关于土层地震反应分析中阻尼矩阵建模方式的讨论          下载免费PDF全文

殷琳  楼梦麟  康帅 《世界地震工程》2019,35(2):132-140

阻尼矩阵的选择对土层时域内地震反应计算的准确性有重要意义。本文构造了质量比例阻尼、刚度比例阻尼、Rayleigh阻尼、Caughey阻尼和Clough阻尼矩阵,研究各阻尼对土层地震反应分析精度的影响。以苏通大桥5号桥塔基础处的工程场地为例,分别以人工合成基岩波,Northridge波、Parkfield波和汶川波为输入,得到不同阻尼模型下土层的地震反应,结果表明Clough阻尼在计算精度和误差稳定性上要优于其他阻尼模型,针对Clough阻尼的不足之处提出了改进方法,算例表明改进后的Clough阻尼能在保证计算精度的前提下减少计算机的存储量和计算量。  相似文献   

铜川新区黄土与古土壤动剪切模量比和阻尼比的统计研究          下载免费PDF全文

段蕊  陈党民 《世界地震工程》2019,35(3):153-160

利用铜川市地震小区划项目的大量典型土样动三轴试验结果,采用双曲线模型拟合得到了铜川新区黄土和古土壤在8个典型应变下的动剪切模量比和阻尼比值。根据不同沉积年代和不同土层深度2种方法对黄土、古土壤动剪切模量比和阻尼比随剪应变变化情况进行了统计和对比分析。研究发现:同一剪应变下,黄土、古土壤动剪切模量比随沉积年代和土层深度的增加而增加。二者对黄土动剪切模量比的影响较为显著。  相似文献   

Effects of supplemental viscous damping on seismic response of asymmetric-plan systems     

Rakesh K. Goel 《地震工程与结构动力学》1998,27(2):125-141

Coupling between lateral and torsional motions may lead to much larger edge deformations in asymmetric-plan systems compared to systems with a symmetric plan. Supplemental viscous damping has been found to be effective in reducing deformations in the symmetric-plan system. This investigation examined how supplemental damping affects the edge deformations in asymmetric-plan systems. First, the parameters that characterize supplemental viscous damping and its plan-wise distribution were identified, and then the effects of these parameters on edge deformations were investigated. It was found that supplemental damping reduces edge deformations and that reductions by a factor of up three are feasible with proper selection of system parameters. Furthermore, viscous damping may be used to reduce edge deformations in asymmetric-plan systems to levels equal to or smaller than those in the corresponding symmetric-plan system. © 1998 John Wiley & Sons, Ltd.  相似文献   

Application of advanced system identification technique to extract roll damping from model tests in order to accurately predict roll motions     

《Applied Ocean Research》2017

In this paper our previously developed advanced system identification technique [1] has been applied to extract the frequency dependent roll damping from a series of model tests run in irregular (random) waves. It is shown that this methodology accurately models the roll damping which can then be used to produce accurate predictions of the ships roll motion. These roll motion predictions are not only more accurate than the potential flow predictions but more accurate than potential flow models corrected using either empirical prediction methods [2] and even those corrected using roll damping obtained from free decay sallying experiments. This methodology has the potential to significantly improve roll motion prediction during full scale at sea trails of vessels in order to dramatically improve safety of critical operations such as helicopter landing or ship to ship cargo transfer.  相似文献   

Anchor loads in taut moorings: The impact of inverse catenary shakedown     

《Applied Ocean Research》2017

Taut mooring systems have become prospective alternatives for the station keeping of offshore floating facilities in deep water. The associated embedded anchors cause a part of the mooring line to be buried in the seabed − the inverse catenary − which introduces a requirement to predict the load and uplift angle at the padeye, where the chain is connected to the anchor. The padeye load and angle depend on the shape and tension profile of the inverse catenary, which must be assessed in the mooring system design. The dynamic interaction between the embedded chain and the soil in the inverse catenary is not usually considered in this analysis. Instead, the inverse catenary is assessed statically, albeit potentially using cyclically-degraded soil strength parameters. The present study employs the lumped mass method to simulate the dynamic response of mooring lines under different imposed oscillations at the fairlead, where the chain is connected to the floating facility. A new chain-soil interaction model, which includes hysteresis effects associated with irrecoverable relative chain-soil displacement is calibrated by experimental results. Simulations of cyclic vessel motion are then performed, and the resulting chain-seabed interaction is observed. During constant-amplitude vessel motion cycles, the load angle at the padeye significantly decreases due to progressive ratcheting or ‘shakedown’ of the inverse catenary from the initial static profile towards a straighter profile. This effect is due to the hysteretic soil response and creates a less onerous loading condition for the anchor which may be beneficial, but is conventionally overlooked in design. At the end of the present study, an elastic bound method is proposed to estimate the profile of the inverse catenary after shakedown. A parametric study illustrates the performance of this simple method for predicting the steady state condition.  相似文献   

Experimental Study on Cross-Flow Induced Vibrations in Heat Exchanger Tube Bundle     

KHUSHNOOD Shah  NIZAM Luqman Ahmad 《海洋工程》2017,31(1):91-97

Vibration in heat exchangers is one of the main problems that the industry has faced over last few decades. Vibration phenomenon in heat exchangers is of major concern for designers and process engineers since it can lead to the tube damage, tube leakage, baffle damage, tube collision damage, fatigue, creep etc. In the present study, vibration response is analyzed on single tube located in the centre of the tube bundle having parallel triangular arrangement (60°) with P/D ratio of 1.44. The experiment is performed for two different flow conditions. This kind of experiment has not been reported in the literature. Under the first condition, the tube vibration response is analyzed when there is no internal flow in the tube and under the second condition, the response is analyzed when the internal tube flow is maintained at a constant value of 0.1 m/s. The free stream shell side velocity ranges from 0.8 m/s to 1.3 m/s, the reduced gap velocity varies from 1.80 to 2.66 and the Reynolds number varies from 44500 to 66000. It is observed that the internal tube flow results in larger vibration amplitudes for the tube than that without internal tube flow. It is also established that over the current range of shell side flow velocity, the turbulence is the dominant excitation mechanism for producing vibration in the tube since the amplitude varies directly with the increase in the shell side velocity. Damping has no significant effect on the vibration behavior of the tube for the current velocity range.  相似文献   

10MW级海上浮式风机运动特性研究   总被引：2，自引：2，他引：0  

徐应瑜  胡志强  刘格梁 《海洋工程》2017,35(3):44-51

以DTU 10 MW基准风机为研究对象,单柱式平台作为基础支撑结构,使用FAST软件计算分析,考虑单独风、单独波浪以及风浪组合三种环境条件,对10 MW级海上浮式风机的运动特性进行研究。研究发现:系统摇荡是风激励的低频运动和波浪激励的波频运动的合成,气动阻尼削弱系统的波频运动;系统纵荡和纵摇运动存在明显的耦合现象,而垂荡运动和其他方向的运动没有耦合关系;受纵摇影响,转动的风轮产生陀螺惯性力矩,激励首摇运动;随着风机单机容量的增加,风激励的低频运动比例增大,波浪激励的波频运动比例减小。  相似文献   

Vertical dynamic impedance of pile considering the dynamic stress diffusion effect of pile end soil     

Tian-Le Liu  Wen-Bing Wu  Bin Dou  Guo-Sheng Jiang  Shu-Hui Lü 《Marine Georesources & Geotechnology》2017,35(1):8-16

A new analytical model is presented to analyze the dynamic stress diffusion effect of pile end soil on the vertical dynamic impedance of the pile. The surrounding soil of the pile is modeled by using the plane strain model and the pile is simulated by using one-dimensional elastic theory. Finite soil layers below the pile end are modeled as conical fictitious soil pile with stress diffusion angle which reflects the dynamic stress diffusion effect of pile end soil. By means of the Laplace transform and impedance function transfer method, the analytical solution of the vertical dynamic impedance at the pile head in frequency domain is yielded. Then, a comparison with other models is performed to verify the conical fictitious soil pile model. Finally, based on the proposed solution, the selected numerical results are compared to analyze the influence of dynamic stress diffusion effect for different design parameters of the soil-pile system on the vertical dynamic impedance at the pile head.  相似文献   

An investigation into the effects of damping and nonlinear geometry models in earthquake engineering analysis          下载免费PDF全文

Andrew Hardyniec  Finley Charney 《地震工程与结构动力学》2015,44(15):2695-2715

The growing emphasis of considering the behavior of structures at extreme performance states, such as collapse, has necessitated the characterization of the effects of varying attributes of the structural model. One source of variability that has not previously been considered is variability in the mathematical model. This study investigated the effects of changing the geometric nonlinearity approach and damping model on a four‐story buckling restrained braced frame, a four‐story steel moment resisting frame, and an eight‐story steel moment resisting frame. The variations in behavior are quantified using the maximum interstory drift ratio as the performance metric and qualified by comparing the relative displaced shapes and component response histories at the collapse performance state. Copyright © 2015 John Wiley & Sons, Ltd.  相似文献   

地基半空间等效集总体系的比拟法与实测分析          下载免费PDF全文

吴邦达  吴丽波 《地震工程学报》2015,37(4):1029-1036

先略述莱斯默比拟法的形成;再由半空间理论等效为质弹体系,得出辐射阻尼比、刚度及参振土质量,并论述两体系的结合;最后经实测、分析和使用,考虑土体非匀质性折减阻尼比以作修正,使其更为实用。这有助于消除在我国长期认为阻尼比大而不安全、不便使用的疑虑,以便推动半空间理论在我国的实用化。  相似文献