Modelling the effect of changing precipitation inputs on deep soil water utilization          下载免费PDF全文

Ji Qi  Daniel Markewitz  David Radcliffe 《水文研究》2018,32(5):672-686

Forests in the Southeastern United States are predicted to experience future changes in seasonal patterns of precipitation inputs as well as more variable precipitation events. These climate change‐induced alterations could increase drought and lower soil water availability. Drought could alter rooting patterns and increase the importance of deep roots that access subsurface water resources. To address plant response to drought in both deep rooting and soil water utilization as well as soil drainage, we utilize a throughfall reduction experiment in a loblolly pine plantation of the Southeastern United States to calibrate and validate a hydrological model. The model was accurately calibrated against field measured soil moisture data under ambient rainfall and validated using 30% throughfall reduction data. Using this model, we then tested these scenarios: (a) evenly reduced precipitation; (b) less precipitation in summer, more in winter; (c) same total amount of precipitation with less frequent but heavier storms; and (d) shallower rooting depth under the above 3 scenarios. When less precipitation was received, drainage decreased proportionally much faster than evapotranspiration implying plants will acquire water first to the detriment of drainage. When precipitation was reduced by more than 30%, plants relied on stored soil water to satisfy evapotranspiration suggesting 30% may be a threshold that if sustained over the long term would deplete plant available soil water. Under the third scenario, evapotranspiration and drainage decreased, whereas surface run‐off increased. Changes in root biomass measured before and 4 years after the throughfall reduction experiment were not detected among treatments. Model simulations, however, indicated gains in evapotranspiration with deeper roots under evenly reduced precipitation and seasonal precipitation redistribution scenarios but not when precipitation frequency was adjusted. Deep soil and deep rooting can provide an important buffer capacity when precipitation alone cannot satisfy the evapotranspirational demand of forests. How this buffering capacity will persist in the face of changing precipitation inputs, however, will depend less on seasonal redistribution than on the magnitude of reductions and changes in rainfall frequency.  相似文献   

Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis     

Ramin Pakzad  Shanyong Wang  Scott W. Sloan 《国际地质力学数值与分析法杂志》2020,44(10):1472-1494

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.  相似文献   

Effects of the geometry of two‐dimensional fractures on their hydraulic aperture and on the validity of the local cubic law          下载免费PDF全文

Ahmad Hajjar  Luc Scholtès  Constantin Oltéan  Michel Antoine Buès 《水文研究》2018,32(16):2510-2525

Flow through rough fractures is investigated numerically in order to assess the validity of the local cubic law for different fracture geometries. Two‐dimensional channels with sinusoidal walls having different geometrical properties defined by the aperture, the amplitude, and the wavelength of the walls' corrugations, the corrugations asymmetry, and the phase shift between the two walls are considered to represent different fracture geometries. First, it is analytically shown that the hydraulic aperture clearly deviates from the mean aperture when the walls' roughness, the phase shift, and/or the asymmetry between the fracture walls are relatively high. The continuity and the Navier–Stokes equations are then solved by means of the finite element method and the numerical solutions compared to the theoretical predictions of the local cubic law. Reynolds numbers ranging from 0.066 to 66.66 are investigated so as to focus more particularly on the effect of flow inertial effects on the validity of the local cubic law. For low Reynolds number, typically less than 15, the local cubic law properly describes the fracture flow, especially when the fracture walls have small corrugation amplitudes. For Reynolds numbers higher than 15, the local cubic law is valid under the conditions that the fracture presents a low aspect ratio, small corrugation amplitudes, and a moderate phase lag between its walls.  相似文献   

Solution for a plane strain rough‐walled hydraulic fracture driven by turbulent fluid through impermeable rock          下载免费PDF全文

N. Zolfaghari  E. Dontsov  A. P. Bunger 《国际地质力学数值与分析法杂志》2018,42(4):587-617

The impact of turbulent flow on plane strain fluid‐driven crack propagation is an important but still poorly understood consideration in hydraulic fracture modeling. The changes that hydraulic fracturing has experienced over the past decade, especially in the area of fracturing fluids, have played a major role in the transition of the typical fluid regime from laminar to turbulent flow. Motivated by the increasing preponderance of high‐rate, water‐driven hydraulic fractures with high Reynolds number, we present a semianalytical solution for the propagation of a plane strain hydraulic fracture driven by a turbulent fluid in an impermeable formation. The formulation uses a power law relationship between the Darcy‐Weisbach friction factor and the scale of the fracture roughness, where one specific manifestation of this generalized friction factor is the classical Gauckler‐Manning‐Strickler approximation for turbulent flow in a rough‐walled channel. Conservation of mass, elasticity, and crack propagation are also solved simultaneously. We obtain a semianalytical solution using an orthogonal polynomial series. An approximate closed‐form solution is enabled by a choice of orthogonal polynomials embedding the near‐tip asymptotic behavior and thus giving very rapid convergence; a precise solution is obtained with 2 terms of the series. By comparison with numerical simulations, we show that the transition region between the laminar and turbulent regimes can be relatively small so that full solutions can often be well approximated by either a fully laminar or fully turbulent solution.  相似文献   

Micromechanical approach to effective viscoelastic properties of micro‐fractured geomaterials          下载免费PDF全文

Cássio B. Aguiar  Samir Maghous 《国际地质力学数值与分析法杂志》2018,42(16):2018-2046

The aim of this paper is to formulate a micromechanics‐based approach to non‐aging viscoelastic behavior of materials with randomly distributed micro‐fractures. Unlike cracks, fractures are discontinuities that are able to transfer stresses and can therefore be regarded from a mechanical viewpoint as interfaces endowed with a specific behavior under normal and shear loading. Making use of the elastic‐viscoelastic correspondence principle together with a Mori‐Tanka homogenization scheme, the effective viscoelastic behavior is assessed from properties of the material constituents and damage parameters related to density and size of fractures. It is notably shown that the homogenized behavior thus formulated can be described in most cases by means of a generalized Maxwell rheological model. For practical implementation in structural analyses, an approximate model for the isotropic homogenized fractured medium is formulated within the class of Burger models. Although the approximation is basically developed for short‐term and long‐term behaviors, numerical applications indicate that the approximate Burger model accurately reproduce the homogenized viscoelastic behavior also in the transient conditions.  相似文献   

浙西北江山─绍兴断裂带构造演化特征     

竺国强  姜继双  陈梓军  周培华 《浙江国土资源》1997,(2)

江山—绍兴断裂带是中国南方最重要的构造带之一。它是江南陆块与华夏陆块神功运动形成的碰撞拼贴带。它表现出明显的多期变形、构造叠加的特征：神功运动形成近东西向平卧褶皱；印支运动沿断裂带有向北西强烈的推覆挤压。断裂带不同时期的活动反映了不同特征的构造环境，形成不同的构造变形特征，并对两侧的地质历史具有明显的控制作用。  相似文献   

超基性岩中含铜、钴块状硫化物矿床——德尔尼铜矿成因新认识   总被引：1，自引：0，他引：1  

章午生  陈杰 《青海国土经略》1996,(1)

长期以来对德尔尼铜矿的成因存在着不同认识。从矿石组成和结构、构造来看,应属典型的块状硫化物矿石,矿床亦应属于含铜黄铁矿型矿床。但从其地质产状来看又与一般的黄铁矿型矿床大不相同,与一般的岩浆熔离铜镍硫化物矿床也有较多差异。这就是本矿床类型独特之处。近年来通过工作又取得一些新资料,特别是超基性岩和矿石的同位素年龄数据。本文在综合新老资料基础上,提出新看法,认为该矿床形成于上地幔,再就位于地壳浅部。其成因类型暂定为:“深部熔离—构造侵位矿床”。鉴于本矿床与一般块状硫化物矿床相比有其独特性,建议命名为“德尔尼型”。  相似文献   

The Geological-Geophysical-Geochemical Exploration Model of the Nancha Type Gold Deposit in Tonghua Area, Jilin Province     

《东北亚地学研究》2001,(2)

  相似文献   

A crack model of afterslip events on shallow faults     

Maria Elina Belardinelli  Maurizio Bonafede 《Geophysical Journal International》1991,106(3):521-530

  相似文献   

元岭金矿蚀变破碎带特征及其找矿意义     

刘红樱  周顺之  胡受奚  王群昌 《河南国土资源》1996,(2)

根据对元岭金矿三条蚀变破碎带一般地质特征、微量元素特征的对比研究，并借鉴邻近矿区蚀变破碎带的矿化特征，本文阐明了元岭蚀变破碎带矿化的有利构造部位，总结了蚀变破碎带特征与矿化强度之间的关系，指出蚀变破碎带的矿化蚀变元素为中低温组合，矿化蚀变愈强则参与元素的种类愈多、数量愈大。围岩性质对矿化蚀变有一定影响，围岩中的易迁移亲铜元素和亲硫铁族无素对矿化有利。据此，为进一步成矿预测、评价蚀变破碎带的含矿性提供依据。  相似文献