首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   515篇
  免费   160篇
  国内免费   113篇
测绘学   34篇
大气科学   100篇
地球物理   309篇
地质学   186篇
海洋学   39篇
天文学   6篇
综合类   21篇
自然地理   93篇
  2024年   3篇
  2023年   8篇
  2022年   12篇
  2021年   8篇
  2020年   23篇
  2019年   26篇
  2018年   18篇
  2017年   10篇
  2016年   22篇
  2015年   28篇
  2014年   33篇
  2013年   26篇
  2012年   26篇
  2011年   35篇
  2010年   26篇
  2009年   39篇
  2008年   33篇
  2007年   42篇
  2006年   48篇
  2005年   34篇
  2004年   37篇
  2003年   30篇
  2002年   35篇
  2001年   21篇
  2000年   22篇
  1999年   22篇
  1998年   13篇
  1997年   14篇
  1996年   20篇
  1995年   13篇
  1994年   3篇
  1993年   11篇
  1992年   11篇
  1991年   3篇
  1990年   6篇
  1989年   4篇
  1988年   4篇
  1987年   2篇
  1986年   2篇
  1985年   3篇
  1983年   1篇
  1982年   3篇
  1980年   6篇
  1978年   1篇
  1954年   1篇
排序方式: 共有788条查询结果,搜索用时 31 毫秒
1.
青藏高原及邻近区域的S波三维速度结构   总被引:25,自引:5,他引:20  
周兵  秦建业 《地球物理学报》1991,34(4):426-441,T001
本文收集了WWSSN台网和我国台网中13个地震台站的长周期地震记录,用140条10-90s瑞利波频散曲线和作者提出的Tarantola-Backus面波频散层析成象方法,作了青藏高原及邻区的速度反演,得出该地区岩石层速度结构的三维图象.结果表明,1.在10-110km深度范围内,速度结构出现与大地构造特征相关的分区性,显示出四个构造单元:青藏块体、柴达木-巴颜喀拉-三江块体、塔里木块体和印度块体.2.高原内部,深度为10-70km内速度较低,莫霍界面呈不对称盆形分布,藏北那曲附近地壳厚度超过70km,高原边缘壳厚为45-50km,90-110km为高速异常,表明高原内部存在上地幔盖层.3.高原北部的班公湖断裂和东部的三江断裂系是该区重要的分界线,是岩石层结构存在明显差异的重要接触部位,可能是冈瓦纳古陆与欧亚古陆的缝合带.4.柴达木-巴颜喀拉-三江块体内部速度分布不均匀,地壳厚度由北向南从45km加深到60km;在深度90-110km存在一低速层.5.塔里木地块内速度随深度均匀增加,从地壳到上地幔110km内没有发现低速层.地壳厚度约50km.  相似文献   
2.
The Rayleigh wave phase and group velocities in the period range of 24–39 sec, obtained from two earthquakes which occurred in northeastern brazil and which were recorded by the Brazilian seismological station RDJ (Rio de Janeiro), have been used to study crustal and upper mantle structures of the Brazilian coastal region. Three crustal and upper mantle models have been tried out to explain crustal and upper mantle structures of the region. The upper crust has not been resolved, due basically to the narrow period range of the phase and group velocities data. The phase velocity inversions have exhibited good resolutions for both lower crust and upper mantle, with shear wave velocities characteristic of these regions. The group velocity data inversions for these models have showed good results only for the lower crust. The shear wave velocities of the lower crust (3.86 and 3.89 km/sec), obtained with phase velocity inversions, are similar to that (=3.89 km/sec) found byHwang (1985) to the eastern South American region, while group velocity inversions have presented shear velocity (=3.75 km/sec) similar to that (=3.78 km/sec) found byLazcano (1972) to the Brazilian shield. It was not possible to define sharply the crust-mantle transition, but an analysis of the phase and group velocity inversions results has indicated that the total thickness of the crust should be between 30 and 39 km. The crustal and upper mantle model, obtained with phase velocity inversion, can be used as a preliminary model for the Brazilian coast.  相似文献   
3.
作者在已完成大气激光雷达系统夜间工作的基础上 ,对白天工作条件下的各种环境背景光的干扰进行了理论与实验分析 ,得出太阳直射光和天空光为白天工作的主要背景干扰。实验结果表明 ,经过激光发射与接收视场角严格匹配及使用干涉滤光器 (2 .6 nm和 0 .15nm)进行窄带滤波 ,背景干扰被明显地剔除 ,可进一步压低背景干扰约 2 0倍。证明采取视场匹配及干涉滤光器的措施可基本保证激光雷达系统在白天条件下工作。  相似文献   
4.
外差激光雷达测量水体布里渊散射可行性研究   总被引:1,自引:0,他引:1  
该文分析外差激光雷达测量水体布里渊散射的可行性。借助测量水体布里渊散射的频移 ,可得到水体声速或温度。文中利用两条 12 7I2 吸收线锁定激光输出频率 ,产生稳定的频差约为7.5 GHz发射激光和激光本振。通过对 12 7I2 吸收线稳定度、激光频率稳定度、系统信噪比和反演精度的分析和计算机模拟 ,得出水体深度 2 5 m以内水体布里渊散射频移的测量误差可以控制在2 .5 MHz以内 ,达到水中声速 0 .6 m/ s或温度 0 .1℃的测量精度。  相似文献   
5.
一种改进的基于坡度变化的机载激光雷达点云滤波方法   总被引:2,自引:0,他引:2  
机载激光点云数据滤波是获取高精度数字表面模型和数字高程模型的关键。本文分析了几种重要的滤波算法,在研究基于坡度变化的滤波算法的基础上,提出一种改进的分块滤波处理的方法。实验表明:该方法能有效对点云数据进行分类。  相似文献   
6.
Accuracy assessment of lidar-derived digital elevation models   总被引:2,自引:0,他引:2  
Despite the relatively high cost of airborne lidar-derived digital elevation models (DEMs), such products are usually presented without a satisfactory associated estimate of accuracy. For the most part, DEM accuracy estimates are typically provided by comparing lidar heights against a finite sample of check point coordinates from an independent source of higher accuracy, supposing a normal distribution of the derived height differences or errors. This paper proposes a new methodology to assess the vertical accuracy of lidar DEMs using confidence intervals constructed from a finite sample of errors computed at check points. A non-parametric approach has been tested where no particular error distribution is assumed, making the proposed methodology especially applicable to non-normal error distributions of the type usually found in DEMs derived from lidar. The performance of the proposed model was experimentally validated using Monte Carlo simulation on 18 vertical error data-sets. Fifteen of these data-sets were computed from original lidar data provided by the International Society for Photogrammetry and Remote Sensing Working Group III/3, using their respective filtered reference data as ground truth. The three remaining data-sets were provided by the Natural Environment Research Council's Airborne Research and Survey Facility lidar system, together with check points acquired using high precision kinematic GPS. The results proved promising, the proposed models reproducing the statistical behaviour of vertical errors of lidar using a favourable number of check points, even in the cases of data-sets with non-normally distributed residuals. This research can therefore be considered as a potentially important step towards improving the quality control of lidar-derived DEMs.  相似文献   
7.
多道瑞利波在矿井独头巷道超前探中的应用   总被引:3,自引:2,他引:1  
瑞利波超前探测作为一种新的矿井地球物理探测方法,具有简便、快速、经济、分辨率高、适用场地小、应用范围广等优点。介绍了瑞利波探测技术原理,并将其用于煤矿井下独头巷道大距离超前探测中。实例表明,探测距离达80 m以上,条件允许时可达100 m以上。  相似文献   
8.
文章以弹性波横波速度为参数,利用瑞利面波频散曲线的快速标量传递算法进行正演模拟计算,系统研究软弱层厚度对瑞利面波基阶模频散曲线的影响,分析和总结了频率与相速度(f-c)、频率与波数(f-k)、深度与相速度(h-c)等瑞利面波基阶模曲线随软弱层厚度变化的规律。  相似文献   
9.
A three-dimensional ultrasonic modelling was used to study the Rayleigh waves reflected from a thin low velocity vertical layer and those transmitted through the same zone. The reflection and transmission coefficients of the Rayleigh waves have been calculated by an approximate method based on the Green function technique. Nonrigid contact boundary conditions were used for the low velocity layer modelling. A rather good correspondence between the theoretical and experimental absolute values of the reflection and the transmission coefficients was obtained. Some discrepancies between experimental and theoretical results, in particular with regard to phase shifts, may be explained by a certain inadequacy of the theoretical model to the low velocity layer investigated by the ultrasonic modelling.  相似文献   
10.
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号