利用钻芯孔检测灌注桩钢筋笼长度的方法     

樊敬亮  董平  叶景艳  李明  朱国伟 《物探与化探》2008,32(3):335-337

根据充电法原理,结合模型桩试验,分析了钢筋笼周围的充电电场特征,结果表明钢筋笼的底端对应于电位梯度曲线的极小值点及电位曲线的拐点。以此研究结果为基础,提出了利用钻芯孔来检测成桩后钢筋笼长度的方法。某桥的应用表明,该方法简便、实用、可靠。  相似文献   

土壤吸湿-湿过程中水力传导度的拟合研究     

郝鹏  郑西来  田守波  马玉杰  李伟 《地下水》2008,30(3):4-7

非饱和含水介质在吸湿和脱湿的不同过程中,水力传导度随介质含水率的变化规律是不同的。本文选取大沽河流域两种代表性砂土,对其吸湿-脱湿两个过程分别进行试验观测,并使用VanGenuchten—Mualem模型对其吸湿-脱湿过程进行水力传导度的拟合。研究结果表明：砂土在吸湿过程的非饱和水力传导度与脱湿过程的非饱和水力传导度大小并不相同,在含水率相同的情况下,吸湿过程的水力传导度要比脱湿过程大,在含水率较低时（小于15％）相差可达1个数量级。  相似文献   

Regional conductance map of Andaman and Nicobar region     

P.B.V. Subba Rao   《Gondwana Research》2008,13(3):386-395

To image the electrical conductivity distribution, fluxgate magnetometers are operated at five sites in Andaman and Nicobar region. Transfer functions are estimated for the period range 8–128 min, from nighttime transient geomagnetic variations, using robust regression analysis. The observed induction arrows in Andaman Islands are found to point towards east despite deep sea located towards its west. This indicates that fore-arc basin (Andaman–Nicobar deep) is more conducting than the region of outer non-volcanic Island arc.Thin sheet model requires the conductance of 10,000–35,000 S (with increase conductivity towards the south) for explaining the observed induction pattern. The observed induction pattern at Andaman–Nicobar stations can be explained in terms of high conducting Cretaceous–Tertiary sediments filling the Andaman–Nicobar deep. High conductivity over Invisible bank has been attributed to the partial melts/volatile fluids derived from the subducting Indian plate that are intruding into the eastern margin of fore-arc basin through the West Andaman Fault (WAF).The induction pattern at Great Nicobar station (Campbell Bay) may be related to the highly conducting sediments filling the Mergui basin along with mafic intrusions. Also crustal transition occurs below the Mergui Terrace at the Malayan coast contributing to the enhanced conductivity anomaly.  相似文献   

Estimating hydraulic conductivity using grain-size analyses, aquifer tests, and numerical modeling in a riverside alluvial system in South Korea   总被引：2，自引：0，他引：2  

Jae-Yeol Cheong  Se-Yeong Hamm  Hyoung-Soo Kim  Eun-Joung Ko  Kyounghee Yang  Jeong-Hwan Lee 《Hydrogeology Journal》2008,16(6):1129-1143

Hydraulic conductivity (K) for an alluvial system in a riverbank filtration area in Changwon City, South Korea, has been studied using grain-size distribution, pumping and slug tests, and numerical modeling. The alluvial system is composed of layers: upper fine sand, medium sand, lower fine sand, and a highly conductive sand/gravel layer at the base. The geometric mean of K for the sand/gravel layer (9.89?×?10^?4 m s^?1), as determined by grain-size analyses, was 3.33 times greater than the geometric mean obtained from pumping tests (2.97?×?10^?4 m s^?1). The geometric mean of K estimates obtained from slug tests (3.08?×?10^?6 m s^?1) was one to two orders of magnitude lower than that from pumping tests and grain-size analyses. K estimates derived from a numerical model were compared to those derived from the grain-size methods, slug tests and pumping tests in order to determine the degree of deviation from the numerical model. It is considered that the K estimates determined by the slug tests resemble the uppermost part of the alluvial deposit, whereas the K estimates obtained by grain-size analyses and pumping tests are similar to those from the numerical model for the sand/gravel layer of the riverside alluvial system.  相似文献   

The relationship between zooplankton,conductivity and lake-water ionic composition in 111 lakes from the Interior Plateau of British Columbia,Canada   总被引：2，自引：0，他引：2  

Darren G. Bos  Brian F. Cumming  Christine E. Watters  John P. Smol 《International Journal of Salt Lake Research》1996,5(1):1-15

Zooplankton collected from vertical net tows were related to the environmental variables from 98 lakes from the Interior Plateau of British Columbia. Canonical correspondence analysis showed that both salinity and ionic composition (pH and Mg) of the lake-water made major and significant contributions to the first two ordination axes (=0.42 and 0.11 respectively,P<0.05). BothArtemia franciscana andMoina hutchinsoni had their highest relative abundance in meso-hypersaline waters. However,Artemia franciscana preferred waters that were higher in Mg and Ca, whileMoina hutchinsoni was found in waters that were lower in Mg and Ca. Similarly, at intermediate salinities,Daphnia pulex and the calanoid copepods preferred waters slightly lower in Mg and Ca, whereasCeriodaphnia laticaudata andSimocephalus spp. were relatively more common in waters higher in Mg and Ca. Because the freshest lakes studied varied much less in ionic composition, the zooplankton in these lakes did not show a preference to ionic composition. As expected, multi-generic groups, such as the calanoid copepods, cyclopoid copepods and nauplii, had wider tolerances to conductivity than groups identified to lower taxonomic levels. Significant weighted-averaging regression and calibration models of conductivity were developed based on zooplankton species composition from the study lakes (r ²=0.56,P<0.05). Samples composed largely of multi-generic taxa yielded the worst estimates of salinity in the reconstruction model. This study suggests that zooplankton community composition may be developed into a useful proxy for paleosalinity reconstruction.  相似文献   

Estimation of statistical parameters for censored lognormal hydraulic conductivity measurements     

Xian-Huan Wen 《Mathematical Geology》1994,26(6):717-731

Field tests of hydraulic conductivity (e.g., injection test, pumping test, etc.) in low permeability formations are subject to censoring due to the detection limit of the instruments used. An iterative method of estimating the mean and variance of hydraulic conductivity data with a presumed log-normal distribution function is presented. This method accounts for the data that are actually below the lower detection limit (called truncated data) and thus gives distribution parameters that are more representative for the underlying distribution. The proposed method is then tested on two simulated normally distributed random datasets having different variances. The results show that the means and variances estimated by the proposed method are very accurate. Finally, the method is used to estimate the mean and variance of hydraulic conductivity data from single hole water injection tests in a fractured geological formation.  相似文献   

The log-normal distribution for hydraulic conductivity of compacted clays: Two or three parameters?     

Huaming Zhai  Craig H. Benson 《Geotechnical and Geological Engineering》2006,24(5):1149-1162

Risk and uncertainty assessments for waste containment systems employing clay barriers often include spatial variability in the hydraulic conductivity as part of the analysis. The two-parameter log-normal distribution is often used to describe the spatial variability, but for compacted clays the three-parameter form can be more appropriate. A statistical hypothesis test was developed that can be used to determine if the two- or three-parameter form of the log-normal distribution is more appropriate. The test is based on a likelihood ratio, comparing likelihood functions for the two- and three-parameter forms at their maximums. Likelihood functions are used assuming that a data set can be segregated into a set of distinct groups of hydraulic conductivities. A step-by-step calculation procedure is described and the test is applied to data collected from 45 sites.  相似文献   

Modification of streaming potential by precipitation of calcite in a sand–water system: laboratory measurements in the pH range from 4 to 12     

Xavier Guichet  Laurence Jouniaux  Nicole Catel 《Geophysical Journal International》2006,166(1):445-460

  相似文献   

Quantitative determination of stress by inversion of speckle interferometer fringe patterns: experimental laboratory tests     

Douglas R. Schmitt  Mamadou S. Diallo  Frank Weichman 《Geophysical Journal International》2006,167(3):1425-1438

  相似文献   

Evaluation of three waterborne polymers as stabilizers for sandy soil     

Abdullah Al-Khanbashi  Shihab W. Abdalla 《Geotechnical and Geological Engineering》2006,24(6):1603-1625

This study reports on waterborne polymer emulsion systems that were used for structural modification of sandy soils. The first emulsion used was a styrene-acrylic, copolymer emulsion; the second and third were vinyl-acrylic, copolymer-based emulsions. Specimens were prepared by adding different polymer emulsions to the sand and water in prescribed amounts. The performance of the different emulsion systems as sand stabilizers was estimated through measurement of the hydraulic conductivity and compressive strength. Measurements of hydraulic conductivity were conducted in a flexible membrane test apparatus. The hydraulic conductivity for the three emulsions decreased at different rates, with an increase in polymer content up to 3 wt. (i.e., % by weight). Additional increase of polymer content did not introduce significant decrease in hydraulic conductivity, and, at 5 wt.%, the three emulsions had essentially the same effect. Measurements made on dry cylindrical specimens disclosed remarkable enhancement in the mechanical behavior of the system. The compressive strength and modulus of elasticity of the examined emulsions increased with a higher concentration of polymer. Scanning electron microscope (SEM) revealed that the reduction in the permeability and the improved mechanical properties can be attributed to three dominant structural changes: the development of interconnecting ties between the sand particles, the development of adhesion between neighboring sand particles in contact, and the covering of the sand particles with a thin polymer film.  相似文献