SAS测量水体表观光学参数的方法     

李铜基  陈清莲 《海洋技术学报》2003,22(1):10-13,57

SeaWiFS航空模拟器（SAS）是专门为在水面之上测量水体表观光学参数的现场设备。文章在介绍SAS现场测量以及数据处理基本方法的基础上，分析了2002年黄海试验SAS的应用效果，并与剖面法测量数据进行了比对。  相似文献   

中国海区区域地质编图中重磁图的编制方法     

张训华 《海洋地质与第四纪地质》1994,14(4):95-100

本文简要介绍了局控项目《中国海区１∶５０万区域地质编图（大连幅）》重力异常图、磁力异常图的编制过程，给出了一种以计算机为手段、实现编图自动化的新方法，并分析了该方法与以往编图方法的不同和优点，以国际分幅在中国海区开展区域地质编图尚属首次，在既无海区地质调查规范，又无海区地质调查编图规范的情况下，这一工作无异具有开创性。从理论上系统总结出一套切实可行的编图方法，对于编制中国海区区域地质调查编图规范以  相似文献   

真空预压联合碎石桩加固港口吹填堆场地基的试验研究     

丛建  曹永琅  杨成军 《海岸工程》2007,26(1):41-47

在港口工程建设中,快速加固超软弱的吹填地基,采用真空预压法是一个经济有效的方法,再联合以碎石桩加固则能进一步提高地基的承载力、减少地基工后沉降.通过真空预压联合碎石桩加固地基的现场试验以及观测资料的分析,得出真空预压联合碎石桩加固后地基的承载力特征值由原天然地基的60 kPa左右提高到220 kPa,计算结果表明打碎石桩后的地基变形模量Esp与真空预压后的Ea相比提高了1倍,联合碎石桩加固后的地基沉降量比仅经过真空预压的地基减少1/3.  相似文献   

合浦珠母贝卵子电击脉冲参数的初步研究     

喻达辉  贾晓平  陈素文  李夏  朱嘉濠 《海洋科学》2005,29(8):15-19

运用电脉冲转基因仪对合浦珠母贝卵子进行电脉冲处理以优化电穿孔法转基因的电击参数。实验中调制百分比：100％；脉冲间隔：1．0s：电极距离：2mm；脉冲个数：5个，参数保持不变。用不同的电脉冲参数组合（脉冲电压100-400V、脉冲持续时间0．5～3．0ms、脉冲频率10～50kHz，共28个组合）对卵子电击，然后加入精子进行授精，统计各组受精率和孵化率，以受精率和孵化率达到50％以上为衡量指标。结果表明，合浦珠母贝卵子对低脉冲频率和高电压非常敏感，当频率低于20kHz或脉冲电压高于400V时对卵子损伤较大。脉冲持续时间对其影响不大，适应范围较宽。优化的转基因电击脉冲参教组合为：脉冲电压1.0kV／cm，脉冲持续时间20ms，脉冲频率50kHz，或者脉冲电压1．5kV／cm，脉冲持续时间1．5ms，脉冲频率50kHz。  相似文献   

动态基准实时测量系统的开发与应用   总被引：3，自引：0，他引：3  

卫建东  徐忠阳  张良琚 《海洋测绘》2005,25(1):31-35

介绍了动态基准实时测量系统的硬件组成、站点上全站仪棱镜组合安装与检测方法、系统软件的开发及特点，最后对系统在广州地铁某地铁站结构变形自动监测中的应用情况进行了阐述。通过实际应用表明该系统能应用在自动化、高精度的变形监测领域。  相似文献   

A time-varying parameter model of a body oscillating in pitch     

A.P. McCabe  G.A. Aggidis  T.J. Stallard   《Applied Ocean Research》2006,28(6):359-370

Among the assumptions upon which linear time-invariant models of floating bodies are based is that the body motions are so small that any change in the body’s angular position can be disregarded. However, it is often a major design requirement of a wave energy conversion device that the response amplitude is large, thereby invalidating one of the assumptions of the linear model. In particular, the immersed geometry of a body undergoes considerable variation when it is moved in pitch. With regard to this we investigate the difference in performance between a quasi-linear model in which the change of immersed surface is modelled by time-varying parameters and a basic linear model in which the immersed surface is time-invariant. The time-varying parameter model is realized by interpolation between the appropriate parameter values of a set of linear time-invariant (LTI) models derived for the different immersed surfaces that occur at discrete body displacements. It is shown that the responses predicted using the time-varying parameter model are closer to those measured experimentally than those of a standard frequency-domain model. Particular improvement occurs when the responses are large, such as at or near the resonance frequency. A problem which may limit the general use of the model is also discussed.  相似文献   

海洋水色卫星遥感器特性参数探讨     

于连生 《海洋技术学报》2001,20(2):76-80

为了评价海洋水色卫星遥感器特性参数的优劣，确定仪器的计量特性及其使用价值，准确的理解和科学的定义仪器的特性参数是非常重要的。作者曾有幸参加了海洋水色卫星的立项论证工作，本文就作者的一些工作体会，对海洋水色卫星遥感器的特性参数作初步探讨。  相似文献   

西太平洋暖池区海—气通量计算分析   总被引：4，自引：0，他引：4  

徐天真  陈伯海 《中国海洋大学学报(自然科学版)》1993,(Z2)

用J.Launiaimen和T.Vihma提出的近地面层湍流通量计算方法,对我国在1992年11月至1993年2月TOGA—COARE—IOP实验中所获资料计算处理。得出所在站位的海一气间显效、潜热及动量通量。指出西大平洋暖池海区游热通量与显效通量之比为10.14:1;风速大于8m/s后各通量随风速的变化率明显增加;动量与热量的块体通量系数Cd和Ce,h随风速变化有相似的规律;Monin—Obukhov大气稳定度参数Z/L与△T/U_(10)之间有较好的统计关系。  相似文献   

水产饲料膨化机设计刍论     

徐钟良  陈启发 《台湾海峡》2001,20(Z1):207-211

据开发应用水产饲料膨化机实践，初步论述了膨化机生产能力与动力匹配，螺杆设计参数长径比，物料在腔内滞留时间，膨化腔设计及其温度调控，并提出改进设计的见解.  相似文献   

Two-Dimensional Mathematical Model of Tidal Current and Sediment for Oujiang Estnary and Wenzhou Bay   总被引：1，自引：0，他引：1  

LU  Yongjun 《中国海洋工程》2002,16(1):107-122

A 2-D mathematical model of tidal current and sediment has been developed for the Oujiang Estuary and the WenzhouBay. This model accomodates complicated features including multiple islands, existence of turbidity, and significant differ-ence in size distribution of bed material. The governing equations for non-uniform suspended load and bed load transport arepresented in a boundary-fitted orthogonal curvilinear coordinate system. The numerical solution procedures along with theirinitial conditions, boundary conditions, and movable boundary technique are presented. Strategies for computation of thecritical condition of deposition or erosion, sediment transport capacity, non-uniform bed load discharge, etc. are suggested.The model verification computation shows that, the tidal levels computed from the model are in good agreement with the fielddata at the 18 tidal gauge stations. The computed velocities and flow directions also agree well with the values measuredalong the totally 52 synchronously observed verticals distributed over 8 cross sections. The computed tidal water throughputsthrough the Huangda‘ao cross section are close to the measured data. And the computed values of bed deformation fromYangfushan to the estuary outfall and in the outer-sea area are in good agreement with the data observed from 1986 to 1992.The changes of tidal volumes through the estuary, velocities in different channels and the bed form due to the influence of thereclamation project on the Wenzhou shoal are predicted by means of this model.  相似文献