中国环境化学研究进展     

高国伟  陈锦凤 《云南地理环境研究》2005,17(5):92-96

通过对近年来中国环境化学学科中的环境分析化学、土壤环境化学、水环境化学、大气环境化学和污染生态化学5个大方面研究现状的详细介绍和评述,分析了中国环境化学基础性研究的进展,归纳总结了中国环境化学中已取得的成果及相关的应用,同时通过对目前一些国际上较热门研究内容及研究方向的讨论,指出了中国环境化学学科发展中存在的问题和不足,并对部分相关前沿领域的研究提出了建议。  相似文献   

松花江上游地区汞污染的化学生态效应   总被引：5，自引：0，他引：5  

王宁  朱颜明  朴明玉  孟丹 《地理科学》2005,25(6):737-741

采样分析了吉林省东部松花江上游金矿开采区及其附近水、土壤、动植物及河流沉积物样品中汞的含量，发现河流沉积物中汞的污染相当严重；受其影响当地的植物和两栖类动物——中国林蛙体内总汞和甲基汞含量也明显高于对照组。实验表明，林蛙内脏对汞的富集能力大于肌肉；秋季对汞的富集大于春季；河流沉积物中甲基汞的含量与林蛙体内甲基汞的含量有较好的正相关。汞污染的来源与区域内个体金矿的滥采滥排有直接关系，表明人类活动所产生的有毒重金属在地表过程中出现了化学生态效应。  相似文献   

Development of a soil moisture‐based distributed hydrologic model for determining hydrologically based critical source areas          下载免费PDF全文

Sisi Li  Margaret Gitau  David Bosch  Bernard A. Engel  Liang Zhang  Yun Du 《水文研究》2017,31(20):3543-3557

A simple grid cell‐based distributed hydrologic model was developed to provide spatial information on hydrologic components for determining hydrologically based critical source areas. The model represents the critical process (soil moisture variation) to run‐off generation accounting for both local and global water balance. In this way, it simulates both infiltration excess run‐off and saturation excess run‐off. The model was tested by multisite and multivariable evaluation on the 50‐km² Little River Experimental Watershed I in Georgia, U.S. and 2 smaller nested subwatersheds. Water balance, hydrograph, and soil moisture were simulated and compared to observed data. For streamflow calibration, the daily Nash‐Sutcliffe coefficient was 0.78 at the watershed outlet and 0.56 and 0.75 at the 2 nested subwatersheds. For the validation period, the Nash‐Sutcliffe coefficients were 0.79 at the watershed outlet and 0.85 and 0.83 at the 2 subwatersheds. The per cent bias was less than 15% for all sites. For soil moisture, the model also predicted the rising and declining trends at 4 of the 5 measurement sites. The spatial distribution of surface run‐off simulated by the model was mainly controlled by local characteristics (precipitation, soil properties, and land cover) on dry days and by global watershed characteristics (relative position within the watershed and hydrologic connectivity) on wet days when saturation excess run‐off was simulated. The spatial details of run‐off generation and travel time along flow paths provided by the model are helpful for watershed managers to further identify critical source areas of non‐point source pollution and develop best management practices.  相似文献   

Material selection for the gas containment system of a compressed natural gas carrier fleet     

《Applied Ocean Research》2016

In this work, the possible exploitation of fiber-reinforced composites in the context of maritime transportation of compressed natural gas (CNG) is investigated. In addition to a more conventional steel configuration, two different fiber materials, carbon and glass, are considered as construction materials for pressure vessels (PVs) to be stored on board ships, with thickness optimized by FEM analysis.The considered scenario is represented by the transportation of CNG from an offshore well to a terminal on shore. Fleets of ships carrying CNG in pressure vessels manufactured with the investigated materials are generated by means of a ship synthesis model (SSM) software and compared on the basis of technical and economical indicators.The choice of the construction material influences considerably the weight of the PVs, which represent a major item of total ship weight and reflects directly on the general transport performances in terms of resistance, seakeeping and reliability in the service. On the other hand, capital as well as operating expenditures are considerably affected by the choice. When exploring the design space, the ship synthesis model is able, at a preliminary stage of the design, to account for the various technical and economical aspects, their implications and relationships. Results are presented of computations carried out in a specific case, identified by the annual gas production and other characteristics of the well terminal and a cruising route for the ships. The comparison is carried out on the basis of the cost per transported unit of gas and of the percentage of success in the transportation process. The computations show that the choice of the PV material has a key influence on the results in terms of optimal number, dimensions and speed of the ships.  相似文献   

Limitations of suction‐controlled triaxial tests in the characterization of unsaturated soils          下载免费PDF全文

X. Zhang 《国际地质力学数值与分析法杂志》2016,40(2):269-296

Behavior of unsaturated soils is influenced by many factors, and the influences of these factors are usually coupled together. Suction‐controlled triaxial (SCTX) tests are considered to allow researchers to investigate influences of individual variables on unsaturated soils under specified stress path with controls of stresses, pore water, and air pressures. In the past 50 years, SCTX testing method has been established as a standard approach to characterize constitutive behavior of unsaturated soils. Most important concepts for modern unsaturated soil mechanics were developed upon results from the SCTX tests. Among these, one of the most important contributions in the constitutive modeling of elasto‐plastic behavior for unsaturated soils is the Barcelona basic model (BBM) proposed by Alonso et al. in 1990. The BBM successfully explained many features of unsaturated soils and received extensive acceptance. However, the SCTX tests are designed based upon the divide‐and‐conquer approach in which an implicit assumption is used: soil behavior is stress‐path independent. However, it is well‐established that unsaturated soil behavior is elasto‐plastic and stress‐path dependent. It is found that the SCTX tests in fact cannot control the stress path of an unsaturated soil during loading. This incapability, in combination with complicated loading/collapse behavior of unsaturated soils, makes the SCTX tests for characterizing unsaturated soil questionable. This paper discusses the limitations of the SCTX tests in the characterization of unsaturated soils. A possible solution to the problem was proposed based on a newly developed modified state surface approach. The discussions are limited for isotropic conditions. Copyright © 2015 John Wiley & Sons, Ltd.  相似文献   

Three‐dimensional shakedown solutions for anisotropic cohesive‐frictional materials under moving surface loads     

Juan Wang  Hai‐Sui Yu 《国际地质力学数值与分析法杂志》2014,38(4):331-348

Previous work on three‐dimensional shakedown analysis of cohesive‐frictional materials under moving surface loads has been entirely for isotropic materials. As a result, the effects of anisotropy, both elastic and plastic, of soil and pavement materials are ignored. This paper will, for the first time, develop three‐dimensional shakedown solutions to allow for the variation of elastic and plastic material properties with direction. Melan's lower‐bound shakedown theorem is used to derive shakedown solutions. In particular, a generalised, anisotropic Mohr–Coulomb yield criterion and cross‐anisotropic elastic stress fields are utilised to develop anisotropic shakedown solutions. It is found that shakedown solutions for anisotropic materials are dominated by Young's modulus ratio for the cases of subsurface failure and by shear modulus ratio for the cases of surface failure. Plastic anisotropy is mainly controlled by material cohesion ratio, the rise of which increases the shakedown limit until a maximum value is reached. The anisotropic shakedown limit varies with frictional coefficient, and the peak value may not occur for the case of normal loading only. Copyright © 2013 John Wiley & Sons, Ltd.  相似文献   

The Fluxes and Behaviour of Plumes Inferred from Measurements of Coherent Structures within Images of the Bulk Flow     

H.C. Burridge  J.L. Partridge  P.F. Linden 《大气与海洋》2016,54(4):403-417

This paper describes how measurements of the movement of identifiable features at the edge of a turbulent plume can be interpreted to determine the properties of the mean flow and consequently, using plume theory, can be used to make estimates of the fluxes of volume (mass), momentum, and buoyancy in a plume. This means that video recordings of smoke rising from a chimney or buoyant material from a source on the sea bed can be used to make accurate estimates of the source conditions for the plume. At best we can estimate the volume flux and buoyancy flux to within about 5% and 15% of the actual values, respectively. Although this is restricted to the case of a plume rising in a stationary and unstratified environment, we show that the results may be of practical use in other more complex situations. In addition, we demonstrate that large-scale (turbulent) coherent structures at the plume edge form on a scale approximately 40% of the local (mean) plume half-width and travel at almost 60% of the average local (mean) velocity in the plume.  相似文献   

固体聚合膜电解浓集法测量天然水中低含量氚的化学淬灭效应研究     

蓝高勇  王华  俞建国  应启和  唐伟  杨会 《岩矿测试》2016,35(4):415-419

固体聚合膜电解浓集法是浓缩氚含量较低(1 Bq/m~3)的天然水样的常用方法,但因水样自身含有杂质离子或电解装置聚合膜带入杂质进入浓集液,使浓集液偏酸性,在测量过程中易产生化学淬灭效应,导致氚的测量值偏低。本文研究了水样自身存在的杂质离子和聚合膜上残留的杂质离子、样品溶液的pH值及其电导率所产生的化学淬灭效应的影响,实验表明,为减少化学淬灭效应,提高测量低含量氚的准确性,需保证水样溶液呈中性,电导率≤1μS/cm,同时避免杂质沉积在聚合膜上。如果水样溶液的pH值偏酸性、电导率大于1μS/cm,可采用酸碱混合型离子交换树脂去除水样中自身的杂质;对于聚合膜引入的杂质,可在电解后的水样中加入微量氨水将其pH值调节至中性。  相似文献   

我国尾矿综合利用研究现状及建议   总被引：2，自引：0，他引：2  

刘志强  郝梓国  刘恋  费红彩  黄敏 《地质论评》2016,62(5):62051277-62051282

尾矿资源综合利用问题已受到世界各国的重视,其对策已由消极的废物处理转向物质再回收,尾矿资源化的发展趋势越来越清晰。但是,我国尾矿综合利用率和发达国家相比还存在较大的差距。大量的尾矿积存,对矿山周边地区环境、土地利用造成了严重的影响。开展典型尾矿资源综合利用技术研究和推广尾矿资源产业化利用技术研究与推广,不但可使原来资源枯竭或资源不足的矿山焕发青春,而且还能够重新成为新的资源基地,以开辟新的材料科技领域,推动科技进步,同时也可以解决环境污染、改善生态环境和整治国土,具有巨大社会、经济和环境效益。因此尾矿的综合利用要做到国家重視、立法保障、评价先行、技术支撑、全部利用,才能真正解决尾矿污染等问题。  相似文献   

A microscale model for air pollutant dispersion simulation in urban areas: Presentation of the model and performance over a single building   总被引：1，自引：0，他引：1  

Ning Zhang  Yunsong Du  Shiguang Miao 《大气科学进展》2016,33(2):184-192

A microscale air pollutant dispersion model system is developed for emergency response purposes. The model includes a diagnostic wind field model to simulate the wind field and a random-walk air pollutant dispersion model to simulate the pollutant concentration through consideration of the influence of urban buildings. Numerical experiments are designed to evaluate the model's performance, using CEDVAL(Compilation of Experimental Data for Validation of Microscale Dispersion Models) wind tunnel experiment data, including wind fields and air pollutant dispersion around a single building. The results show that the wind model can reproduce the vortexes triggered by urban buildings and the dispersion model simulates the pollutant concentration around buildings well. Typically, the simulation errors come from the determination of the key zones around a building or building cluster. This model has the potential for multiple applications; for example, the prediction of air pollutant dispersion and the evaluation of environmental impacts in emergency situations; urban planning scenarios;and the assessment of microscale air quality in urban areas.  相似文献