排序方式： 共有47条查询结果，搜索用时 15 毫秒
1.
Projections of ocean climate for northwestern Pacific Ocean 总被引：1，自引：1，他引：0
The long-term adjustment processes of atmosphere and ocean in response to gradually increased atmospheric CO2 concentration have been analyzed in 70 and 140a integrations with NCAR fully-coupled climate system model (CSM). In these experiments the CO2 concentration has been increased to double and quadruples the initial concentration, respectively. After 70a, at the time of CO2 doubling, the model predicts surface air temperature rises by 1.2 and 1.5K for the globe and the northwestern Pacific Ocean, respectively. The behavior of the quadrupling run is similar: each global and regional mean surface air temperatures increase by 2.8 and 3.0K at the time of CO2 quadrupling. From the experiments, surface air temperature changes in the northwestern Pacific Ocean will be more distinctive compared with the global average, mainly due to exceptionally large warming and sea level change near the entrance of the Kuroshio extension. 相似文献
2.
Byung Sun Lee Sung-Ho Song Jin Sung Kim Jae Yeon Um Kyoungphile Nam 《Environmental Earth Sciences》2014,71(4):1521-1532
This study was conducted to identify the availability of coastal groundwater discharge (CGD), subsurface fluids flowing from inland through the coastal area to sea, as an alternative water resource for a large-scale reclaimed land. The behaviors of stable isotopes indicated that groundwater originated from inland precipitation and traveled as CGD along the coast line. Most of the groundwater samples collected from domestic wells installed along the old coast line were considered to be relatively fresh from the correlation analysis among chemical constituents. The average electrical conductivity (EC) values of the samples were identified as averaging 1,125–1,297 μS cm?1, corresponding to appropriate crop growth. A weathered-rock layer in a small catchment within the reclaimed land was proved to be a main CGD pathway, with electrical resistivity anomalies ranging from 7 to 14 Ω m. Five monitoring wells were placed in this catchment to delineate the occurrence of CGD. Long-term vertical EC profiling results for the monitoring wells indicated that CGD occurs within a depth of 30 m below the ground surface. Annual monitoring data for groundwater level and EC demonstrated that the water quality of CGD was improved by introducing fresh terrestrial groundwater. A remarkable improvement in water quality (EC decrease of 900–1,600 μS cm?1) of CGD was observed during the saline water pumping test that explains how CGD could be an alternative water resource for the reclaimed land. 相似文献
3.
At the circular Babi Island in the Flores tsunami (1992) and pear shaped island in the Okushiri event (1993), unexpectedly large tsunami run‐up heights in the lee of conic islands were observed. The flume and basin physical model studies were conducted in the Coastal Hydraulic Laboratory, Engineering Research and Development Center, U.S. Army Corps of Engineers to provide a better understanding of the physical phenomena and verify numerical models used in predicting tsunami wave run‐up on beaches, islands, and vertical walls. Reasonably accurate comparison of run‐up height of solitary waves on a circular island has been obtained between laboratory experimental results and two‐dimensional computation model results. In this study we apply three‐dimensional RANS model to simulate wave run‐up on conical island. In the run‐up computation we obtain that 3D calculations are in very good comparison with laboratory and 2D numerical results. A close examination of the three‐dimensional velocity distribution around conical island to compare with depth‐integrated model is performed. It is shown that the velocity distribution along the vertical coordinate is not uniform: and velocity field is weaker in the bottom layer and higher on the sea surface. The maximum difference (about 40%) appears at the time when solitary wave reached the circular island. 相似文献
4.
A small goby, Trimma grammistes, was described in detail as the first reliable record from Korea based on 10 specimens (27.8～34.0 mm SL) collected from the coastal waters of Jeju Island. The species is easily differentiated from congeners by having no scales on the predorsal region, VI-I, 10 dorsal fin rays modally, I, 10 anal fin rays, 18 pectoral fin rays, 27～30 longitudinal scales as well as two dark longitudinal bands on the body. 相似文献
5.
Based on performance-based seismic engineering, this paper proposes an optimal seismic retrofit model for steel moment resisting frames (SMRFs) to generate a retrofit scheme at minimal cost. To satisfy the acceptance criteria for the Basic Safety Objective (BSO) specified in FEMA 356, the minimum number of upgraded connections and their locations in an SMRF with brittle connections are determined by evolutionary computation. The performance of the proposed optimal retrofitting model is evaluated on the basis of the energy dissipation capacities, peak roof drift ratios, and maximum interstory drift ratios of structures before and after retrofitting. In addition, a retrofit efficiency index, which is defined as the ratio of the increment in seismic performance to the required retrofitting cost, is proposed to examine the efficiencies of the retrofit schemes derived from the model. The optimal seismic retrofit model is applied to the SAC benchmark examples for threestory and nine-story SMRFs with brittle connections. Using the retrofit efficiency index proposed in this study, the optimal retrofit schemes obtained from the model are found to be efficient for both examples in terms of energy dissipation capacity, roof drift ratio, and maximum inter-story drift ratio. 相似文献
6.
Surface‐wetting properties are an important cause of changing the groundwater and two‐phase fluid flows. Various factors affecting the surface wettability were investigated in a parallel‐walled glass fracture with non‐aqueous phase liquid (NAPL) (gasoline, diesel, trichloroethylene, and creosote) wetted surfaces. First, the effect of the duration of NAPL exposure on wettability change was considered at pre‐wet fracture surfaces using the various NAPL species, and the result showed that the surface became hydrophobic after the exposure time of NAPL exceeded 2000 min. Second, the initial wetting state of the surface affected the timing when the wettability change begins as well as the extent of the wettability change in an NAPL‐wetted rock fractures. Under the dry condition, the wettability change was completed within a very short time of exposure to NAPL (~5 min), and then it finally reached the intermediate and weakly NAPL wetting (contact angle of 118°). Under the pre‐wet condition, a relatively long time of exposure (~5000 min) was needed to observe the obvious change of the surface wettability, which was changed up to strongly NAPL wetting (contact angle of 142°). Third, the wettability changed by NAPL exposure was stable and maintained for a long time, regardless of water flushing rate and temperature. Finally, the wettability change by the exposure of NAPL on parallel fracture surfaces was evaluated at various groundwater flow velocities. Result showed that groundwater flow velocity has an important impact upon measured contact angle. Although fracture surfaces were exposed to NAPL at the low groundwater flow velocity, the wettability was not changed from hydrophilic to hydrophobic when the contact time between NAPL and mineral surfaces was not sufficient owing to the pulse‐type movement of NAPL. This implies that the variation of exposure pattern due to groundwater flow on the wettability change can be an important factor affecting the wettability change of fracture surface and migration behaviour at natural fractured rock aquifers in case of NAPL spill. Copyright © 2015 John Wiley & Sons, Ltd. 相似文献
7.
A Tidal Power Plant (TPP) is being constructed in the middle section of the existing Lake Sihwa dike located near the southern Incheon Port in Korea. The project, which will be completed in 2010, is to harness the largest tidal energy in the Kyeonggi Bay in the eastern Yellow Sea. While noting the current progress in terms of plant construction, this paper outlines the overall project in the tidal regime and uses predictive local flow modeling. The results of two-dimensional finite element method simulations that predict the real-time tidal characteristics during the construction and after the completion of the tidal power plant are presented, including a method to estimate the electricity output from the plant in the future. 相似文献
8.
This paper reports the results of an investigation into flood simulation by areal rainfall estimated from the combination of gauged and radar rainfalls and a rainfall–runoff model on the Anseong‐cheon basin in the southern part of Korea. The spatial and temporal characteristics and behaviour of rainfall are analysed using various approaches combining radar and rain gauges: (1) using kriging of the rain gauge alone; (2) using radar data alone; (3) using mean field bias (MFB) of both radar and rain gauges; and (4) using conditional merging technique (CM) of both radar and rain gauges. To evaluate these methods, statistics and hyetograph for rain gauges and radar rainfalls were compared using hourly radar rainfall data from the Imjin‐river, Gangwha, rainfall radar site, Korea. Then, in order to evaluate the performance of flood estimates using different rainfall estimation methods, rainfall–runoff simulation was conducted using the physics‐based distributed hydrologic model, Vflo?. The flood runoff hydrograph was used to compare the calculated hydrographs with the observed one. Results show that the rainfall field estimated by CM methods improved flood estimates, because it optimally combines rainfall fields representing actual spatial and temporal characteristics of rainfall. Copyright © 2008 John Wiley & Sons, Ltd. 相似文献
9.
Wave-tide-surge coupled simulation for typhoon Maemi 总被引：1，自引：0，他引：1
The main task of this study focuses on studying the effect of wave-current interaction on currents, storm surge and wind wave as well as effects of current induced wave refraction and current on waves by using numerical models which consider the bottom boundary layer and sea surface roughness parameter for shallow and smooth bed area around Korean Peninsula. The coupled system (unstructured-mesh SWAN wave and ADCIRC) run on the same unstructured mesh. This identical and homogeneous mesh allows the physics of wave-circulation interactions to be correctly resolved in both models. The unstructured mesh can be applied to a large domain allowing all energy from deep to shallow waters to be seamlessly followed. There is no nesting or overlapping of structured wave meshes, and no interpolation is required. In response to typhoon Maemi (2003), all model components were validated independently, and shown to provide a faithful representation of the system’s response to this storm. The waves and storm surge were allowed to develop on the continental shelf and interact with the complex nearshore environment. The resulting modeling system can be used extensively for prediction of the typhoon surge. The result show that it is important to incorporate the wave-current interaction effect into coastal area in the wave-tide-surge coupled model. At the same time, it should consider effects of depth-induced wave breaking, wind field, currents and sea surface elevation in prediction of waves. Specially, we found that: (1) wave radiation stress enhanced the current and surge elevation otherwise wave enhanced nonlinear bottom boundary layer decreased that, (2) wind wave was significantly controlled by sea surface roughness thus we cautiously took the experimental expression. The resulting modeling system can be used for hindcasting (prediction) the wave-tide-surge coupled environments at complex coastline, shallow water and fine sediment area like areas around Korean Peninsula. 相似文献
10.
Palanivel Sathishkumar Kannan Balan Thayumanavan Palvannan Seralathan Kamala‐Kannan Byung‐Taek Oh Susana Rodríguez‐Couto 《洁净——土壤、空气、水》2013,41(7):665-672
Laccase from the white‐rot fungus Pleurotus florida, produced under solid‐state fermentation conditions, was used for the decolorization of reactive dye Remazol Brilliant Blue R (RBBR). RBBR was decolorized up to 46% by P. florida laccase alone in 10 min. In the presence of N‐hydroxybenzotriazole (HBT), the rate of decolorization was enhanced 1.56‐fold. Central composite design of response surface methodology with four variables namely, dye, enzyme, redox mediator concentrations, and time at five levels was applied to optimize the RBBR decolorization. The predicted optimum level of variables for maximum RBBR decolorization (87%) was found to be 52.90 mg L?1 (RBBR), 1.87 U mL?1 (laccase), 0.85 mM (HBT), and 7.17 min (time), respectively. The validation results showed that the experimental value of RBBR decolorization (82%) was close to the predicted one. The disappearance of C–N and C–X groups, and a small shift in N–H groups in Fourier‐transform infra red (FTIR) spectroscopy confirms the degradation of RBBR chromophore by laccase enzyme. The phytotoxicity of RBBR was considerably reduced after the treatment with laccase. RBBR decolorization kinetics; Km and Vmax were calculated to be 145.82 mg L?1 and 24.86 mg L?1 min, respectively. 相似文献