Simplified multi-block constitutive model predicting earthquake-induced landslide triggering and displacement along slip surfaces of saturated sand     

《Soil Dynamics and Earthquake Engineering》2014

Slopes consisting of saturated sand have recently moved down-slope tens or hundreds of meters under the action of earthquakes. This paper presents a simplified but accurate method predicting the triggering and displacement of such landslides. For this purpose, a simplified constitutive model simulating soil response of saturated sands along slip surfaces is proposed and validated. Then, this constitutive model is coupled with the multi-block sliding system model to predict the triggering and displacement of such slides. The multi-block model considers a general mass sliding on a trajectory which consists of n linear segments. The steps needed to apply this method are described in detail. The method was applied successfully to predict the triggering, the motion and the final configuration of the well-documented (a) Higashi Takezawa, (b) Donghekou and (c) Nikawa earthquake-induced slides.  相似文献   

黄土山区煤层群分层开采地表位移规律分析     

沈宇恒 《北京测绘》2020,(4):490-494

为了研究黄土山区地形对煤层群开采地表位移的影响,以榆林某矿为地质原型,利用数值软件模拟地表为近水平、正坡、负坡、凸面和凹面五种地形条件下煤层群开采。结果表明:黄土山区地形的变化,对煤层群开采顶板垂直应力影响不明显,对地表位移影响较大;单向坡开采,斜坡滑移引起的下沉量在坡顶与开采沉陷量形成“叠加”,在坡底形成“抵消”;在组合坡中,煤层群开采地表位移量相差很大,说明在变坡点附近地表位移较为复杂。  相似文献   

Critical Top Tension for Static Equilibrium Configuration of A Steel Catenary Riser     

Chainarong ATHISAKUL  Karun KLAYCHAM  Somchai CHUCHEEPSAKUL 《中国海洋工程》2014,(6):829-842

This paper aims to present the critical top tension for static equilibrium configurations of a steel catenary riser（SCR） by using the finite element method. The critical top tension is the minimum top tension that can maintain the equilibrium of the SCR. If the top tension is smaller than the critical value, the equilibrium of the SCR does not exist. If the top tension is larger than the critical value, there are two possible equilibrium configurations. These two configurations exhibit the nonlinear large displacement. The configuration with the smaller displacement is stable, while the one with larger displacement is unstable. The numerical results show that the increases in the riser＇s vertical distances, horizontal offsets, riser＇s weights, internal flow velocities, and current velocities increase the critical top tensions of the SCR. In addition, the parametric studies are also performed in order to investigate the limit states for the analysis and design of the SCR.  相似文献   

Political ecology of tiger conservation in India: Adverse effects of banning customary practices in a protected area     

Nitin D. Rai  Tor A. Benjaminsen  Siddhartha Krishnan  C. Madegowda 《Singapore journal of tropical geography》2019,40(1):124-139

Protected areas have had significant impacts on local communities primarily through the physical removal of people. In some instances, people continue to live within protected areas due to the inability of the state to evict them. The restrictions on livelihoods placed on people living inside protected areas lead to in situ displacement. We show how conservation enclosures in the Biligiri Rangaswamy Temple Tiger Reserve have produced a class of people that the state ‘lets die’ by banning customary practices such as fire use, hunting and harvesting of forest produce. Using longitudinal ethnographic, socio‐economic and ecological data, we demonstrate that conservation policy has alienated indigenous forest dwellers from their agricultural and forest‐land. The outcomes of conservation policy include dispossession through increased crop losses, reduced income from agriculture and forest produce, as well as a forest that is dominated by weeds due to fire suppression. The ban on hunting in particular has increased wildlife densities, which has enabled the state to accumulate revenues through the establishment of wildlife tourism facilities. All in all, centralized protected area governance has changed the relationships among people, forest and the state in a way that has produced adverse effects for both livelihoods and the ecosystem.  相似文献   

Analysis of rectangular piles subjected to lateral loads in nonhomogeneous soil using a Winkler model approach          下载免费PDF全文

Hiroyoshi Hirai 《国际地质力学数值与分析法杂志》2015,39(9):937-968

An analytical approach using a Winkler model based on two lateral soil displacement components in a three‐dimensional soil is investigated to provide analytical solutions of horizontal response of a rectangular pile subjected to lateral loads in nonhomogeneous soil. The two lateral displacement components of a soil surrounding the rectangular pile are represented by the Fourier series of displacement potential functions in the elastic three‐dimensional analysis. The lateral stiffness coefficient of the rectangular pile shaft in nonhomogeneous soil is derived from the rocking stiffness coefficient taking into account rocking rotation of a rigid pile shaft. The relationship between horizontal displacement, rotation, moment, and shear force for the rectangular pile subjected to horizontal loads in nonhomogeneous soil is obtainable in the form of the recurrence equation. The formulation of lateral displacement and rotation for a rectangular pile subjected to lateral loads on the pile base in nonhomogeneous soil is proposed by taking into account Mindlin's equation and the equivalent thickness for soil layers in the equivalent elastic method. The difference of lateral behavior between square and circular piles subjected to lateral loads is insignificant. The effect of aspect ratio of the rectangular pile on the lateral behavior is great for the lower stiffness ratio between pile and soil and the larger length–equivalent diameter ratio. The effect of the value of Poisson's ratio of soil on lateral stiffness coefficient is relatively small except Poisson's ratio close to 0.5. The comparison of the results calculated by the current method for a rectangular pile subjected to lateral loads in nonhomogeneous soil has shown good agreement with those obtained from the analytical methods and the finite element method. Copyright © 2015 John Wiley & Sons, Ltd.  相似文献   

Displacement analytical prediction of shallow tunnel based on unified displacement function under slope boundary     

Fanchao Kong  Dechun Lu  Xiuli Du  Chenpeng Shen 《国际地质力学数值与分析法杂志》2019,43(1):183-211

For slope condition of ground surface, the asymmetrical deformation about the vertical center line and the horizontal center line of the tunnel cross section can be formed. A unified displacement function expressed by the Fourier series is presented to express the asymmetrical deformation of the tunnel cross section. Five basic deformation modes corresponding to the expansion order 2 are a complete deformation mode to reflect deformation behaviors of the tunnel cross section under slope boundary. Such this complete displacement mode is implemented into the complex variable solution for analytically predicting tunneling-induced ground deformation under slope boundary. All of these analytical solutions are verified by good agreements of the comparison between the analytical solutions and finite element method results. A parameter study is carried out to investigate the influence of deformation modes of the tunnel cross section, geometrical conditions of the tunnel and the slope angle, and “Buoyancy effect” on the displacement field. Finally, the proposed method is consistent with measured data of the Hejie tunnel in China qualitatively. The presented solution can provide a simplified indication for evaluating the ground deformation under slope condition of ground surface.  相似文献   

Large‐scale poroelastic fractured reservoirs modeling using the fast multipole displacement discontinuity method          下载免费PDF全文

A. Verde  A. Ghassemi 《国际地质力学数值与分析法杂志》2016,40(6):865-886

An effective approach to modeling the geomechanical behavior of the network and its permeability variation is to use a poroelastic displacement discontinuity method (DDM). However, the approach becomes rather computationally intensive for an extensive system of cracks, particularly when considering coupled diffusion/deformation processes. This is because of additional unknowns and the need for time‐marching schemes for the numerical integration. The Fast Multipole Method (FMM) is a technique that can accelerate the solution of large fracture problems with linear complexity with the number of unknowns both in memory and CPU time. Previous works combining DDM and FMM for large‐scale problems have accounted only for elastic rocks, neglecting the fluid leak‐off from the fractures into the matrix and its influence on pore pressure and stress field. In this work we develop an efficient geomechanical model for large‐scale natural fracture networks in poroelastic reservoirs with fracture flow in response to injection and production operations. Accuracy and computational performance of the proposed method with those of conventional poroelastic DDM are compared through several case studies involving up to several tens of thousands of boundary elements. The results show the effectiveness of the FMM approach to successfully evaluate field‐scale problems for the design of exploitation strategies in unconventional geothermal and petroleum reservoirs. An example considering faults reveals the impact of reservoir compartmentalization because of sealing faults for both geomechanical and flow variables under elastic and poroelastic rocks. Copyright © 2015 John Wiley & Sons, Ltd.  相似文献   

Soil‐pile interaction in the pile vertical vibration considering true three‐dimensional wave effect of soil     

W.B. Wu  K.H. Wang  Z.Q. Zhang  Chin Jian Leo 《国际地质力学数值与分析法杂志》2013,37(17):2860-2876

The dynamic response of an end bearing pile embedded in a linear visco‐elastic soil layer with hysteretic type damping is theoretically investigated when the pile is subjected to a time‐harmonic vertical loading at the pile top. The soil is modeled as a three‐dimensional axisymmetric continuum in which both its radial and vertical displacements are taken into account. The pile is assumed to be vertical, elastic and of uniform circular cross section. By using two potential functions to decompose the displacements of the soil layer and utilizing the separation of variables technique, the dynamic equilibrium equation is uncoupled and solved. At the interface of soil‐pile system, the boundary conditions of displacement continuity and force equilibrium are invoked to derive a closed‐form solution of the vertical dynamic response of the pile in frequency domain. The corresponding inverted solutions in time domain for the velocity response of a pile subjected to a semi‐sine excitation force applied at the pile top are obtained by means of inverse Fourier transform and the convolution theorem. A comparison with two other simplified solutions has been performed to verify the more rigorous solutions presented in this paper. Using the developed solutions, a parametric study has also been conducted to investigate the influence of the major parameters of the soil‐pile system on the vertical vibration characteristics of the pile. Copyright © 2013 John Wiley & Sons, Ltd.  相似文献   

测斜技术原理与作业要点探讨     

侯金波  李更召  陈潇  朱俊鹏 《测绘与空间地理信息》2016,(6)

深层水平位移监测(即测斜)能直接反映土体或支护结构的变形特征,是高风险建筑基坑工程安全的重要保证。本文对测斜技术原理进行了阐述,并根据工程实践经验对测斜监测的作业要点进行了探讨与总结。  相似文献   

地面三维激光扫描仪测量误差检定     

代志宇  肖昭然  王力  杨文峰 《测绘与空间地理信息》2016,(7):79-81

在利用三维激光扫描仪进行测量工作前,我们首先应了解其实际测量精度是否符合标称精度,而可靠的评价方式对得到精确的数据结果至关重要。本文利用北京卓立汉光TSA50-C型电动位移台作为评价标准,通过其精确的位移功能,准确地评价了RIGEL VZ-400三维激光扫描仪在测量单点位移时的误差,从而得到了其最佳工作距离。  相似文献