Over the last few years, the impacts of wildlife on agriculture have constantly been growing, in particular in areas close to woodland and in hunting ban zones (“refuge effect”). Public administrations have difficulty in meeting the growing requests for crop damage compensation. The development of appropriate measures to control this trend—starting from the understanding of the dynamics concerned—is crucial. The aim of this study was, therefore, to analyze damage at regional scale and define common local actions. In particular, the study involved different steps that define a spatial-based classification of risk levels, integrating statistical methods (principal component analysis and receiver operating characteristic) with multi-criteria evaluation (MCE) in a geographic information system (GIS). It turns out that, in the study area, the very high-risk zones affect 8.83% of used agricultural areas; about 97% of them concentrated in the first 400 m from the most suitable habitats. A selected cluster of 11 test areas within these zones allowed us to assess the cost-effectiveness of integrated prevention and control actions (IPCA) with respect to the compensation of the damage. The analysis shows cost of IPCA to be nearly twice the actual cost incurred by the public administration to compensate partially the damage. The comparison with the estimated damage shows the overall economic convenience of the proposed investment with significant differences depending on the areas. Thus, we suggest reaching an “agro-ecological” balance starting from actions on specific areas; if they produce the desired effects, they could be progressively extended to other areas with gradual investments (adaptive management).
Two sets of cooling experiments were run at atmospheric conditions for two anhydrous starting latitic and trachytic melts: 1) five cooling rates (25, 12.5, 3, 0.5, and 0.125 °C/min) between 1300° and 800 °C, and 2) a 0.5 °C/min cooling rate from 1300 °C with quench temperatures at 1200°, 1100°, 1000° and 900 °C. Trachytic run-products are invariably glassy. Nucleation is also suppressed in the latitic run-products at the three highest cooling rates. Conversely, in the 0.5 and 0.125 °C/min runs, latites have a crystal content of 90 vol.%. The phases are: plagioclase, clinopyroxene, glass and iron-bearing oxide (in order of abundance). The variable quench temperatures, investigated by coupling experiments with Pt wire and Pt capsule sample containers in set 2, again did not produce crystallization of trachyte, whereas latitic samples are characterized by 10 vol.% of oxides, pyroxenes and plagioclase (in order of appearance), at temperature < 1000 °C. Effects of (preferential) heterogeneous nucleation on sample holders, of superheating degree, and chemical species loss during cooling are absent for both melt compositions. The difference of solidification paths between these two silicate melts can be ascribed only to their small chemical differences. In comparison with calculated equilibrium conditions all the experimental latitic and trachytic run-products revealed strong kinetic effects, interpretable in the light of the nucleation theory. The glass-forming ability (GFA) of trachyte is higher, whereas their critical cooling rate (Rc) is lower (< 0.125 °C/min), in comparison to latitic melts (Rc > 0.5 °C/min). The experimental results carried out in this study can be applied to lava flows and domes; trachytic lavas are able to flow for longer period with respect to latitic ones in a metastable condition. Glass-rich terrestrial lavas, i.e. obsidians, can be the result of sluggish nucleation kinetics due to the relative high polymerisation of evolved silicate melts. 相似文献
A newly developed, multistage quick-look methodology allows for the efficient screening of an unmanageably large number of
reservoirs to generate a workable set of sites that closely match the requirements for optimal CO2 enhanced oil recovery (EOR) storage. The objective of the study is to quickly identify miscible CO2 EOR candidates in areas that contain thousands of reservoirs and to estimate additional oil recovery and sequestration capacities
of selected top options through dimensionless modeling and reservoir characterization. Quick-look assessments indicate that
the CO2 EOR resource potential along the US Gulf Coast is 4.7 billion barrels, and CO2 sequestration capacity is 2.6 billion metric tons. In the first stage, oil reservoirs are screened and ranked in terms of
technical and practical feasibility for miscible CO2 EOR. The second stage provides quick estimates of CO2 EOR potential and sequestration capacities. In the third stage, a dimensionless group model is applied to a selected set
of sites to improve the estimates of oil recovery and storage potential using appropriate inputs for rock and fluid properties,
disregarding reservoir architecture and sweep design. The fourth stage validates and refines the results by simulating flow
in a model that describes the internal architecture and fluid distribution in the reservoir. The stated approach both saves
time and allows more resources to be applied to the best candidate sites. 相似文献
Abstract. The secondary production of Spisula subtruncata (somatic production) is calculated in the framework of a benthic monitoring study in a coastal area. The temporal trends of density, biomass and growth increments are examined in the three year-classes present. These are compared to certain physical and chemical parameters. 相似文献
Natural Resources Research - A reliable and realistic subsurface resource spatial modeling is a common and critical task for geosciences projects (mining, petroleum and environmental) because the... 相似文献
With the ability of multibeam echo sounders (MBES) to measure backscatter strength (BS) as a function of true angle of insonification across the seafloor, came a new recognition of the potential of backscatter measurements to remotely characterize the properties of the seafloor. Advances in transducer design, digital electronics, signal processing capabilities, navigation, and graphic display devices, have improved the resolution and particularly the dynamic range available to sonar and processing software manufacturers. Alongside these improvements the expectations of what the data can deliver has also grown. In this paper, we identify these user-expectations and explore how MBES backscatter is utilized by different communities involved in marine seabed research at present, and the aspirations that these communities have for the data in the future. The results presented here are based on a user survey conducted by the GeoHab (Marine Geological and Biological Habitat Mapping) association. This paper summarises the different processing procedures employed to extract useful information from MBES backscatter data and the various intentions for which the user community collect the data. We show how a range of backscatter output products are generated from the different processing procedures, and how these results are taken up by different scientific disciplines, and also identify common constraints in handling MBES BS data. Finally, we outline our expectations for the future of this unique and important data source for seafloor mapping and characterisation. 相似文献