A fluorescent sand-tracer experiment was performed at Comporta Beach (Portugal) with the aim of acquiring longshore sediment transport data on a reflective beach, the optimization of field and laboratory tracer procedures and the improvement of the conceptual model used to support tracer data interpretation.
The field experiment was performed on a mesotidal reflective beach face in low energetic conditions (significant wave height between 0.4 and 0.5 m). Two different colour tracers (orange and blue) were injected at low tide and sampled in the two subsequent low tides using a high resolution 3D grid extending 450 m alongshore and 30 m cross-shore. Marked sand was detected using an automatic digital image processing system developed in the scope of the present experiment.
Results for the two colour tracers show a remarkable coherence, with high recovery rates attesting data validity. Sand tracer displayed a high advection velocity, but with distinct vertical distribution patterns in the two tides: in the first tide there was a clear decrease in tracer advection velocity with depth while in the second tide, the tracer exhibited an almost uniform vertical velocity distribution. This differing behaviour suggests that, in the first tide, the tracer had not reached equilibrium within the transport system, pointing to a considerable time lag between injection and complete mixing. This issue has important implications for the interpretation of tracer data, indicating that short term tracer experiments tend to overestimate transport rates. In this work, therefore, longshore estimates were based on tracer results obtained during the second tide.
The estimated total longshore transport rate at Comporta Beach was 2 × 10− 3 m3/s, more than four times larger than predicted using standard empirical longshore formulas. This discrepancy, which results from the unusually large active moving layer observed during the experiment, confirms the idea that most common longshore transport equations under-estimate total sediment transport in plunging/surging waves. 相似文献
In autumn 2002 a time-series station was installed in the tidal inlet between the Islands of Langeoog and Spiekeroog (Southern North Sea, NW Germany) to continuously measure physical, chemical, and meteorological parameters, even during extreme weather conditions (gale-force storms, drifting ice). Inside the pole of the station sensor tubes are installed in direction of the prevailing tidal currents. The tubes are equipped with hydrographic sensors (pressure, temperature, conductivity) and allow retrieval of water for nutrient analysis by automated instruments located inside the pole. Dissolved methane and the nutrients ammonia, nitrite, nitrate, phosphate, and silicate are measured at the station. 相似文献
Incremental Differential Quadrature Method (IDQM) as a rapid and accurate method for numerical simulation of Nonlinear Shallow Water (NLSW) waves is employed. To the best of authors’ knowledge, this is the first endeavor to exploit DQM in coastal hydraulics. The one-dimensional NLSW equations and related boundary conditions are discretized in space and temporal directions by DQM rules and the resulting system of equations are used to compute the state variables in the entire computational domain. It was found that the splitting of total simulation time into a number of smaller time increments, could significantly enhance the performance of the proposed method. Furthermore, results of this study show two main advantages for IDQM compared with other conventional methods, namely; unconditional stability and minimal computational effort. Indeed, using IDQM, one can use a few grid points (in spatial or time direction) without imposing any stability condition on the time step to obtain an accurate convergent solution. 相似文献
