排序方式： 共有14条查询结果，搜索用时 15 毫秒
1.
Flavio Poletto Lorenzo Petronio Biancamaria Farina Andrea Schleifer 《Geophysical Prospecting》2011,59(3):464-476
We present the results of a seismic interferometry experiment in a shallow cased borehole. The experiment is an initial study for subsequent borehole seismic surveys in an instrumented well site, where we plan to test other surface/borehole seismic techniques. The purpose of this application is to improve the knowledge of the reflectivity sequence and to verify the potential of the seismic interferometry approach to retrieve high‐frequency signals in the single well geometry, overcoming the loss and attenuation effects introduced by the overburden. We used a walkaway vertical seismic profile (VSP) geometry with a seismic vibrator to generate polarized vertical and horizontal components along a surface seismic line and an array of 3C geophones cemented outside the casing. The recorded traces are processed to obtain virtual sources in the borehole and to simulate single‐well gathers with a variable source‐receiver offset in the vertical array. We compare the results obtained by processing the field data with synthetic signals calculated by numerical simulation and analyse the signal bandwidth and amplitude versus offset to evaluate near‐field effects in the virtual signals. The application provides direct and reflected signals with improved bandwidth after vibrator signal deconvolution. Clear reflections are detected in the virtual seismic sections in agreement with the geology and other surface and borehole seismic data recorded with conventional seismic exploration techniques. 相似文献
2.
3.
The output from the hydraulic vibrators typically used for land seismic surveys is controlled by monitoring the acceleration measured by accelerometers mounted on the reaction mass and baseplate. The considerable energy output by such vibrators, which are coupled with the sensitivity of the accelerometers used, results in crosstalk if more than one vibrator is being used. In this paper, we present the results of a field experiment in which we measured the crosstalk between two adjacent vibrators. We found that the level of crosstalk was approximately ‐20 dB when the vibrators were adjacent but decreased with increasing frequency and separation. This result has implications for measurements of vibrator performance, source‐signature deconvolution, and in particular, estimates of the total energy output by a fleet of vibrators. 相似文献
4.
当测区噪声很强，采用组合震源工作仍然不能满足信噪比要求时，为进一步提高地震勘探信噪比，引入能形成定向地震波的相控震源.针对水平层状介质模型，对组合震源、相控震源地震进行了数值模拟，并定量计算了采用4，8，15，20单元的组合与相控震源地震数据的信噪比，同组合地震相比，相控地震使来自不同反射层的反射波信号的信噪比平均提高了154～990 dB.结果表明，相控震源地震得到的反射波信号信噪比高于组合地震，并且随着激震器数目增加，相控震源合成地震记录中的反射波地震数据信噪比明显提高. 相似文献
5.
Ewald Lüschen Daniela Borrini Helmut Gebrande Bernd Lammerer Karl Millahn Franz Neubauer Rinaldo Nicolich TRANSALP Working Group 《Tectonophysics》2006,414(1-4):9
The TRANSALP consortium, comprising institutions from Italy, Austria and Germany, carried out deep seismic reflection measurements in the Eastern Alps between Munich and Venice in 1998, 1999 and 2001. In order to complement each other in resolution and depth range, the Vibroseis technique was combined with simultaneous explosive source measurements. Additionally, passive cross-line recording provided three-dimensional control and alternative north–south sections. Profits were obtained by the combination of the three methods in sectors or depths where one method alone was less successful.The TRANSALP sections clearly image a thin-skinned wedge of tectonic nappes at the northern Alpine front zone, unexpected graben or half-graben structures within the European basement, and, thick-skinned back-thrusting in the southern frontal zone beneath the Dolomite Mountains. A bi-vergent structure at crustal scale is directed from the Alpine axis to the external parts. The Tauern Window obviously forms the hanging wall ramp anticline above a southward dipping, deep reaching reflection pattern interpreted as a tectonic ramp along which the Penninic units of the Tauern Window have been up-thrusted.The upper crystalline crust appears generally transparent. The lower crust in the European domain is characterized by a 6–7 km thick laminated structure. On the Adriatic side the lower crust displays a much thicker or twofold reflective pattern. The crustal root at about 55 km depth is shifted around 50 km to the south with respect to the main Alpine crest. 相似文献
6.
A wide-angle reflection seismic experiment was carried out in the Eastern Goldfields granite–greenstone terrane of the Archaean Yilgarn Craton during 2001. This was the first time in Australia that wide-angle data were collected using a vibrator source and with a high density of observations. Unlike other wide-angle surveys carried out in other parts of the world, our survey used both a smaller number of sweeps, and shorter sweeps. We recorded three sweeps (each with its own frequency range) at each vibration point. The experiment demonstrated that the sum of three 12 s sweeps using 3 large vibrators provides enough energy to record signal at offsets up to up to 60–70 km. A comparison of individual shot gathers from near-vertical data and receiver gathers from wide-angle data demonstrated higher reflectivity in near-vertical data. This may be due to differences in the frequency bands of the recording equipment. The after stack section obtained from dense wide-angle data is different from that obtained from conventional near-vertical reflection data. The conventional reflection section provides higher quality image of the crust compared to the wide-angle section. This could be explained by the low-fold in wide-angle data and differences in the acquisition and processing methodology. The wide-angle survey, which was coincident with a regional vibroseis seismic reflection transect, was focused on the Leonora–Laverton region. The survey was designed to supplement the deep seismic reflection studies with velocity information. This also created an opportunity to compare velocity model derived from wide-angle reflection seismic data with a structural image obtained from the deep common mid-point seismic reflection data, and thus refine our geological understanding of the area. A high velocity body reaching a maximum thickness of 2 km was identified exclusively from the seismic velocity model derived from wide-angle study. This body is interpreted as mafic rocks within the Archaean Granite–Greenstone Belt. The joint interpretation also shows that structural boundaries do not always follow lithological boundaries in our study area. The combination of wide-angle reflection and near-vertical reflection data has facilitated a more complete geological interpretation of the seismic data. 相似文献
7.
The use of pseudorandom sweeps for vibroseis surveys 总被引：1，自引：0，他引：1
T. Dean 《Geophysical Prospecting》2014,62(1):50-74
Pseudorandom vibroseis sweeps have long been suggested as an alternative to standard linear sweeps due to their potential for having superior orthogonality, a lower likelihood for infrastructure damage, and increased low‐frequency content. In the past, they were also attractive as they have a better autocorrelation shape, although that is less important today. Their use has been limited but the increasing popularity of simultaneous acquisition techniques has rekindled interest as they offer the ability to reduce interference noise. A wide variety of methods for generating pseudorandom sweeps have been developed over the last 45 years. This paper gives an overview of the motivations for their use before classifying and describing the different sweep types. Finally, the sweeps will be compared in terms of their major attributes including their suitability for simultaneous surveys. 相似文献
8.
Cross-line recording formed a companion experiment of the TRANSALP seismic reflection transect through the Eastern Alps, conducted by partner institutions from Austria, Germany and Italy in three field campaigns in the period fall 1998 to fall 1999. Besides of the originally expected three-dimensional control for the north–south running main transect, additional information on seismic anisotropy and alternative images of crucial parts of the main transect could be gained.Conventionally processed sections along N–S running common-midpoint (CMP) binning lines confirm and strengthen the predominance of midcrustal reflective structures of the ‘Sub-Tauern-Ramp’ beneath and south of the Tauern Window. Velocity analysis of the first arrivals exhibit about 10% higher velocities in east–west propagating P-waves, compatible with texture-dominated rock anisotropy, recorded on cross-lines at the Tauern Window. Pre-stack depth migration of cross-line recordings shows dominant south dip of the Sub-Tauern-Ramp with easterly dip components and a sub-horizontal root zone of the Sub-Dolomites-Ramp. 相似文献
9.
10.
王广科 《物探化探计算技术》2007,(Z1)
激发地震波的震源是地震勘探的关键因素,只有在震源激发出的地震波信号具有足够的能量和宽频带的前提下,才有可能接收到地下界面产生的反射波,也才使数据采集、处理和解释具有实际意义。这里介绍了二种用于城市活断层探测中的激发震源,并就其工作原理、技术指标、激发参数和对比试验效果进行了阐述,试验研究结果表明:夯击震源和可控震源均能满足城市活断层探测的需要。虽然如此,在城市活断层探测中,尤其在城市特定环境下(不允许炸药震源激发、各种外界干扰十分严重),仍需根据工作需要和测区实际情况,合理选取激发震源。 相似文献