共查询到19条相似文献，搜索用时 187 毫秒
1.
阶变折射率轴棱锥产生局域空心光束 总被引：5，自引：0，他引：5
提出利用折射率成阶跃性变化的轴棱锥产生局域空心光束(bottle beam).讨论了折射率沿径向成阶跃式减小或增加两种模型,从几何光学角度分析了它们产生bottle beam的原理,利用衍射积分理论数值模拟两种轴棱锥光传输的光场分布和不同距离处的二维光斑图,研究结果表明折射率沿径向阶跃减小的轴棱锥产生单个bottle beam,而折射率沿径向阶跃增加的轴棱锥产生具有周期再现的bottle beams.bottle beam在原子引导和囚禁、光学俘获及光镊等方面有广泛的应用, 因此本文的研究对bottle 相似文献
2.
非稳腔主动式直接获取纳秒近似无衍射贝塞尔绿光 总被引：1，自引：0，他引：1
通过对基于轴棱锥的贝塞尔谐振腔和贝塞尔-高斯谐振腔的研究,设计了一台腔内倍频Nd:YAG纳秒近似无衍射贝塞尔绿光激光器. 非稳激光器谐振腔由轴棱锥和凸面镜组成. 实验采用单灯脉冲抽运激光增益介质Nd:YAG晶体,倍频晶体选用KTP. 当抽运电压为350 V时,由主动式直接产生纳秒近似零阶贝塞尔绿光,其脉冲宽度为55.1 ns,波长为532 nm,线宽为0.8 nm,近似无衍射零阶贝塞尔绿光的中心光斑直径为192 μm. 利用Fresnel-Kirchhoff 衍射积分和Fox-Li迭代法,通过数值计算得出 相似文献
3.
4.
为掌握青岛奥帆基地重点海域海底水深数据、地形地貌及障碍物分布特征,采用多波束测深系统对该区海域进行了全覆盖、高效率的海底地形扫测,经过高精度的数据处理,编绘得到海底地形地貌图,并发现了可疑沉船、暗堤等海底障碍物的分布,保障了奥帆赛事的顺利进行. 相似文献
5.
几种鱼礁模型对真鲷诱集效果的研究 总被引：1，自引：0，他引：1
观察了真鲷(Pagrosomus major)对4种不同结构模型礁的行为反应,并对不同结构模型礁的诱集效果进行了比较,进而选择诱集效果最好的1种模型礁,研究该模型礁在不同光强下诱集效果的差异.实验结果表明:未投放礁时,真鲷在水槽中的分布无选择性,呈随机分布;而投礁后各种模型礁均能对真鲷产生诱集效果,真鲷在鱼礁标志区的分布率从6%提高到17.89%~21.50%,其中以表面积大且无孔的 D型模型礁的诱集效果最好;双模型礁投放后对真鲷的聚集率均在20%以上,其中表面积大且有孔的2个模型礁聚集率最大;随光强增强,真鲷的聚集率不断下降,研究发现这可能与真鲷的领域行为有很大关系. 相似文献
6.
7.
对不规则波对浪溅区结构物的冲击作用实验结果进行了谱分析研究。给出了不同试验组次的结构物底面所受波浪冲击压力的谱分析结果，得到了结构物底面所受波浪冲击压力的谱矩m0沿结构物底面的分布规律，讨论了入射波波要素和结构物底面距静水面的相对高度s/H1/3对作用于结构物底面的冲击压力谱矩m0,avg的影响，给出了平均冲击压力谱矩m0,svg.与统计分析的压力特征值Pc的关系。 相似文献
8.
针对UUV避碰声呐探测障碍物过程中自主选择分割阈值进行障碍物检测的问题,提出了基于分区自适应阈值的障碍物检测算法。首先将避碰声呐图像均匀分为相同大小的图像块,对每个图像块基于最大类间方差算法确定该区域障碍物图像分割的高低阈值,然后对检测到的障碍物进行形态学处理去除孤立噪声点,对目标区域进行连通性分析及内部空洞处理,最终得到完整的障碍物轮廓信息。通过湖试数据验证表明了该方法对声呐障碍物检测的有效性。 相似文献
9.
10.
11.
Measurements in the Levantine Sea with a seismic-type array [i.e., the high-frequency array (27 wavelengths at 348 Hz), the mid-frequency array (27 wavelengths at 175 Hz), and the low-frequency array (21 wavelengths at 58 Hz)] were found to have on average results within 1 dB of the theoretical signal gain. Observed signal gain degradations for peak-tracked and short integration times (1 min) had standard deviations from 2 to 3 dB and were caused by the combination of coherent multipaths, array shape, and array motion. The relative motion of source and receiver (5-8 kn) was an important cause of the average degradation at longer integration times (5 min). Equivalent plane wave beam noise levels were measured as a function of frequency, time, bearing, and aperture length. The beam noise level results show contributions from distant surface-ship-generated noise and natural environmental background noise. These results showed resolved distant shipping with median beam noise levels consistent with array noise gain 1-2 dB greater than the theoretical value for incoherent isotropic noise. The beam noise cumulative probability distribution function versus equivalent plane wave levels differed significantly from log-normality. Beam noise surfaces (beam noise levels versus time and bearing) show a higher density of ships for the high-frequency array when compared to the low-frequency array. Beam-to-beam cross correlations were found be sharply peaked and beam autocorrelation functions versus time showed zero crossing times on the order of 9-10 min. Significant space-time noise fade durations were observed at lower frequencies 相似文献
12.
《Coastal Engineering》2005,52(3):257-283
Vortex generation and evolution due to flow separation around a submerged rectangular obstacle under incoming cnoidal waves is investigated both experimentally and numerically. The Particle Image Velocimetry (PIV) technique is used in the measurement. Based on the PIV data, a characteristic velocity, phrased in terms of incoming wave height, phase speed, dimension of the obstacle, and a local Reynolds number are proposed to describe the intensity of vortex. The numerical model, which solves the two dimensional Reynolds Averaged Navier Stokes (RANS) equations, is used to further study the effects of wave period on the vortex intensity. Measurements for the mean and turbulent velocity fields further indicate that the time history of the intensity of fluid turbulence is closely related to that of the vortex intensity. 相似文献
13.
An array of elliptic ring radiators is proposed which generates a fan-type beam with controllable sidelobe levels. Such an array has applications in specialized acoustic systems such as sidescan sonars, sonars for fish finding and stock assessment, obstacle avoidance systems, and others. Two possible approaches to the design are presented. One approach utilizes a mapping which transforms a radiation pattern generated by a circular ring array to that of an elliptic ring array. This approach takes advantage of methodologies developed for the design of circular ring arrays. The other approach uses the concept of an equivalent linear array. This approach benefits from existing design techniques developed for linear arrays. It requires only simple matrix operations and does not involve any optimization. The design examples presented demonstrate that a fan-type beam with sidelobes suppressed to more than 40 dB in all possible directions is achievable 相似文献
14.
The bandwidth and the duration of incident pulsed beam are proved to play important roles in modifying the nonlinear image of amplitude-type scatterer. It is found that the initially positive chirp-type bandwidth can suppress the nonlinear image, while the negative one can enhance it, and that both effects are inversely proportional to the incident pulse duration. Numerical simulations further demonstrate that the location of nonlinear image is at the conjugate plane of the scatterer and that, for negatively pre-chirped pulsed beam, the nonlinear image peak intensity can be higher than that in the corresponding monochromatic case under certain conditions. Moreover the effect of group velocity dispersion on nonlinear image is found to be similar to that of chirp-type bandwidth. 相似文献
15.
Wave measurement based on light refraction 总被引：2，自引：0，他引：2
Some authors have developed a few methods of measuring wave slopes based on light refraction, including the measurement method via the distribution of light intensity or color under water. A new method based on light refraction is specified for the measurement of wave surface elevation in wave flume via imaging technology. A plane painted with black and white stripes is put on the flume floor as an indication plane, which can be arranged easily and cheaply. Compared with the previous methods, the present method is less sensitive to the noise and nonlinear effects of optical process, which can be taken as a digital method. The CCD camera is fixed above the flume with its optical axis arranged vertically to grab the images of stripes modulated by the wave surface. The modulated value can be calculated from the Hilbert transform, and then the wave surface elevation can be obtained. The algorithm and experimental procedure are specified in detail, and some experimental results are provided to show the validity of the present method. 相似文献
16.
Some authors have developed a few methods of measuring wave slopes based on light refraction, including the measurement method via the distribution of light intensity or color under water. A new method based on light refraction is specified for the measurement of wave surface elevation in wave flume via imaging technology. A plane painted with black and white stripes is put on the flume floor as an indication plane, which can be arranged easily and cheaply. Compared with the previous methods, the present method is less sensitive to the noise and nonlinear effects of optical process, which can be taken as a digital method. The CCD camera is fixed above the flume with its optical axis arranged vertically to grab the images of stripes modulated by the wave surface. The modulated value can be calculated from the Hilbert transform, and then the wave surface elevation can be obtained. The algorithm and experimental procedure are specified in detail, and some experimental results are provided to show the validity of the present method. 相似文献
17.
《Coastal Engineering》2001,44(1):13-36
Interactions between a solitary wave and a submerged rectangular obstacle are investigated both experimentally and numerically. The Particle Image Velocimetry (PIV) technique is used to measure the velocity field in the vicinity of the obstacle. The generation and evolution of vortices due to flow separation at the corners of the obstacle are recorded and analyzed. It is found that although the size of the vortex at the weatherside of the obstacle is smaller than that at the leeside, the turbulence intensity is, however, stronger. A numerical model, based on the Reynolds Averaged Navier–Stokes (RANS) equations with a k–ϵ turbulence model, is first verified with the measurements. Overall, the agreement between the numerical results and laboratory velocity measurements is good. Using the RANS model, a series of additional numerical experiments with different wave heights and different heights of the rectangular obstacle are then performed to test the importance of the energy dissipation due to the generation of vortices. The corresponding wave transmission coefficient, the wave reflection coefficient and the energy dissipation coefficient are calculated and compared with solutions based on the potential flow theory. As the height of the obstacle increases to D/h=0.7, the energy dissipation inside the vortices can reach nearly 15% of the incoming wave energy. 相似文献
18.
Masaaki Fukuda 《Journal of Oceanography》1974,30(2):67-76
The suspended matter in seawater near the bottom is distributed by the effects of sinking and diffusion. The author developed a method of estimation of the vertical eddy diffusivity near the sea bottom and the particle size distribution of bottom sediment, in the case of equilibrium state. This estimation was made by the comparison of measured and computed vertical distribution of beam attenuation. The parameters which were used for the computation were (1) median of the particle size distribution of bottom sediment, assuming that the particle size was a log-normal distribution, and (2) the proportional constant of vertical eddy diffusivity which was proportional to the height from the bottom.As the suspended matter in seawater contains particles of different sizes, the computation of the diffusion and beam attenuation was made for each particle size, and summarizing the results, the vertical distribution of beam attenuation coefficient was computed.In order to estimate the beam attenuation in high particle concentration, an equation by which the effect of overlapping of particle shadow in the light beam was eliminated, was used. 相似文献
19.
利用ADCP和LISST-100仪观测悬浮物浓度的研究 总被引：3，自引：0，他引：3
利用黄河口海床基声学多普勒流速剖面仪(ADCP)的周日观测资料对悬浮物浓度进行了反演,反演过程中综合考虑了球面扩散、声学近场的非球面扩散、海水和悬浮颗粒的吸收衰减以及其他因素对回声信号的影响,结果表明在粒径保持相对稳定的情况下,利用ADCP仪回声强度反演悬浮物浓度具有较高的精度.结合现场激光粒度仪(LISST-100)测得的粒径分布信息在反演过程中考虑了粒径修正,重点讨论了观测区域粒径变化对结果的影响,结果表明粒径的剧烈变化会降低体积后向散射强度与悬浮物浓度之间的相关性.大颗粒物质的存在使计算得到的悬浮物浓度偏高,粒径修正虽然在一定程度上消除了这种影响,但线性拟合的相关性并未提高. 相似文献