基于ARP协议的网络主机地址的识别技术研究   总被引：3，自引：0，他引：3  

杨漫  周安民  方勇 《成都信息工程学院学报》2006,21(2):186-189

从移动IPv6工作原理入手，IP地址管理器是针对越来越严重的IP地址盗用现象而设计的一套有效的监控和管理IP地址的方案。分析与研究IP地址管理器中的信息收集模块后，以Winpcap为开发工具，利用ARP，附等协议完成对网络中活动主机的扫描以及信息（主机名、MAC、操作系统）的收集和识别。模块实现了对网络的自动实时监控，有效地提高了管理效率。  相似文献   

Study of a model for correcting the effects of horizontal advection on surface fluxes measurement based on remote sensing     

Tian  Jing  Zhang  Renhua  Sun  Xiaomin  Zhu  Zhilin  Zhou  Yanlian 《中国科学:地球科学(英文版)》2006,49(2):273-280

As well known, the methods of remote sensing and Bowen Ratio for retrieving surface flux are based on energy balance closure; however, in most cases, surface energy observed in experiment is lack of closure. There are two main causes for this: one is from the errors of the observation devices and the differences of their observational scale; the other lies in the effect of horizontal advection on the surface flux measurement. Therefore, it is very important to estimate the effects of horizontal advection quantitatively. Based on the local advection theory and the surface experiment, a model has been proposed for correcting the effect of horizontal advection on surface flux measurement, in which the relationship between the fetch of the measurement and pixel size for remote sensed data was considered. By means of numerical simulations, the sensitivities of the main parameters in the model and the scaling problems of horizontal advection were analyzed. At last, by using the observational data acquired in agricultural field with relatively homogeneous surface, the model was validated.

  相似文献   

CPLD技术及其在现代时统中的应用     

杨蕾  胡永辉 《时间频率学报》2003,26(1):40-47

对CPLD(复杂可编程逻辑器件)技术的基本特征和发展趋势作了简要介绍,揭示了该技术在现代数字系统中的重要地位及作用.利用CPLD对时统设备IRIG-B码产生器进行集成,其实验结果表明,集成了的B码产生器不但简单、可靠,而且便于调试,克服了以往硬件电路复杂的缺点.  相似文献   

CCD联合平差方法及其初步实例检验     

YU Yong LI Jinling TANG Zhenghong WANG Guangli ZHAO Ming 《中国科学院上海天文台年刊》2003,(1)

在常规照相天体测量工作中 ,对暗天体的定位是采用逐级定标星过渡的方法实现的。由于星表系统差和局部差的存在 ,最终定位结果可能包含难以把握的误差积累。在CCD小视场观测情况下时常难以找到足够数量的定标星。鉴于此 ,推导了CCD观测联合平差方法的严格矢量表达式 ,以期通过共同星的过渡 ,实现大天区统一平差。原理上此方法可实现相对于河外天体的定位 ,以削弱星表系统差和局部差对定位结果的影响。讨论了CCD联合平差方法实现中的问题 ,包括底片常数模型选择、切点位置改正、共同星的较差改正和法方程解算方法等 ,并分析了具体的处理措施。用实例初步检验了CCD联合平差方法的效果 ,表明通过对多张CCD观测的联合平差 ,可以削弱单张CCD观测参考星数目过少、单张CCD观测参考星分布不均、个别参考星存在位置偏差和局部区域参考星存在系统性位置偏差等不利因素对归算结果的影响 ,进而达到扩大视场和提高归算精度的目的  相似文献   

Effect of spatial variation characteristics on contouring of design storm depth     

Ke‐Sheng Cheng  Chiang Wei  Yen‐Ben Cheng  Hui‐Chung Yeh 《水文研究》2003,17(9):1755-1769

The ordinary kriging method, a geostatistical interpolation technique, was applied for developing contour maps of design storm depth in northern Taiwan using intensity–duration–frequency (IDF) data. Results of variogram modelling on design storm depths indicate that the design storms can be categorized into two distinct storm types: (i) storms of short duration and high spatial variation and (ii) storms of long duration and less spatial variation. For storms of the first category, the influence range of rainfall depth decreases when the recurrence interval increases, owing to the increasing degree of their spatial independence. However, for storms of the second category, the influence range of rainfall depth does not change significantly and has an average of approximately 72 km. For very extreme events, such as events of short duration and long recurrence interval, we do not recommend usage of the established design storm contours, because most of the interstation distances exceed the influence ranges. Our study concludes that the influence range of the design storm depth is dependent on the design duration and recurrence interval and is a key factor in developing design storm contours. Copyright © 2003 John Wiley & Sons, Ltd.  相似文献   

Elastic solutions for stresses in a transversely isotropic half‐space subjected to three‐dimensional buried parabolic rectangular loads     

Cheng‐Der Wang  Jyh‐Jong Liao 《国际地质力学数值与分析法杂志》2002,26(14):1449-1476

In many areas of engineering practice, applied loads are not uniformly distributed but often concentrated towards the centre of a foundation. Thus, loads are more realistically depicted as distributed as linearly varying or as parabola of revolution. Solutions for stresses in a transversely isotropic half‐space caused by concave and convex parabolic loads that act on a rectangle have not been derived. This work proposes analytical solutions for stresses in a transversely isotropic half‐space, induced by three‐dimensional, buried, linearly varying/uniform/parabolic rectangular loads. Load types include an upwardly and a downwardly linearly varying load, a uniform load, a concave and a convex parabolic load, all distributed over a rectangular area. These solutions are obtained by integrating the point load solutions in a Cartesian co‐ordinate system for a transversely isotropic half‐space. The buried depth, the dimensions of the loaded area, the type and degree of material anisotropy and the loading type for transversely isotropic half‐spaces influence the proposed solutions. An illustrative example is presented to elucidate the effect of the dimensions of the loaded area, the type and degree of rock anisotropy, and the type of loading on the vertical stress in the isotropic/transversely isotropic rocks subjected to a linearly varying/uniform/parabolic rectangular load. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

The influence of a non‐associated flow rule on the calculation of the factor of safety of soil slopes     

Yu‐Jie Wang  Jian‐Hua Yin  C. F. Lee 《国际地质力学数值与分析法杂志》2001,25(13):1351-1359

This paper presents a method that incorporates a non‐associated flow rule into the limit analysis to investigate the influence of the dilatancy angle on the factor of safety for the slope stability analysis. The proposed method retain's the advantage of the upper bound method, which is simple and has no stress involvement in the calculation of the energy dissipation and the factor of safety. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

Abundance and isotopic composition of noble gases in metal and graphite of the Bohumilitz IAB iron meteorite     

Teruyuki MARUOKA  Jun‐ichi MATSUDA  Gero KURAT 《Meteoritics & planetary science》2001,36(5):597-609

Abstract— Abundances and isotopic compositions of noble gases in metal and graphite of the Bohumilitz IAB iron meteorite were measured. The abundance ratios of spallogenic components in metal reveal a ³He deficiency which is due to the diffusive loss of parent isotopes, that is, tritium (Tilles, 1963; Schultz, 1967). The diffusive loss likely has been induced by thermal heating by the Sun during cosmic‐ray exposure (～160 Ma; Lavielle et al, 1999). Thermal process such as impact‐induced partial loss may have affected the isotopic composition of spallogenic Ne. The ¹²⁹Xe/¹³¹Xe ratio of cosmogenic components in the metal indicates an enhanced production of epi‐thermal neutrons. The abundance ratios of spallogenic components in the graphite reveal that it contained small amounts of metal and silicates. The isotopic composition of heavy noble gases in graphite itself was obtained from graphite treated with HF/HCl. The isotopic composition of the etched graphite shows that it contains two types of primordial Xe (i.e., Q‐Xe and El Taco Xe). The isotopic heterogeneity preserved in the Bohumilitz graphite indicates that the Bohumilitz graphite did not experience any high‐temperature event and, consequently, must have been emplaced into the metal at subsolidus temperatures. This situation is incompatible with an igneous model as well as the impact melting models for the IAB‐IIICD iron meteorites as proposed by Choi et al. (1995) and Wasson et al (1980).  相似文献   

Radar observations of Itokawa in 2004 and improved shape estimation     

Steven J. Ostro  Lance A. M. Benner  Christopher Magri  Jon D. Giorgini  Randy Rose  Raymond F. Jurgens  Donald K. Yeomans  Alice A. Hine  Michael C. Nolan  Daniel J. Scheeres  Stephen B. Broschart  Mikko Kaasalainen  Jean‐Luc Margot 《Meteoritics & planetary science》2005,40(11):1563-1574

Abstract— We present June 2004 radar images of asteroid 25143 Itokawa (1998 SF36) that improve upon the longitude‐latitude coverage of images obtained in 2001 by Ostro et al. (2004) and use the 2001–2004 data to refine that paper's constraints on Itokawa's shape. The 2004 images, the first of the asteroid's southern side, look distinctly different from the 2001 images, revealing leading edges that are much more curved and rugged than the nearly convex leading edges seen at northern latitudes in 2001. Itokawa is shaped like a slightly asymmetrical, bent, lumpy ellipsoid with dimensions along the principal axes within 10% of 594 times 320 times 288 m. To illustrate the uncertainty space associated with shape reconstruction from images with suboptimal orientational coverage, we present two alternative three‐dimensional models of the object.  相似文献   

企鹅珍珠贝人工苗生长的初步观察   总被引：3，自引：0，他引：3  

梁飞龙  毛勇  余祥勇 《广东海洋大学学报》2001,21(1):6-9

为了解企鹅珍珠贝生长规律，观察了壳高2.5～5.0mm的出池幼苗，按月测量其生长参数和成活率，以及环境因子。结果表明，企鹅珍珠贝生长最快的月份为7～11月和次年4～6月，壳长，壳高和壳宽月均增加量分别为3.8～13.0mm、4.7～11.2mm、2.3～3.8mm，月成活率97.8%～98.6%。企鹅珍珠贝生长最慢月份是11月至次年3月。  相似文献