A Step Towards Evaluation of the Seismic Response Reduction Factor in Multistorey Reinforced Concrete Frames   总被引：1，自引：0，他引：1  

Barakat  Samar a.  Husein Malkawi  Abdallah I.  Al-Shatnawi  Anis S. 《Natural Hazards》1997,16(1):65-80

A seismic nonlinear time-history analysis was made for four-, six-, and eight-storey reinforced concrete buildings. These buildings were made as three-dimensional space frame structures with shear walls in both orthogonal directions. They have five bays with 4.8 m spacing each in the horizontal direction, and three bays with 4.2 m spacing each in the transversal direction. The frames were designed according to the Jordanian Seismic Code of practice for Seismic Zones 4, 3, 2, and 1 as proposed for Jordan by several authors. Time-history analysis was made using the El Centro (N-S) earthquake record of May 1940 as an actual earthquake excitation. The response reduction factor (R) that primarily consists of two factors that are the ductility reduction (Rµ) and the overstrength (), is obtained. It has been seen that the seismic zoning has a slight effect on the ductility reduction factor for different buildings, since it ranges from Zone 4 to Zone 1 as 2.37 to 2.52, 1.72 to 1.78, and 1.14 to 1.18 for four-, six-, and eight-storey buildings, respectively. Moreover, it is observed that, for different buildings and different seismic zones, the ductility reduction factor (Rµ) is slightly different from the system ductility factor (µ) especially for higher values of µ (i.e., Rµ µ). The response reduction factor, called overstrength (), was evaluated. The overstrength factor was found to vary with seismic zones (Z) , number of stories, and design gravity loads. However, the dependency on seismic zones was the strongest. The average overstrength of these buildings in Zones 4 and 1 was 2.61 and 6.94, respectively. The overstrength increased as the number of storeys decreased: overstrength of a four-storey building was higher than an eight-storey building by 36% in Zone 4, and 39% in Zone 1. Furthermore, buildings of the three heights had an average overstrength 165.9% higher in Zone 1 than in Zone 4. These observations have a significant implications for the seismic design codes which currently do not take into account the variation of the response reduction factor, R (i.e., ductility reduction factor times overstrength).  相似文献   

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations     

Ser‐Tong Quek  Chengmei Bian  Xilin Lu  Wensheng Lu  Haibei Xiong 《地震工程与结构动力学》2002,31(2):459-474

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

A procedure for evaluating seismic energy demand of framed structures     

Chung‐Che Chou  Chia‐Ming Uang 《地震工程与结构动力学》2003,32(2):229-244

Energy serves as an alternative index to response quantities like force or displacement to include the duration‐related seismic damage effect. A procedure to evaluate the absorbed energy in a multistorey frame from energy spectra was developed. For low‐ to medium‐rise frames, it required a static pushover analysis of the structure to determine the modal yield force and ductility factor of an equivalent single‐degree‐of‐freedom system for the first two modes. The energy spectra were then used to determine the energy contribution of each mode. A procedure was also developed to distribute the energy along the frame height based on energy shapes. This study showed that the second‐mode response in some cases needs to be considered to reflect the energy (or damage) concentration in the upper floors. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

对目前岩石“全曲线”测试的若干看法   总被引：1，自引：0，他引：1  

马世民  马宇博 《岩土力学》2003,(Z1)

从电液伺服岩石压力试验机工作机理的角度,对目前岩石应力-应变全过程曲线(以下简称“全曲线”)测试中的一些问题进行了分析,提出了自己的看法,目的是为了解决“全曲线”测试的2个问题,即如何测出“全曲线”;如何使测出的“全曲线”真实反映岩石的力学特性,并将其用到工程中。  相似文献   

Study on comparison between absolute and relative input energy spectra and effects of ductility factor     

公茂盛  谢礼立 《地震学报(英文版)》2005,18(6):717-726

Introduction Estimation of an attenuation relationship for strong ground motion parameters has been an interesting research subject in the field of engineering seismology and has played a very important role in seismic safety evaluation, seismic zoning, seismic hazard evaluation of major constructions, etc. At present, the generally used parameters include peak acceleration, peak velocity and elastic response spectrum. Such parameters mentioned above are essentially independent of the duration…  相似文献   

Energy demands for seismic design against low‐cycle fatigue     

Amador Teran‐Gilmore  James O. Jirsa 《地震工程与结构动力学》2007,36(3):383-404

A seismic design procedure that does not take into account the maximum and cumulative plastic deformation demands that a structure is likely to undergo during severe ground motion could lead to unsatisfactory performance. In spite of this, current design procedures do not take into account explicitly the effect of low‐cycle fatigue. Based on the high correlation that exists between the strength reduction factor and the energy demand in earthquake‐resistant structures, simple procedures can be formulated to estimate the cumulative plastic deformation demands for design purposes. Several issues should be addressed during the use of plastic energy within a practical performance‐based seismic design methodology. Copyright © 2006 John Wiley & Sons, Ltd.  相似文献   

Earthquake‐resistant structural design through energy demand and capacity     

Adang Surahman 《地震工程与结构动力学》2007,36(14):2099-2117

An energy‐based earthquake‐resistant structural design method is proposed. The proposed method uses specific input energy spectra, modal or time‐history analyses, and energy distribution among structural members. For a given member strength and stiffness, a relationship between the energy attributable to damage absorbed by a member and its cumulative ductility demand can be determined. Member strength, stiffness and energy capacity are design parameters which are simultaneously used in the design. The method can avoid soft‐storey design. The damage is measured based on a cumulative basis considering earthquake magnitude, frequency, and duration. Tests have been carried out to determine energy absorbing capacities of various structural components. More efforts are needed to make the energy‐based earthquake‐resistant structural design practical, but ssimple formulations for this method are possible. Copyright © 2007 John Wiley & Sons, Ltd.  相似文献   

Non-linear seismic behavior of structures with limited hysteretic energy dissipation capacity   总被引：1，自引：0，他引：1  

Pierino Lestuzzi  Youssef Belmouden  Martin Trueb 《Bulletin of Earthquake Engineering》2007,5(4):549-569

This paper investigates the non-linear seismic behavior of structures such as slender unreinforced masonry shear walls or precast post-tensioned reinforced concrete elements, which have little hysteretic energy dissipation capacity. Even if this type of seismic response may be associated with significant deformation capacity, it is usually not considered as an efficient mechanism to withstand strong earthquakes. The objective of the investigations is to propose values of strength reduction factors for seismic analysis of such structures. The first part of the study is focused on non-linear single-degree-of-freedom (SDOF) systems. A parametric study is performed by computing the displacement ductility demand of non-linear SDOF systems for a set of 164 recorded ground motions selected from the European Strong Motion Database. The parameters investigated are the natural frequency, the strength reduction factor, the post-yield stiffness ratio, the hysteretic energy dissipation capacity and the hysteretic behavior model (four different hysteretic models: bilinear self-centring, with limited or without energy dissipation capacity, modified Takeda and Elastoplastic). Results confirm that the natural frequency has little influence on the displacement ductility demand if it is below a frequency limit and vice versa. The frequency limit is found to be around 2 Hz for all hysteretic models. Moreover, they show that the other parameters, especially the hysteretic behavior model, have little influence on the displacement ductility demand. New relationships between the displacement ductility demand and the strength reduction factor for structures having little hysteretic energy dissipation capacity are proposed. These relationships are an improvement of the equal displacement rule for the considered hysteretic models. In the second part of the investigation, the parametric study is extended to multi-degree-of-freedom (MDOF) systems. The investigation shows that the results obtained for SDOF systems are also valid for MDOF systems. However, the SDOF system overestimates the displacement ductility demand in comparison to the corresponding MDOF system by approximately 15%.  相似文献   

钢筋混凝土圆形截面柱式桥墩抗震性能评价   总被引：4，自引：0，他引：4  

王东升  郭恩栋  柳春光  翟桐 《世界地震工程》2001,17(1):98-102

对4座典型的钢筋混凝土圆形截面双柱式桥墩，利用Priestley等建议的钢筋混凝土桥墩抗剪强度计算方法和型态描述方程，结合Rush-over方法进行了延性抗震能力评价。一般说来，纵桥向能够满足延性抗震要求，而横桥向一些配箍率较低的桥墩在地震中会发生脆性的弯剪破坏，其底部塑性铰将形成在柱基之中，部分桩基可能会遭受损害。  相似文献   

圆钢管混凝土压弯构件荷载一位移滞回性能分析   总被引：6，自引：1，他引：6  

韩林海  陶忠  阎维波 《地震工程与工程振动》2001,21(1):64-73

在空钢管中填充混凝土可以避免或延缓钢管过早地发生局部屈曲，并有效地提高构件的延性，从而增强构件的抗震性能，本文在对圆钢管混凝土构件弯矩－曲率关系分析的基础上，分析了圆钢管混凝土压弯构件P－△滞回关系曲线，理论计算结果得到国内外大量结果的验证，基于理论分析模型，分析了各参，如构件轴压比，长细比，截面含钢率和材料强度等因素对圆钢管混凝土压变变构件P－△滞回关系曲线的影响，最后，确定了圆钢管混凝土压弯构件P－△恢复力学模型和延性系数的简化计算方法。  相似文献