Based on the idea of disturbing the water motion in the upright direction, a new kind of multiple-layer breakwater is proposed in this article, which mainly consists of several horizontal plates. The breakwater's performance of dissipating waves has been investigated in detail in the regular wave tests. The factors identified with the characteristics of the breakwater are discussed, such as the relative width, the wave steepness and the models geometrical parameters (the width and the gap). The comparison and analysis of the transmission and reflection coefficients with respect to different factors are presented. The model test results indicate that the multiple-layer breakwater has the good characteristic of dissipating waves. Further more, only in a little extent can it reflect the waves. The multiple-layer breakwater proposed in the paper is very significative to promote the open type breakwater to be the permanent wave attenuator in the application. 相似文献
The numerical wave channel has been developed based on the volume of fluid method (VOF) in conjunction with the Navier-Stokes equations. The absorbing wave-maker boundary on the left side of the channel is presented by prescribing velocity reference to linear wave-maker theory. The principle of which is that the numerical wave-maker is designed to move in a way that generates the required incident wave and cancels out any reflected wave that reach it at the same time. On the right side of the channel, the open boundary is set to permit incident waves to be transmitted freely. The parametric studies have been carried out at a range of ratios of water depth to wave length d/ L from 0.124 to 0.219, with wave height in the front of paddle/water depth ratio (H0 / d) from 0.1 to 0.3. Wave height, wave pressure distribution along the channel and velocity field are obtained for both open boundary condition and reflective boundary condition at the other end of the channel. For a reflective case, it is shown that 相似文献
For large cross-section tunnel in horizontal layered rock mass, blasting excavation often causes serious overbreak and underbreak. In this study, blasting excavation tests of tunnel upper face were conducted, blast-induced excavation damage and the influence mechanisms of weak beddings and joints were analyzed based on the Panlongshan tunnel. In order to achieve fine excavation, the cut mode of “center holes and four-wedge cutting holes”, the blasthole pattern of “empty holes, long holes, short holes and additional relief holes”, the maximum single-hole charge and the air-deck charge structure were proposed. Compared with the damage characteristics, overbreak and underbreak, and deformations of surrounding rock before and after optimization, the latter was better in tunnel contour formation and surrounding rock stability. The results show that after optimization, the large-area separation of vault rock mass is solved, the step-like overbreak of spandrel rock mass is reduced and the large-size rock block and underbreak are avoided. The maximum linear overbreak of vault, spandrel, and haunch surrounding rock is decreased by 42.3%, 53.7% and 45.1%, respectively. The underbreak at the bottom of the upper face is reduced from ??111.5 to ??16.5 cm. The average overbreak area is decreased by 61.1%. The surrounding rock displacement after optimization finally converges to the smaller value. The arch crown settlement and the horizontal convergence of haunch are reduced by about 21.6% and 18.3%, respectively. Furthermore, from the completion of blasting excavation to the stabilization of surrounding rock, it takes less time by using the optimized blasting scheme.
Experimental investigation of for floe breakup on waves by use of non-refrigerated breakablematerials has been carried out.The incident wave heights for breakup of ice floe with different lengths,andthe influence of rigidity on reflection and transmission coeffcients are discussed.The experimental resultsshow that the ratio of the ice floe length,L_i,to the wavelength,L,is one of the significant factor affectingthe minimum wave height to cause fracture of ice floe,and another key factor is the ratio of the ice floethickness,h_i and L_i. 相似文献
The experimental investigation of unidirectional random wave slamming on the three-dimensional structure in the splash zone is presented. The experiment is conducted in the marine environment channel in the State Key Laboratory of Coastal and Offshore Engineering, Dalian University of Technology. The test wave is unidirectional irregular wave. The experiments are carried out with perpendicular random waves (β=0°) and oblique random waves (β=15°, 30°, 45°), the significant wave heights H1/3 ranging from 7.5 to 20 cm with 2.5 cm increment, the peak wave periods Tp ranging from 0.75 to 2.0 s with 0.25 s increment, and the clearance of the model with respect to the significant wave height s/H1/3 ranging from 0.0 to 0.5 with 0.1 increment. The statistical analysis results of different test cases are presented. The statistical distribution characteristics of the perpendicular irregular wave impact pressures are compared with that of the oblique irregular wave on the underside of the structure. The effect of the wave direction β on the wave impact forces on the underside of the structure is determined. The relation between the impact forces and the parameters such as the significant wave height, the relative structure width and the relative clearance of the structure is also discussed. 相似文献
