共查询到20条相似文献，搜索用时 187 毫秒
1.
ＴｈｅｉｒｒｅｇｕｌａｒｂｒｏｋｅｎｗａｖｅｆｏｒｃｅｓｏｎｖｅｒｔｉｃａｌｗａｌｌＬｉＹｕｃｈｅｎｇ,ＬｉｕＤａｚｈｏｎｇ,ＱｉＧｕｉｐｉｎｇ,ＳｕＸｉａｏｊｕｎ（ＲｅｃｅｉｖｅｄＡｐｒｉｌ２１,１９９７,ａｃｃｅｐｔｅｄＪｕｌｙ２,１９９７）Ａｂ... 相似文献
2.
3.
通过系列模型试验，对透空水平板下波浪总上托力进行了研究，结果表明：平板下最大总上托力并不与最大冲击压强同步发生。为此，依据试验结果对波浪总上托力产生机理和影响因素进行详细分析，提出透空水平板波浪最大总上托力的计算公式，试验结果表明，该公式与实验值有着较好的一致性。 相似文献
4.
通过三维物理模型系列试验,对港珠澳大桥工程西人工岛、岛桥结合跨进行模拟。试验测量了不同波浪入射角度、波高、波周期以及梁底净高等影响因子下的岛桥结合跨箱梁所受的浮托力和水平力,分析了受力随波陡、相对梁底作用高度以及波浪入射角度的变化规律。研究表明,在一定条件下箱梁浮托力和水平力,随波陡的增大而减小,随梁底相对作用高度的增加而增大,波浪入射方向的影响主要表现为与箱梁沿波浪传播方向的有效长度相关。由于岛桥结合跨的特殊性,改进的Douglass公式并不适用于岛桥结合跨箱梁受力的计算。通过主要影响因子的量纲分析,建立针对岛桥结合跨箱梁浮托力和水平力的计算公式。研究成果可为今后同类工程以及数值模拟提供借鉴与参考。 相似文献
5.
透空式水平板波浪上托力计算方法 总被引：6，自引：2，他引：6
在透空式平板波浪上托力试验研究基础上，针对实际工程应用要求，提出相对简便的透空式平板下波浪局部上托力和最大总上托力计算方法，包括上托力大小、分布宽度和发生位置。对具体工程实例的计算结果表明，该方法与实验值有着较好的一致性。 相似文献
6.
通过正向与斜向波浪对半圆型防波堤(不开孔出水堤)的实验研究,给出了其水力特性及单位堤长所受的无因次水平波浪力、竖向波浪力和波浪浮托力随各主要影响因素的变化规律,特别指出了斜向波浪力可大于正向波浪力及水平波浪力中波谷作用大于波峰作用发生的条件。 相似文献
7.
透空式水平板波浪上托力冲击压强试验研究 总被引：7，自引：1，他引：7
首先对以往波浪作用下透空式平板上托力研究进行了回顾，在此基础上，通过系列模型试验，对波浪上托力产生的机理进行了详细的分析和论述，认为透空式平板下波浪上托力主要由一个迅速上升的冲击压强和一个缓慢变化的压强构成，其中冲击压强通常远大于缓变压强，起主导作用，影响其大小的最直接因素为几何因素(即波浪冲击角)、动力因素(包括波高、波速等)和空气垫层因素，由此通过对各影响因素的分析，得到最大冲击压强计算公式，大量试验资料表明，该公式与实验值有着较好的一致性。 相似文献
8.
The Wake II model for the determination of the hydrodynamic forces on marine pipelines is extended to include currents and waves. There are two main differences between the Wake II and the traditional model. First, in the Wake II model the velocity is modified to include the pipe's encounter with the wake flow when the velocity reverses. Second, the model uses time dependent drag and lift coefficients. The flow field is assumed to be the linear superposition of regular waves and uniform current and is treated as wave only but in two different phases. The model requires eight empirical parameters that are obtained from comparisons with field data for various Keulegan–Carpenter numbers and current to wave ratios. The effective velocity and the force predictions are compared with field data from Exxon Production Research Company and with the conventional model. The model gives satisfactory results and predicts lift forces that in shape, magnitude and phase relative to the velocity are in very close agreement with measured forces. For the horizontal forces the results are very accurate. A substantial improvement is obtained over the predictions with the conventional model. This work is applicable to the design of submarine pipelines laying on the sea bottom in water depths where waves or waves and currents contribute to the hydrodynamic forces. 相似文献
9.
斜坡上封闭式水平板波浪上托力分布试验研究 总被引：1，自引：1，他引：0
通过系列模型试验,对斜坡上尾部封闭式平板结构波浪上托力沿板宽分布进行了详细分析,提出板下最大冲击压强和最大总上托力并不一定同时出现,其分布形态可分为局部冲击型和均匀型。由于封闭空气层和底部斜坡影响,较大总上托力形成机理不尽一致,其均匀分布宽度也不相同,可分为气压型和反射型两类,由此提出分类标准,并分别得到压强分布的计算公式。 相似文献
10.
Corresponding to the sliding and the overturning failure, the elementary motion modes of caisson breakwater include the horizontal-rotational oscillation coupled motion, the horizontal sliding-rotational oscillation coupled motion, the horizontal vibrating-uplift rocking coupled motion, and the horizontal sliding- uplift rocking coupled motion. The motion mode of a caisson will transform from one to another depending on the wave forces and the motion behaviors of the caisson. The numerical models of four motion modes of caisson are developed, and the numerical simulation procedure for joint motion process of various modes of caisson breakwater under wave excitation is presented and tested by a physical model experiment. It is concluded that the simulation procedure is reliable and can be applied to the dynamic stability analysis of caisson breakwaters. 相似文献
11.
Adrian W. K. Law 《Ocean Engineering》1999,26(11):301
In this study, the surface drift of an inextensible film due to a series of progressive gravity waves is investigated both analytically and experimentally. A second approximation of the conformal mapping that transforms the progressive sinusoidal surface to the horizontal axis is applied, thus allowing the analysis to formally accommodate a boundary layer thickness that is much less than the wave height. By computing the stream function to the third order that is an order higher than the past analysis, a pressure component in phase with the wave slope is revealed. The pressure force generated is comparable to the bottom shear on the thin film induced by the moving fluid and thus cannot be ignored. Based on the combined forces on the surface firm, a mean drift is estimated by assuming that the opposing force is due to the viscous drag induced by the drift motion. The experimental results show that the computed drift velocity based on the present study mostly underestimates the experimental observations, but it is in closer agreement than the classical Phillips' 7/4 estimate. 相似文献
12.
1 .IntroductionTraditionally ,thedesignofcoastalstructuresisbasedontheformulaedevelopedforhead onuni directionalwaves .However,wavesusuallyattackabreakwaterobliquely ,formingshort crestedwavesinfrontofthebreakwater.Ontheotherhand ,asthehumanactivityareaisspreading ,thewaterdepthattheconstructionsiteforbreakwatershasatendencytobecomelarge ,andsomebreakwatershavebeenconstructedinwaterareasdeeperthan 6 0minJapan (Tanimotoetal.,1 988) .Theseawaveismulti directionalandrandom ,especiallyindeepwater… 相似文献
13.
基于物理模型试验,考虑畸形波参数、相对板宽、相对波高等影响因素,就畸形波对平顶双层水平板防波堤作用进行研究。首先对畸形波作用下双层水平板的波浪力分布特征进行了讨论,然后就最大波动压强、结构最大总垂向力与不规则波作用进行了对比分析。结果表明,畸形波作用下,双层水平板最大波动压力出现在前端迎浪区域附近,向尾端逐渐递减。双层水平板4个受力面的压力分布不同且有相位差,4个受力面的最大波动压力时间差约在0.1Tp~0.4Tp范围内变化。与不规则波作用比较,畸形波作用没有显著改变波压包络分布特征,但增大了波压包络强度值。试验范围内,就最大总力而言,两者最大总浮托力比值在1.06~2.45间变化;向下的最大总垂向力比值在1.22~2.07之间变化;就波动压力而言,其增大的幅度与畸形波参数α1相关性最强,随α1的增大而增大,在α1=2.04~3.1试验范围内,畸形波作用时的最大压强比不规则波作用时可约增大20%~80%。就最大波吸力而言,两者的比值与畸形波参数α4相关性最强,随α4的增大而减小。在α4=0.62~0.75试验范围内,最大波吸力强度的比值在1.61~0.87范围内变化。当α4≤0.72时,畸形波作用时的最大波吸力大于不规则波作用时的最大波吸力;当α4 > 0.72时则刚好相反。 相似文献
14.
《中国海洋工程》2021,(4)
Wave forces on two side-by-side boxes in close proximity under wave actions were analyzed using the OpenFOAM package. The upstream box heaved freely under wave actions, whereas the downstream box remained fixed. For comparison, a configuration in which both boxes were fixed was also considered. The effects of the heave motion of the upstream box on the wave loads, including the horizontal wave forces, vertical wave forces, and moments on the boxes, were the focus of this study. Numerical analyses showed that all frequencies at which the maximum horizontal wave forces, maximum vertical wave forces, and maximum moment appeared are dependent on the heave motion of the upstream box and that the effects of the heave motion on these frequencies are different. Furthermore,these frequencies were observed to deviate from the corresponding fluid resonant frequency. Moreover, the heave motion of the upstream box reduced the wave forces acting on both boxes and altered the variation trends of the wave forces with the incident wave frequency. 相似文献
15.
Uplift Pressure of Waves on A Horizontal Plate 总被引：4，自引：0，他引：4
1 .IntroductionOwingtotheneedfordevelopingoffshoreresources,moreandmorehollow trussedstructuresareconstructed ,suchasalongshorequays ,islandquays,artificialislands ,bollards ,maritimeplatforms ,etc .Thelargeentitypartofthosemaritimestructuresusuallyconsistsofahorizontalplateabovethestillwaterlevel,anditusuallysuffersfromwaveattacksandthuscaneasilybedestroyed .Toavoidsuchakindofaccidents ,themostimportantistoaccuratelyevaluatetheupliftpressuresofwavesontheplateundervariouswaveconditionsandbound… 相似文献
16.
17.
This paper is concerned with the determination of dynamic load variations in the riser and yoke pivot components of an offshore vessel/mooring oil production and storage system.Forces on the yoke system arise from wave induced inertial and drag forces including current and motion due to vessel surge, heave and pitch.The analysis is carried out in the frequency domain and the results yield the limiting wave height for a specific design of SALS which will give rise to loss of tension in the riser. Also presented are the maximum horizontal and vertical components of load variation at the yoke pivoted connections with the vessel. 相似文献
18.
This study examines the hydrodynamic performance of a modified two-layer horizontal-plate breakwater. The breakwater consists of an upper submerged horizontal porous plate and a lower submerged horizontal solid plate. By means of the matched eigenfunction expansion method, a linear analytical solution is developed for the interaction of water waves with the structure. Then the reflection coefficient, the transmission coefficient, the energy-loss coefficient and the wave forces acting on the plates are calculated. The numerical results obtained for limiting cases are exactly the same as previous predictions for a single submerged horizontal solid plate and a single submerged horizontal porous plate. Numerical results show that with a suitable geometrical porosity of the upper plate, the uplift wave forces on both plates can be controlled at a low level. Numerical results also show that the transmission coefficient will be always small if the dimensionless plate length (plate length versus incident wavelength) exceeds a certain moderate value. This is rather significant for practical engineering, as the incident wavelength varies over a wide range in practice. Moreover, it is found that the hydrodynamic performance of the present structure may be further enhanced if the lower plate is also perforated. 相似文献
19.