新疆和田地区耕地面源污染生态风险评价          下载免费PDF全文

田丰收  刘新平  原伟鹏 《干旱区地理》2019,42(2):295-304

随着化肥、农膜等在农业生产中的过量投入，耕地面源污染的程度随之加重。文章选取塔里木河流域上游和田地区为研究区域，依据P-S-R框架理论，构建和田地区耕地面源污染生态风险评价指标体系，加入土壤理化数据，使用生态风险评价模型对和田地区1980 年及2016 年耕地面源污染状况进行生态风险评价，运用耕地生态风险模型、生态风险转移矩阵、Arcgis分析和田地区耕地面源污染时空分异状况。研究结论如下：和田地区1980 年耕地生态风险等级均为II级或III级，呈“中间高，两侧低”分布；2016 年耕地生态风险等级上升至IV级或V级，呈“倒W型”分布，各县耕地面源污染程度较1980 年均有较大幅度的上升，其中墨玉县和于田县在2016 年耕地生态风险等级达到最高的V级，而民丰县因自身生态环境的强脆弱性，同样需要提高关注。根据面源污染“从源头治理”的原则，应切实推进和田地区耕地生态环境保护与治理，提高政府重视程度，增强技术指导，开展试点工作，改善和田地区耕地面源污染现状。  相似文献   

张掖盆地地下水硝酸盐污染与人体健康风险评价     

盛丹睿  温小虎  冯起  武君  司建华  吴敏 《中国沙漠》2019,39(5):37-44

地下水是张掖盆地的重要水资源，其硝酸盐污染尚未得到足够重视。对张掖盆地2004、2015年地下水硝酸盐浓度进行了系统分析，并采用美国环境保护署（USEPA）推荐的健康风险评价模型评估了地下水硝酸盐的健康风险。结果表明：自2004年以来张掖盆地地下水硝酸盐污染日趋严重。2015年硝酸盐浓度最高已达到283.32 mg·L^-1，17.61%的采样点硝酸盐氮浓度超过GB5749-2006《生活饮用水卫生标准》中饮用地下水限量值（20 mg·L^-1）。研究区人群经皮肤接触途径摄入硝酸盐的健康风险在可接受水平，而饮水摄入硝酸盐的健康风险较高，总风险中饮水途径引起健康风险的贡献率占99.40%，远大于皮肤接触途径。儿童经饮水摄入和皮肤接触两种途径的健康风险均显著高于成人，分别为成人的1.544倍和1.039倍。32.39%的采样点地下水硝酸盐对儿童的健康风险超出了可接受水平，14.79%的采样点地下水硝酸盐对成人的健康风险不可接受。甘州区城区、临泽县北部边缘及高台县城区周围硝酸盐浓度最高，这些区域内所有人群都面临硝酸盐引发的高健康风险，其余区域硝酸盐引发的健康风险相对较低。  相似文献   

Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis     

Ramin Pakzad  Shanyong Wang  Scott W. Sloan 《国际地质力学数值与分析法杂志》2020,44(10):1472-1494

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.  相似文献   

基于VSD模型的铁山港湾红树林生态系统脆弱性初步评价   总被引：2，自引：0，他引：2  

李小维  黄子眉  陈剑锋  王欣  韦江玲 《热带海洋学报》2018,37(2):47-54

基于脆弱性域图 (vulnerability scoping diagram, VSD)评价模型, 从暴露程度、敏感性、适应能力3个方面构建了红树林生态系统脆弱性评价指标体系。采用改进的综合指数法和模糊综合评价法, 重新定义脆弱性分级标准, 定量评价了铁山港湾红树林生态系统在1989年、2003年和2014年3个年份的脆弱性水平。结果显示, 铁山港湾红树林生态系统在3个年份的脆弱性水平值分别为0.145、0.255、0.334, 呈现增加趋势。首先, 铁山港湾红树林生态系统面临的暴露程度不断增大, 主要胁迫因子为滩涂围垦面积、废水排放量; 其次, 生态系统的敏感性增强, 主要敏感因子是海洋生物质量综合指数、底栖生物和潮间带生物多样性指数; 第三, 生态系统的适应能力略有增加, 总体上较弱。  相似文献   

Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials          下载免费PDF全文

Chao Jiang  Gao‐Feng Zhao 《国际地质力学数值与分析法杂志》2018,42(4):674-693

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.  相似文献   

深水铺管船托管架疲劳分析及动态监测点选取研究     

闫宏生  王哲  王晓波  陈永訢  孟祥伟 《海洋工程》2018,36(1):107-113

作为S型铺管作业的关键性装备,托管架长期承受着交变载荷的作用,随着海洋开发向超深水发展,结构疲劳破坏问题不容忽视。采用疲劳谱分析的方法并结合线性累积损伤理论,对托管架结构频域下的变形进行了分析,计算了正常海况下和极端海况下托管架疲劳损伤度并对疲劳寿命进行了评估。研究发现托管架在正常海况下作业符合安全要求,在极端海况下局部结构会受到破坏。并从托管架结构安全监测角度,筛选了结构疲劳分析关键点位,为监测点位的选取提供了依据。  相似文献   

Damage assessment for submarine photoelectric composite cable under anchor impact     

《Applied Ocean Research》2018

The impact of dropped anchor on submarine photoelectric composite cables may possibly cause electrical faults, i.e. electricity and optical signal transmission failure. In order to study the impact capacity and structural impact failure mechanism, a test setup is designed originally to examine the structural and functional integrity. A detailed finite element model (FEM) is created, considering material nonlinearity and component interaction. A parametric analysis has been performed to predict the deformation of components and impact forces, under different impact velocities and collision directions. Relationships between the armor layer indentation rate and that of internal power and optical units are achieved. The impact deformation of internal entities can be evaluated intuitively by armor layer indentation. The proposed experimental and numerical methods are well correlated, suitable to assess the impact capacity of subsea power cables and assist the protection design of subsea power cables in engineering.  相似文献   

Micromechanical approach to effective viscoelastic properties of micro‐fractured geomaterials          下载免费PDF全文

Cássio B. Aguiar  Samir Maghous 《国际地质力学数值与分析法杂志》2018,42(16):2018-2046

The aim of this paper is to formulate a micromechanics‐based approach to non‐aging viscoelastic behavior of materials with randomly distributed micro‐fractures. Unlike cracks, fractures are discontinuities that are able to transfer stresses and can therefore be regarded from a mechanical viewpoint as interfaces endowed with a specific behavior under normal and shear loading. Making use of the elastic‐viscoelastic correspondence principle together with a Mori‐Tanka homogenization scheme, the effective viscoelastic behavior is assessed from properties of the material constituents and damage parameters related to density and size of fractures. It is notably shown that the homogenized behavior thus formulated can be described in most cases by means of a generalized Maxwell rheological model. For practical implementation in structural analyses, an approximate model for the isotropic homogenized fractured medium is formulated within the class of Burger models. Although the approximation is basically developed for short‐term and long‐term behaviors, numerical applications indicate that the approximate Burger model accurately reproduce the homogenized viscoelastic behavior also in the transient conditions.  相似文献   

Smeared crack approach: back to the original track     

M. Cervera  M. Chiumenti 《国际地质力学数值与分析法杂志》2006,30(12):1173-1199

This paper briefly reviews the formulations used over the last 40 years for the solution of problems involving tensile cracking, with both the discrete and the smeared crack approaches. The paper focuses on the smeared approach, identifying as its main drawbacks the observed mesh‐size and mesh‐bias spurious dependence when the method is applied ‘straightly’. A simple isotropic local damage constitutive model is considered, and the (exponential) softening modulus is regularized according to the material fracture energy and the element size. The continuum and discrete mechanical problems corresponding to both the weak discontinuity (smeared cracks) and the strong discontinuity (discrete cracks) approaches are analysed and the question of propagation of the strain localization band (crack) is identified as the main difficulty to be overcome in the numerical procedure. A tracking technique is used to ensure stability of the solution, attaining the necessary convergence properties of the corresponding discrete finite element formulation. Numerical examples show that the formulation derived is stable and remarkably robust. As a consequence, the results obtained do not suffer from spurious mesh‐size or mesh‐bias dependence, comparing very favourably with those obtained with other fracture and continuum mechanics approaches. Copyright © 2006 John Wiley & Sons, Ltd.  相似文献   

GRADATION AND ASSESSMENT OF DAMAGE DEGREE OF NATURAL LANDSCAPE IN XING, AN COUNTY, GUANGXI     

李家永  李昌华 《中国地理科学(英文版)》1992,(4)

A new technique designed to help quantify the degree of damage to the landscape from one area to another shows a close relationship between population density and the degree of landscape damage. The technique establishes a scale of damage from 0 to 5 (zero = no damage; 5 = severe damage) using data from aerial photographs, land-use maps, and field data. The related formula allows one to compare the relative degree of damage across regions using a combination of an absolute index, a theoretical index, a relative index, and population density. Xing'an County is used to demonstrate the technique.  相似文献