共查询到19条相似文献，搜索用时 109 毫秒
1.
2.
续航力与水平速度均是水下滑翔器的重要性能指标。采用单位重量滑翔器、单位水平速度所耗功率作为滑翔效率的评价指标，以一新型扁平型水下滑翔器为研究对象，利用 CFD 计算结合模型试验验证的方法获取了所需的流体动力系数，然后进行了滑翔运动分析及垂直面滑翔运动仿真计算，得到了最优滑翔运动参数。 建立的滑翔性能计算方法对扁平型水下滑翔器水动力性能设计及滑翔运动参数优化有着重要的应用价值。 相似文献
3.
对水下滑翔器的整体外形设计与水动力性能进行研究。在Slocum等几种典型水下滑翔器样机的基础上,对滑翔器的主体和附体进行一体化设计,得到阻力最小的新型水下滑翔器构型设计。利用CFD方法对水下滑翔器进行模拟仿真,通过分析对比五种主体构型,得到了比较合理的主体线型,然后用正交设计方法和曲线拟合法对附体进行了优选工作,最后得到了性能更优的整体载体外形。模拟仿真实验表明,滑翔器在8°左右攻角航行时,具有最大的升阻比;和Slocum等经典样机相比,新的载体具有更好的水动力性能。通过上述研究工作,也可以缩短水下滑翔器研制周期,降低设计成本,并为水下滑翔器的更优设计提供了有力的技术指导和参考。 相似文献
4.
5.
6.
7.
8.
9.
混合驱动自主潜航器融合了自主潜航器机动灵活和水下滑翔机续航能力强的优点,针对自身携带能源有限的问题,对在两种工作模式下如何实现最大航行距离进行了研究.从航行过程中的能源消耗入手,得出航行距离与速度、电子设备功率等的关系,通过理论分析和仿真手段得出最大续航能力的实现方法.在螺旋桨驱动模式下,当以经济航速航行时,可以达到最大航行距离;在浮力驱动模式下,当以最大滑翔效率航行时,水平方向上的滑翔距离最大,并且水平方向上的滑翔距离随着剖面深度的增大而增大,当剖面深度大到一定程度之后,最大滑翔距离趋于恒定.该研究方法可为类似水下航行器电源管理系统的能源分配提供参考,也可为航行器外形的设计和传感器的选型提供理论指导. 相似文献
10.
采用标准k-ε两方程涡粘性模型,压力的隐式算子分割算法(PISO)求解时均Reynolds方程(RANS),对三种新型无尾翼水下滑翔器的升阻比性能进行研究。先对滑翔器摩擦阻力的CFD模拟结果与理论计算结果进行对比分析,验证CFD模拟结果的合理性与可靠性;再对不同迎流速度、不同速度攻角下的试验工况进行数值模拟,分析不同试验工况下滑翔器的粘压阻力与升力,得到不同试验工况下滑翔器的升阻比性能。研究结果表明,新型无尾翼水下滑翔器在5°~15°攻角区间内具有良好的升阻比,小攻角下圆碟型和飞碟型滑翔器的升阻比性能优于椭圆型滑翔器,而大攻角下椭圆型滑翔器相对其它两种具有更佳的升阻比性能,为新型无尾翼水下滑翔器升阻比性能的研究提供一定的思路。 相似文献
11.
水下滑翔机可以高效地观测海水的温度、盐度和压强等海洋参数,但由于热滞后效应,盐度数据,特别是在温度梯度较大的温跃层,会出现一定程度的偏差。本研究选取了3种目前常用的盐度热滞后订正方法,对带泵的“海翼号”水下滑翔机,于2019年8月在中北太平洋所观测的盐度数据因热滞后效应引起的偏差进行订正处理,与船载911型温盐深测量仪(Instrument for Measuring Conductivity Temperature and Depth,CTD)观测盐度进行对比,在比较了3种方法对滑翔机盐度订正前后下降和上升剖面偏差的减少程度、订正后剖面与船载CTD观测剖面的偏差大小和下降上升温盐曲线(T-S曲线)的一致程度后,得出了水下滑翔机盐度订正的最优方法,即在订正电导池中实际温度的前提下,采用计算机图形分割方法,最小化滑翔机机载CTD测得的下降和上升两个剖面T-S曲线围成面积所确定的目标函数,来确定合适的热滞后修正振幅和时间常数,从而修正下降和上升两个剖面之间盐度偏差。 相似文献
12.
《中国海洋工程》2017,(1)
A hybrid underwater glider Petrel-II has been developed and field tested. It is equipped with an active buoyancy unit and a compact propeller unit. Its working modes have been expanded to buoyancy driven gliding and propeller driven level-flight, which can make the glider work in strong currents, as well as many other complicated ocean environments. Its maximal gliding speed reaches 1 knot and the propelling speed is up to 3 knots. In this paper, a 3D dynamic model of Petrel-II is derived using linear momentum and angular momentum equations. According to the dynamic model, the spiral motion in the underwater space is simulated for the gliding mode. Similarly the cycle motion on water surface and the depth-keeping motion underwater are simulated for the level-flight mode. These simulations are important to the performance analysis and parameter optimization for the Petrel-II underwater glider.The simulation results show a good agreement with field trials. 相似文献
13.
Motion Analysis and Trials of the Deep Sea Hybrid Underwater Glider Petrel-II 总被引：2，自引：0，他引：2 
下载免费PDF全文
下载免费PDF全文 A hybrid underwater glider Petrel-II has been developed and field tested. It is equipped with an active buoyancy unit and a compact propeller unit. Its working modes have been expanded to buoyancy driven gliding and propeller driven level-flight, which can make the glider work in strong currents, as well as many other complicated ocean environments. Its maximal gliding speed reaches 1 knot and the propelling speed is up to 3 knots. In this paper, a 3D dynamic model of Petrel-II is derived using linear momentum and angular momentum equations. According to the dynamic model, the spiral motion in the underwater space is simulated for the gliding mode. Similarly the cycle motion on water surface and the depth-keeping motion underwater are simulated for the level-flight mode. These simulations are important to the performance analysis and parameter optimization for the Petrel-II underwater glider. The simulation results show a good agreement with field trials. 相似文献
14.
Development and experiments of the Sea-Wing underwater glider 总被引：1，自引：0，他引：1
Underwater gliders,which glide through water columns by use of a pair of wings,are efficient long-distance,long-duration marine environment observatory platforms.The Sea-Wing underwater glider,developed by the Shenyang Institute of Automation,CAS,is designed for the application of deep-sea environment variables observation.The system components,the mechanical design,and the control system design of the Sea-Wing underwater glider are described in this paper.The pitch and roll adjusting models are derived based on the mechanical design,and the adjusting capabilities for the pitch and roll are analyzed according to the models.Field experiments have been carried out for validating the gliding motion and the ability of measuring ocean environment variables.Experimental results of the motion performances of the glider are presented. 相似文献
15.
Profiles observed by Sea-Wing underwater gliders are widely applied in scientific research. However, the quality control(QC) of these data has received little attention. The mismatch between the temperature probe and conductivity cell response times generates erroneous salinities, especially across a strong thermocline. A sensor drift may occur owing to biofouling and biocide leakage into the conductivity cell when a glider has operated for several months. It is therefore critical to design a mature real-time QC procedure and develop a toolbox for the QC of Sea-Wing glider data. On the basis of temperature and salinity profiles observed by several Sea-Wing gliders each installed with a Sea-Bird Glider Payload CTD sensor, a real-time QC method including a thermal lag correction, Argo-equivalent real-time QC tests, and a simple post-processing procedure is proposed. The method can also be adopted for Petrel gliders. 相似文献
16.
For Cconsideration ofing both the eccentric rotatable rigid body and the translational rigid body, the dynamic model of the underwater glider is derived. Dynamical behaviors are also studied based on the model and can be used as the guidance to underwater gliders design. Gibbs function of the underwater glider system is derived first, and then the nonlinear dynamic model is obtained by use of Apell Equations. The relationships between dynamical behaviors and design parameters are studied by solving the dynamic model. The spiral motion, swerving motion in three dimensions and the saw-tooth motion of the underwater glider in vertical plane are studied. Lake trials are carried out to validate the dynamic model. 相似文献
17.
水下滑翔机其通过集成生物、化学、物理传感器可以测量如温度、盐度、溶解氧等多种海洋基础水文要素,其利用卫星定位系统获得实际出水速度和理论出水模型获得理论出水速度之差可以计算深度平均流,。本文利用海翼水下滑翔机获得温盐场及卫星定位数据评估深度平均流,结果显示利用温盐场获得深度平均地转流与水下滑翔机获得深度平均流相关系数0.95,表明其流场的一致性,同时根据船载观测ADCP误差分析法估算深度平均流误差约为0.036 m/s。借助深度平均流可以估算绝对地转流,包括正压地转流和斜压地转流。在零动力面的假设下,我们选取了海翼号水下滑翔机在南海的一组实验对流量误差进行了评估。该实验为2019年1月3日-2月16日海翼号水下滑翔机自南向北穿越西沙群岛附近一个中尺度涡观测。观测结果表明,该中尺度涡为冷涡流核,在涡心以南,绝对地转流为东向流,最大流速约为0.48 m/s;涡心以北,绝对地转流为西向流,最大流速约为0.47 m/s,稍弱于南侧。受不均匀时空观测计划影响,本文未对流量做出估计。 相似文献
18.
For consideration of both the eccentric rotatable rigid body and the translational rigid body, the dynamic model of the underwater glider is derived. Dynamical behaviors are also studied based on the model and can be used as the guidance to underwater gliders design. Gibbs function of the underwater glider system is derived first, and then the nonlinear dynamic model is obtained by use of Appell equations. The relationships between dynamic behaviors and design parameters are studied by solving the dynamic m... 相似文献
19.
海洋湍流混合过程对大洋热盐环流具有重要调控作用,因此海洋湍流混合特征量如湍动能耗散率等物理量的定量刻画,主要通过现场湍流观测来实现。为满足长期连续海洋湍流混合观测资料的迫切需求及打破国外的技术封锁,自行研制了基于水下滑翔机的湍流观测仪。为了测试滑翔机在小尺度湍流观测方面的可行性,将一个携带有剪切探头的湍流仪安装在滑翔机本体上,并在千岛湖进行了一系列的实验。滑翔机平台的主要噪声来源于浮力调节机构中的油泵,油泵会在接近剖面的底端时开启。三轴加速度谱在30 Hz左右有明显的谱峰,说明滑翔机油泵的振动频率应该是在30 Hz左右,在其他频率点上振动较小。由剖面下潜过程(开泵)的波数谱可知,开泵时虽然对湍流观测有影响,但是振动频率在波数空间中处于无效观测谱一侧,由此说明平台的振动对剪切信号影响很小。剪切探头测得的耗散率在10-7 W/kg量级上,且都与Nasymth理论谱吻合良好,验证了滑翔机在小尺度湍流观测方面的可行性。 相似文献