声频应力波在锚杆锚固状态检测中的应用   总被引：17，自引：0，他引：17  

汪明武 《地质与勘探》1998,34(4):54-56,59

研究了声频应力波法快速普查检测锚杆锚固状态的原理及评价分级标准,并将它成功地应用于潘一矿锚杆施工质量的检测,得出了利用声频应力波快速普查检测锚杆锚固质量的方法是切实可行和有效的。  相似文献   

Laboratory modelling of shear behaviour of soft joints under constant normal stiffness conditions   总被引：1，自引：0，他引：1  

B. Indraratna  A. Haque  N. Aziz 《Geotechnical and Geological Engineering》1998,16(1):17-44

Shear behaviour of regular sawtooth rock joints produced from casting plaster are investigated under constant normal stiffness (CNS) conditions. Test results obtained in this investigation are also compared with the constant normal load (CNL) tests. It is observed that the peak shear stress obtained under CNL conditions always underestimates the peak shear stress corresponding to the CNS condition. Plots of shear stress against normal stress show that a nonlinear (curved) strength envelope is acceptable for soft rock joints subjected to a CNS condition, in comparison with the linear or bilinear envelopes often proposed for a CNL condition. Models proposed by Patton (1966) and Barton (1973) have also been considered for the predictions of peak shear stress of soft joints under CNS conditions. Although Patton's model is appropriate for low asperity angles, it overestimates the shear strength in the low to medium normal stress range at higher asperity angles. In contrast, while Barton's model is realistic for the CNL condition, it seems to be inappropriate for modelling the shear behaviour of soft joints under CNS conditions. The effect of infill material on the shear behaviour of the model joints is also investigated, and it is found that a small thickness of bentonite infill reduces the peak stress significantly. The peak shear stress almost approached that of the shear strength of infill when the infill thickness to asperity height ratio (t/a) reached 1.40. This paper also introduces an original, empirical shear strength envelope to account for the change in normal stress and surface degradation during CNS shearing. © Rapid Science Ltd. 1998  相似文献   

应用光率体论述宝石折射率仪测试原理及其应用     

孙先如  蒋小平  雷能忠  杜建国 《安徽地质》1998,(3)

】应用晶体光学中的光率体原理对宝石折射仪测试应用问题作较为详尽的论述,特别对一轴晶、二轴晶宝石测试所遇到的各种现象作进一步全面探讨,并给予确切的解释。  相似文献   

Strain fields and mechanical response of a highly to medium fissured bentonite clay     

C. Vitone  F. Cotecchia  G. Viggiani  S. A. Hall 《国际地质力学数值与分析法杂志》2013,37(11):1510-1534

This article presents the developments of an ongoing research aimed at modelling the influence of fissuring on the behaviour of clays. In particular, it recalls the main results of an extensive laboratory investigation on a fissured bentonite clay from the south of Italy and presents the data of a new investigation on the evolution with shearing of the strain fields developing within the clay, resulting from Digital Image Correlation (DIC). Element test results are analysed in the framework of continuum mechanics and linked to the clay fissuring features, once characterised using the Fissuring IDentity (F‐ID) chart. This article compares the bentonite behaviour with that of other fissured clays of different F‐IDs, highlighting the common behavioural features. Thereafter, the soil response at the macro level is related to the DIC‐derived strain fields evolving within the clay with loading. For this purpose, DIC was successfully used to investigate the deformation processes active in the fissured clay and the sources of the localisation phenomena. DIC is shown to provide indications of the extent to which highly to medium fissured clays element test results can be of use to model the clay behaviour according to continuum mechanics. Copyright © 2012 John Wiley & Sons, Ltd.  相似文献   

Internal testing of a numerical model of hillslope–channel coupling using laboratory flume experiments     

Katerina Michaelides  John Wainwright 《水文研究》2008,22(13):2274-2291

The numerical model COUP 2D simulates the hydrological coupling between hillslopes and the river channel during a rainfall event. In order to test the numerical model, a 1:100 scaled laboratory flume which was modified to incorporate lateral hillslope elements, was used to run a series of experiments in which hillslope angle, channel angle, hillslope discharge and channel discharge were the varying parameters. Overall, there were 18 different experimental configurations with three replicates carried out for each condition, leading to a total of 54 experiments. These conditions were then used to parameterize and run COUP 2D. Internal model outputs of flow depth and flow velocity at four cross‐sections in the channel were compared to the measurements made in the physical model for the same parameter conditions. Statistical comparisons of the measured and modelled data were carried out for each experiment and across all experiments, using two goodness‐of‐fit measures—root mean square error and Nash–Sutcliffe coefficient of efficiency—in order to assess the performance of the model over an entire simulation as well as over all the simulations. The main effects on the goodness‐of‐fit measures for flow depth of each experimental variable, as well as the interactions between variables, were evaluated using statistical modelling. The results show that the model captures flow‐depth variations in response to changing channel and hillslope parameters. Statistical modelling suggests that the main effects on model error are cross‐section position, channel angle and channel discharge. Significant interactions also occur between all the channel variables and between the channel variables and hillslope discharge. The results of the testing procedure have significant implications for the consideration of different model components and for the interaction between data‐ and model evaluation. Copyright © 2007 John Wiley & Sons, Ltd.  相似文献   

同幅双速跟踪成像CCD相机模拟电路系统设计     

李勇明  李彬华  王慧娟  卢诚 《天文研究与技术》2007,4(4):376-382

讨论了同幅双速跟踪成像技术对CCD相机系统的特殊要求,详细地介绍了该相机前端模拟系统的设计思想、系统结构和主要的电路模块。对系统中一些关键电路模块进行了仿真和测试,并对仿真和测试结果进行比较分析,以检验电路系统设计的合理性。  相似文献   

Testing turbulence model at metric scales with mid-infrared VISIR images at the VLT     

A. Tokovinin  M. Sarazin  A. Smette 《Monthly notices of the Royal Astronomical Society》2007,378(2):701-708

  相似文献   

Ӧ�ǵش�̨��Ź۲⻷������   总被引：2，自引：0，他引：2  

李德前  陈慧杰  魏贵春  孙伶俐  戴苗  贺玉方 《大地测量与地球动力学》2015,35(2):356-359

??????????????????????????????????????????????????????в?????????????????????????????????????????????≤1 nT/m????????????≤0.1 nT?????????????????????????????????????????????????????в???????????????????????????????????  相似文献   

渤中25-1油田沙河街组低孔低渗储层特征及分类评价   总被引：3，自引：0，他引：3  

杨玉卿  潘福熙  田洪  徐晋  陈力群 《现代地质》2010,24(4)

渤中25-1油田位于渤海南部海域,其主力油层为古近系沙河街组,总体上属于低孔低渗储层。通过薄片、扫描电镜、X衍射分析和测井解释等手段,对沙河街组砂岩储层的岩石学特征、沉积特征、物性和孔隙结构特征进行了分析研究。沙河街组沙三段为较深水湖泊环境下的浊积扇沉积,沙二段为扇三角洲沉积;岩性主要为岩屑长石砂岩,储层孔隙类型为混合孔隙、次生孔隙和原生孔隙,由于沙三段溶蚀孔隙发育较沙二段少,沙三段物性较沙二段差。结合储层试油结果,提出了低孔低渗储层宏观成因、微观孔隙结构和综合评价3种分类方案,总体上把储层分为好、中和差3类,对应产能分别为大于80 m3/d、介于10~100 m3/d之间、小于10 m3/d和微量或无产能。经过该油田沙河街组5口井、15个储层段的测试验证,储层宏观成因分类评价结果与实际试油结果符合率达到86.67%,微观孔隙结构分类和综合分类评价结果与实际试油结果基本吻合。  相似文献   

大唐国际东营一期49.5 MW风电场工程桩基施工及其原体试验          下载免费PDF全文

李吉林  张旭虎 《探矿工程》2010,37(9):40-45

大唐国际东营风电一期工程拟建风电场场区位于东营市东部沿海区域,拟建场地上覆第四系地层,结构松散,厚度较大,工程性质较差,地基强度较低,不能满足重要建（构）筑物对其强度及变形的要求,且场地内的饱和粉土及砂土在地震影响烈度达Ⅶ度时将可能产生液化现象,因此需进行地基处理。根据现场岩土条件,拟采用预应力高强混凝土管桩（PHC）,需进行桩基原体试验。主要介绍了桩基原体试验施工过程、检测方法及试验成果等。  相似文献