The H. J. Andrews Experimental Forest (HJA) encompasses the 6400 ha Lookout Creek watershed in western Oregon, USA. Hydrologic, chemistry and precipitation data have been collected, curated, and archived for up to 70 years. The HJA was established in 1948 to study the effects of harvest of old-growth conifer forest and logging-road construction on water quality, quantity and vegetation succession. Over time, research questions have expanded to include terrestrial and aquatic species, communities and ecosystem dynamics. There are nine small experimental watersheds and 10 gaging stations in the HJA, including both reference and experimentally treated watersheds. Gaged watershed areas range from 8.5 to 6242 ha. All gaging stations record stage height, water conductivity, water temperature and above-stream air temperature. At nine of the gage sites, flow-proportional water samples are collected and composited over 3-week intervals for chemical analysis. Analysis of stream and precipitation chemistry began in 1968. Analytes include dissolved and particulate species of nitrogen and phosphorus, dissolved organic carbon, pH, specific conductance, suspended sediment, alkalinity, and major cations and anions. Supporting climate measurements began in the 1950s in association with the first small watershed experiments. Over time, and following the initiation of the Long Term Ecological Research (LTER) grant in 1980, infrastructure expanded to include a set of benchmark and secondary meteorological stations located in clearings spanning the elevation range within the Lookout Creek watershed, as well as a large number of forest understory temperature stations. Extensive metadata on sensor configurations, changes in methods over time, sensor accuracy and precision, and data quality control flags are associated with the HJA data. 相似文献
At a service station closed in 1993, groundwater contained benzene that persisted above the cleanup goal of 1 mg/L in zones depleted of background sulfate. The benzene and other petroleum hydrocarbons (PHCs) were present as much as 36 feet (11 m) below the water table and therefore remediation of a thick saturated zone interval was required. Microcosms using site sediments demonstrated that anaerobic benzene biodegradation occurred only if sulfate was added, suggesting sulfate addition as a remediation approach. Twenty-four boreholes (9.1″ diameter and 56′ deep) were drilled around four monitoring wells, in which benzene concentrations exceeded 1 mg/L. The boreholes were backfilled with a mixture of gravel and 15,000 pounds of gypsum (which releases sulfate as it dissolves) to create “Permeable Filled Borings” (PFBs). Concurrently, nine high pressure injections (HPIs) of gypsum slurry were conducted in other site locations (312 pounds of gypsum total). PFBs were expected to release sulfate for up to 20 years, whereas HPIs were expected to produce a short-lived plume of sulfate. Concentrations of benzene and sulfate in groundwater were monitored over a 3-year period in six monitoring wells. In two wells near PFBs, benzene concentrations dropped below the cleanup goal by two to three orders of magnitude; in one well, sulfate concentrations exceeded 500 mg/L for the most recent 18 months. Benzene concentrations in two other PFB monitoring wells declined by a factor of 2 to 4, but remained above 1 mg/L, presumably due to high-dissolved PHC concentrations and possibly greater residual PHC mass in adjacent sediments, and therefore greater sulfate demand. However, hydrogen and sulfur isotopic enrichment in benzene and sulfate, respectively, confirmed biodegradation of benzene and stimulation of sulfate-reducing conditions. Thus, it is hypothesized that the PHC mass in adjacent sediments will decline over time, as will dissolved PHC concentrations, and eventually benzene concentrations will decrease below the cleanup goal. Benzene in two HPI monitoring wells was below the cleanup goal for all but one sampling event before HPIs were conducted and remained below the cleanup goal after HPIs; there was no stimulation of sulfate-reducing conditions. It is concluded that sulfate released from PFBs contributed to declining benzene concentrations. 相似文献
For many researchers, government agencies, and emergency responders, access to the geospatial data of US electric power infrastructure is invaluable for analysis, planning, and disaster recovery. Historically, however, access to high quality geospatial energy data has been limited to few agencies because of commercial licenses restrictions, and those resources which are widely accessible have been of poor quality, particularly with respect to reliability. Recent efforts to develop a highly reliable and publicly accessible alternative to the existing datasets were met with numerous challenges – not the least of which was filling the gaps in power transmission line voltage ratings. To address the line voltage rating problem, we developed and tested a basic methodology that fuses knowledge and techniques from power systems, geography, and machine learning domains. Specifically, we identified predictors of nominal voltage that could be extracted from aerial imagery and developed a tree-based classifier to classify nominal line voltage ratings. Overall, we found that line support height, support span, and conductor spacing are the best predictors of voltage ratings, and that the classifier built with these predictors had a reliable predictive accuracy (that is, within one voltage class for four out of the five classes sampled). We applied our approach to a study area in Minnesota. 相似文献
A functional model for a bundle block adjustment in the inertial reference frame was developed, implemented and tested. This approach enables the determination of rotation parameters of planetary bodies on the basis of photogrammetric observations. Tests with a self-consistent synthetic data set showed that the implementation converges reliably toward the expected values of the introduced unknown parameters of the adjustment, e.g., spin pole orientation, and that it can cope with typical observational errors in the data. We applied the model to a data set of Phobos using images from the Mars Express and the Viking mission. With Phobos being in a locked rotation, we computed a forced libration amplitude of \(1.14^\circ \pm 0.03^\circ \) together with a control point network of 685 points. 相似文献
On 22 March 2014, a massive, catastrophic landslide occurred near Oso, Washington, USA, sweeping more than 1 km across the adjacent valley flats and killing 43 people. For the following 5 weeks, hundreds of workers engaged in an exhaustive search, rescue, and recovery effort directly in the landslide runout path. These workers could not avoid the risks posed by additional large-scale slope collapses. In an effort to ensure worker safety, multiple agencies cooperated to swiftly deploy a monitoring and alerting system consisting of sensors, automated data processing and web-based display, along with defined communication protocols and clear calls to action for emergency management and search personnel. Guided by the principle that an accelerating landslide poses a greater threat than a steadily moving or stationary mass, the system was designed to detect ground motion and vibration using complementary monitoring techniques. Near real-time information was provided by continuous GPS, seismometers/geophones, and extensometers. This information was augmented by repeat-assessment techniques such as terrestrial and aerial laser scanning and time-lapse photography. Fortunately, no major additional landsliding occurred. However, we did detect small headscarp failures as well as slow movement of the remaining landslide mass with the monitoring system. This was an exceptional response situation and the lessons learned are applicable to other landslide disaster crises. They underscore the need for cogent landslide expertise and ready-to-deploy monitoring equipment, the value of using redundant monitoring techniques with distinct goals, the benefit of clearly defined communication protocols, and the importance of continued research into forecasting landslide behavior to allow timely warning.
In a previous paper (Chassefière et al. 2013 ), we have shown that most volcanic sulfur released to the early Mars atmosphere could have been trapped in the upper cryosphere under the form of CO2‐SO2 clathrates. Huge amounts of sulfur, up to the equivalent of an ~1 bar atmosphere of SO2, would have been stored in the Noachian upper cryosphere, then massively released to the atmosphere during the Hesperian due to rapidly decreasing CO2 pressure. It could have resulted in the formation of the large sulfate deposits observed mainly in Hesperian terrains, whereas no or little sulfates are found at the Noachian. In the present paper, we first clarify some aspects of our previous work. We discuss the possibility of a smaller cooling effect of sulfur particles, or even of a net warming effect. We point out the fact that CO2‐SO2 clathrates formed through a progressive enrichment of a pre‐existing reservoir of CO2 clathrates and discuss processes potentially involved in the slow formation of a SO2‐rich upper cryosphere. We show that episodes of sudden destabilization at the Hesperian may generate 1000 ppmv of SO2 in the atmosphere and contribute to maintaining the surface temperature above the water freezing point. 相似文献
Within the Ararat Valley (Armenia), a continuously growing water demand (for irrigation and fish farming) and a simultaneous decline in groundwater recharge (due to climate change) result in increasing stress on the local groundwater resources. This detrimental development is reflected by groundwater-level drops and an associated reduction of the area with artesian conditions in the valley centre. This situation calls for increasing efforts aimed at more sustainable water resources management. The aim of this baseline study was the collection of data that allows for study on the origin and age distribution of the Ararat Valley groundwater based on environmental tracers, namely stable (δ2H, δ18O) and radioactive (35S, 3H) isotopes, as well as physical-chemical indicators. The results show that the Ararat Valley receives modern recharge, despite its (semi-)arid climate. While subannual groundwater residence times could be disproved (35S), the detected 3H pattern suggests groundwater ages of several decades, with the oldest waters being recharged around 60 years ago. The differing groundwater ages are reflected by varying scatter of stable isotope and hydrochemical signatures. The presence of young groundwater (i.e., younger that the 1970s), some containing nitrate, indicates groundwater vulnerability and underscores the importance of increased efforts to achieve sustainable management of this natural resource. Since stable isotope signatures indicate the recharge areas to be located in the mountains surrounding the valley, these efforts must not be limited to the central part of the valley where most of the abstraction wells are located.
Climatic Change - This study examines the climatic drivers of ice-off dates for lakes and rivers across the Northern Hemisphere. Most lakes and rivers have trended toward earlier ice-off dates over... 相似文献
Between the years 2008 and 2013, approximately 67 kilotons of CO2 have been injected at the Ketzin site, Germany. As part of the geophysical monitoring programme, time‐lapse electrical resistivity tomography has been applied using crosshole and surface‐downhole measurements of electrical resistivity tomography. The data collection of electrical resistivity tomography is partly based on electrodes that are permanently installed in three wells at the site (one injection well and two observation wells). Both types of ERT measurements consistently show the build‐up of a CO2‐related resistivity signature near the injection point. Based on the imaged resistivity changes and a petrophysical model, CO2 saturation levels are estimated. These CO2 saturations are interpreted in conjunction with CO2 saturations inferred from neutron‐gamma loggings. Apart from the CO2–brine substitution response in the observed resistivity changes, significant imprints from the dynamic behaviour of the CO2 in the reservoir are observed. 相似文献
Existing methods for black carbon (BC) quantification measure different parts of the BC continuum, which complicates the calculation of a global BC budget. Benzenepolycarboxylic acids (BPCA) are used as molecular markers to quantify and characterize BC in soils and sediments using gas chromatography for BPCA separation (GC-BPCA). Recently, this method was refined for BC analysis in seawater using high performance liquid chromatography (LC-BPCA), which omits the cleaning steps and derivatization necessary in GC analysis. As yet it is not clear whether the two analytical methods yield similar results. Here we apply both methods to a suite of laboratory produced charcoals derived from wood and grass. We found systematically lower total BPCA-C contents and larger analytical variability for all tested charcoals when using GC-BPCA compared to LC-BPCA, the latter giving 1.5 ± 0.3 times higher yields for the charcoal samples formed at 275-700 °C. At lower and higher pyrolysis temperatures the differences between the two analytical methods were larger. The main reason for the differences between the two methods is the loss of BPCA during sample preparation for GC analysis. We propose a correction factor of 1.5 to account for at least part of these losses. No qualitative biases, i.e. towards more or less functionalized BPCAs, were observed between the two methods. The relative contribution of mellitic acid C to total BPCA-C, a measure for the degree of condensation of BC, was the same in the two analytical techniques. Qualitative differences between wood and grass charcoals as detected by both methods were small. 相似文献
下载免费PDF全文