H2O-CH4-H2-CO2-CO-O2在高温、高压和高密度条件下的状态方程     

胡家文 《地球化学》2002,31(4):389-394

为了计算高温，高压和高密度流体的热力学性质，提出了一个具有19个参数的维里型状态方程，其中参数与温度间的函数关系采用由Sutherland位能函数导出的维里系数近似式。除临界点附近以外，在已报道的pVT数据所覆盖的大部分超临界区域内，该方程均可适用。用该方程对H2O，CH4，H2，CO2，CO和O2等流体pVT关系的计算结果令人满意，其中pVT上限分别为：91-610GPa,1.6-11.0cm^3/mol,4000-5000K。计算体积的平均偏 小于0．8％，最大偏差小于5．4％。  相似文献   

Groundwater-flow modeling in the Yucatan karstic aquifer, Mexico   总被引：1，自引：0，他引：1  

Roger González-Herrera  Ismael Sánchez-y-Pinto  José Gamboa-Vargas 《Hydrogeology Journal》2002,10(5):539-552

The current conceptual model of the unconfined karstic aquifer in the Yucatan Peninsula, Mexico, is that a fresh-water lens floats above denser saline water that penetrates more than 40 km inland. The transmissivity of the aquifer is very high so the hydraulic gradient is very low, ranging from 7–10 mm/km through most of the northern part of the peninsula. The computer modeling program AQUIFER was used to investigate the regional groundwater flow in the aquifer. The karstified zone was modeled using the assumption that it acts hydraulically similar to a granular, porous medium. As part of the calibration, the following hypotheses were tested: (1) karstic features play an important role in the groundwater-flow system; (2) a ring or belt of sinkholes in the area is a manifestation of a zone of high transmissivity that facilitates the channeling of groundwater toward the Gulf of Mexico; and (3) the geologic features in the southern part of Yucatan influence the groundwater-flow system. The model shows that the Sierrita de Ticul fault, in the southwestern part of the study area, acts as a flow barrier and head values decline toward the northeast. The modeling also shows that the regional flow-system dynamics have not been altered despite the large number of pumping wells because the volume of water pumped is small compared with the volume of recharge, and the well-developed karst system of the region has a very high hydraulic conductivity. Electronic Publication  相似文献   

An automated strategy for calculation of phase diagram sections and retrieval of rock properties as a function of physical conditions   总被引：9，自引：0，他引：9  

J. A. D. Connolly  K. Petrini 《Journal of Metamorphic Geology》2002,20(7):697-708

We formulate an algorithm for the calculation of stable phase relations of a system with constrained bulk composition as a function of its environmental variables. The basis of this algorithm is the approximate representation of the free energy composition surfaces of solution phases by inscribed polyhedra. This representation leads to discretization of high variance phase fields into a continuous mesh of smaller polygonal fields within which the composition and physical properties of the phases are uniquely determined. The resulting phase diagram sections are useful for understanding the phase relations of complex metamorphic systems and for applications in which it is necessary to establish the variations in rock properties such as density, seismic velocities and volatile‐content through a metamorphic cycle. The algorithm has been implemented within a computer program that is general with respect to both the choice of variables and the number of components and phases possible in a system, and is independent of the structure of the equations of state used to describe the phases of the system.  相似文献   

Physical properties of ultrahigh-pressure metamorphic rocks from the Sulu terrain, eastern central China: implications for the seismic structure at the Donghai (CCSD) drilling site     

Hartmut Kern  Zhenmin Jin  Shan Gao  Till Popp  Zhiqin Xu 《Tectonophysics》2002,354(3-4)

About 30 samples representing major lithologies of Sulu ultrahigh-pressure (UHP) metamorphic rocks were collected from surface exposures and exploration wells, and compressional (Vp) and shear wave (Vs) velocities and their directional dependence (anisotropy) were determined over a range of constant confining pressures up to 600 MPa and temperatures ranging from 20 to 600 °C. Samples range in composition from acidic to ultramafic. P- and S-wave velocities measured at 600 MPa vary from 5.08 to 8.64 km/s and 2.34 to 4.93 km/s, respectively. Densities are in the range from 2.60 to 3.68 g/cm³. To make a direct tie between seismic measurements (refraction and reflection) and subsurface lithologies, the experimental velocity data (corresponding to shallow depths) were used to calculate velocity profiles for the different lithologies and profiles of reflection coefficients at possible lithologic interfaces across the projected 5000-m Chinese Continental Scientific Drilling Program (CCSD) crustal segment. Comparison of calculated in situ velocities with respective intrinsic velocities suggests that the in situ velocities at shallow depths are lowered by an increased abundance of open microcracks. The strongly reflective zone beneath the Donghai drill site can be explained by the impedance contrasts between the different lithologies. Contacts between eclogite/peridotite and felsic rocks (gt-gneiss, granitic gneiss), in particular, may give rise to strong seismic reflections. In addition, shear-induced (lattice preferred orientation (LPO)-related) seismic anisotropy can increase reflectivity. For the explanation of the high velocity bodies (>6.4 km/s) around 1000 m and below 3200-m depth, large proportions of eclogite/peridotite (about 40 and 30 vol.%, respectively) are needed.  相似文献   

Al hematites prepared by homogeneous precipitation of oxinates: material characterization and determination of the Morin transition     

G. M. da Costa  E. Van San  E. De Grave  R. E. Vandenberghe  V. Barrón  L. Datas 《Physics and Chemistry of Minerals》2002,29(2):122-131

A novel method for synthesis of aluminium hematites, based upon the homogeneous precipitation of Fe and Al oxinates in various proportions, is presented. The precursor precipitates are heated in air at 700?°C. X-ray diffraction, thermal analyses, BET, FTIR, optical reflection analysis, TEM and Mössbauer spectroscopy at room temperature and 80?K of the resulting products indicate that single-phase hematites are formed with structural Al substitution of up to 10 at%. Interestingly, the particle size (>100?nm) is not substantially reduced by the Al content. Although it remains difficult to obtain a homogeneously distributed Al substitution in the final hematite, this processing line offers a unique opportunity to separate the effects of grain size and Al substitution on the Morin transition temperature (T _M) of Al hematite. From the comparison between the present hematites and a series of Al-substituted hematites with lepidocrocite as precursor, it could be shown that the effect on T _M, associated with a change of a factor 10 in grain size, is about 1/3 of the effect caused by a change of 10 in the degree of substitution. Finally, it is suggested that proper thermal treatments under different conditions of the same precursors are likely to produce spinel phases.  相似文献   

中超长钻孔灌注桩的沉降计算   总被引：1，自引：0，他引：1       下载免费PDF全文

管雯  史海兵  李志成 《探矿工程》2002,(2):11-13

针对现有的桩基沉降计算理论不仅难以完整地描述桩－土系统的复杂程度，在应用上也难以满足各方面的要求，根据中超长钻孔灌注桩的实际情况，采取一些合理的简化措施后，提出了一种实用的桩基沉降计算方法，实例分析表明，该方法可较好地预测桩的沉降量。  相似文献   

城市地区抗御地震灾害风险评估项目综述     

何玉林  韩渭宾  裴锡瑜  李广俊 《四川地震》2002,(4):35-38

城市地区抗御地震灾害风险评估项目系联合国在上世纪末为减轻地震灾害所实施的规模宏大，影响甚远的国际性研究项目，其宗旨是为了提高社会公众防灾意识，有效地减轻城市地区的地震灾害。这一历时2年的项目在有限的经费支持下，取得了令人瞩目的成绩。结合自贡市开展这个项目的实践。综合介绍和总结了该项目的情况及经验。  相似文献   

A methodology for the evaluation of long-term volcanic risk from pyroclastic flows in Campi Flegrei (Italy)     

I. Alberico  L. Lirer  P. Petrosino  R. Scandone 《Journal of Volcanology and Geothermal Research》2002,116(1-2)

The volcanological history of Campi Flegrei suggests that the most frequent eruptions are characterized by the emplacement of pyroclastic flow and surge deposits erupted from different vents scattered over a 150-km² caldera. The evaluation of volcanic risk in volcanic fields is complex because of the lack of a central vent. To approach this problem, we subdivided the entire area of Campi Flegrei into a regular grid and evaluated the relative spatial probability of opening of vents based on geological, geophysical and geochemical data. We evaluated the volcanic risk caused by pyroclastic flows based on the formula proposed by UNESCO (1972), R=H×V×Va, where H is the hazard, V is the vulnerability and Va is the value of the elements at risk. The product H×V was obtained by performing simulations of type eruptions centered in each cell of the grid. The simulation is based on the energy cone scheme proposed by Sheridan and Malin [J. Volcanol. Geotherm. Res. 17 (1983) 187–202], hypothesizing a column collapse height of 100 m for eruptions of VEI=3 and 300 m for eruptions of VEI=4 with a slope angle of 6°. Each simulation has been given the relative probability value associated with the corresponding cell. We made use of the GIS software ArcView 3.2 to evaluate the intersection between the energy cone and the topography. The superposition of the areas invaded by pyroclastic flows (124 simulations for VEI=3 and 37 for VEI=4) was used to obtain the relative hazard map of the area. The relative volcanic risk map is obtained by superimposing the urbanization maps.  相似文献   

Sediment yield and storage variations in the Négron River catchment (south western Parisian Basin,France) during the Holocene period     

Jean‐Jacques Macaire  Saïda Bellemlih  Christian Di‐Giovanni  Patrick De Luca  Lionel Visset  Jacques Bernard 《地球表面变化过程与地形》2002,27(9):991-1009

In the Négron River catchment area (162 km²), surface‐sediment stores are composed of periglacial calcareous ‘grèze’ (5 × 10⁶ t) and loess (21 × 10⁶ t), and Holocene alluvium (12·6 × 10⁶ t), peat (0·6 × 10⁶ t) and colluvium (18·5 × 10⁶ t). Seventy‐five per cent of the Holocene sediments is stored along the thalwegs. Present net sediment yield, calculated from solid discharge at the Négron outlet, is low (0·6 t km^?2 a^?1) due to the dominance of carbonate rocks in the catchment. Mean sediment yield during the Holocene period is 7·0 t km^?2 a^?1 from alluvium stores and 7·6 t km^?2 a^?1 from colluvium stores. Thus, the gross sediment yield during the Holocene period is about 18·7 t km^?2 a^?1 and the sediment delivery ratio 3 per cent. The yield considerably varies from one sub‐basin to another (3·9 to 24·5 t km^?2 a^?1) according to lithology: about 25 per cent and 50 per cent of initial stores of periglacial grèze and loess respectively were reworked during the Holocene period. Sediment yield has increased by a factor of 6 in the last 1000 years, due to the development of agriculture. The very high rate of sediment storage on the slope during that period (88 per cent of the yield) can be accounted for by the formation of cultivation steps (‘rideaux’). It is predicted that the current destruction of these steps will result in a sediment wave reaching the valley floors in the coming decades. Subboreal and Subatlantic sediments and pollen assemblages in the Taligny marsh, where one‐third of the alluvium is stored, show the predominant influence of human activity during these periods in the Négron catchment. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Development of site-specific design ground motions in Western and Eastern North America     

Walter Silva  Carl Costantino   《Soil Dynamics and Earthquake Engineering》2002,22(9-12):755-764

This paper presents results recently obtained for generating site-specific ground motions needed for design of critical facilities. The general approach followed in developing these ground motions using either deterministic or probabilistic criteria is specification of motions for rock outcrop or very firm soil conditions followed by adjustments for site-specific conditions. Central issues in this process include development of appropriate attenuation relations and their uncertainties, differences in expected motions between Western and Eastern North America, and incorporation of site-specific adjustments that maintain the same hazard level as the control motions, while incorporating uncertainties in local dynamic material properties. For tectonically active regions, such as the Western United States (WUS), sufficient strong motion data exist to constrain empirical attenuation relations for M up to about 7 and for distances greater than about 10–15 km. Motions for larger magnitudes and closer distances are largely driven by extrapolations of empirical relations and uncertainties need to be substantially increased for these cases.

For the Eastern United States (CEUS), due to the paucity of strong motion data for cratonic regions worldwide, estimation of strong ground motions for engineering design is based entirely on calibrated models. The models are usually calibrated and validated in the WUS where sufficient strong motion data are available and then recalibrated for applications to the CEUS. Recalibration generally entails revising parameters based on available CEUS ground motion data as well as indirect inferences through intensity observations. Known differences in model parameters such as crustal structure between WUS and CEUS are generally accommodated as well. These procedures are examined and discussed.  相似文献