INELASTIC SEISMIC RESISTANCE OF REINFORCED CONCRETE STACK-LIKE STRUCTURES     

ALOK GOYAL  MANOJ K. MAITI 《地震工程与结构动力学》1997,26(5):501-513

A method is presented to quantify the inelastic seismic resistance of reinforced concrete stack-like structures by non-linear earthquake analysis. The deformed configuration of stack is idealized as an assemblage of beam elements and actual stress–strain relationships of concrete and reinforcing steel are used to evaluate element matrices. Repeated non-linear analyses are performed by gradually increasing the intensity of acceleration time histories to a level where collapse of the stack is observed in primary stresses. The set of time histories thus obtained are then used to define the ultimate intensity of ground motion that the stack can sustain if inelastic deformations are permitted. A procedure is presented to quantify the difference between inelastic seismic resistance and elastic seismic resistance in terms of displacement ductility capacity factors. For seismic design using available inelastic resistance, values of curvature ductility factor demand for the cross-sections of stacks are also presented. © 1997 by John Wiley & Sons, Ltd.  相似文献   

T形截面柱的非线性分析   总被引：6，自引：0，他引：6  

李晓莉  郭棣  吴敏哲 《世界地震工程》2005,21(3):122-125

编制了适用于任意截面的钢筋混凝土压弯构件截面的弯矩—曲率非线性分析程序。在此基础上,计算了考虑非线性变形的异形柱弯矩—曲率关系,并研究了翼缘、轴压比等因素对异形柱强度和延性的影响,可作为异形柱研究的参考依据。  相似文献   

反复荷载下混凝土框架柱塑性铰区基于延性的抗剪承载力机理分析     

管品武  王建强  刘立新 《世界地震工程》2005,21(3):75-81

在试验研究的基础上,以框架结构延性设计为目的采用桁架＋拱模型研究了框架柱塑性铰区域抗剪受力机理,分析了,位移延性系数、加载循环次数等因素对框架柱构件塑性铰区域剪切受力性能的影响,并结合试验结果提出了混凝土框架柱塑性铰区域剪切承载力抗震延性设计实用公式,可有效实现结构的延性破坏机制。主要为配合GBJ10-89的修订,该成果已被《混凝土结构设计规范》（GB50010—2003）吸收。  相似文献   

Predictive optimal control for seismic analysis of non-linear and hysteretic structures     

K. Huang  R. Betti 《地震工程与结构动力学》1999,28(6):585-607

In this paper, an effective active predictive control algorithm is developed for the vibration control of non-linear hysteretic structural systems subjected to earthquake excitation. The non-linear characteristics of the structural behaviour and the effects of time delay in both the measurements and control action are included throughout the entire analysis (design and validation). This is very important since, in current design practice, structures are assumed to behave non-linearly, and time delays induced by sensors and actuator devices are not avoidable. The proposed algorithm focuses on the instantaneous optimal control approach for the development of a control methodology where the non-linearities are brought into the analysis through a non-linear state vector and a non-linear open-loop term. An autoregressive (AR) model is used to predict the earthquake excitation to be considered in the prediction of the structural response. A performance index that is quadratic in the control force and in the predicted non-linear states, with two additional energy related terms, and that is subjected to a non-linear constraint equation, is minimized at every time step. The effectiveness of the proposed closed-open loop non-linear instantaneous optimal prediction control (CONIOPC) strategy is presented by the results of numerical simulations. Since non-linearity and time-delay effects are incorporated in the mathematical model throughout the derivation of the control methodology, good performance and stability of the controlled structural system are guaranteed. Copyright © 1999 John Wiley & Sons, Ltd.  相似文献   

The ductility reduction factor in the seismic design of buildings     

Nelson Lam  John Wilson  Graham Hutchinson 《地震工程与结构动力学》1998,27(7):749-769

This paper presents new trends in the relationship between the ductility reduction factor and the ductility demand in the seismic design of buildings. A total of 4860 inelastic time-history analyses were carried out to study this relationship using 60 single-degree-of-freedom models excited by an ensemble of 81 earthquake accelerogram records from around the world. The asymmetrical distribution of the results highlighted the inaccuracies associated with assuming a normal distribution simply described by the mean and standard deviation to represent the data. A probability of exceedence approach has been used based on counting the number of occurrences the ductility demand exceeds a specified level. The ductility reduction factors developed in this study are consistent with other studies in the long-period range but are different in the short-period range. The ductility reduction factor for very short period buildings of limited ductility has been found to be greater than previously predicted. © 1998 John Wiley & Sons, Ltd.  相似文献   

Torsional mechanisms in ductile building systems     

T. Paulay 《地震工程与结构动力学》1998,27(10):1101-1121

It is postulated that in order to estimate torsional effects on the seismic response of ductile building structures, the associated plastic mechanism to be developed in the three-dimensional system should be identified. The proposed approach is very different from that embodied in building codes. Inelastic structures are classified as either torsionally unrestrained or restrained. It is shown that clearly defined mechanisms that are to be mobilized, enable the acceptable system ductility demand to be estimated. This should ensure that the corresponding demands imposed on critical translatory elements of the system do not exceed their established displacement ductility capacity. To this end familiar quantities, such as element yield displacement and stiffness, are redefined. Comparisons are made of the intents of existing codified design approaches and those emphasising the role of imposed inelastic displacements. A simple treatment of the consequences of earthquake-induced inelastic skew displacements is also addressed. The primary aim of the paper is to offer very simple concepts, based on easily identifiable plastic mechanisms, to be utilized in structural design rather than advancement in analyses. Detailed design applications of these concepts are described elsewhere. The approach is an extension of the deterministic philosophy of capacity design, now used in some countries. © 1998 John Wiley & Sons, Ltd.  相似文献   

Response reduction factor of irregular RC buildings in Kathmandu valley     

Hemchandra Chaulagain  Hugo Rodrigues  Enrico Spacone  Ramesh Guragain  Radhakrishna Mallik  Humberto Varum 《地震工程与工程振动(英文版)》2014,13(3):455-470

Most current seismic design includes the nonlinear response of a structure through a response reduction factor(R). This allows the designer to use a linear elastic force-based approach while accounting for nonlinear behavior and deformation limits. In fact, the response reduction factor is used in modern seismic codes to scale down the elastic response of a structure. This study focuses on estimating the actual ‘R' value for engineered design/construction of reinforced concrete(RC) buildings in Kathmandu valley. The ductility and overstrength of representative RC buildings in Kathmandu are investigated. Nonlinear pushover analysis was performed on structural models in order to evaluate the seismic performance of buildings. Twelve representative engineered irregular buildings with a variety of characteristics located in the Kathmandu valley were selected and studied. Furthermore, the effects of overstrength on the ductility factor, beam column capacity ratio on the building ductility, and load path on the response reduction factor, are examined. Finally, the results are further analyzed and compared with different structural parameters of the buildings.  相似文献   

绝对和相对输入能量谱对比及延性系数的影响研究          下载免费PDF全文

公茂盛  谢礼立 《地震学报》2005,27(6):666-676

利用266条强震记录,在研究绝对输入能量谱和相对输入能量谱衰减规律的基础上,对由衰减关系所确立的两种输入能量谱进行对比分析,讨论了延性系数对这两种输入能量谱的影响. 研究发现,在弹性情况下,两种输入能量谱在周期0.5~1.0 s范围内相差不大; 在非弹性情况下 两种输入能量谱在周期0.5 s处相差不大. 周期较小时,绝对输入能量谱要大于相对输入能量谱;周期较大时,绝对输入能量谱小于相对输入能量谱. 延性系数对这两种输入能量谱影响均比较大, 对绝对输入能量谱而言,周期小于0.3 s时,随着延性系数的增大, 能量谱升高;周期大于0.3 s时,随着延性系数的增大能量谱降低. 不同延性系数的绝对输入能量谱在分界点0.3 s左右相等. 相对输入能量谱受延性系数影响与绝对输入能量谱相似, 但分界点在0.5 s左右. 与绝对输入能量谱相比, 相对输入能量谱在短周期段受延性系数的影响较大, 特别是当场地较软时更为明显.   相似文献   

方钢管混凝土框架内隔板节点抗震性能的试验研究   总被引：15，自引：3，他引：12  

王来  王铁成  邓芃 《地震工程与工程振动》2005,25(1):76-80

本文设计了一榀三层两跨的方钢管混凝土框架模型,梁柱节点采用内隔板节点型式。采用拟静力试验方法,对方钢管混凝土框架施加低周反复水平荷载,研究了方钢管混凝土框架内隔板节点的荷载一位移曲线、节点延性、节点破坏机制和破坏特点等抗震性能。研究结果表明,方钢管混凝土框架内隔板节点的抗震性能较好。  相似文献   

延性需求谱在基于性能的抗震设计中的应用   总被引：23，自引：4，他引：19  

周定松  吕西林 《地震工程与工程振动》2004,24(1):30-38

基于性能的抗震设计理论涉及如何简便而合理地确定结构在指定强度地震下的弹塑性位移需求。本文给出了利用延性需求谱求解结构位移需求的一般步骤:借助模态Pushover分析将多自由度体系分解为几个非线性单自由度体系,以考虑各阶振型的影响;利用延性需求谱计算对应模态的等效单自由度体系的延性及位移需求,并以一定方式组合转化为多自由度体系位移需求。最后,通过算例分析表明:利用延性需求谱求解结构位移需求是一种具有一定精度可为工程接受的简便方法,在基于性能的抗震设计中具有较好的应用前景。  相似文献