Elasto-Plastic Analysis of Tubular Joints of Offshore Platforms by Finite Element Method     

Chen Tieyun Zhu Zhenghong Professor  Dept. of Naval Architecture  Ocean Engineering  Shanghai Jiao Tong University  Shanghai Lecturer 《中国海洋工程》1991,(1)

The plastic node method is reformulated by the variational principle and is applied to elasto-plastic finite element analysis of tubular joints, eventually including the effect of internal and external gussets, stiffener rings, etc., if necessary. Four different joints are studied here in detail for the elasto-plastic behavior, the strain at the hot spot, the strain concentration factor around the intersection line, and the propagation of the plastic region with loading up to collapse in order to determine the ultimate strength, safety factor, and development of the plastic field. The present results are in good agreement with the experimental results.  相似文献   

Computation of Viscous Uniform and Shear Flow over A Circular Cylinder by A Finite Element Method     

赵明  滕斌 《中国海洋工程》2004,18(2):267-280

The incompressible viscous uniform and shear flow past a circular cylinder is studied. The two-dimensional Navier-Stokes equations are solved by a finite element method. The governing equations are discretized by a weighted residual method in space. The stable three-step scheme is applied to the momentum equations in the time integration. The numerical model is firstly applied to the computation of the lid-driven cavity flow for its validation. The computed results agree well with the measured data and other numerical results. Then, it is used to simulate the viscous uniform and shear flow over a circular cylinder for Reynolds numbers from lO0 to lO00. The transient time interval before the vortex shedding occurs is shortened considerably by introduction of artificial perturbation. The computed Strouhal number, drag and lift coefficients agree well with the experimental data. The computation shows that the finite element model can be successfully applied to the viscous flow problem.  相似文献   

桶形基础平台三维有限元稳定性分析     

钱荣  周锡礽  孙克俐  张伟 《海洋技术学报》2003,22(4):49-53

以我国第一座桶形基础采油平台工程实例为原型，采用三维有限元计算方法对桶形基础稳定性分析。平台在波浪、风等荷载作用下，其稳定性不仅与平台的整体结构有关，而且与桶形基础及其周围土体相互作用相关。在计算中，利用薄层摩擦单元模拟土与结构间的相互作用，取得了很好的效果。分析结果表明桶形基础采油平台在设计条件下运行是较为稳定的。  相似文献   

低围压水平下砂的排水行为(英文)   总被引：2，自引：1，他引：2  

杨少丽  Rolf Sandven  冯秀丽  林霖 《中国海洋大学学报(自然科学版)》2001,31(3):441-447

采用干样沉降法制备样品 ,选用静三轴仪对松砂和密砂样在 10 k Pa至 10 0 k Pa的低围压下的排水行为进行了实验研究 ,并对实验结果作了橡皮膜校正 ,在围压为 10 k Pa的密砂实验中 ,轴向应力的校正值可达到 12 %。实验研究表明低围压下松砂的剪胀性非常明显 ,且存在剪应力极值 ;围压越低 ,松砂和密砂的剪应力极值越小 ,达到最大剪应力所对应的剪应变越小。同时还表明低围压范围内相对密度不同 ,砂的应力应变特性不同 ;此外 ,低围压下砂的内摩擦角高于高围压下的值 ,从而在工程上应重视低围压水平下砂土工程参数的合理选取  相似文献   

Numerical simulation of solitary wave scattering by a circular cylinder array   总被引：1，自引：0，他引：1  

Ming Zhao  Liang Cheng  Bin Teng 《Ocean Engineering》2007,34(3-4):489-499

The interaction of a solitary wave with an array of surface-piercing vertical circular cylinders is investigated numerically. The wave motion is modeled by a set of generalized Boussinesq equations. The governing equations are discretized using a finite element method. The numerical model is validated against the experimental data of solitary wave reflection from a vertical wall and solitary wave scattering by a vertical circular cylinder respectively. The predicted wave surface elevation and the wave forces on the cylinder agree well with the experimental data. The numerical model is then employed to study solitary wave scattering by arrays of two circular cylinders and four circular cylinders respectively. The effect of wave direction on the wave forces and the wave runup on the cylinders is quantified.  相似文献   

Stress Sharing Behavior and Its Mechanism during Consolidation Process in Composite Ground Improved by Sand Compaction Piles with Low Replacement Area Ratio     

S. -K. You  K. Oda  T. -H. Kim 《Marine Georesources & Geotechnology》2006,24(4):287-304

In order to accurately design a sand compaction pile (SCP) with low replacement area ratio, it is important to understand the mechanical interaction between the sand pile and clay ground and its mechanism during consolidation process in composite ground. In this article, therefore, a series of numerical analyses on composite ground improved by SCP with low replacement area ratio were carried out. The applicability of numerical analyses, in which an elasto-viscoplastic consolidation finite element method was applied, were confirmed by comparing the results obtained from a series of laboratory model tests with the composite ground improved by SCP. Through the results of the numerical analyses, mechanical behavior of the sand pile and clay in composite ground during consolidation is elucidated, together with a stress sharing mechanism between sand pile and clay.  相似文献   

The buckling of a corrugated carbon fibre cylinder under external hydrostatic pressure     

Carl T. F. Ross  Andrew P. F. Little 《Ocean Engineering》2001,28(9)

A theoretical and an experimental investigation was carried out, where a carbon fibre corrugated circular cylinder was tested to destuction under external hydrostatic pressure. The theoretical investigation was via the finite element method, where the structure was modelled with several orthotropic axisymmetric thin-walled shell elements. The experimental observations were aided with strategically placed strain gauges. Comparison between theory and experiment showed that the experimentally observed buckling pressure was a little lower than the theoretical prediction. This may have been due to the fact that the model had slight initial geometrical imperfections in the circumferenential direction.  相似文献   

一类序同态的构造     

熊凤兰 《中国海洋大学学报(自然科学版)》1992,(3)

作者定义了从L_1~X到L_2~Y的映射σ,证明了σ是满足σ(x_λ~0)=σ(λ)∧σ(x_(I_1)~0)的保并映射的充要条件是σ(A)=∨g(λ)∧f(Aλ),其中f为X到L_1~Y的映射,g为L_1到L_2~Y的保并映射,且有f(X)≤g(I_1);最后证明了一类序同态的分解定理,它们是前人相应结果的推广与补充。  相似文献   

鲁苏榴辉岩的地球化学     

韩宗珠 《中国海洋大学学报(自然科学版)》1994,(1)

以微量元素、稀土元素、Ｓｒ和Ｎｄ同位素变异特征为依据，确定鲁苏榴辉岩为多成因、多来源和多阶段，指出主要是在印支期扬子陆块与华北陆块碰撞造山作用过程中，挤入的上地幔碎片以及不同原岩类型的壳内高压变质岩碎块。燕山晚期的区域构造热事件使得某些榴辉岩的同位素体系再平衡。  相似文献   

Second order wave diffraction forces and runup by finite—infinite element method     

B.Y. Li  S.L. Lau  C.O. Ng 《Applied Ocean Research》1991,13(6):270-286

  相似文献