Calibration of LRFD Format for Steel Jacket Offshore Platforms in China Offshore Area （ 1 ） ： Statistical Parameters of Loads and Resistances     

段忠东周道成  欧进萍 《中国海洋工程》2006,20(1):1-14

1 .IntroductionThe structural design method has evolvedfromthe workingstress method,damage stage methodtolimit state method.The more recent probabilisticlimit state design method,whichis based onreliabili-tytheory,has beengenerallyacceptedinthe designcode…  相似文献   

Discussion: A review on the behaviour of helical piles as a potential offshore foundation system     

Shah Neyamat Ullah  Yuxia Hu 《Marine Georesources & Geotechnology》2020,38(9):1121-1127

Abstract

Helical piles have emerged as an attractive foundation system for offshore applications with renewed interest from the offshore community. Significant research gap currently exists in transferring this technology offshore and this paper discusses how existing and emerging knowledge can be successfully used to bridge some of the gaps. We focus on the Coupled Eulerian Lagrangian (CEL) large deformation finite element (LDFE) modelling technique that is commercially available and can be used to model the three-dimensional installation process with consideration of strain rate and softening effects in soft offshore clays. A helical pile of L?=?7.5?m long is modelled with one or two large-diameter helices (D?=?2?m) attached to a central shaft of d?=?0.5?m in diameter.The net effect of strain rate and softening is to increase the installation torque. The measured torque is within the range of 200–400?kN.m for the offshore clay and the pile geometry studied. Additional helices increase the uplift force but to a lesser degree than that of the measured torque. Remoulding induced strength reduction is found to be within the range of 25–33% of the intact clay strength. Issues of extracting and reusing offshore helical pile foundations are discussed.  相似文献   

城市建设中的地震小区划与浅层地震探测     

薛荣俊  辛柏森  杨和乃 《中国海洋大学学报(自然科学版)》1993,(Z1)

简要阐述地震小区划在现代城市建设中的重要性以及在实施地震小区划的研究中浅层地震探测的重要作用及其方法原理,并给出应用浅层地震探测在城市地震小区划中的实例。  相似文献   

东南沿海海堤现状调研报告（福建部分）   总被引：1，自引：0，他引：1  

段祥宝  毛佩郁  毛昶熙 《海洋工程》1996,(3)

这部分是福建省正在建设中的四大海堤现状调研，包括达标设计各项指标及其加高加固的技术经验。同时调研了围海工程堵口海堤的施工过程，并对灌砂防渗措施加以评述。最后介绍了兴化湾的莆田海堤试验站和木兰陂水利工程  相似文献   

连云港近岸海域物理自净能力研究及水质预测——Ⅲ.西大堤建成后对物质输运的影响     

赵可胜  娄安刚  王学昌 《中国海洋大学学报(自然科学版)》1994,(Z1)

在连云港近岸海域计算潮流场基础上建立拉格朗日余流模型,并对连云港市两大堤建成前后的拉格朗日余流变化进行了分析,且选择有代表性的排污口进行了数值跟踪。  相似文献   

A Linear Programming Model for Seabed Oil-Gas Pipe Network     

LI Hongwei  TAN Jiahua Ph. D. Candidate  School of Naval Architecture  Ocean Engineering  Shanghai Jiaotong University 《中国海洋工程》1998,(4)

This paper analyzes the pipe network system of oil-gas collection and transportation foroffshore oilfield development.A"0-1"integer linear programming model is constructed to optimize theinvestment of seabed pipe network.The mathematical model is solved by the spanning tree method ofgraph theory and network analysis.All spanning trees of a network graph compose all the feasible solu-tions of the mathematical model.The optimal solution of the model is the spanning tree with the minimumcost among all spanning trees.This method can be used to optimize the seabed pipe network system andgive a minimum cost plan for the development of offshore marginal oilfield groups.  相似文献   

Numerical study of enhanced energy dissipation near a seamount     

Nobuyuki Iwamae  Toshiyuki Hibiya  Yoshihiro Niwa 《Journal of Oceanography》2006,62(6):851-858

Using a two-dimensional primitive equation model, we examine nonlinear responses of a semidiurnal tidal flow impinging on a seamount with a background Garrett-Munk-like (GM-like) internal wavefield. It is found that horizontally elongated pancake-like structures of high vertical wavenumber near-inertial current shear are created both in the near-field (the region over the slope of the seamount) and far-field (the region over the flat bottom of the ocean). An important distinction is that the high vertical wavenumber near-inertial current shear is amplified only at mid-latitudes in the far-field (owing to a parametric subharmonic instability (PSI)), whereas it is amplified both at mid-and high-latitudes (above the latitude where PSI can occur) in the near-field. In order to clarify the generating mechanism for the strong shear in the near-field, additional numerical experiments are carried out with the GM-like background internal waves removed. The experiments show that the strong shear is also created, indicating that it is not caused by the interaction between the background GM-like internal waves and the semidiurnal internal tides. One possible explanation is proposed for the amplification of high vertical wavenumber near-inertial current shear in the near-field where tide residual flow resulting from tide-topography interaction plays an important role in transferring energy from high-mode internal tides to near-inertial internal waves.  相似文献   

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin   总被引：1，自引：1，他引：1  

Michael Riedel 《Marine Geophysical Researches》2007,28(4):355-371

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.  相似文献   

海洋平台复杂节点阴极保护电位分布的有限元法计算   总被引：1，自引：0，他引：1  

王爱萍  杜敏  陆长山  曹圣山  王庆璋 《中国海洋大学学报(自然科学版)》2007,37(1):129-134

了解阴极保护电位分布是合理设计阴极保护工程的必要条件和评价阴极保护效果的重要依据。本文应用有限元素法(FEM)计算海洋平台复杂节点表面的阴极保护电位分布。在实验室通过边界条件试验建立数学模型,计算海水中被保护的I,Y,K型复杂节点电位分布情况。计算结果与测量结果吻合得很好,说明FEM能够应用于海洋平台复杂节点阴极保护电位分布的计算,所获得的边界条件合理。  相似文献   

Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan     

Martin Gutowski  Monika Breitzke  Volkhard Spieß 《Marine Geophysical Researches》2002,23(1):57-75

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.  相似文献