排序方式： 共有8条查询结果，搜索用时 15 毫秒
1
1.
2.
A multi-layer deposited ice film was prepared through water vapor deposition on a Ni plate in a vacuum chamber at 90 K, and was used as it was or after annealing at 140 K. NO2 was adsorbed as N2O4 approximately 90 K on the ice film prepared as above, and irradiated by 193 nm excimer laser light. The time-of-flight (TOF) spectra of the desorbed species, i.e., NO2, NO, O2 and O, were measured by a quadrupole mass spectrometer. The photochemical process obeyed an one-photon process. The relative yields of the products and their TOF spectra were dependent on the preparation condition of the ice film and also varied with the continuation of the laser irradiation. From the ice film annealed at 140 K, NO2, NO and O2 were desorbed with an approximate ratio of 1:1:0.01. From the non-annealed film, the relative yield of NO2 was much smaller than that of NO. The TOF spectrum of NO from the non-annealed ice film consisted of distinctly different two components corresponding to the 1700 and 100 K translational temperature, respectively. The fast component was lost when additional ice was deposited on the adsorbed N2O4. NO was supposed to be a predissociation product from the electronically excited NO2 prepared through the photodissociation of N2O4. 相似文献
3.
Takeshi Tsuji Yasuyuki Nakamura Hidekazu Tokuyama Millard F. Coffin Keita Koda 《Island Arc》2007,16(3):361-373
Abstract To show the structure of oceanic crust and Moho around the eastern Ogasawara Plateau, we have analyzed industry-standard two-dimensional multichannel seismic reflection data. To obtain improved velocity models, phase information of seismic signals was used for velocity analysis and velocity models for oceanic crust above Moho were determined. We apply this velocity analysis technique to seismic reflection data around the eastern Ogasawara Plateau, with the result of clear images of structures within oceanic crust and Moho. South of the Ogasawara Plateau, Moho deepens proximal to the Plateau. Moho distal to the Plateau is ca 7 km below sea floor (bsf), whereas it is ca 10 km bsf near the Plateau. The characters of oceanic crust and Moho differ significantly north and south of the Plateau. To the north, the structure of oceanic crust is ambiguous, the sea floor is shallower and less smooth, and Moho is discontinuous. To the south, structures within oceanic crust and Moho are imaged clearly, and the sea floor is deeper. A strong Moho reflection south of the Plateau might represent a sharp boundary between layered gabbro and peridotite. However, discontinuous Moho reflections north of the Plateau might represent rough topography because of intensive magmatism or a gradual downward increase in velocity within a thick Moho transition zone. A fracture zone north of the Plateau also appears to separate oceanic crust and Moho of different characters, suggesting vigorous magmatism between the Plateau and the fracture zone, and that the Ogasawara Plateau and the fracture zone influenced the genesis of oceanic crust and upper mantle. Differences in acoustic characteristics to the north and south of the Plateau are apparent in profiles illuminated by seismic attributes. 相似文献
4.
Variation of crustal thickness in the Philippine Sea deduced from three-dimensional gravity modeling
Abstract Crustal thickness of the northern to central Philippine Sea was gravimetrically determined on the simple assumption of four layers: seawater, sediments, crust and lithospheric mantle, with densities of 1030, 2300, 2800 and 3300 kg/m3 , respectively. As for the correction of the regional gravity variation, a 15 km difference of the lithospheric thickness with a density difference of 50 kg/m3 against the asthenosphere below between both sides of the Kyushu-Palau Ridge was taken into consideration. Mantle Bouguer anomalies were calculated on the assumption of constant crustal thickness of 6 km, and then the crustal thickness was obtained by three-dimensional gravity inversion method. The results show occurrence of thin crust areas with a thickness of approximately 5 km in the southern part and at the western margin of the Shikoku Basin and also of thick crust areas in the northwestern and northeastern parts of the Parece Vela Basin. We suggest that these are because of the variation of magma supply at the time of sea floor spreading in the Shikoku and Parece Vela Basins, which is possibly related to the variation of spreading rate and enhanced magmatism near the past arc volcanic fronts. The results further show the occurrence of crust thinner than 5 km in the northeastern part of the West Philippine Basin, of crust thicker than 15 km in the Amami Plateau, the Daito and Oki-Daito Ridges, and also in the northern part of Kyushu-Palau Ridge, whereas the southern part of the Kyushu-Palau Ridge the crust is thicker than 10 km. It was also inferred that small basins in the Daito Ridge province have the thinnest oceanic crust of less than 5 km in the Kita-Daito Basin. 相似文献
5.
Fault configuration produced by initial arc rifting in the Parece Vela Basin as deduced from seismic reflection data 总被引：1，自引：0，他引：1
Mikiya Yamashita Tetsuro Tsuru Narumi Takahashi Kaoru Takizawa Yoshiyuki Kaneda Kantaro Fujioka Keita Koda 《Island Arc》2007,16(3):338-347
Abstract The Parece Vela Basin (PVB), which is a currently inactive back-arc basin of the Philippine Sea Plate, was formed by separation between the Izu-Ogasawara Arc (IOA) and the Kyushu-Palau Ridge (KPR). Elucidating the marks of the past back-arc opening and rifting is important for investigation of its crustal structure. To image its fault configurations and crustal deformation, pre-stack depth migration to multichannel seismic reflection was applied and data obtained by the Japan Agency for Marine-Earth Science and Technology and Metal Mining Agency of Japan and Japan National Oil Corporation (Japan Oil, Gas and Metals National Corporation). Salient results for the pre-stack depth-migrated sections are: (i) deep reflectors exist around the eastern margin of KPR and at the western margin of IOA down to 8 km depth; and (ii) normal fault zones distributed at the eastern margin of the KPR (Fault zone A) and the western margin of the IOA (Fault zone B) have a total displacement of greater than 500 m associated with synrift sediments. Additional normal faults (Fault zone C) exist 20 km east of the Fault zone B. They are covered with sediment, which indicates deposition of recent volcanic products in the IOA. According to those results: (i) the fault displacement of more than 500 m with respect to initial rifting was approximately asymmetric at 25 Ma based on PSDM profiles; and (ii) the faults had reactivated after 23 Ma, based on the age of deformed sediments obtained from past ocean drillings. The age of the base sediments corresponds to those of spreading and rotation after rifting in the PVB. Fault zone C is covered with thick and not deformed volcanogenic sediments from the IOA, which suggests that the fault is inactive. 相似文献
6.
Akinori Takami Teruo Kondo Azumi Kado Seiichiro Koda 《Journal of Atmospheric Chemistry》2001,39(2):139-153
Uptake coefficient of I2 on aqueous surfaces was measured by using an impinging flow method. Dependence of the uptake coefficient on the gas-liquid contact time and pH was investigated. The uptake coefficient was (3.7± 2.0)×10–4 at 120 ms, 293 K and pH = 5.6. In the alkaline region, the uptake coefficient was larger by one order of magnitude than that in the neutral and acidic region. The I2 uptake on KI solutions and synthetic sea water solutions was also measured. According to the analysis by the reactive uptake model, the uptake of I2 was shown to be mainly determined by liquid phase reactions and the accommodation coefficient of I2 on aqueous surfaces was estimated to be 0.01. 相似文献
7.
An acoustic positioning system using a continuous frequency-modulated (FM) ultrasonic wave transmitted from a sound source source located on the sea bottom is described in this paper. This system consists of a direction detecting system and a distance-change detecting system. The accuracy of the direction detection of the tested system was2deg and the accuracy of the distance-change detection was within 0.10 m for a displacement of 50 m. Combining these two systems, it is possible to detect the change of position of the vessel sensitively. Since information from the phases of demodulated signals of the received FM ultrasonic wave is used exclusively, this system is excellent in signal-to-noise ratio (S/N) in spite of the simplicity of the electronic circuit. It was confirmed in experiments in the sea that both the direction detecting system and the distance-change detecting system worked well simultaneously, and that the combined systems would be suitable as an acoustic positioning system. 相似文献
8.
Yu Higuchi Yutaka Yanagimoto Kazuyoshi Hoshi Sadao Unou Fumio Akiba Kunishige Tonoike Keita Koda 《Island Arc》2007,16(3):374-393
Abstract To clarify the regional distribution and characteristics of the sedimentary deposits in the northern part of the Philippine Sea, multichannel seismic reflection surveys of 26 864 km in total length were performed. The seismic reflection data were interpreted and correlated with available Deep Sea Drilling Project/Ocean Drilling Program (DSDP/ODP) data and a general stratigraphic framework of the area was established. The sedimentary deposits in this area were divided into five layers; Units I, II, III, IV and V in ascending order. Their approximate geological ages are the Early Eocene, Middle to Late Eocene, Oligocene, Miocene and Pliocene‐Pleistocene, respectively. Seismic records were classified into three seismic facies, Facies A, B and C, on the basis of their characteristics. They were judged to represent pelagic and hemipelagic sediments of non‐volcanic origin, fine pyroclastic sediments and coarse pyroclastic or volcanic sediments, respectively, by comparing them with lithological data in the DSDP/ODP holes. From the thickness and facies distributions of these sediments, a sedimentary history in the area was reconstructed as follows. The oldest sediments in the study area, Unit I, interfinger with some parts of the Daito Ridge (acoustic basement) in the Minami Daito Basin. The geological age of the unit is estimated by microfossils in the sediment and supports the idea that this part of the Daito Ridge is composed of the Early Eocene oceanic basalt. Later, a fair amount of sediments were deposited in the Minami Daito Basin in the Middle to Late Eocene age. A large volume of volcanic materials was supplied from the Paleo‐Kyushu‐Palau Ridge in the Kita Daito Basin in the Eocene and Oligocene ages. The eastern part of the Shikoku and Parece Vela basins is characterized by volcanic sediments supplied from the Nishi Shichito and West Mariana Ridges in the Miocene age. However, pelagic and hemipelagic sediments prevail in the northern part of the Shikoku Basin in the Miocene or later. In short, the area of principal sedimentation has generally shifted from west to east through geological time, reflecting the evolution of the island arc systems with the same trend in the northern Philippine Sea. 相似文献
1