桩承载力时效对桩土相互作用及沉降的影响分析   总被引：2，自引：2，他引：2  

郑刚  任彦华 《岩土力学》2003,24(1):65-69

对软土中两根47 m长灌注桩分别在成桩28 d和1 750 d后进行了承载力试验，其极限承载力提高幅度达到30％左右。分析了单桩承载力随时间提高(称为时效)的机理，提出了单桩承载力时效对桩筏基础桩土相互作用影响的分析方法，并结合工程实例进行了分析。  相似文献   

武汉长江底钻孔同位素单井法地下水流速、流向测试   总被引：4，自引：1，他引：4  

韩庆之  陈辉  万凯军  万讯平 《水文地质工程地质》2003,30(2):74-76,82

本文论述了在武汉市长江底部第四纪孔隙含水层中用单井稀释法测定地下水流速、流向实验的过程和结果。并对在这种试验条件下所得的测定结果进行分析讨论,得出了相应的结论。测试结果表明:武汉长江底部JC II 6号钻孔处地下水流向从上到下都受到地表长江水流的影响。上部受到影响大,而深部较弱,地下水流向从上到下逐渐向东偏转35°左右。上部中细砂层中的地下水流速,大于下部粗中砂层中地下水流速。本次测试由于测定点靠近江心地下水排泄带,其地下水和地表水的水头差0 5m左右,试验虽然采取了特殊的施工工艺,也还可能受到垂向流的微小影响,使测试结果中的水流速度比实际地下水水流速度可能要稍偏大些。但因本点水文地质条件决定了三段之间或地下水流和江水之间无明显的水头差,所以引起的误差不大,可以忽略不计。  相似文献   

PowerBuilder 8.0中C/S模式应用过渡到B/S模式应用的实现技术   总被引：1，自引：0，他引：1  

李军  罗省贤 《物探化探计算技术》2003,25(2):188-192

简要分析了PowerBuilder 8．0中各种B/S解决方案的优劣，探讨了适用于已有C／S模式应用过渡到B／S模式应用的实现方法，以及利用ASP技术实现对不同类型的客户测览器隐藏底层实现方法的技术，并给出了C／S模式应用过渡到B／S模式应用的一个实例。  相似文献   

浅水方程数值计算方法的研究   总被引：1，自引：5，他引：1       下载免费PDF全文

张修忠  王光谦  金生 《水科学进展》2003,14(4):417-423

求解以水位为变量的连续方程,并根据Navier-Stokes方程压力修正算法的基本思想,建立了浅水方程的水位修正算法,放宽了对离散时间步长的限制.通过对离散方程系数矩阵的重新构造,建立了高分辨率有限元格式,该格式既具有较高的离散精度又避免了数值解的伪振荡.对动量方程的阻力项做负坡线性化处理,提高了露滩计算的稳定性.数值模拟结果与解析解吻合良好,表明所建立的数值计算方法是正确的和可靠的.  相似文献   

Inelastic displacement ratios for evaluation of existing structures     

Jorge Ruiz‐García  Eduardo Miranda 《地震工程与结构动力学》2003,32(8):1237-1258

Results of a detailed statistical study of constant relative strength inelastic displacement ratios to estimate maximum lateral inelastic displacement demands on existing structures from maximum lateral elastic displacement demands are presented. These ratios were computed for single‐degree‐of‐freedom systems with different levels of lateral strength normalized to the strength required to remain elastic when subjected to a relatively large ensemble of recorded earthquake ground motions. Three groups of soil conditions with shear wave velocities higher than 180m/s are considered. The influence of period of vibration, level of lateral yielding strength, site conditions, earthquake magnitude, distance to the source, and strain‐hardening ratio are evaluated and discussed. Mean inelastic displacement ratios and those associated with various percentiles are presented. A special emphasis is given to the dispersion of these ratios. It is concluded that distance to the source has a negligible influence on constant relative strength inelastic displacement ratios. However, for periods smaller than 1s earthquake magnitude and soil conditions have a moderate influence on these ratios. Strain hardening decreases maximum inelastic displacement at a fairly constant rate depending on the level of relative strength for periods of vibration longer than about 1.0s while it decreases maximum inelastic displacement non‐linearly as the period of vibration shortens and as the relative‐strength ratio increases for periods of vibration shorter than 1.0s. Finally, results from non‐linear regression analyses are presented that provide a simplified expression to be used to approximate mean inelastic displacement ratios during the evaluation of existing structures built on firm sites. Copyright © 2003 John Wiley & Sons, Ltd.  相似文献   

The inversion of anelastic coefficient,source parameters and site respond using genetic algorithm     

刘杰  郑斯华  黄玉龙 《地震学报(英文版)》2003,16(2):226-232

It gradually becomes a common work using large seismic wave data to obtain source parameters, such as seismic moment, break radius, stress drop, with completingof digital seismic network in China (Hough, et al, 1999; Bindi, et al, 2001). These parameters are useful on earthquake prediction and seismic hazard analysis.Although the computation methods of source parameters are simple in principle and the many research works have been done, it is not easy to obtain the parameters accurately. There are two factors affecting the stability of computation results. The first one is the effect of spread path and site respond on signal. According to the research results, there are different geometrical spreading coefficients on different epicenter distance. The better method is to introduce trilinear geometrical spreading model (Atkinson, Mereu, 1992; Atkinson, Boore, 1995; WONG, et al, 2002). In addition, traditional site respond is estimated by comparing with rock station, such as linear inversion method (Andrews, 1982), but the comparative estimation will introduce some errors when selecting different stations. Some recent research results show that site respond is not flat for rock station (Moya, et al, 2000; ZHANG,. et al, 2001; JIN, et al, 2000; Dutta, et al, 2001). The second factor is to obtain low-frequency level and corner frequency fromdisplacement spectrum. Because the source spectrum model is nonlinear function,these values are obtained by eye. The subjectivity is strong. The small change of corner frequency will affect significantly the result of stress drop.  相似文献   

Coupled inverse modelling of groundwater flow and mass transport and the worth of concentration data   总被引：1，自引：0，他引：1  

Harrie-Jan Hendricks Franssen  Jaime Gómez-Hernández  Andrés Sahuquillo 《Journal of Hydrology》2003,281(4):281-295

This paper presents the extension of the self-calibrating method to the coupled inverse modelling of groundwater flow and mass transport. The method generates equally likely solutions to the inverse problem that display the variability as observed in the field and are not affected by a linearisation of the state equations. Conditioning to the state variables is measured by an objective function including, among others, the mismatch between the simulated and measured concentrations. Conditioning is achieved by minimising the objective function by gradient-based methods. The gradient contains the partial derivatives of the objective function with respect to: log conductivities, log storativities, prescribed heads at boundaries, retardation coefficients and mass sources. The derivatives of the objective function with respect to log conductivity are the most cumbersome and need the most CPU-time to be evaluated. For this reason, to compute this derivative only advective transport is considered. The gradient is calculated by the adjoint-state method. The method is demonstrated in a controlled, synthetic study, in which the worth of concentration data is analysed. It is shown that concentration data are essential to improve transport predictions and also help to improve aquifer characterisation and flow predictions, especially in the upstream part of the aquifer, even in the case that a considerable amount of other experimental data like conductivities and heads are available. Besides, conditioning to concentration data reduces the ensemble variances of estimated transmissivity, hydraulic head and concentration.  相似文献   

A procedure for evaluating seismic energy demand of framed structures     

Chung‐Che Chou  Chia‐Ming Uang 《地震工程与结构动力学》2003,32(2):229-244

Energy serves as an alternative index to response quantities like force or displacement to include the duration‐related seismic damage effect. A procedure to evaluate the absorbed energy in a multistorey frame from energy spectra was developed. For low‐ to medium‐rise frames, it required a static pushover analysis of the structure to determine the modal yield force and ductility factor of an equivalent single‐degree‐of‐freedom system for the first two modes. The energy spectra were then used to determine the energy contribution of each mode. A procedure was also developed to distribute the energy along the frame height based on energy shapes. This study showed that the second‐mode response in some cases needs to be considered to reflect the energy (or damage) concentration in the upper floors. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

遗传算法与单纯形法组合的影像纹理分类方法   总被引：7，自引：3，他引：7  

郑肇葆 《测绘学报》2003,32(4):325-329

提出遗传算法(简称GA)与单纯形法组合的影像纹理分类方法(简称GASPX)。单纯形法是一种局部搜索方法，它通过反射，扩张，收缩操作，求得新的单纯形点，组成新单纯形，新单纯形比前一个单纯形更接近局部最优解。这种寻优方法收敛速度快，它与GA组合起来可以改善单独使用GA收敛速度慢的缺陷。由于在组合算法中是多个单纯形的局部区域的并行搜索，避免GA优化过程中过早收敛于局部最优解的现象出现。通过5种不同类别航空影像纹理识别的试验，并与GA的结果作对比，结果表明GASPX法优于GA法。  相似文献   

影像匹配中几种相似性测度的分析   总被引：8，自引：3，他引：8  

山海涛  郭建星  耿则勋 《测绘信息与工程》2003,28(4):11-13

对基于灰度影像匹配中的几种相似性测度进行了研究，分析了每种测度的直观意义、限制条件以及改进措施，最后通过实验结果验证了上述结论。  相似文献