An eddy covariance (EC) station was deployed at Solfatara crater, Italy, June 8–25, 2001 to assess if EC could reliably monitor CO2 fluxes continuously at this site. Deployment at six different locations within the crater allowed areas of focused gas venting to be variably included in the measured flux. Turbulent (EC) fluxes calculated in 30-min averages varied between 950 and 4460 g CO2 m−2 d−1; the highest measurements were made downwind of degassing pools. Comparing turbulent fluxes with chamber measurements of surface fluxes using footprint models in diffuse degassing regions yielded an average difference of 0% (±4%), indicating that EC measurements are representative of surface fluxes at this volcanic site. Similar comparisons made downwind of degassing pools yielded emission rates from 12 to 27 t CO2 d−1 for these features. Reliable EC measurements (i.e. measurements with sufficient and stationary turbulence) were obtained primarily during daytime hours (08:00 and 20:00 local time) when the wind speed exceeded 2 m s−1. Daily average EC fluxes varied by ±50% and variations were likely correlated to changes in atmospheric pressure. Variations in CO2 emissions due to volcanic processes at depth would have to be on the same order of magnitude as the measured diurnal variability in order to be useful in predicting volcanic hazard. First-order models of magma emplacement suggest that emissions could exceed this rate for reasonable assumptions of magma movement. EC therefore provides a useful method of monitoring volcanic hazard at Solfatara. Further, EC can monitor significantly larger areas than can be monitored by previous methods. 相似文献
‘No portion of the American continent is perhaps so rich in wonders as the Yellow Stone’ (F.V. Hayden, September 2, 1874)Discoveries from multi-beam sonar mapping and seismic reflection surveys of the northern, central, and West Thumb basins of Yellowstone Lake provide new insight into the extent of post-collapse volcanism and active hydrothermal processes occurring in a large lake environment above a large magma chamber. Yellowstone Lake has an irregular bottom covered with dozens of features directly related to hydrothermal, tectonic, volcanic, and sedimentary processes. Detailed bathymetric, seismic reflection, and magnetic evidence reveals that rhyolitic lava flows underlie much of Yellowstone Lake and exert fundamental control on lake bathymetry and localization of hydrothermal activity. Many previously unknown features have been identified and include over 250 hydrothermal vents, several very large (>500 m diameter) hydrothermal explosion craters, many small hydrothermal vent craters (1–200 m diameter), domed lacustrine sediments related to hydrothermal activity, elongate fissures cutting post-glacial sediments, siliceous hydrothermal spire structures, sublacustrine landslide deposits, submerged former shorelines, and a recently active graben. Sampling and observations with a submersible remotely operated vehicle confirm and extend our understanding of the identified features. Faults, fissures, hydrothermally inflated domal structures, hydrothermal explosion craters, and sublacustrine landslides constitute potentially significant geologic hazards. Toxic elements derived from hydrothermal processes also may significantly affect the Yellowstone ecosystem. 相似文献
Among the Sinian to Triassic strata in South China, the stratiform, quasi-stratiform and lenticular metallic deposits in association with hydrothermal sedimentation mainly occur in the four periods: (1) the Sinian Datangpo interglacial period, (2) the early period of Early Cambrian, (3) the late period of Middle Devonian to early period of Late Devonian,and (4) the late period of Early Permian. The four mineralization periods all happened around the maximum flooding period in the third-order seal-level cycle during the ascending stage in the first-order sea-level cycle. The deep seawater layer, starved and non-compensatory basin, low sedimentary rate, and low energy and anoxic environment during the maximum flooding period are very suitable for the formation and preservation of large to superlarge hydrothermal sedimentary deposits. The maximum flooding period also coincided with the intensified regional tectonism, extensive deep magmatism and hydrothermal sedimentation, which provide, for the formation of large to superlarge hydrothermal sedimentary deposits through the rapid accumulation of hydrothermal sediments, the needed dynamics, ore-forming materials and favorable passway for hydrothermal fluids to enter the basin. 相似文献
The peak metamorphic conditions of subducted continental crust in the Dora-Maira massif (Western Alps) have been revised by combining experimental results in the KCMASH system with petrologic information from whiteschists. Textural observations in whiteschists suggest that the peak metamorphic assemblage garnet+phengite+kyanite+coesite±talc originates from the reaction kyanite+talc↔garnet+coesite+liquid. In the experimentally determined petrogenetic grid, this reaction occurs above 45 kbar at 730 °C. At lower pressures, talc reacts either to orthopyroxene and coesite or, together with phengite, to biotite, coesite and kyanite. The liberated liquid contains probably similar amounts of H2O and dissolved granitic components. The composition of the liquid in the whiteschists at peak metamorphic conditions, a major unknown in earlier studies, was probably very similar to the liquid composition produced in the experiments. Therefore, the experimentally determined petrogenetic grid represents a good model for the estimation of the peak metamorphic conditions in whiteschists. Experimentally determined Si-isopleths for phengite further constrain peak pressures to 43 kbar for the measured Si=3.60 of phengite in the natural whiteschists. All these data provide evidence that the whiteschists reached diamond-facies conditions.
The fluid-absent equilibrium 4 kyanite+3 CELADONITE=4 coesite+3 muscovite+pyrope has been calibrated on the basis of garnet and phengite compositions in the experiments and serves as a geothermobarometer for ultra-high-pressure (UHP) metapelites. For graphite-bearing metapelites and kyanite–phengite eclogites, forming the country rocks of the whiteschists, peak metamorphic pressures of about 44±3 kbar were calculated from this barometer for temperatures of 750 °C estimated from garnet–phengite thermometry. Therefore, the whole ultra-high-pressure unit of the Dora-Maira massif most likely experienced peak metamorphic conditions in the diamond stability field. While graphite is common in the metapelites, diamond has not been found so far. The absence of metamorphic microdiamonds might be explained by the low temperature of metamorphism, the absence of a free fluid phase in the metapelites and a short residence time in diamond-facies conditions resulting in kinetic problems in the conversion of graphite to diamond. 相似文献
The influx of a H2O–CO2‐dominated fluid into actinolite‐bearing metabasic rocks during greenschist facies metamorphism in the Kalgoorlie area of Western Australia resulted in a zoned alteration halo around inferred fluid conduits that contain gold mineralisation. The alteration halo is divided into two outer zones, the chlorite zone and the carbonate zone, and an inner pyrite zone adjacent to the inferred fluid conduits. Reaction between the fluid and the protolith resulted in the breakdown of actinolite and the development of chlorite, dolomite, calcite and siderite. In addition, rocks in the pyrite zone developed muscovite‐bearing assemblages as a consequence of the introduction of potassium by the fluid. Mineral equilibria calculations undertaken using the computer software thermocalc in the model system Na2O–CaO–K2O–FeO–MgO–Al2O3–SiO2–H2O–CO2 show that mineral assemblages in the outer zones of the alteration halo are consistent with equilibrium of the protoliths with a fluid of composition XCO2 = CO2/(CO2 + H2O) = 0.1–0.25 for temperatures of 315–320 °C. The inner zone of the alteration halo reflect equilibrium with a fluid of composition XCO2≈ 0.25. Fluid‐rock buffering calculations show that the alteration halo is consistent with interaction with a single fluid composition and that the zoned structure of the halo reflects the volume of this fluid with which the rocks reacted. This fluid is likely to have also been the one responsible for the gold mineralisation at Kalgoorlie. 相似文献
Abstract. Magnetotelluric (MT) surveys were carried out around the Muine volcano, Hokkaido, Japan, where it is expected that the heat and metal source forming the polymetallic Ag-Pb-Zn-Cu-In Toyoha deposit is present at depth. Measurements were performed at 20 sites, 18 of which were located along a WSW-ENE profile traversing the north ridge of Mt. Muine. A resistivity model obtained from 2D inversion of the MT data shows subsurface specific conductive and resistive features. Conductive layers are present at the surface of Mt. Muine. The low resistivity is probably due to the clay-rich rocks associated with the hydrothermal alteration. A high resistivity layer, which corresponds to the pre-Tertiary Usubetsu Formation, crops out east of Mt. Muine and dips westward. At the west foot of Mt. Muine, relatively high resistive layers are widely exposed. The resistivity increases with depth and exceeds 1000 ohm-m. This fact indicates that this region is not influenced by the recent hydrothermal activity. An extremely conductive zone about 3–6 km wide and 6–9 km thick exists at a depth of 2 km below Mt. Muine. This zone mostly corresponds to an elastic wave attenuation zone detected by a seismic survey. It is interpreted as a large hydrothermal reservoir or melted magma, which is a heat source of the hydrothermal system in this area. 相似文献
Abstract. The petrography, chemical, fluid inclusion and isotope analyses (O, Rb-Sr) were conducted for the shale samples of the Mount McRae Shale collected from the Tom Price, Newman, and Paraburdoo mines in the Hamersley Basin, Western Australia. The Mount McRae Shale at these mines occurs as a footwall unit of the secondary, hematite-rich iron ores derived from the Brockman Iron Formation, one of the largest banded iron formations (BIFs) in the world. Unusually low contents of Na, Ca, and Sr in the shales suggest that these elements were leached away from the shale after deposition. The δ18O (SMOW) values fall in the range of + 15.0 to +17.9 per mil and show the positive correlation with calculated quartz/sericite ratios of the shale samples. This suggests that the oxygen isotopic compositions of shale samples were homogenized and equilibrated by postdepositional event. The pyrite nodules hosted by shales are often rimmed by thin layers of silica of varying crystallinity. Fluid inclusions in quartz crystals rimming a pyrite nodule show homogenization temperatures ranging from 100 to 240C for 47 inclusions and salinities ranging from 0.4 to 12.3 wt% NaCl equivalent for 18 inclusions. These fluid inclusion data give direct evidence for the hydrothermal activity and are comparable to those of the vein quartz collected from the BIF-derived secondary iron ores (Taylor et al, 2001). The Rb-Sr age for the Mount McRae Shale is 1,952 ± 289 Ma and at least 200 million years younger than the depositional age of the Brockman Iron Formation of ∼ 2.5 Ga in age. All the data obtained in this study are consistent with the suggestion that high temperature hydrothermal fluids were responsible for both the secondary iron ore formation and the alteration of the Mount McRae Shale. 相似文献
The Okinawa Trough is a heavily sedimented, rifted back-arc basin formed in an intracontinental rift zone. Submarine hydrothermal activity is located within the six back-arc rifts located in the middle and southern Okinawa Trough and its distribution is controlled principally by tectonic factors. Subduction of the Daito and Gagua Ridges beneath the Ryukyu Arc has resulted in fracturing of the brittle lithosphere beneath the Okinawa Trough. Hydrothermal activity is strongest in the volcanic arc-rift migration phenomenon (VAMP) area plus the JADE site and Southernmost Part of the Okinawa Trough (SPOT) area which form the prolongation of these two ridges. These areas are characterized by extremely high heat flow locally. Submarine hydrothermal fluids from the Okinawa Trough tend to be strongly influenced by interaction of the hydrothermal fluids with organic matter in the sediment resulting in high alkalinity and NH4+ concentrations of the fluids. The fluids also contain high concentrations of CO2 of magmatic origin. Submarine hydrothermal mineralization in the trough is diverse. The CLAM site consists principally of carbonate chimneys. Interaction of the hydrothermal fluid with organic matter in the sediment is particularly strong at this site. This is most probably a sediment-hosted deposit in which sulphide minerals have deposited within the sediment column leaving ‘spent ore-fluids’ to emerge at the seafloor. The JADE site consists of active and inactive sulphide–sulphate chimneys and mounds. The Zn–Pb-rich sulphides at this site contain the highest concentrations of Pb, Ag and Au so far recorded in submarine hydrothermal sulphide deposits. At Minami-Ensei Knoll and Hatoma Knoll, active and inactive chimneys consist principally of anhydrite and barite as a result of phase separation of the hydrothermal fluids beneath the seafloor. An intense black smoker has recently been discovered at Yonaguni Knoll in the SPOT area. If it is confirmed that sulphide mineralization is dominant at this site, this could be a highly prospective area. The most prospective areas for economic-grade minerals in the Okinawa Trough appear to be the JADE site and the SPOT area. 相似文献