Geochemical data are presented for the meta-igneous, mafic-ultramafic complex near Finero. This complex is in contact with a phlogopite-bearing mantle peridotite and is subdivided into the Internal Gabbro unit, the Amphibole Peridotite unit, and the External Gabbro unit. The Internal Gabbro and the Amphibole Peridotite units consist of coarse-grained, chemically heterogeneous cumulates, whereas the External Gabbro unit is generally massive, chemically more uniform and approximately representative of the residual melt with MgO contents between 6.6 and 9.1% and Mg numbers between 38 and 58. Both whole-rock and mineral contents of Ni and Cr are significantly higher (at similar Mg numbers) in the Amphibole Peridotite unit than in the Internal Gabbro unit. The most straightforward interpretation of this is that the Amphibole Peridotite unit accumulated after the influx of fresh mafic (or ultramafic) magma into the magma chamber. Major-element chemical trends are continuous from the Amphibole Peridotite unit to the External Gabbro unit and are consistent with closed-system fractionation with no further addition of magma or contamination by wall or roof rock assimilation. In the External Gabbro unit, total FeO and TiO2 contents are strongly correlated with each other (and with P2O5 and Zr) and reach values as high as 19 and 4%, respectively, indicating an advanced degree of crystal fractionation along a tholeftic trend. The External Gabbro samples have generally smooth normalized trace element patterns, which are consistent with being representative of a liquid composition. The residual nature of the External Gabbro magma is also indicated by negative Eu and Sr anomalies, clear evidence for prior feldspar fractionation. REE patterns are otherwise indistinguishable from N-type MORB, but Th and U are significantly more depleted than in MORB. This Th and U depletion is similar to that found in olivine basalts and picrites on Iceland and Hawaii; its origin is not well understood. No evidence is seen for any assimilation of crystal material, in sharp contrast with the situation of the igneous complex in Val Sesia near Balmuccia, where the magma composition is dominated by assimilation of crust. We suggest that the heat provided by at most two injections of magma near Finero was insufficient to induce crystal anatexis, in contrast with the excess heat supplied by multiple magma injections at Balmuccia. 相似文献
The 117.38 m of gabbroic core drilled during the Ocean Drilling Program (ODP) Leg 153 at Sites 921 to 924 in the Mid-Atlantic Ridge (MAR) between 23 °N and the Kane Fracture Zone, exhibits a remarkable primary compositional heterogeneity, such as magmatic layering, intrusive contacts and late magmatic veining, which express a succession of magmatic events. Textural indicators suggest that the cooling of the crystal mush occurred in a dynamic environment, with infiltration of progressively evolved liquids. Magmatic features include random shape fabric and magmatic lamination; the subsequent deformational overprint occurred in subsolidus conditions. The ductile deformation, generally concentrated in discrete domains of the gabbro, is associated with continuous re-equilibration of the metamorphic assemblages of (1) olivine + clinopyroxene + orthopyroxene + plagioclase + ilmenite + Ti-magnetite, (2) olivine + clinopyroxene + plagioclase + ilmenite + Ti-magnetite + red hornblende. At lower temperatures brittle deformation prevails and subsequent fractures control the development of metamorphic assemblages: (3) clinopyroxene + plagioclase + red brown hornblende + Ti-magnetite + magnetite (?) + ilmenite, (4) plagioclase + brown hornblende + Ti-magnetite + magnetite + hematite + titanite ± Ti-oxide, (5) plagioclase + green hornblende + magnetite + titanite, (6) plagioclase + actinolite + chlorite + titanite + magnetite, (7) albite + actinolite + chlorite + prehnite ± epidote ± titanite and (8) albite + prehnite + chlorite ± smectite. Assemblages 1 to 8 express increasing water/rock ratios and decreasing degrees of recrystallization.
During the ductile phase, red hornblende is stable and its abundance increases with deformation intensity, possibly as an effect of the introduction of hydrous fluids. During the brittle phase, water diffusion controls the development of the fracture-filling mineral assemblages and re-equilibration of the adjacent rock; temperatures decrease further, as demonstrated by mineral zoning and incompletely re-equilibrated assemblages. The lowest temperatures correspond to the development of hydrothermal assemblages.
Compared with oceanic gabbros from fast-spreading transform environments, high-temperature ductile phases (granulite and amphibolite) are well developed, whereas brittle phases are widespread, as microcracks, prevalent on fracturing associated with discrete veins. 相似文献
Four metallogenic epochs occurred in different tectonic environments during theevolution of the Northern Qilian metallogenic province through the geological time. The Mid-dle Proterozoic metallogenic epoch witnessed the tectonic environment of crustal breakupcaused by mantle diapirism, in which ultramafic-mafic rocks were intruded along beep faultbelts and the superlarge Jinchuan magmatic Cu-Ni sulphide deposit was formed. In theMiddle-Late Proterozoic metallogenic epoch the crust was further broken to form anintracontinental rift, in which the Chenjiamiao style massive Cu-Fe sulphide deposits hosted bybasic volcanic tuff were formed in the lower volcano-sedimentary sequence, while the largesedex type Jingtieshan style Fe-Cu deposits were formed within the upper abyssal carbon-richargillaceous sedimentary sequence. The Early Palaeozoic saw the aulacogen environment, with-in which the Baiyinchang style superlarge massive base and precious metal sulphide depositshosted by quartz keratophyric tuff were formed in the Middle-Late Cambrian rifted island arcand the massive Cu-Zn sulphide deposits and magmatic chromite deposits associated with theophiolite suite were formed in the Early-Middle Ordovician, and the Honggou style massiveCu-Fe sulphide deposits hosted by spilite were formed in the Late Ordovician back-arc basinenvironment. In the Late Palaeozoic-Meso-Cenozoic, the metallogenic province went into anintracontinental orogenic stage characterized by compressive tectonic environment, in whichthere occurred carbonate-quartz vein type and tectono-alteration gold deposits associated withductile-shear structures. 相似文献
We study the importance of the zones of weakness and the pattern of downgoing flow in steady-state models of subducting lithosphere, which interacts mechanically and thermally with the ambient mantle. The non-linear system of governing equations consists of (i) the momentum equation in stream function formulation and (ii) the steady-state heat transfer equation including conduction and advection of heat and dissipation. A finite element method has been applied to this system. We consider the viscosity to be a non-linear function of both the temperature and the stream function. In steady-state two-dimensional (2D) flow, the stream function isolines follow material trajectories. They are used to follow the top of the subducting slab, which because of its possible increase in water content, is assumed to have a lower viscosity. The zone of weakness has been thus obtained in the self-consistent fashion since the stream function as well as the temperature are the output from our modeling and no a priori assumptions about the shape of the bending lithosphere are taken into account. It was shown that several orders decrease of viscosity in the zone of weakness is required to obtain the dip angle of about 45°. If the decrease of viscosity is not sufficient enough, the subducted slab either sinks almost vertically or does not exhibit a plate-like behavior. We have also demonstrated that shear heating can unrealistically increase at the zone of weakness for fast subductions if decrease of viscosity is underestimated. 相似文献
In southern Turkey ongoing differential impingement of Arabia into the weak Anatolian collisional collage resulting from subduction of the Neotethyan Ocean has produced one of the most complex crustal interactions along the Alpine–Himalayan Orogen. Several major transforms with disputed motions, including the northward extension of the Dead Sea Fault Zone (DSFZ), meet in this region. To evaluate neotectonic motion on the Amanos and East Hatay fault zones considered to be northward extensions of the DSFZ, the palaeomagnetism of volcanic fields in the Karasu Rift between these faults has been studied. Remanence carriers are low-Ti magnetites and all except 5 of 51 basalt lavas have normal polarity. Morphological, polarity and K–Ar evidence show that rift formation occurred largely during the Brunhes chron with volcanism concentrated at 0.66–0.35 Ma and a subsidiary episode at 0.25–0.05. Forty-four units of normal polarity yield a mean of D/I=8.8°/54.7° with inclination identical to the present-day field and declination rotated clockwise by 8.8±4.0°. Within the 15-km-wide Hassa sector of the Karasu Rift, the volcanic activity is concentrated between the Amanos and East Hatay faults, both with left lateral motions, which have rotated blocks bounded by NW–SE cross faults in a clockwise sense as the Arabian Block has moved northwestwards. An average lava age of 0.5 Ma yields a minimum cumulative slip rate on the system bounding faults of 0.46 cm/year according with the rate deduced from the Africa–Arabia Euler vector and reduced rates of slip on the southern extension of the DSFZ during Plio-Quaternary times. Estimates deduced from offsets of dated lavas flows and morphological features on the Amanos Fault Zone [Tectonophysics 344 (2002) 207] are lower (0.09–0.18 cm/year) probably because they are limited to surface fault breaks and do not embrace the seismogenic crust.Results of this study suggest that most strike slip on the DSFZ is taken up by the Amanos–East Hatay–Afrin fault array in southern Turkey. Comparable estimates of Quaternary slip rate are identified on other faults meeting at an unstable FFF junction (DSFZ, East Anatolian Fault Zone, Karatas Fault Zone). A deceleration in slip rate across the DSFZ and its northward continuation during Plio-Quaternary times correlates with reorganization of the tectonic regime during the last 1–3 Ma including tectonic escape within Anatolia, establishment of the North and East Anatolian Fault Zones bounding the Anatolian collage in mid–late Pliocene times, a contemporaneous transition from transpression to transtension and concentration of all basaltic magmatism in this region within the last 1 Ma. 相似文献
Studies of supercontinental cycle are mainly concentrated on the assembly, breakup and dispersal of supercontinents, and studies of continental crustal growth largely on the growth and loss (recycling) of the crust. These two problems have long been studied separately from each other. The Paleozoic–Mesozoic granites in the Central Asian Orogenic Belt have commonly positive Nd values, implying large-scale continental crustal growth in the Phanerozoic. They coincided temporally and spatially with the Phanerozoic Pangea supercontinental cycle, and overlapped in space with the P-wave high-V anomalies and calculated positions of subducted slabs for the last 180 Ma, all this suggests that the Phanerozoic Laurasia supercontinental assembly was accompanied by large-scale continental crustal growth in central Asia. Based on these observations, this paper proposes that there may be close and original correlations between a supercontinental cycle, continental crustal growth and catastrophic slab avalanches in the mantle. In this model we suggest that rapid continental crustal growth occurred during supercontinent assembly, whereas during supercontinental breakup and dispersal new additions of the crust were balanced by losses, resulting in a steady state system. Supercontinental cycle and continental crustal growth are both governed by changing patterns of mantle convection. 相似文献
The Proterozoic Eastern Ghats Mobile Belt along the east coast of India shares a thrusted lower contact with the surrounding cratons. The thrust, known as the Terrane Boundary shear zone, is associated with two large lateral ramps resulting in a curved outline on the northwestern corner of the mobile belt. The Eastern Ghats Mobile Belt is divided into two lithotectonic units, the Lathore Group and the Turekela Group, based on their lithological assemblages and deformational history. On the basis of published data from a Deep Seismic Sounding (DSS) profile of the Eastern Ghats crust, the Terrane Boundary Shear Zone is considered to be listric in nature and acts as the sole thrust between craton and mobile belt. The Lathore and Turekela Groups are nappes. With this structural configuration the NW part is described as a fold thrust belt. However, the thrusting postdates folding and granulite metamorphism that occurred in the Eastern Ghats, as in the Caledonide type of fold thrust belt of NW Scotland. The Terrane Boundary Shear Zone is interpreted to be contiguous with the Rayner-Napier boundary of the Enderby Land in a Gondwana assembly. 相似文献