GYD-300型全液压动力头工程钻机的研制     

靳益民  高淑芳 《探矿工程》2008,35(12):23-25,34

GYD-300型全液压动力头工程钻机为全液压驱动,动力头反循环式机型。液压系统采用插装阀集成结构,电液复合操作。使用PC控制监测系统,适时检测孔底各相关压力,对不同地层进行范围设置,实现钻进过程中孔底的自动、手动恒压钻进。重点介绍了该钻机的结构特点、实验情况、主要技术参数等。  相似文献   

饱和粉砂不稳定性的试验研究   总被引：3，自引：0，他引：3  

符新军  赵仲辉 《岩土力学》2008,29(2):381-385

通过对净砂和级配良好粉砂(含10 %粉土)进行一系列三轴固结不排水试验（CU）,研究了粉土、孔隙比和围压对饱和粉砂不稳定性的影响。试验结果表明,净砂与粉砂在不排水剪切条件下均会出现应变软化现象（即不稳定性）。同一围压下脆性指数(IB)随孔隙比增加,但不稳定线的应力比随孔隙比增加而减小。引用等效粒间孔隙比(ege)后,净砂和粉砂在ege-ln p?平面上拥有基本相同的临界状态线。在临界状态理论及等效粒间孔隙比的基础上,提出在同一修正状态参数(?ge)下净砂和级配良好粉砂有相似的不稳定性。  相似文献   

深水沉积层序特点及构成要素   总被引：6，自引：0，他引：6  

蒋恕  王华  Paul  Weimer 《地球科学》2008,33(6):825-833

本文在回顾当前国际上深水沉积研究热点的基础上,结合在墨西哥湾深水研究的成果系统描述了深水沉积的定义、形成机理、深水沉积层序及深水沉积构成要素的特点.深水沉积主要是在重力流作用下深水环境的沉积,主要形成于相对水平面下降和早期上升的时期,主要分布在低位体系域中.深水层序以凝缩段为边界,块状搬运沉积最早形成并直接位于层序界面上,其上被河道-天然堤沉积所覆盖.典型深水沉积的要素主要由河道、天然堤及越岸沉积、板状砂、块状搬运沉积等构成,这些沉积要素时空上有序地分布.深水河道是物源的主要通道和沉积的重要场所,从上游至下游河道弯曲度增加,能量逐渐减弱.侧向迁移明显,垂向上由富砂的顺直河道演化为相对富泥的弯曲河道.天然堤及越岸沉积以泥质为主,天然堤沿河道呈楔状分布,其近端砂岩含量高,地层厚且倾角较陡;远端砂岩含量低,地层薄且平缓,侧向连续性好但垂向连续性差.板状砂主要为深水扇前缘非限制性沉积,可分为块型和层型.块型侧向连续性好,同时垂向连通性高.层型侧向连续性好,垂向连通性差.块状搬运沉积主要是低水位期坡上沉积物失稳形成的各类滑塌体及碎屑流,其对下伏地层侵蚀明显,分布广泛,变形构造常见,可作为油气良好的封盖层.  相似文献   

Centrifugal test of a road embankment built after new dredger fill on thick marine clay     

Fayun Liang  Mingyi Zhao  Chengrui Qin  Yajie Jia  Zhongwei Wang  Guiping Yue 《Marine Georesources & Geotechnology》2020,38(1):114-121

Abstract

The construction of a 100-km road network is planned on a land reclamation area in the Oujiang Estuary in China. The embankment had a height of 4 m and a base width of 60 m. The reclamation area is newly filled by a 3-m dredger fill on a 48-m thick layer of marine clay. Estimation of the settlement of the future road network is difficult. To guide the construction of the road network, a 1/100-scale centrifuge model test was performed with a marine clay sample from the construction site to simulate the layered settlements and evaluate the drainage effect of prefabricated vertical drains in the dredger fill in the following 10 years. The results of the centrifuge modeling test are verified by 10-month in situ monitoring, which shows agreement between the centrifuge modeling test results and the in situ results. The test results indicate that additional time is needed to reinforce the newly added dredger fill by the surcharge preloading method to uplift the elevation of the reclamation area with dredger fill.  相似文献   

西洋东大港水道流速垂线分布研究   总被引：2，自引：0，他引：2  

吴德安  张忍顺 《海洋工程》2005,23(1):88-92,96

对辐射沙洲海域东大港4#站位连续2个潮周期的流速测量资料进行了分析、研究,拟合给出了流速垂线分布关系,并根据实际测量资料确定了该站位6个水层的浑水水流尾流函数项表达式。这些表达式表明浑水水流尾流函数是相对深度和摩阻速度的函数。探讨分析了尾流函数的空间分布和潮周期过程。非恒定流的水流尾流函数项的准确表达,对于揭示含沙水流流速结构及水、沙相影响作用规律将起到启发和推动作用。  相似文献   

辐射沙洲南翼“水道-沙洲”系统与西太阳沙的稳定   总被引：2，自引：0，他引：2  

侯庆志  徐敏  陆培东 《海洋科学》2006,30(6):16-22

通过对江苏岸外辐射沙洲动态和西太阳沙海域动力泥沙环境的分析,论述了西太阳沙演变的宏观背景;由实测固定断面资料、地形资料的对比得出近40年来西太阳沙表面形态和水下地形的变化;结合西太阳沙表面泥沙在波浪和波流共同作用下运动特性的水槽试验研究,分析了西太阳沙冲淤变化的动力机制。从“烂沙洋水道-西太阳沙-西太阳沙南水道”系统的角度研究了西太阳沙演变的控制因素和演变规律。  相似文献   

Modeling bed-load transport of coarse sediments in the Great Bay Estuary, New Hampshire   总被引：1，自引：0，他引：1  

A. Bilgili  M. R. Swift  D. R. Lynch  J. T. C. Ip 《Estuarine, Coastal and Shelf Science》2003,58(4):937-950

Current, sea level and bed-load transport are investigated in the Lower Piscataqua River section of the Great Bay Estuary, New Hampshire, USA—a well-mixed and geometrically complex system with low freshwater input, having main channel tidal currents ranging between 0.5 and 2 m s⁻¹. Current and sea level forced by the M₂M₄M₆ tides at the estuarine mouth are simulated by a vertically averaged, non-linear, time-stepping finite element model. The hydrodynamic model uses a fixed boundary computational domain and accounts for flooding–drying of tidal flats by making use of a groundwater component. Inertia terms are neglected in comparison with pressure gradient and bottom friction terms, which is consistent with the observed principal dynamic balance for this section of the system. The accuracy of hydrodynamic predictions in the study area is demonstrated by comparison with four tidal elevation stations and two cross-section averaged current measurements. Simulated current is then used to model bed-load transport in the vicinity of a rapidly growing shoal located in the main channel of the lower system. Consisting of coarse sand and gravel, the shoal must be dredged every five to eight years. Two approaches are taken—an Eulerian parametric method in which nodal bed-load flux vectors are averaged over the tidal cycle and a Lagrangian particle tracking approach in which a finite number of sediment particles are released and tracked. Both methods yield pathways and accumulations in agreement with the observed shoal formation and the long-term rate of sediment accumulation in the shoal area.  相似文献   

低围压水平下砂的排水行为(英文)   总被引：2，自引：1，他引：2  

杨少丽  Rolf Sandven  冯秀丽  林霖 《中国海洋大学学报(自然科学版)》2001,31(3):441-447

采用干样沉降法制备样品 ,选用静三轴仪对松砂和密砂样在 10 k Pa至 10 0 k Pa的低围压下的排水行为进行了实验研究 ,并对实验结果作了橡皮膜校正 ,在围压为 10 k Pa的密砂实验中 ,轴向应力的校正值可达到 12 %。实验研究表明低围压下松砂的剪胀性非常明显 ,且存在剪应力极值 ;围压越低 ,松砂和密砂的剪应力极值越小 ,达到最大剪应力所对应的剪应变越小。同时还表明低围压范围内相对密度不同 ,砂的应力应变特性不同 ;此外 ,低围压下砂的内摩擦角高于高围压下的值 ,从而在工程上应重视低围压水平下砂土工程参数的合理选取  相似文献   

The morphodynamic modelling of tidal sand waves on the shoreface     

P.K. Tonnon  L.C. van Rijn  D.J.R. Walstra 《Coastal Engineering》2007

An artificial sand wave on the Dutch shoreface of the North Sea has been studied in conditions with relatively strong tidal currents in the range of 0.5 to 1 m/s and sediments in the medium sand size range of 0.2 to 0.5 mm. The sand wave is perpendicular to the tidal current and has a maximum height and length of the order of 5 m and 1 km, respectively. The sand wave is dynamically active and shows migration rates of the order of a few metres per year. A numerical morphodynamic model (DELFT3D model) has been used to simulate the morphological behaviour of the sand wave in the North Sea. This model approach is based on the numerical solution of the three-dimensional shallow water equations in combination with a surface wave propagation model (wind waves) and the advection–diffusion equation for the sediment particles with online bed updating after each time step. The model results show that the sand wave grows in the case of dominant bed-load transport (weak tidal currents; relatively coarse sediment; small roughness height; low waves) and that the sand wave decays in the case of dominant suspended transport (strong currents, relatively fine sediment, large roughness height; storm waves).  相似文献   

Stress Sharing Behavior and Its Mechanism during Consolidation Process in Composite Ground Improved by Sand Compaction Piles with Low Replacement Area Ratio     

S. -K. You  K. Oda  T. -H. Kim 《Marine Georesources & Geotechnology》2006,24(4):287-304

In order to accurately design a sand compaction pile (SCP) with low replacement area ratio, it is important to understand the mechanical interaction between the sand pile and clay ground and its mechanism during consolidation process in composite ground. In this article, therefore, a series of numerical analyses on composite ground improved by SCP with low replacement area ratio were carried out. The applicability of numerical analyses, in which an elasto-viscoplastic consolidation finite element method was applied, were confirmed by comparing the results obtained from a series of laboratory model tests with the composite ground improved by SCP. Through the results of the numerical analyses, mechanical behavior of the sand pile and clay in composite ground during consolidation is elucidated, together with a stress sharing mechanism between sand pile and clay.  相似文献