基于原位双环、试坑浸水试验和数值模拟反演的Q3黄土饱和渗透系数对比研究     

蒋小虎  黄跃廷  胡海军  陈铄  陈锐  王崇华  汪慧  康顺祥 《岩土力学》2022,43(11):2941-2951

为准确获取原状Q3黄土的竖向和水平饱和渗透系数,进行了原位、室内试验测试以及数值模拟反演,并应用大型试坑浸水试验检验了所获饱和渗透系数的可靠性。进行了不同内径尺寸的原位双环入渗试验,获取了竖向饱和渗透系数,并应用室内试验测试了竖向和水平饱和渗透系数以及持水曲线;应用COMSOL软件对双环入渗试验进行数值模拟,检验了所测饱和渗透系数的可靠性,利用正交试验获得了最优的竖向和水平饱和渗透系数取值,并利用反演结果对试坑进行数值模拟,将其水分入渗情况与实测值对比。研究结果表明：在现场进行双环入渗试验时选取较大内径的双环获得的竖向饱和渗透系数更为合理。针对双环入渗试验,数值模拟反演所得最优饱和渗透系数在竖向上接近于原位试验所得竖向饱和渗透系数、水平向上接近室内所测水平向饱和渗透系数,竖向饱和渗透系数比水平向饱和渗透系数更加显著地影响水分入渗过程。通过对大型试坑水分入渗情况的验证,检验了反演所得最优饱和渗透系数的可靠性。  相似文献   

太行山东麓北拒马河冲积扇结构探测及地震砂土液化判别     

刘莎莎  丰成君  谭成轩  邓亚虹  戚帮申  孟静  张鹏  宋焱勋  慕焕东  周永恒 《地球学报》2022,43(1):82-92

北拒马河冲积扇及邻近地区位于太行山东麓,地表覆盖全新世(Qh)松散砂土与粉土,该区域地下水埋深较浅,潜在地震最大震级达6.5级,在地震作用下存在发生砂土液化危险性.通过野外地质调查、工程地质钻探和高密度电阻率法勘探揭示北拒马河冲积扇地层结构特征.在此基础上,采用原位标准贯入试验和室内动三轴试验评价北拒马河冲积扇饱和砂土...  相似文献   

饱和土地下源u-P形式解答动力响应计算     

丁伯阳  宋宥整 《岩土力学》2019,40(2):474-480

一直以来,由Biot孔隙弹性动力方程得到的饱和土地下源Green函数都是u-w形式（u为固相介质位移,w为流相相对于固相的平均位移）。应用两相介质纵波解耦理论,得到了饱和土半空间地下点源荷载的u-P形式（P为孔压）Green函数频域解答;克服了u-w形式Green函数在边界元（BEM）积分时的增根影响。再由Hankel反演,结合Somigliana表象积分,完成BEM计算。并以计算结果分析了地下集中力作用时,饱和土位移、孔压、排水量等动力特性,这对地铁等交通工程、地震工程、土-结构动力相互作用（SSI）的响应计算都具有较重要应用价值。  相似文献   

空隙特征对砂岩水致劣化规律的影响     

许宝田  张莉萍  燕晓莹  邱德俊 《岩土力学》2019,40(2):561-569

针对南京秦淮东河开挖后的稳定性问题,选取黄马青组（T2h）砂岩为研究对象,对砂岩在吸水-干燥循环条件下的单轴抗压、抗拉特性进行试验研究。考虑到未来边坡运营过程中水的影响,试验时分别考虑自然吸水和饱和吸水两种情况。根据试验结果对所研究砂岩的空隙特征、水致劣化特征和劣化机制进行了详细分析。随着吸水-干燥循环次数增加,岩石的抗压、抗拉强度和凝聚力均呈劣化趋势,说明循环次数的增加对岩石的损伤有累积作用。岩石自然吸水条件下（小开空隙未进水时）强度和弹性模量下降速度较慢,而饱和吸水条件下（开空隙被水充满时）强度和弹性模量下降速度较快,表明岩石中小开空隙对岩石的劣化效果显著。微观结构分析结果表明,随着吸水-干燥循环次数增加,岩石中空隙率增大。结合抗剪强度特征分析认为,干-湿循环导致岩石的黏结强度不断下降,而摩擦强度变化较小,表明黏结强度劣化是岩石水致劣化的主要原因,干-湿循环导致水-岩反应,岩石颗粒胶结物发生松散,边缘发生开裂,宏观上表现为岩石劣化。该研究成果对于新开挖河道边坡稳定性分析具有较大的参考价值,为河岸边坡的长期稳定性分析提供了依据。  相似文献   

群桩基础引发饱和地基振动的近似解析解     

史吏  王慧萍  孙宏磊  潘晓东 《岩土力学》2019,40(5):1750-1760

建立了饱和半空间-群桩基础耦合动力近似解析模型,其中基桩考虑为欧拉梁,饱和地基采用Biot两相介质动力控制方程,二者在频率-波数域中利用桩-土相互作用点处的饱和地基柔度矩阵进行耦合,并采用快速傅里叶逆变换获得频域解答。分析了饱和地基中群桩基础的动力阻抗及刚性承台上施加简谐振动荷载时群桩基础引起的饱和地基振动响应。研究结果表明,荷载类型、激振频率以及地基渗透系数对饱和地基位移和孔压响应有明显影响。特别的,群桩基础动力阻抗峰值频率会随着地基渗透系数的增加而增大。  相似文献   

饱和软土大应变自重固结非线性分析     

龚文惠  赵旭东  邱金伟  李逸  杨晗 《岩土力学》2019,40(6):2099-2107

饱和软土的自重固结涉及许多复杂的非线性问题,而现有分析方法一般基于线性假设,将固结控制方程简化,在沉降变形较大的情况下并不合理。基于Gibson大变形固结方程,推导在单面排水和双面排水条件下的边界条件,综合考虑饱和软土的自重特性与非线性压缩、渗透关系,采用稳定性较好的Crank-Nicolson型差分格式离散并求解非线性控制方程,并从孔隙比、沉降、孔隙水流速3个方面将数值解与CS2固结数值模型进行对比验证。结合工程实例,研究土层不同初始厚度和初始孔隙比对自重固结的影响。结果表明：初始厚度与初始孔隙比较大土层最终沉降也较大。与传统方法相比,该方法所得出的数值解精度较高,实现了高度非线性固结方程的快速求解,其成果更能广泛运用于实际工程的分析之中。  相似文献   

Clogging of saturated porous media by silt‐sized suspended solids under varying physical conditions during managed aquifer recharge          下载免费PDF全文

Xinqiang Du  Xueyan Ye  Xiaowan Zhang 《水文研究》2018,32(14):2254-2262

Managed aquifer recharge is an effective method for utilizing excess flood flows, but clogging of porous media is a limiting factor in the implementation of this water storage technique. In recent years, much research on the physical clogging of porous media during artificial recharge has been conducted. However, the understanding of clogging due to silt‐sized suspended solids (SS) is still inadequate, especially under varying physical conditions. Here, we subjected sand columns to controlled rates of flow and SS suspensions to investigate the influence of media size, SS size, SS concentration, and flow velocity on the clogging of porous media by silt‐sized SS. The results show that the diameter ratio of SS particles to sand grains is the dominant factor influencing the position of physical clogging. As pore velocity increased, the mobility of silt‐sized SS was enhanced and retention in the porous media decreased noticeably. The spatial retention profiles in the porous media were found to vary greatly at different flow velocities. The SS concentration of the infiltrating suspension also dramatically influenced the mobility and deposition of silt‐sized SS particles, such that high concentrations accelerated the clogging process. As the different physical factors changed, the breakthrough curves and retention profiles of silt‐sized SS particles changed obviously and the mechanisms of retention differed. On the whole, clogging position is mainly determined by particle size ratio, but clogging rate is dominated by a variety of factors including particle size ratio, SS concentration, and flow velocity.  相似文献   

Crack nucleation in saturated porous media     

Luc Dormieux  Eric Lemarchand  Thomas Carlioz  Laurent Jeannin 《国际地质力学数值与分析法杂志》2020,44(5):553-574

Crack nucleation has been the subject of important contributions in the last two last decades. However, it seems that few attention has been granted to the case of saturated porous media. This is the question addressed in the present paper which is devoted to nucleation in traction mode. From a physical point of view, nucleation is a sudden phenomenon, so that the material response is both adiabatic and undrained. In the spirit of the variational approach, the nucleated crack is viewed as the final state of a region of space in which the material undergoes a full damage process. In traction mode, the opening of a saturated crack in undrained condition induces a drop of fluid pressure. In case of low fluid compressibility, the presence of the fluid delays the brittle failure usually associated with nucleation, as long as the fluid pressure remains above the saturation vapor pressure. Nucleation is therefore possible only if a partial vaporization of the fluid takes place.  相似文献   

上海地区饱和粉土层中土钉墙支护的工程实践     

汪幼江  王兆玺 《上海国土资源》1999,(3):54-57

通过虹祺花苑复合式土钉墙工程实例,阐述饱和粉土层中的土钉墙支护计算原理及现场施工要点,并总结了技术要点及注意事项以资推广。  相似文献   

非混溶饱和两相渗流与孔隙介质耦合作用的理论研究——数学模型   总被引：1，自引：0，他引：1       下载免费PDF全文

薛世峰  宋惠珍 《地震地质》1999,21(3):243

基于连续介质力学的一般理论,在黑油多相渗流理论模型的基础上,推导了非混溶饱和两相渗流与变形孔隙介质耦合作用的数学模型方程,并对流固耦合效应进行了初步的讨论  相似文献