offer the advantages of remote sensing, i.e., sampling the sediment structure without mechanical disturbance and a significantly larger seabed coverage rate per unit time. Two different acoustic methods are described: one using short-range single-bounce interactions with the seabed, and the second using long-range modal propagation to infer the sediment properties. The relative strengths and sensitivities of each approach are explored through simulations guided by experience with measured data.  相似文献   

无机碳与雨生红球藻(Haematococcus pluvialis)细胞调节物质   总被引：4，自引：0，他引：4  

刘建国  孙艳妮  殷明焱  刘伟  张展 《海洋与湖沼》2004,35(5):459-466

以单细胞雨生红球藻为材料，采用酸碱滴定和CO2加富通气培养微藻的方法，对旧液中HCO3^-和CO3^2-浓度变化以及对红球藻细胞生长的影响进行了研究。结果表明，旧液具有限制红球藻细胞生长和诱导细胞转化的作用。同时，旧液中无机碳离子浓度明显高于新液。培养液中富含CO3^2-时，各细胞数量与CO3^2-浓度呈正相关，相关系数为0．88。溶液中仅有HCO3^-时，各细胞数与HCO3^-浓度也呈正相关性。因此，排除了CO3^2-和HCO3^-作为旧液中的调节物质，限制红球藻细胞生长和诱导细胞转化的可能性。旧液乙酸乙酯提取物生物检测实验表明，在粗提取物中有降低细胞增长和诱导细胞转化的活性，表明调节物质能溶于有机相，也反过来证实无机碳离子不是旧液中的调节物质。DNA含量和倍性分析结果表明，红球藻游动细胞DNA复制可以加倍后不经过原生质分裂就可以再次进行，因此推测旧液中的调节物质对原生质分裂过程产生抑制作用，而不对DNA复制过程产生抑制作用。  相似文献   

断阶型潜山带地质模型的建立及储层预测--以CG20潜山为例     

姜素华  王永诗  张家震  王军 《中国海洋大学学报(自然科学版)》2004,34(3):437-445

以 CG2 0潜山为例 ,从建立地质模型入手 ,包括地层模型、构造模型、储集模型、储盖组合模型、速度模型等 ,认识到各套地层分布和储层物性的差异均与地震响应密切相关 ,因此可以利用地震波的信息 ,预测潜山储层的发育及分布情况。在对 CG2 0潜山进行精细全三维构造解释的基础上 ,探讨性地应用了测井约束反演、吸收系数、相干分析及三维模式识别等技术 ,对潜山储层进行了预测 ,从而提高了潜山勘探的效益 ,并为类似断阶型潜山带的勘探提供了成功的经验 ,具有一定的指导意义。  相似文献   

塘沽海区海底地形的SAR影像仿真与反演研究   总被引：1，自引：0，他引：1  

夏长水  袁业立 《海洋科学进展》2003,21(4):437-445

利用袁业立、金梅兵(1997)提出的海底地形SAR影像仿真与反演模型，对渤海塘沽海区的一张Radarsat SAR影像进行了仿真和水深反演研究。研究结果表明：仿真影像与真实SAR影像基本吻合，反演水深与实际水深也有较好的一致性；进一步证实了袁业立(1997)SAR成像机理的正确性和在中国近海利用SAR影像进行浅海水深探测的可行性。  相似文献   

Optimum Sample Size to Detect Perturbation Effects: The Importance of Statistical Power Analysis – A Critique     

Marco Ortiz 《Marine Ecology》2002,23(1):1-9

Abstract. The current article describes statistical power analysis as an efficient strategy for the estimation of the optimum sample size. The principle aim is constructively to criticise and enrich the results presented by Mouillot et al. (1999) , who estimate the optimum sample size for evaluating possible perturbations. The authors did not make any reference to statistical power analysis, even though their objective clearly went beyond a simple stock evaluation to assess management strategies in a particular marine ecosystem. Surprisingly, they proposed (a priori) an ANOVA design to test a hypothesis considering both space and temporal scales. However, the authors did not cover important topics related with power analysis and the precautionary principle, both used into environment impact assessment programmes for marine ecosystems. Based on their results and on statistical power analysis, it is demonstrated that the variability (dispersion statistics), a key factor they used to estimate the sample size, is less relevant than the magnitude of perturbation (effect size). Therefore, a greater effort must be devoted to estimate the effect size of a particular phenomenon rather than a desired variability.  相似文献   

3D gravity modelling for Anyongbok Seamount in the East Sea     

Moo Hee Kang  Hyun-Chul Han  Hyesu Yun  Gee Soo Kong  Kyong O. Kim  Youn Soo Lee 《Marine Geophysical Researches》2007,28(3):257-269

A seamount chain with an approximately WNW trend is observed in the northeastern Ulleung Basin. It has been argued that these seamounts, including two islands called Ulleung and Dok islands, were formed by a hotspot process or by ridge related volcanism. Many geological and geophysical studies have been done for all the seamounts and islands in the chain except Anyongbok Seamount, which is close to the proposed spreading ridge. We first report morphological characteristics, sediment distribution patterns, and the crustal thickness of Anyongbok Seamount using multibeam bathymetry data, seismic reflection profiles, and 3D gravity modeling. The morphology of Anyongbok Seamount shows a cone shaped feature and is characterized by the development of many flank cones and flank rift zones. The estimated surface volume is about 60 km³, and implies that the seamount is smaller than the other seamounts in the chain. No sediments have been observed on the seamount except the lower slope, which is covered by more than 1,000 m of strata. The crustal structure obtained from a 3D gravity modeling (GFR = 3.11, SD 3.82 = mGal) suggests that the seamount was formed around the boundary of the Ulleung Plateau and the Ulleung Basin, and the estimated crustal thickness is about 20 km, which is a little thicker than other nearby seamounts distributed along the northeastern boundary of the Ulleung Basin. This significant crustal thickness also implies that Anyongbok Seamount might not be related to ridge volcanism.  相似文献   

Modelling morphological processes in the vicinity of shore-parallel breakwaters     

Julio A. Zyserman  Hakeem K. Johnson 《Coastal Engineering》2002,45(3-4)

  相似文献