共查询到20条相似文献，搜索用时 218 毫秒
1.
设计了一种用于采集中底层水样的海水石油类样品原位采水器。适用于分析水样中油类、生物类等指标。其主要特点是可以采集所需深度的水样,保持所采集水样的原位特征。与常见的采水器相比,该采水器采用"闭-开-闭"的采样瓶启闭模式,即把经过清洗处理的采样瓶装到采水器上,瓶口保持密封状态,下放到设定深度后,发出指令打开采样瓶瓶口,开始采水,采样瓶装满水样后,关闭采样瓶瓶口。闭-开-闭模式,保证了样品瓶采样前后始终处于密封状态,避免在采水器下放和提升过程中,采样瓶和采集的水样可能受到其他深度水体的污染和干扰。 相似文献
2.
3.
SJC6-15型CTD专用卡盖式采水器 总被引：4，自引：1，他引：4
概述了SJC6—15型CTD专用卡盖采水器的构造、特点及工作原理，重点对采水器瓶体材料、瓶体密封结构和瓶体各部件的连接技术进行了有益的探讨。 相似文献
4.
5.
6.
文章概述了用电磁方式控制采水器释放机构的可行性，介绍了释放机构的工作原理、结构和特点，给出了应用实例试验中的测量方法和结果。 相似文献
7.
本文阐述了 QCC10—2型和 QCC10—2A 型深层痕量金属分析采水器的研制过程,并介绍了任务的来源、方案的设计、选材及结构设计等诸方面采取的措施,同时简述了深层痕量金属分析采水器所进行的一系列试验。 相似文献
8.
9.
10.
11.
Silva A. Babb J. Lipkin J. Pietryka P. Butler D. 《Oceanic Engineering, IEEE Journal of》1985,10(1):23-31
The In Situ Vane (ISV) system has been developed to determine the strength profile within the upper 1.5 m of deep sea clays. The system is designed to operate in 6000-m water depth after one-year dormancy on the bottom and consists of four integrated packages; controller and data acquisition system, mechanical system, volume compensator, and power supply. This paper describes development of a prototype which was used under a pressure of 550 bars after a 30-day dormancy and of the full system which was successfully used in a deep water (5800 m) test. In the first full application of the system the ISV will be used to measure changes in sediment strength caused by high temperature (300deg C) as part of the U.S. Subseabed Disposal Program. 相似文献
12.
Taylor G.W. Burns J.R. Kammann S.A. Powers W.B. Welsh T.R. 《Oceanic Engineering, IEEE Journal of》2001,26(4):539-547
The Energy Harvesting Eel (Eel) is a new device that uses piezoelectric polymers to convert the mechanical flow energy, available in oceans and rivers, to electrical power. Eel generators make use of the regular trail of traveling vortices behind a bluff body to strain the piezoelectric elements; the resulting undulating motion resembles that of a natural eel swimming. Internal batteries are used to store the surplus energy generated by the Eel for later use by a small, unattended sensor or robot. Because of the properties of commercially available piezoelectric polymers, Eels will be relatively inexpensive and are easily scaleable in size and have the capacity to generate from milli-watts to many watts depending on system size and flow velocity of the local environment. A practical Eel structure has been developed that uses the commercially available piezoelectric polymer, PVDF. Future Eels may use more efficient electrostrictive polymer. Every aspect of the system from the interactions between the hydrodynamics of the water flow and structural elements of the Eel, through the mechanical energy input to the piezoelectric material, and finally the electric power output delivered through an optimized resonant circuit has been modeled and tested. The complete Eel system, complete with a generation and storage system, has been demonstrated in a wave tank. Future work on the Eel will focus on developing and then deploying a small, lightweight, one-watt power generation unit, initially in an estuary and then subsequently in the ocean. Such Eels will have the ability to recharge batteries or capacitors of a distributed robotic group, or remote sensor array, thus extending the mission life indefinitely in regions containing flowing water 相似文献
13.
The Soft Yoke Mooring System (SYMS) is a single point mooring system for shallow water. It is composed of a mooring framework, mooring legs, yoke, and single point, and is located at the Floating Production Storage and Offloading (FPSO) through 13 hinge joints, such as universal joints and thrust bearings. Mooring restoring force, motions and postures of mooring components, and mechanical behaviors of hinge joints are major criteria for the structural design of the SYMS. Aiming at the difficulties of the multibody dynamics in traditional design of the SYMS, a multi-body dynamic mathematical modeling with seven independent degrees of freedom (DOFs) which is applicable to prototype field engineering was developed in this study. The proposed mathematical modeling of the SYMS multibody dynamic system has several advantages: 1. Internal tribological behaviors in hinge joints are considered within the presented multibody dynamics model to illustrate the good dynamic effects of the SYMS. 2. The multibody dynamic model can be applied in field service. Correctness and feasibility of the proposed multibody dynamic simulation method for describing motions and postures of hinges and single-body were validated by the prototype monitoring data. 3. The horizontal restoring force of the SYMS was calculated according to field measurement data. The motion state of each single body and internal stress distributions at each hinge joint in the SYMS are given. 4. The multibody dynamics calculation program can be directly used for the real-time monitoring of mechanical behaviors of the SYMS under the service state. The simulated results can provide real-time guarantee for safety alarming of the system. The vulnerability of the mooring system in service was evaluated based on long-term monitoring data analysis. 相似文献
14.
Floating platform system has been extensively used in ocean exploitation, particularly for a tension-leg platform (TLP) system in deep water. Most of the TLPs are multi-mooring systems, where multi-joints are connected to the tension-legs so that the platform is not allowed to twist freely and may subject to enormous force induced by large incident waves in the weak-direction of the structure. This study aims to exploit a single moored offshore platform system that may attract less force and can be operated with less effort. In our analysis, in addition to mechanical properties of the tether, two important properties are also taken into consideration for the single mooring tether with expanded cross sectional dimension and utilization of stronger material, namely, the sag-extensibility and the flexural rigidity. Finally, the dynamic structural behavior produced by the mechanical effects on the new system is investigated and compared with that of traditional design while the wave-structure interactions of large body are also accounted for. Our study finds that the neglect of sag-extensibility or the flexural rigidity of large, strong mooring cable may result in a conservative but not necessarily safe design. 相似文献
15.
16.
Abyssal recipes II: energetics of tidal and wind mixing 总被引：11，自引：0，他引：11
Walter Munk Carl Wunsch 《Deep Sea Research Part I: Oceanographic Research Papers》1998,45(12):1977-2010
Without deep mixing, the ocean would turn, within a few thousand years, into a stagnant pool of cold salty water with equilibrium maintained locally by near-surface mixing and with very weak convectively driven surface-intensified circulation. (This result follows from Sandström’s theorem for a fluid heated and cooled at the surface.) In this context we revisit the 1966 “Abyssal Recipes”, which called for a diapycnal diffusivity of 10-4m2/s (1 cgs) to maintain the abyssal stratification against global upwelling associated with 25 Sverdrups of deep water formation. Subsequent microstructure measurements gave a pelagic diffusivity (away from topography) of 10-5 m2/s — a low value confirmed by dye release experiments.A new solution (without restriction to constant coefficients) leads to approximately the same values of global upwelling and diffusivity, but we reinterpret the computed diffusivity as a surrogate for a small number of concentrated sources of buoyancy flux (regions of intense mixing) from which the water masses (but not the turbulence) are exported into the ocean interior. Using the Levitus climatology we find that 2.1 TW (terawatts) are required to maintain the global abyssal density distribution against 30 Sverdrups of deep water formation.The winds and tides are the only possible source of mechanical energy to drive the interior mixing. Tidal dissipation is known from astronomy to equal 3.7 TW (2.50±0.05 TW from M2 alone), but nearly all of this has traditionally been allocated to dissipation in the turbulent bottom boundary layers of marginal seas. However, two recent TOPEX/POSEIDON altimetric estimates combined with dynamical models suggest that 0.6–0.9 TW may be available for abyssal mixing. A recent estimate of wind-driving suggests 1 TW of additional mixing power. All values are very uncertain.A surprising conclusion is that the equator-to-pole heat flux of 2000 TW associated with the meridional overturning circulation would not exist without the comparatively minute mechanical mixing sources. Coupled with the findings that mixing occurs at a few dominant sites, there is a host of questions concerning the maintenance of the present climate state, but also that of paleoclimates and their relation to detailed continental configurations, the history of the Earth–Moon system, and a possible great sensitivity to details of the wind system. 相似文献
17.
为了研究黄河口海床沉积物固结过程中电阻率同工程力学性质指标的对应关系,探索海床土体固结过程的新型原位监测技术,本文在黄河刁口流路三角洲叶瓣潮坪上,现场取土配置黄河口快速沉积形成的流体状沉积物和观测研究粉质土海床的固结过程。利用静力触探、十字板剪切试验、孔隙水压力监测等原位土工测试手段,实时测定固结过程中海床土强度变化和孔隙水压力消散过程;同时通过埋置自行研制的环形电极探杆,实时测定海床土固结过程中的电阻率变化。通过对比分析海床土电阻率与工程力学性质指标的同步测定数据发现:黄河口饱和粉土的电阻率与微型贯入试验测得的土体贯入强度,静力触探试验测得的比贯入阻力,十字板剪切试验测得的不排水抗剪强度(峰值强度、残余强度)均呈乘幂关系,且相关性良好;海床沉积物在固结过程中的电阻率与孔隙水压力呈负线性相关性。 相似文献
18.
Jingqiang Wang Baohua Liu Guangming Kan Zhiwen Sun Xiangmei Meng 《Marine Georesources & Geotechnology》2018,36(5):515-521
The mechanical structure, the function modules, the working principles, and a sea trial of the newly developed ballast in situ sediment acoustic measurement system are reported in this study. The system relies on its own weight to insert transducers into seafloor sediments and can accurately measure the penetration depth using a specially designed mechanism. The system comprises of an underwater position monitoring and working status judgment module and has two operation modes: self-contained measurement and real-time visualization. The designed maximum working water depth of the system is 3,000?m, and the maximum measured depth of seafloor sediment is 0.8?m. The system has one transmitting transducer with the transmitting frequency band of 20–35?kHz and three receiving transducers. The in situ acoustic measurement system was tested at 15 stations in the northern South China Sea, and repeated measurements in seawater demonstrated good working performance. Comparison with predictions from empirical equations indicated that the measured speed of sound and attenuation fell within the predicted range and that the in situ measured data were reliable. 相似文献
19.
Development and experiments of the Sea-Wing underwater glider 总被引：1，自引：0，他引：1
Underwater gliders,which glide through water columns by use of a pair of wings,are efficient long-distance,long-duration marine environment observatory platforms.The Sea-Wing underwater glider,developed by the Shenyang Institute of Automation,CAS,is designed for the application of deep-sea environment variables observation.The system components,the mechanical design,and the control system design of the Sea-Wing underwater glider are described in this paper.The pitch and roll adjusting models are derived based on the mechanical design,and the adjusting capabilities for the pitch and roll are analyzed according to the models.Field experiments have been carried out for validating the gliding motion and the ability of measuring ocean environment variables.Experimental results of the motion performances of the glider are presented. 相似文献
20.
人类活动对海洋生态系统影响的空间量化评价——以莱州湾海域为例 总被引：2，自引：0，他引：2
本文针对海域管理中难以量化人类活动对海洋生态系统影响的问题,提出人海关系空间量化模型,通过完善概念模型、构建指标体系、确定权重及标准,最终利用作用强度和位置关系量化人类活动对海洋生态系统的影响,数值在0—1之间,等分为四个影响程度,由弱到强依次为微弱、中等、强烈和极强,并将该模型和量化方法应用于莱州湾海域。研究结果表明:整个莱州湾受人类活动的综合影响均值为0.425,处于中等影响程度;其中污水排放、围填海工程及港口航运是对莱州湾生态系统影响比较强烈的人类活动;研究海域中40%受到人类活动的强烈影响,44%为中等影响,16%为微弱影响。空间量化分析显示,人类活动对莱州湾近岸海域的综合影响比邻近外海强烈,其中影响较强烈的区域出现在西南近岸海区,而影响较微弱的海区则为莱州湾北部外海。该方法空间量化结果与莱州湾实际情况相符,说明人海关系空间量化模型适合定量化评估人类活动对该海域生态系统的影响,可为"山东半岛蓝色经济区"海域管理提供技术支持。 相似文献