共查询到17条相似文献，搜索用时 515 毫秒
1.
2.
利用基于光滑粒子流体动力学(SPH)数值方法的开源软件DualSPHysics进行数值试验,模拟斜坡式防波堤上扭王字护面块体的安放过程,研究护面块体的稳定性。首先以DualSPHysics为平台开发了护面块体的安放功能模块,并对护面块体的安放效果进行评价,实现了按指定安放密度进行块体安放。块体安放完成后,在数值波浪水槽中研究护面块体在规则波作用下的运动及受力响应,并分析护面块体失稳的典型形式和失稳标准,通过系统化的参数分析,探讨波浪要素及块体安放等因素对块体稳定性的影响。结果表明,扭王字块体稳定性系数的取值范围为21.64~26.20,是规范推荐值的1.5倍左右。块体鼻轴方向的相对位置主要影响单个块体的上举脱出失稳,鼻轴方向在坡面上赤平投影图越分散,护面块体层整体上越稳定。坡面坡度变缓时,护面块体层整体下滑趋势减弱,但更易发生上举脱出失稳;单个块体缺失会加大周围块体的上举失稳概率。 相似文献
3.
护面是海堤和护岸的重要结构,直接抵御波浪作用,可采用人工块体、块石等,种类繁多。采用紧密排列方块石作为护面结构是一种景观性较好的型式,依据方块石厚度不同能抵御不同大小的波浪作用。干砌条石及干砌块石护面曾有一些规范给出过计算方法,但现行规范没有相关内容可供设计参考,已有计算方法的理论分析还存在不足。当波浪与斜坡堤相互作用时,方块石护面出现位移或脱落可能发生在波浪回落最低阶段、波浪破碎打击阶段及破后爬高水流作用阶段,通过研究得到了不同阶段波浪对方块石护面作用力的计算方法。在波浪回落最低阶段,考虑了护面及其下方垫层渗透性影响,通过理论分析建立了低渗透护面浮托压强计算模型,采用物模试验将计算结果与试验测量值进行了对比分析,结果表明总体趋势符合,量值接近;在波浪破碎冲击阶段,基于射流冲击作用原理,提出了波浪在斜坡面破碎冲击压强计算方法,通过试验分析了波浪破碎水深波高比与破波相似参数的关系,利用浅水波理论计算了波浪破碎冲击水流流速;在爬高水流作用阶段,提出了水流引起的方块石护面垂直浮托力及水平拖曳力的计算方法,通过试验结果拟合了浮托力系数和拖曳力系数,验证了水流作用下护面的受力特征。最后,针对方块... 相似文献
4.
近海区域广泛分布着第四纪新沉积的松散海洋土,波浪荷载作用下松散海床会发生液化进而对近海结构物的稳定性存在巨大威胁。本文采用中国科学院流体-结构-海床相互作用数值计算模型FSSI-CAS 2D,选用Pastor-Zienkiewicz-Mark Ⅲ（PZⅢ）弹塑性本构研究了波浪诱发的松散海床液化问题。分析了波浪荷载引起的松散海床内超孔隙水压力、有效应力以及应力角的时程变化特性,并预测了松散海床的渐进液化过程。计算结果表明,波浪荷载作用下松散海床内残余孔压会累积增长,海床表面最先发生液化,然后逐渐向下发展至液化最大深度。同时指出海床内超孔隙水压力的竖向分布特征和应力角的变化时程均可以作为判断海床液化的间接参数。最后,通过应力状态分析,讨论了海床渐进式液化的发展过程和趋势。 相似文献
5.
6.
波浪在斜坡地形上破碎,破波后稳定波高多采用物理模型试验方法进行研究,利用近岸波浪传播变形的抛物型缓坡方程和波能流平衡方程,导出了适用于斜坡上波浪破碎的数值模拟方法。首先根据波能流平衡方程和缓坡方程基本型式分析波浪在破波带内的波能变化和衰减率,推导了波浪传播模型中波能衰减因子和破波能量流衰减因子之间的关系;其次,利用陡坡地形上的高阶抛物型缓坡方程建立了波浪传播和波浪破碎数学模型;最后,根据物理模型试验实测数据对数值模拟的效果进行验证。数值计算与试验资料比较表明,该模型可以较好地模拟斜坡地形的波浪传播波高变化。 相似文献
7.
《海洋湖沼通报》2021,(4)
船舶大型化的趋势导致港口设施向深水发展。而对于深水防波堤,在较大设计波浪作用下,护面块体和垫层块石的重量往往超出现行技术规范的要求,针对大型天然块石垫层选料和施工困难,大量的开山选石损害自然环境等问题,本文总结了国内外人工块体的研究成果,阐明了人工块体垫层代替大型块石垫层的可行性,遴选了3种类型人工块体作为垫层,进行护面块体稳定性试验,经对比分析得出扭王字护面下带槽方块垫层的新结构,并确定其重量比值关系对护面稳定性的影响;对比传统垫层块石,给出遴选人工块体垫层的K_D值、堤前反射系数经验公式及波浪爬高糙渗系数推荐值。通过物理模型试验证明了深水斜坡防波堤通过采用人工垫层块体代替大型天然垫层块石的方法是可行的,为港口工程技术规范的修订提供了参考。 相似文献
8.
9.
10.
应用经CSPM法和黎曼解修正后的光滑粒子流体动力学(SPH)方法,建立了主动吸收无反射数值波浪水槽,研究波浪作用下多孔介质结构的水动力特性。流体运动控制方程采用N-S方程,多孔渗水结构内流体的运动控制方程考虑渗流力的影响。数值计算结果给出了水槽内不同位置测点的波面历时曲线和越浪量随时间变化曲线,并同试验结果和Philip Liu的数值计算结果进行了比较。并对一个波浪周期内斜坡堤多孔介质结构内外的速度场和压力分布进行了讨论分析。计算分析表明,数值计算波面较Philip Liu的计算结果与试验结果吻合更好。说明应用SPH方法建立的二维数学模型能够较好地模拟破碎波在多孔渗水斜坡上的爬坡和越浪。 相似文献
11.
This paper presents analytical and numerical models to predict the behavior of unbonded flexible risers under torsion. The analytical model takes local bending and torsion of tensile armor wires into consideration, and equilibrium equations of forces and displacements of layers are deduced. The numerical model includes lay angle, cross-sectional profiles of carcass, pressure armor layer and contact between layers. Abaqus/Explicit quasi-static simulation and mass scaling are adopted to avoid convergence problem and excessive computation time caused by geometric and contact nonlinearities. Results show that local bending and torsion of helical strips may have great influence on torsional stiffness, but stress related to bending and torsion is negligible; the presentation of anti-friction tapes may have great influence both on torsional stiffness and stress; hysteresis of torsion-twist relationship under cyclic loading is obtained by numerical model, which cannot be predicted by analytical model because of the ignorance of friction between layers. 相似文献
12.
13.
Based on the open source code OpenFOAM,a three-dimensional model is presented for simulation of the interaction between waves and rubble mound breakwater with armor units.The armor units with their real geometries are depicted through computational grids.The volume-averaged RANS equation and the seepage equation containing nonlinear term are used to describe the percolation in the core and underlayer of the breakwater.Grids independence analysis are carried out,the horizontal and vertical grid size are recommended to take as one-fifteenth of the mean nominal diameter D50 of the armor units and one-fifteenth of the wave height respectively.Random wave overtopping of rubble mound breakwater with armor units is simulated through the proposed model.The results show good agreement between the simulated and measured overtopping discharge rates for different types of armor units.The developed numerical model can be used to evaluate the random wave overtopping in design of rubble mound breakwater with artificial armor blocs. 相似文献
14.
The hydrodynamic performance of the oscillating water column type shoreline-mounted wave-power device is numerically studied within linear wave theory by using a boundary element method based on the Wehausen and Laitone 3D shallow water Green's function. In order to verify the numerical model, a 1:12 physical model with different bottom slopes was constructed and tested in a wave basin under regular wave conditions. The effects of the bottom slope on the hydrodynamic performance are investigated by both analytical and experimental methods. 相似文献
15.
为确保2008北京奥运会青岛帆船比赛基地内工程的水工建筑物安全可靠，对给定的2种防波堤断面结构型式及护面块体稳定性进行物理模型试验。准确掌握在极端高水位、设计高水位、设计低水位和极端低水位时．SW向、25a和50a一遇波浪作用下，试验断面所承受的波浪作用力，及SE向50a一遇波浪作用下块体的稳定重量。并绘制各工况1％峰值波压力分布图，得出断面波压力的分布规律。对断面结构和护面块体稳定性进行分析。 相似文献
16.
Numerical Simulation of Local Scour Around A Large Circular Cylinder Under Wave Action 总被引：1，自引：0，他引：1
A horizontal two- dimensional numerical model is developed for estimation of sediment transport and sea bed change around a large circular cylinder under wave action. The wave model is based on an elliptic mild slope equation. The wave-induced current by the gradient of radiation stress is considered and a depth integrated shallow water equation is applied to the calculation of the current. The mass transport velocity and the bed shear stress due to streaming are considered, which are important factors affecting the sediment transport around a structure due to waves, especially in reflective areas. Wave-current interaction is taken into account in the model for computing the bed shear stress. The model is implemented by a finite element method. The results of this model are compared with those from other methods and agree well with experimental data. 相似文献
17.
This paper presents a numerical model for simulating wave interaction with porous structures. Incompressible smoothed particle hydrodynamics in porous media (ISPHP) method is introduced in this study as a mesh free particle approach that is capable of efficiently tracking the large deformation of free surfaces in a Lagrangian coordinate system. The developed model solves two porous and pure fluid flows simultaneously by means of one equation that is equivalent to the unsteady 2D Navier–Stokes (NS) equations for the flows outside the porous media and the extended Forchheimer equation for the flows inside the porous media. Interface boundary between pure fluid and porous media is effectively modeled by the SPH integration technique. A two-step semi-implicit scheme is also used to solve the fluid pressure satisfying the fluid incompressibility criterion.The developed ISPHP model is then validated via different experimental and numerical data. Fluid flow pattern through porous dam with different porosities is studied and regular wave attenuation over porous seabed is investigated. As a practical case, wave running up and overtopping on a caisson breakwater protected by a porous armor layer are modeled. The results show good agreements between numerical and laboratory data in terms of free surface displacement, overtopping rate and pressure distribution. Based on this study, ISPHP model is an efficient method for simulating the coastal applications with porous structures. 相似文献