水平井和大斜度井中阵列侧向测井响应数值模拟   总被引：1，自引：0，他引：1  

祝鹏  林承焰  李智强  赵文积  张华莲 《吉林大学学报(地球科学版)》2015,45(6):1862-1869

针对水平井和大斜度井中阵列侧向电极系的工作原理,利用多电场叠加方式进行电场合成,采用三维有限元方法模拟仿真各个分电场的场分布,进而利用电场线性叠加原理得到阵列侧向测井响应。在基于计算机仿真的基础上,得到阵列侧向五条测井曲线的径向探测深度,阵列侧向径向探测深度要小于深侧向探测深度。考察了三维地层模型下井斜和侵入深度变化对阵列侧向测井响应的影响,分析了水平井和大斜度井中阵列侧向测井响应特征。模拟结果表明,在井斜小于15°时,阵列侧向测井响应受井斜影响小,可以不进行井斜校正;井斜超过60°的大斜度井以及水平井中,阵列侧向测井响应视地层厚度逐渐增大,测井响应值与直井条件下响应值差别较大,必须进行井斜校正。  相似文献   

Seismic characterization of switching platform geometries and dominant carbonate producers (Miocene,Las Negras,Spain)          下载免费PDF全文

Lucas M. Kleipool  Koos de Jong  Eveline L. de Vaal  John J. G. Reijmer 《Sedimentology》2017,64(6):1676-1707

The primary goals of seismic interpretation and quantification are to understand and define reservoir architecture and the distribution of petrophysical properties. Since seismic interpretation is associated with major uncertainties, outcrop analogues are used to support and improve the resulting conceptual models. In this study, the Miocene carbonates of Cerro de la Molata (Las Negras, south‐east Spain) have been selected as an outcrop analogue. The heterogeneous carbonate rocks of the Cerro de la Molata Platform were formed by a variety of carbonate‐producing factories, resulting in various platform morphologies and a wide range of physical properties. Based on textural (thin sections) and petrophysical (porosity, density, carbonate content and acoustic properties) analyses of the sediments, eleven individual facies types were determined. The data were used to produce synthetic seismic profiles of the outcrop. The profiles demonstrate that the spatial distribution of the facies and the linked petrophysical properties are of key importance in the appearance of the synthetic seismic sections. They reveal that carbonate factory and facies‐specific reflection patterns are determined by porosity contrasts, diagenetic modifications and the input of non‐carbonate sediment. The reflectors of the seismograms created with high‐frequency wavelets are coherent with the spatial distribution of the predefined facies within the depositional sequences. The synthetic seismograms resulting from convolution with lower frequency wavelets do not show these details – the major reflectors coincide with: (i) the boundary between the volcanic basement and the overlying carbonates; (ii) the platform geometries related to changes in carbonate factories, thus sequence boundaries; and (iii) diagenetic zones. Changes in seismic response related to diagenesis, switching carbonate producers and linked platform geometries are important findings that need to be considered when interpreting seismic data sets.  相似文献   

Acoustic full waveform inversion of synthetic land and marine data in the Laplace domain     

Wansoo Ha  Sukjoon Pyun  Jewoo Yoo  Changsoo Shin 《Geophysical Prospecting》2010,58(6):1033-1048

Elastic waves, such as Rayleigh and mode‐converted waves, together with amplitude versus offset variations, serve as noise in full waveform inversion using the acoustic approximation. Heavy preprocessing must be applied to remove elastic effects to invert land or marine data using the acoustic inversion method in the time or frequency domains. Full waveform inversion using the elastic wave equation should be one alternative; however, multi‐parameter inversion is expensive and sensitive to the starting velocity model. We implement full acoustic waveform inversion of synthetic land and marine data in the Laplace domain with minimum preprocessing (i.e., muting) to remove elastic effects. The damping in the Laplace transform can be thought of as an automatic time windowing. Numerical examples show that Laplace‐domain acoustic inversion can yield correct smooth velocity models even with the noise originating from elastic waves. This offers the opportunity to develop an accurate smooth starting model for subsequent inversion in the frequency domain.  相似文献   

Estimating longitudinal dispersion in rivers using Acoustic Doppler Current Profilers     

Chaopeng Shen  Jie Niu  Eric J. Anderson  Mantha S. Phanikumar 《Advances in water resources》2010

The longitudinal dispersion coefficient (D) is an important parameter needed to describe the transport of solutes in rivers and streams. The dispersion coefficient is generally estimated from tracer studies but the method can be expensive and time consuming, especially for large rivers. A number of empirical relations are available to estimate the dispersion coefficient; however, these relations are known to produce estimates within an order of magnitude of the tracer value. The focus of this paper is on using the shear-flow dispersion theory to directly estimate the dispersion coefficient from velocity measurements obtained using an Acoustic Doppler Current Profiler (ADCP). Using tracer and hydrodynamic data collected within the same river reaches, we examined conditions under which the ADCP and tracer methods produced similar results. Since dead zones / transient storage (TS) are known to influence the dispersion coefficient, we assessed the relative importance of dead zones in different stream reaches using two tracer-based approaches: (1) TS modeling which explicitly accounts for dead zones and (2) the advection–dispersion equation (ADE) which does not have separate terms for dead zones. Dispersion coefficients based on the ADE tend to be relatively high as they describe some of the effects of dead zones as well. Results based on the ADCP method were found to be in good agreement with the ADE estimates indicating that storage zones play an important role in the estimated dispersion coefficients, especially at high flows. For the river sites examined in this paper, the tracer estimates of dispersion were close to the median values of the ADCP estimates obtained from multiple datasets within a reach. The ADCP method appears to be an excellent alternative to the traditional tracer-based method if care is taken to avoid spurious data and multiple datasets are used to compute a distance-weighted average or other appropriate measure that represents reach-averaged conditions.  相似文献   

Use of the Acoustic Energy Meter (AEM) for rapid geomorphological field assessment of rock hardness: comparison with Schmidt hammer R‐value          下载免费PDF全文

M. S. Brook  S. Winkler 《地球表面变化过程与地形》2016,41(12):1804-1812

Rapid, field‐based assessments of rock hardness are required in a broad range of geomorphological investigations where rock intact strength is important. Several different methods are now available for taking such measurements, in particular the Schmidt hammer, which has seen increasing use in geomorphology in recent decades. This is despite caution from within the engineering literature regarding choice of Schmidt hammer type, normalization of rebound (R‐) values, surface micro‐roughness, weathering degree and moisture content, and data reduction/analysis procedures. We present a pilot study of the use of an Acoustic Energy Meter (AEM), originally produced, tested and developed within the field of underground mining engineering as a rapid measure of rock surface hardness, and compare it with results from a mechanical N‐Type Schmidt hammer. We assess its capabilities across six lithological study sites in southeast Queensland, Australia, in the Greater Brisbane area. Each rock exposure has been recently exposed in the 20th/21st century. Using a ‘paired’ sampling approach, the AEM G‐value shows an inverse relationship with Schmidt hammer R‐value. While both devices show variability with lithology, the AEM G‐values show less scatter than the Schmidt hammer. We conclude that each device can contribute to useful rock hardness testing in geomorphological research, but the AEM requires further field testing in a range of environments, and in particular on older and naturally‐exposed rock surfaces. Future evaluations can extend this pilot study by focusing on sampling procedures, energy sources, and data reduction protocols, within the framework of a comparison study with other rock hardness testing apparatus. Copyright © 2016 John Wiley & Sons, Ltd.  相似文献   

测井曲线重构和频谱分析技术在塔里木盆地塔河油田卡拉沙依组储层预测中的应用     

张红贞  孟恩 《现代地质》2009,23(5)

由于受不同地质情况的影响,常规测井曲线不能很好地解决特殊地质问题。针对塔河油田三区石炭系卡拉沙依组的储层地质特征,利用频谱分析技术对伽马、中子测井曲线进行处理。与常规测井曲线比较,地层的旋回特征在频谱分析曲线上更加明显。根据相同地层具有相似旋回性的原理,利用伽马、中子频谱分析曲线进行地层横向对比,使研究区卡拉沙依组砂泥段的砂组划分、对比达到了协调和统一;以声波曲线为本体,结合反映岩性的测井曲线(伽马、中子、自然电位等曲线),应用曲线重构技术构建储层特征曲线,为测井约束反演提供地质依据,使反演结果更接近于地质实际情况。利用反演资料进行储层预测的结果与测井解释有利储层段进行比较,吻合率和较吻合率分别为71.6%、11.3%。  相似文献   

泥页岩油气藏水平井评价对策与实践     

胡松  周灿灿  王昌学  李霞  程相志  徐波 《地球物理学进展》2013,28(4)

随着泥页岩油气藏勘探程度不断深入,水平井数量成倍增长,给水平井测井评价带来机遇与挑战,但水平并测井解释方法还停留在直井思维上,且水平并响应特征与直并存在较大差剐.而泥页岩储层砂泥薄互层发育,各向异性、非均值性非常严重,砂体横向上不连续,给测井解释评价造成很大困难.本文根据实际资料,采用交互式反演方法,以寻找井眼轨迹与目的层的精细关系为目的,探索了泥页岩油气藏水平井测井评价方法以及应注意的事项.  相似文献   

TTI介质qP波逆时偏移中伪横波噪声压制方法   总被引：6，自引：6，他引：0       下载免费PDF全文

张岩  吴国忱 《地球物理学报》2013,56(6):2065-2076

在对地下复杂构造介质,特别是盐丘侧翼及岩下区域进行成像时,相对于传统的各向同性逆时偏移和VTI逆时偏移,具有倾斜对称轴的TTI逆时偏移成像效果最优.不仅反射同相轴更加的连续,而且能量得到了更好的聚焦.传统的各向异性介质全弹性波RTM的计算量大且计算效率低.由于目前仍以纵波勘探为主,因此TTI逆时偏移qP波波动方程的选取显得尤为重要.为了提高计算效率,采用将沿着对称轴方向的横波速度设为零的方法,简化得到qP波波动方程.然而,这样会引入一种严重影响成像效果的低速度、低振幅的qSV波人为干扰.本文建立了qP波方程的完全匹配层控制方程,而后借助于辅助波场采用一种高效的压制伪横波噪声传播的方法,通过模型测试验证了该方法的有效性.  相似文献   

地震波动方程的局部间断有限元方法数值模拟          下载免费PDF全文

廉西猛  张睿璇 《地球物理学报》2013,56(10):3507-3513

近年来,随着地震波数值模拟对计算精度和效率的要求越来越高,间断有限元方法开始受到越来越多的关注.本文中,针对具有吸收边界条件的二维地震声波波动方程,作者提出了一种基于局部间断有限元方法的数值模拟算法.该算法在空间上使用局部间断有限元方法进行离散,在时间上采用了显式蛙跳格式.在这种时空离散的组合方式下,每个时间步上,此算法在空间剖分的每个单元上的求解计算是相互独立的,因而具有极高的并行性.通过数值算例,我们将该算法与连续有限元方法进行了比较.结果表明,本算法不仅具有对起伏构造的良好适应性,而且在计算效率和计算精度等方面,都具有优越性.  相似文献   

基于WebGIS的Web服务器日志管理系统设计与实现     

张群;张雯;李飞雪;李满春;陈东 《东北测绘》2013,(4):13-16

WebGIS优势是通过互联网对地理空间数据进行发布和应用,以实现空间数据的共享和相互操作。将WebGIS和富客户端技术引入Web服务器日志管理领域,从总体设计、数据库设计、实现框架等几个方面设计了Web服务器日志管理系统开发框架,并开发了某工业园区信息共享平台日志管理系统。该系统可以高效便捷地实现网络访问数据空间可视化、访问流量在线监控、访问数据统计与分析等功能,为Web服务器运行维护提供科学的决策依据。  相似文献