Non-Newtonian topographic relaxation on Europa   总被引：1，自引：0，他引：1  

F. Nimmo 《Icarus》2004,168(1):205-208

Models of topographic support on Europa by lateral shell thickness variations have previously assumed a Newtonian ice viscosity. Here I show that using a more realistic stress-dependent viscosity gives relaxation times which can be significantly different. Topography of wavelength 100 km cannot be supported by lateral shell thickness variations for ∼50 Myr, unless the shell thickness is <10 km or the ice grain size >10 mm. Shorter wavelength topography would require even thinner shells, but may be supported elastically. Global-scale variations in shell thickness, however, can be supported for geological timescales if the shell thickness is O(10 km).  相似文献   

In situ strength measurements on natural upper-mantle minerals   总被引：1，自引：0，他引：1  

Junji Yamamoto  Jun-ichi Ando  Hiroyuki Kagi  Toru Inoue  Akihiro Yamada  Daisuke Yamazaki  Tetsuo Irifune 《Physics and Chemistry of Minerals》2008,35(5):249-257

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.  相似文献   

Debris-flow event in the Frangerello Stream-Susa Valley (Italy)—calibration of numerical models for the back analysis of the 16 October, 2000 rainstorm     

P. Bertolo  G. Bottino 《Landslides》2008,5(1):19-30

Three debris-flow simulation model software have been applied to the back analysis of a typical alpine debris flow that caused significant deposition on an urbanized alluvial fan. Parameters used in the models were at first retrieved from the literature and then adjusted to fit field evidence. In the case where different codes adopted the same parameters, the same input values were used, and comparable outputs were obtained. Results of the constitutive laws used (Bingham rheology, Voellmy fluid rheology and a quadratic rheology formulation which adds collisional and turbulent stresses to the Bingham law) indicate that no single rheological model appears to be valid for all debris flows. The three applied models appear to be capable of reasonable reproduction of debris-flow events, although with different levels of detail. The study shows how different software can be used to predict the debris-flow motion for various purposes from a first screening, to predict the runout distance and deposition of the solid material and to the different behaviour of the mixtures of flows with variation of maximum solid concentration.  相似文献   

The impact of cover rock rheology on the style of folding in the Zagros fold-thrust belt     

M. Sepehr  J. Cosgrove  M. Moieni 《Tectonophysics》2006,427(1-4):265

The present day morphology of the Zagros fold-thrust belt is dominated by magnificent exposures of NW–SE trending folds. These folds differ in their size and geometry and these differences are related mainly to the rheological profile of the cover rock. The cover rock succession of the Zagros consists of a sequence of competent and incompetent units which vary both along and across the belt. Field based study combined with the use of satellite images reveals that the thickness and facies distribution of the cover rock succession has a significant impact on the style of deformation. During the shortening linked to the current convergence of the Arabian and Iranian plates, the incompetent units act as detachment horizons which localise thrusting and which act as décollement above which detachment folds form. In addition, where these incompetent units are thick (e.g.> 1 km), they allow the deformation above and below them to become completely decoupled enabling disharmonic folding to occur. As a result the folds above and below the incompetent units in the central part of the Zagros Folded Belt, have significantly different geometries and wavelengths. As the Zagros folds host the majority of the hydrocarbon reserves in Iran and Iraq, an understanding of the processes that influence their geometry and spatial organization at different levels in the cover rock is crucial for the future exploration in the region.  相似文献   

Mais comment s'écoule donc un glacier ? Aperçu historique     

Frédérique Rémy  Laurent Testut 《Comptes Rendus Geoscience》2006,338(5):368-385

Ice and snow have often helped physicists understand the world. On the contrary it has taken them a very long time to understand the flow of the glaciers. Naturalists only began to take an interest in glaciers at the beginning of the 19th century during the last phase of glacier advances. When the glacier flow from the upslope direction became obvious, it was then necessary to understand how it flowed. It was only in 1840, the year of the Antarctica ice sheet discovery by Dumont d'Urville, that two books laid the basis for the future field of glaciology: one by Agassiz on the ice age and glaciers, the other one by canon Rendu on glacier theory. During the 19th century, ice flow theories, adopted by most of the leading scientists, were based on melting/refreezing processes. Even though the word ‘fluid’ was first used in 1773 to describe ice, more the 130 years would have to go by before the laws of fluid mechanics were applied to ice. Even now, the parameter of Glen's law, which is used by glaciologists to model ice deformation, can take a very wide range of values, so that no unique ice flow law has yet been defined. To cite this article: F. Rémy, L. Testut, C. R. Geoscience 338 (2006).  相似文献   

岩石圈流变机制的确定及影响岩石圈流变强度的因素   总被引：20，自引：2，他引：20  

臧绍先  李昶  魏荣强 《地球物理学进展》2002,17(1):50-60

讨论了确定岩石圈流变强度中存在的问题，根据Byerlee定律，给出了在Anderson断层系统下三种断层的摩擦滑动强度公式，利用小标本实验结果外推，用大标本实验结果作约束，得到岩石圈几种典型岩石的脆性破裂规律，利用上述结果和传统的方法，分别得到了鄂尔多斯和山西裂谷两个典型地区的流变强度随深度的变化。结果表明，以往的计算对岩石圈流变强度的估计过高，对脆性形变区估计不足，流变机制估计不对；岩石圈有力学分层的特性，但各地分层的深度范围不同，使得成层和力学作用变得复杂，讨论了水、应变率以及多相矿物对流变强度的影响。  相似文献   

Thermo-mechanical structure beneath the young orogenic belt of Taiwan     

Kuo-Fong Ma  Teh-Ru Alex Song 《Tectonophysics》2004,388(1-4):21

We investigate the thermo-mechanical properties beneath the young orogenic belt of Taiwan by constructing a shear strength profile from a vertical stratified rheological structure. The stratified rheological structure is estimated based on the recently developed thermal structure and its likely composition. Subduction–collision in the young orogenic belts and the thick accretionary wedge make a significant contribution to the growth of sialic crust in the hinterland. The sialic bulk crust not only results in a low seismic velocity but also produces weak crust in the hinterland. The earthquake depth–frequency distribution in the foreland and hinterland correlates very well with the regimes of the brittle/ductile transition revealed in the strength profile. Our results show that the observed two-layer seismicity in the foreland is due to a moderate geotherm and an intermediate mafic bulk composition; while single-layer seismicity in the hinterland is due to its felsic bulk composition. In the foreland, the mechanically strong crust (MSC) and the mechanically strong lithosphere (MSL) coincide with frequent seismicity. The shallow MSC in the hinterland is consistent with the 20- to 25-km seismicity occurring there. The total lithospheric integrated strength (LIS) in the hinterland is only about half of that in the foreland, suggesting a weak lower crust and lithosphere mantle in the hinterland. The results confirm that the earthquake cutoff depth is a proxy for temperature. The calculated decrease of effective elastic thickness (EET) from the orogenic margin (foreland) to the center (hinterland) is consistent with the results of flexure modeling in most orogenic belts. Due to the weak LIS in the hinterland, crustal thinning and rifting may occur in the future. Our results, thus, suggest that the mechanical structure is also closely related to the composition and is not directly reflected in the thermal structure.  相似文献   

Crustal and mantle strengths in continental lithosphere: is the jelly sandwich model obsolete?     

Juan Carlos Afonso  Giorgio Ranalli 《Tectonophysics》2004,394(3-4):221-232

The relative importance of the contribution of the lower crust and of the lithospheric mantle to the total strength of the continental lithosphere is assessed systematically for realistic ranges of layer thickness, composition, and temperature. Results are presented as relative strength maps, giving the ratio of the lower crust to upper mantle contribution in terms of crustal thickness and surface heat flow. The lithosphere shows a “jelly sandwich” rheological layering for low surface heat flow, thin to average crustal thickness, and felsic or wet mafic lower crustal compositions. On the other hand, most of the total strength resides in the seismogenic crust in regions of high surface heat flow, crust of any thickness, and dry mafic lower crustal composition.  相似文献   

The influence of stress history on the grain size and microstructure of experimentally deformed quartzite     

《Journal of Structural Geology》2016

Deformation of middle crustal shear zones likely varies with time as a result of the stress build-up and release associated with earthquakes and post-seismic deformation, but the processes involved and their microstructural signature in the rock record are poorly understood. We conducted a series of experiments on quartzite at 900 °C to characterize microstructures associated with changes in stress and strain rate, and to investigate the feasibility of carrying out grain size piezometry in natural rocks that experienced analogous changes. Differential stress (referred to simply as “stress”) was varied in two-stage experiments by changing strain rate and by stopping the motor and allowing stress to relax. The two-stage samples preserve a microstructural record that can be interpreted quantitatively in terms of stress history. The microstructure associated with a stress increase is a bimodal distribution of recrystallized grain sizes. The smaller grains associated with the second deformation stage accurately record the stress of the second stage, and the surviving coarse grains remain similar in size to those formed during the earlier stage. The transient microstructure associated with stress decrease is a “partial foam” texture containing a larger concentration of stable 120° triple junctions than occur in samples deformed at a relatively constant strain rate. Our results indicate that microstructures preserved in rocks that experienced relatively simple, two-stage deformation histories can be used to quantitatively assess stress histories.Grain growth rates during deformation are similar to rates observed in previous isostatic growth experiments, supporting theoretical approaches to recrystallized grain size, such as the wattmeter theory (Austin and Evans, 2007), that incorporate static growth rates. From an analysis of the experimental data for quartz recrystallized grain size, we find: 1) Recrystallized grain size quickly reaches a value consistent with ambient deformation conditions. We argue that this explains a good match between average grain sizes predicted by the wattmeter after complete recrystallization and the recrystallized grain sizes of the experiments. 2) The present formulation of the wattmeter overestimates the rates at which porphyroclasts recrystallize by as much as an order of magnitude, and 3) owing to problems with extrapolation of grain growth data for quartz, the wattmeter is not presently applicable to natural samples deformed at low temperatures. We present a simplified flow law for quartz, and suggest that the change in slope of the quartz piezometer at high stress (regime 1) is related to a switch to a linear viscous rheology.  相似文献   

上地幔橄榄岩流变性研究新进展及其地球动力学意义   总被引：2，自引：1，他引：2  

王子潮 《地球物理学进展》1995,10(2):1-15

本文系深部地幔流性研究进展综述文章之一，重点介绍了近年来国际地球物理学界在涉及橄榄岩上地幔流变性的下述三方面取得的进展：（１）化学环境因素对橄榄石高温塑性的影响；（２）高温高压下水在橄榄石晶体中的溶解度和赋存状态；（３）橄榄石多晶体的变形机制转变，并对由此得出的地球动力学意义作了讨论。  相似文献