Evaluation of a probabilistic approach to simulation of alkalinity and electrical conductivity at a river bank filtration site     

A. K. Thakur  V. P. Singh  C. S. P. Ojha 《水文研究》2012,26(22):3362-3368

In river bank filtration, impurities present in the river water travel with the bank filtrate towards the pumping well. During this passage, certain types of impurities, such as turbidity, total coliform, and so forth, may get attenuated; however, it is interesting to note that some of the instant raw river water quality parameters, such as alkalinity and electrical conductivity, increase after the passage of water through the porous medium. This occurs because water, when passing through the soil pores, absorbs many of the solutes that cause an increase in alkalinity and electrical conductivity. Measurements at a river bank filtration site for a year showed that alkalinity of 116–32 mg l^?1 in river water increased to 222.4–159.9 mg l^?1 in the river bank filtered water. Likewise, the electrical conductivity increased from 280–131 μS cm^?1 to 462–409.6 μS cm^?1. This study uses a probabilistic approach for investigating the variation of alkalinity and electrical conductivity of source water that varies with the natural logarithm of the concentration of influent water. The probabilistic approach has the potential of being used in simulating the variation of alkalinity and electrical conductivity in river bank filtrate. Copyright © 2011 John Wiley & Sons, Ltd.  相似文献   

Coupled finite‐element simulation of injection well testing in unconsolidated oil sands reservoir     

Bin Xu  Ron C.K. Wong 《国际地质力学数值与分析法杂志》2013,37(18):3131-3149

This paper presents a finite‐element (FE) model for simulating injection well testing in unconsolidated oil sands reservoir. In injection well testing, the bottom‐hole pressure (BHP) is monitored during the injection and shut‐in period. The flow characteristics of a reservoir can be determined from transient BHP data using conventional reservoir or well‐testing analysis. However, conventional reservoir or well‐testing analysis does not consider geomechanics coupling effects. This simplified assumption has limitations when applied to unconsolidated (uncemented) oil sands reservoirs because oil sands deform and dilate subjected to pressure variation. In addition, hydraulic fracturing may occur in unconsolidated oil sands when high water injection rate is used. This research is motivated in numerical modeling of injection well testing in unconsolidated oil sands reservoir considering the geomechanics coupling effects including hydraulic fracturing. To simulate the strong anisotropy in mechanical and hydraulic behaviour of unconsolidated oil sands induced by fluid injection in injection well testing, a nonlinear stress‐dependent poro‐elasto‐plastic constitutive model together with a strain‐induced anisotropic permeability model are formulated and implemented into a 3D FE simulator. The 3D FE model is used to history match the BHP response measured from an injection well in an oil sands reservoir. Copyright © 2013 John Wiley & Sons, Ltd.  相似文献   

Hydraulic diffusivity and macrodispersivity calculations embedded in a geographic information system     

F.A.L. Pacheco 《水文科学杂志》2013,58(4):930-944

Abstract

A numerical technique is presented whereby aquifer hydraulic diffusivities (D) and macrodispersivities (α) are calculated by linear equations rewritten from flow and solute transport differential equations. The approach requires a GIS to calculate spatial and temporal hydraulic head (h) and solute concentration gradients. The model is tested in Portugal, in a semi-confined aquifer periodically monitored for h and chloride/sulphate concentrations. Average D (0.46 m²/s) and α (1975 m) compare favourably with literature results. The relationship between α and scale (L) is also investigated. In this context, two aquifer groups could be identified: the first group is heterogeneous at the “macroscopic” scale (solute travelled distances <1 km), but homogeneous at the “megascopic” scale. The overall scale dependency in this case is given by an equation of logarithmic type. The second group is heterogeneous at the macroscopic and megascopic scales, with a scale dependency of linear type.

Citation Pacheco, F.A.L., 2013. Hydraulic diffusivity and macrodispersivity calculations embedded in a geographic information system. Hydrological Sciences Journal, 58 (4), 930–944.  相似文献   

增强型AlGaN/GaN高电子迁移率晶体管高温退火研究     

王冲  全思  马晓华  郝跃  张进城  毛维 《海洋学报》2010,32(10):7333-7337

深入研究了两种增强型AlGaN/GaN高电子迁移率晶体管(HEMT)高温退火前后的直流特性变化.槽栅增强型AlGaN/GaN HEMT在500 ℃ N₂中退火5 min后,阈值电压由0.12 V正向移动到0.57 V,器件Schottky反向栅漏电流减小一个数量级.F注入增强型AlGaN/GaN HEMT在 400 ℃ N₂中退火2 min后,器件阈值电压由0.23 V负向移动到-0.69 V,栅泄漏电流明显增大.槽栅增强型器件退火过程中Schottky有效势垒  相似文献   

Modelling of groundwater flow in heterogeneous porous media by finite element method     

Hassan Smaoui  Lahcen Zouhri  Abdellatif Ouahsine  Erick Carlier 《水文研究》2012,26(4):558-569

The HySuf‐FEM code (Hydrodynamic of Subsurface Flow by Finite Element Method) is proposed in this article in order to estimate the spatial variability of the transmissivity values of the Berrechid aquifer (Morocco). The calibration of the model is based on the hydraulic head, hydraulic conductivity and recharge. Three numerical tests are used to validate the model and verify its convergence. The first test case consists in using the steady analytical solution of the Poisson equation. In the second, the model has been compared with the hydrogeological system which is characterized by an unconfined monolayer (isotropic layer) and computed by using PMWIN‐MODFLOW software. The third test case is based on the comparison between the results of HySuf‐FEM and the multiple cell balance method in the aquifer system with natural boundaries case. Good agreement between the Hydrodynamic of Subsurface Flow, the numerical tests and the spatial distribution of the thickening of the hydrogeological system is deduced from the analysis and the interpretations of hydrogeological wells. Copyright © 2011 John Wiley & Sons, Ltd.  相似文献   

Geotechnical assessment of the bearing capacity of coal mine floors     

A. Afrouz  F. P. Hassani  M. J. Scoble 《Geotechnical and Geological Engineering》1988,6(4):297-312

Summary This investigation concerns 3 longwall faces having variable strata and mining conditions, but supported by 202 tonnes hydraulic 6-leg chocks. Bearing capacity tests along the faces were conducted to evaluate the factors influencing floor deformation and failure. The effect of size, shape and perimeter of the base plates, thickness of the floor layer, time and moisture on the ultimate bearing capacity of the floor was measured and discussed. Application of this work is the prediction of stability and support performance of face ends, as well as the design of support systems and ground control on production faces.  相似文献   

Primary cracking of kerogens. Experimenting and modelling C₁, C₂–C₅, C₆–C₁₅ and C₁₅₊ classes of hydrocarbons formed     

J. Espitali  P. Ungerer  I. Irwin  F. Marquis 《Organic Geochemistry》1988,13(4-6)

Mathematical models of hydrocarbon formation can be used to simulate the natural evolution of different types of organic matter and to make an overall calculation of the amounts of oil and/or gas produced during this evolution. However, such models do not provide any information on the composition of the hydrocarbons formed or on how they evolve during catagenesis.From the kinetic standpoint, the composition of the hydrocarbons formed can be considered to result from the effect of “primary cracking” reactions having a direct effect on kerogen during its evolution as well as from the effect of “secondary cracking” acting on the hydrocarbons formed.This report gives experimental results concerning the “primary cracking” of Types II and III kerogens and their modelling. For this, the hydrocarbons produced have been grouped into four classes (C₁, C₂–C₅, C₆–C₁₅ and C₁₅₊). Experimental data corresponding to these different classes were obtained by the pyrolysis of kerogens with temperature programming of 4°C/min with continuous analysis, during heating, of the amount of hydrocarbons corresponding to each of these classes.The kinetic parameters of the model were optimized on the basis of the results obtained. This model represents the first step in the creation of a more sophisticated mathematical model to be capable of simulating the formation of different hydrocarbon classes during the thermal history of sediments. The second step being the adjustment of the kinetic parameters of “secondary cracking”.  相似文献   

北京市北山泥石流分布规律及形成过程     

董桂芝  赵波 《城市地质》1994,(4):8-15

北京北山泥石流的分布受构造控制，呈北东方向展布。其分布在时间上和空间上均有一定的规律可寻。一条泥石流沟谷的形成从开始到结束，概括分为形成、位移和堆积。区内泥石流的形成主要有三种形式：以水力侵蚀为主，以坡面侵蚀为主和以沟源崩、滑塌形式触发沟床物质活动而形成的泥石流。  相似文献   

南水北调中线工程交叉建筑物水毁风险分析   总被引：11，自引：1，他引：11  

韩国宏  王汝慈 《水文》1995,(3):1-7

南水北调中线工程输水总干渠上需建数以百计的河渠交叉建筑物。总干渠经过地区为暴雨多发区，只要其中任一座遭遇特大洪水而失事，干渠供水将会受到影响。对这些交叉建筑物进行水毁风险分析，是此项工程规划、设计和运行管理的供输水风险评价和可靠度分析必不可少的组成部分。主要从水文风险要素的辨识入手，采用概率组合法，建立了整个总干渠洪水水毁风险计算的框架，并提出了二维复合事件的风险计算模型。所建模型巧妙地解决了各交  相似文献   

过山气流与大兴安岭焚风   总被引：1，自引：0，他引：1  

齐瑛  傅抱璞 《地理学报》1993,48(5):403-411

本文利用二维大气中尺度数值模式,模拟了冬季1月份大兴安岭东坡的焚风现象,并讨论了该焚风的成因。  相似文献