共查询到10条相似文献，搜索用时 109 毫秒
1.
In offshore engineering, pile foundations are commonly constructed in marine deposits to support various structures such as offshore platforms. These piles are subjected to lateral cyclic loading due to wind, wave action, and drag load from ships. In this paper, centrifuge model tests are conducted to investigate the response of the existing single piles due to lateral cyclic loading. The cyclic loading was simulated by a hydraulic actuator. It is found that the residual lateral movement and bending strain are induced in the existing pile after each loading–unloading cycle. This is because plastic deformation is induced in the soil surrounding the existing pile during each loading–unloading cycle. By increasing the applied loads during cyclic loading–unloading process, the lateral movements and bending strains induced in the pile head increase simultaneously. As the cyclic loading varies from 10 to 50 kN, the residual pile head movement increases from 40 to 154?mm, and the residual bending strain of the existing pile varies from 100 to 260 με. The ratio of residual to the maximum pile head movements varies from 0.17 to 0.22, while the ratio of residual to the maximum bending strains is in a range of 0.12–0.55. 相似文献
2.
In the field of ocean engineering, pile foundations are extensively used in supporting several structures. In many cases, piles are subjected to significant lateral loads. The environment prevalent in the ocean necessitates the piles to be designed for cyclic wave loading. In this investigation, the behaviour of rigid piles under cyclic lateral loading has been studied through an experimental programme carried out on model piles embedded in a soft marine clay. Static tests were also conducted on piles embedded in a clay bed prepared at different consistencies suitable to field situations. Cyclic load was applied by using a specially designed pneumatic controlled loading system. Tests were conducted on model piles made of mild steel (MS), aluminium and PVC with wide variation in pile soil relative stiffness. For cyclic load levels less than 50% of static lateral capacity, the deflections are observed to increase with number of cycles and cyclic load level and stabilise after a certain number of cycles. For cyclic load levels greater than 50% of static lateral capacity, the deflections are observed to increase enormously with number of cycles. The results of post-cyclic load tests indicate that the behaviour under static load can improve for cyclic load levels less than 40% of the static lateral capacity. The variations in the load capacity due to cyclic loading are explained in terms of the changes in strength behaviour of soil. 相似文献
3.
AbstractPile foundation is the most popular option for the foundation of offshore wind turbines. The degradation of stiffness and bearing capacity of pile foundation induced by cyclic loading will be harmful for structure safety. In this article, a modified undrained elastic–plastic model considering the cyclic degradation of clay soil is proposed, and a simplified calculation method (SCM) based on shear displacement method is presented to calculate the axial degradated capacity of a single pile foundation for offshore wind turbines resisting cyclic loadings. The conception of plastic zone thickness Rp is introduced to obtain the function between accumulated plastic strain and displacement of soil around pile side. The axial ultimate capacity of single piles under axial cyclic loading calculated by this simplified analysis have a good consistency with the results from the finite element analysis, which verifies the accuracy and reliability of this method. As an instance, the behavior of pile foundation of an offshore wind farm under cyclic load is studied using the proposed numerical method and SCM. This simplified method may provide valuable reference for engineering design. 相似文献
4.
Jiunn-Shyang Chiou Zhi-Wei Xu Cheng-Chang Tsai Jin-Hung Hwang 《Marine Georesources & Geotechnology》2018,36(5):554-563
Lateral cyclic load tests were performed on an aluminum model pile in dry sand. Two levels of loading were adopted to represent different service load conditions. The maximum number of loading cycles was 1,000. From the test results, it was found that the even though in the service load condition, the pile response was still affected by cyclic effects and a larger load level would produce more significant influence. In a global point of view, the lateral displacement and maximum moment increased with loading cycles, while the secant stiffness within a cycle decreased with cycles. The cyclic effect was more significant on the lateral displacement than on the moment. In a local point of view, cyclic loading would degrade the equivalent subgrade stiffness for the soil shallower than about seven times diameter. In addition, the secant subgrade stiffness within a cycle increased with loading cycles. Some experimental relationships of lateral pile response and loading cycles were built and compared with those in the literature. 相似文献
5.
Sudip Basack 《Marine Georesources & Geotechnology》2013,31(4):356-360
Pile foundations subjected to cyclic load is an age-old problem dealt with for decades by geotechnical engineers. The ocean environment necessitates the piles supporting offshore structures to be designed against lateral cyclic loading initiated by wave action. Substantial experimental and analytical investigations have already been conducted by the author and other researchers. The quasi-static load reversal induces deterioration in the strength and stiffness of the soil-pile system introducing progressive reduction in the bearing capacity as well as settlement of the pile foundation, the degree of such degradation has been observed to be a function of the cyclic load parameters and the type of soil. Based on these observations, a design recommendation has been attempted in this paper for piles subjected to cyclic load in cohesive soil. 相似文献
6.
海上风电工程主要受到风、波浪及洋流等产生的水平循环荷载作用，本文研究楔形单桩基础在水平循环荷载作用下的变形规律，并探讨不同循环荷载对变形规律产生的影响，以确保风电设施正常运行。通过数值模拟建立海上风电单桩-海床模型，考虑土体超孔隙水压力的演变规律及土体致密规律，土体采用UBC3D-PLM本构模型。本文重点讨论并分析在不同水平循环荷载作用下楔形单桩基础与等截面单桩基础的桩周土体位移、塑性应变及桩基累计转角位移之间的差异。研究结果表明：楔形结构会降低桩周土体位移及塑性应变，使得楔形单桩基础旋转中心位置更低，产生倾覆的可能更小，当循环荷载比为0.7时，累计转角位移能减少41.86%；循环荷载越大，楔形单桩基础水平受荷特性越好，累计位移减少量的增长率越高。研究成果可为今后海上风电基础的选择与设计提供参考。 相似文献
7.
Behavior of Pile Groups under Lateral Load 总被引：2，自引：0，他引：2
Yang Keji Li Qixin Wang Fuyuan
Associate Proferssor Hehai University Nanjing Engineer Hehai University Nanjing 《中国海洋工程》1991,(2)
Based on investigation and model tests, and in combination with the research work on group effect for pile groups under lateral loads relating to the code of fixed offshore platforms, a series of studies have been performed on the behavior and failure mechanism of laterally loaded pile groups, critical pile spacing inducing group effect, lateral bearing capacity of pile groups and its main influence factors, the stress-strain relationship for single piles and pile groups and so on. Some new laws about non-uniformity of load distribution in the longitudinal direction of pile groups and load-deflection (p - y) curves for pile groups have been discovered, and an empirical formula is presented in order to remedy the defect of current calculating methods at home and abroad. These results can be used for reference in the design of pile foundation under lateral loads. 相似文献
8.
AbstractIn this article, the degradation of the lateral bearing capacity of piles in soft clay subjected to cyclic lateral loading is studied numerically. A modified kinematic hardening constitutive model is employed to simulate the degradation of soft clay after cyclic loading. The modified model is verified by comparing the numerical simulation results with the results of centrifuge model tests. Furthermore, the modified model is applied to numerical simulations for evaluating the lateral bearing capacity of piles in soft clay subjected to cyclic lateral loading. The degradation of the lateral bearing capacity of piles in soft clay after different cyclic displacement levels and different numbers of cycles is investigated. The study reveals that the modified kinematic hardening constitutive model can effectively estimate the cyclic degradation behavior of piles in soft clay subjected to cyclic lateral loading. The degradation of the ultimate lateral bearing capacity progresses slowly with increasing cyclic displacement level for fewer cycles, and the degradation develops significantly at higher levels of cyclic displacement after applying a larger number of cycles. 相似文献
9.
A fundamental study of pile–soil systems subjected to lateral loads in offshore deposit was conducted using experimental tests and numerical analysis. The emphasis was on the soil–pile rigidity of a laterally loaded pile in marine clay. Rigid- and flexible-pile analyses were conducted for comparison. A framework for determining the lateral load transfer curve (p–y curves) is proposed based on both field and laboratory model tests. A numerical analysis that takes into account the proposed p–y curves was performed for the pile flexibility parameters such as pile diameter, pile length, pile-bending stiffness, and the modulus of subgrade reaction. Based on the analysis, it is shown that the differences in bending moment and lateral displacement are more significant for flexible piles rather than rigid piles. It was found that the p–y curves influence the behavior of flexible piles more than rigid piles, thus the magnitude and distribution of the p–y curves are significantly important in flexible pile design. 相似文献
10.
Various offshore structures, especially large structures such as Tension Leg Platforms (TLP), are usually supported by concrete piles as the foundation elements. The stress distribution within such a large structure is a dominant factor in the design procedure of an offshore pile. To provide a more accurate and effective design for offshore foundation systems under axial and lateral wave loads, a finite element model is employed herein to determine the stresses and displacements in a concrete pile under similar loading conditions. A parametric study is also performed to examine the effects of the stress distribution due to the changing loading conditions. 相似文献