共查询到16条相似文献，搜索用时 562 毫秒
1.
L2C监测跟踪网信噪比SNR数据质量分析 总被引：2，自引：1，他引：1
本文从L2C监测跟踪网的数据出发,分析了其中六个监测站的信噪比(SNR)数据。首先分析了未调制L2C码卫星的L1载波和L2载波的信噪比,得出此时的L2的信噪比数值相对较小(L1载波的信噪比均值与L2的信噪比均值差异最大为19.1dB)且稳定性较差;随后分析了调制有L2C码的卫星的L1载波和L2载波的信噪比,得出现代化后的L2载波信噪比与L1载波的信噪比基本一致(两个信噪比之差基本上在5dB左右);进而得出结论:调制有L2C码的L2载波具有更好的数据稳定性和抗干扰能力,且具有易于捕获的特点。 相似文献
2.
GPS现代化后L2载波的定位精度研究 总被引：4，自引：0，他引：4
利用实际采集的数据,从信噪比和定位残差上分析了L2载波的数据质量,指出GPS现代化后,用L2C码恢复的L2载波信噪比明显提高,与L2载波信噪比接近,两者的差值仅在5 dBHz以内;用L2 C码恢复的L2载波比GPS现代化前的L2载波的信噪比更加稳定,不容易受卫星高度角的影响;同时利用L2 C码恢复的L2载波的定位残差比没有L2 C码的L2裁波小,定位精度明显提高. 相似文献
3.
4.
一种改进的GPS微弱信号捕获方法 总被引：1，自引：0，他引：1
介绍了GPSL1载波中C/A码的捕获算法,以快速傅立叶变换为基础,采用相关积分和非相关积分对较长的信号进行处理,实现对GPS微弱信号的捕获.为验证这一算法,利用一组在室内采集的GPS L1C/A码IF数据,采用一般的信号捕获方法和改进的信号捕获方法分别进行了处理.结果显示,采用改进的方法捕获到了较微弱的GPS信号,提高了接收机的灵敏度. 相似文献
5.
6.
分析了L2C码的主要作用,比较了GPS现代化后L2载波信噪比的变化特点,阐述了伪距观测值的噪声水平。 相似文献
7.
对搭载美国BlackJack接收机的CHAMP/GRACE-A/Jason-2卫星和搭载国产接收机的HY2A/ZY3/TH1卫星的星载GPS数据的伪距多路径误差与观测噪声进行了研究,重点分析了国产接收机伪距多路径误差的变化特性,并研究了多路径误差与观测噪声对星载GPS自主定轨的影响。结果表明:国产接收机的C/A码与P1码伪距观测精度要整体差于美国的BlackJack接收机,而P2码伪距观测精度要整体优于BlackJack接收机;国产接收机P1码伪距受多路径效应影响较大,其多路径误差随高度角减小存在单调递增的变化趋势,其中HY2A、ZY3与TH1卫星的多路径误差最大分别可达3.6 m、1.8 m与0.7 m;这种单调递增变化的多路径误差会导致星载GPS自主定轨位置结果在径向与切向产生系统性偏差。 相似文献
8.
本文分析了GPS现代化信号L5载波的结构及相对于非现代化信号的改进,比较了GPS L5载波和WAAS L5载波的区别;比较了2颗现代化卫星SVN49和SVN62播发的L5载波的信号结构及信噪比,结果表明:SVN49播发的L5载波演示信号的抗干扰能力较差,而SVN62播发的L5载波具有更强的抗干扰能力,满足设计规范要求。 相似文献
9.
10.
11.
介绍了L5载波的特点,分析了L5载波对GPS测量的影响,用实测数据分析了三频载波的信噪比及各个民用码的噪声水平。 相似文献
12.
Geometry-free undifferenced, single and double differenced analysis of single frequency GPS, EGNOS and GIOVE-A/B measurements 总被引：3，自引：1，他引：2
This paper demonstrates a geometry-free GNSS measurement analysis approach and presents results of single frequency GPS, EGNOS
and GIOVE short and zero baseline measurements. The purpose is to separate the different contributions to the measurement
noise of pseudo range code and carrier phase observations at the receiver. The influence of multipath on the different combinations
of observations is also determined. Quantitative results are presented for the thermal code and phase measurement noise and
for the correlation between the observations. Comparison of the results with theoretical approximations confirms the validity
of the used approach. Results from field measurements clearly show less thermal noise on the Galileo E1BC observations than
on the GPS L1C/A observations due to the new signal modulation. The feasibility of ambiguity resolution with a geometry-free
model is also discussed including the significant impact of multipath thereon. 相似文献
13.
As GPS is modernizing, there are currently fourteen satellites transmitting L2C civil code and seven satellites transmitting L5 signal. While the GPS observables are subject to several sources of errors, the ionosphere is one of the largest error sources affecting GPS signals. Small irregularities in the electrons density along the GPS radio signal propagation path cause ionospheric scintillation that is characterized by rapid fluctuations in the signal amplitude and phase. The ionospheric scintillation effects are stronger in equatorial and high-latitude geomagnetic latitude regions and occur mainly due to equatorial anomaly and solar storms. Several researchers have analyzed the L2C signal quality since becoming available in December, 2005. We analyze the performance of L2C using GPS data from stations in the equatorial region of Brazil, which is subject of weak, moderate and strong ionospheric scintillation conditions. The GPS data were collected by Septentrio PolaRxS–PRO receivers as part of the CIGALA/CALIBRA network. The analysis was performed as a function of scintillations indexes S4 and Phi60, lock time (time interval in seconds that the carrier phase is tracked continuously without cycle slips), multipath RMS and position variation of precise point positioning solutions. The analysis shows that L2C code solutions are less affected by multipath effects than that of P2 when data are collected under weak ionospheric scintillation effects. In terms of analysis of positions, the kinematic PPP results using L2C instead P2 codes show accuracy improvements up to 33 % in periods of weak or strong ionospheric scintillation. When combining phase and code collected under weak scintillation effects, the results by applying L2C against P2 provide improvement in accuracy up to 59 %. However, for data under strong scintillation effects, the use of L2C for PPP with code and phase does not provide improvements in the positioning accuracy. 相似文献
14.
An open source GPS multipath simulator in Matlab/Octave 总被引：2，自引：1，他引：1
Multipath is detrimental for both GPS positioning and timing applications. However, the benefits of GPS multipath for reflectometry have become increasingly clear for monitoring soil moisture, snow depth, and vegetation growth. In positioning applications, a simulator can support multipath mitigation efforts in terms of, e.g., site selection, antenna design, receiver performance assessment, and in relating different observations to a common parameterization. For reflectometry, in order to convert observed multipath parameters into useable environmental products, it is important to be able to explicitly link the GPS observables to known characteristics of the GPS receiver/antenna and the reflecting environment. Existing GPS multipath software simulators are generally not readily available for the general scientific community to use and/or modify. Here, a simulator has been implemented in Matlab/Octave and is made available as open source code. It can produce signal-to-noise ratio, carrier phase, and code pseudorange observables, based on L1 and L2 carrier frequencies and C/A, P(Y), and L2C modulations. It couples different surface and antenna types with due consideration for polarization and coherence. In addition to offering predefined material types (water, concrete, soil, etc.), it allows certain dimensional properties to be varied, such as soil moisture and snow density. 相似文献
15.
16.
通过载噪比(CNR)、数据完整率、伪距与载波相位观测值噪声和伪距多路径效应四个指标对北斗三号卫星导航系统(BDS-3)新频点B1C/B2a车载动态数据的特性进行了分析,测试了BDS-3新频点动态精密单点定位(PPP)的性能,并与其它全球卫星导航系统(GNSS)进行了对比. 试验结果表明,BDS-3新频点B2a平均CNR优于北斗卫星导航系统(BDS)其它频率,但略差于GPS L5;相较于其它GNSS,BDS数据完整率相对较高,其中BDS-3 B2a新频点数据完整率最高;BDS-3 B2b伪距观测值噪声最小,B1C和B2a伪距观测值噪声约为B2b信号的3倍,但不同频率相位观测值噪声处于同一量级;对于伪距多路径而言,BDS-3 B1C/B2a 信号略小于B2b 信号. 总体而言,GPS L5信号抑制多路径效应的能力最强. 在动态PPP性能方面,BDS-3 B1C/B2a双频组合动态PPP定位精度最优,其三维(3D)均方根(RMS)误差为0.439 m,相比BDS B1I/B3I、GPS L1/L2、GLONASS G1/G2和Galileo E1/E5a双频组合PPP,其精度改善率分别为49%、56%、81%和42%. 相似文献