利用钻芯孔检测灌注桩钢筋笼长度的方法     

樊敬亮  董平  叶景艳  李明  朱国伟 《物探与化探》2008,32(3):335-337

根据充电法原理,结合模型桩试验,分析了钢筋笼周围的充电电场特征,结果表明钢筋笼的底端对应于电位梯度曲线的极小值点及电位曲线的拐点。以此研究结果为基础,提出了利用钻芯孔来检测成桩后钢筋笼长度的方法。某桥的应用表明,该方法简便、实用、可靠。  相似文献   

Chebyshev逼近滤波器在位场分离中的应用   总被引：1，自引：0，他引：1  

蒋甫玉  孟令顺  张凤旭  高丽坤 《物探与化探》2008,32(3):311-315

在对经典FIR数字滤波器的设计方法进行研究的基础上,提出了一种可以用于位场分离的基于Chebyshev最佳一致逼近原理的FIR滤波器的设计方法。在理论模型实验中,采用基于Hanning窗的低通滤波器计算出的区域异常最大误差为6.266×10^-6 m/s² ,均方差为2.115×10^-6 m/s² ,最大百分比误差为22.2%,而且计算点在±9 km以外的误差均大于10.1%。而利用最佳一致逼近原理分离出的区域场和局部场与理论异常值拟合得较好,曲线基本重合。分离出的区域异常最大误差为3.101×10^-6 m/s² ,均方差为0.989×10^-6 m/s² ,最大百分比误差仅在边部的几个数据上,为7.76%,其余各点的误差均小于4.1%。实例检验中将该方法用于孙吴—嘉荫剖面布格重力异常场的分离,分离出的区域场中局部场残留少,分离彻底,效果较为理想。  相似文献   

Estimating Influence of Crystallizing Latent Heat on Cooling-Crystallizing Process of a Granitic Melt and Its Geological Implications     

ZHANG Bangtong  WU Junqi  LING Hongfei  CHEN Peirong 《《地质学报》英文版》2008,82(2):438-443

Based on the theory of thermal conductivity, in this paper we derived a formula to estimate the prolongation period （AtL） of cooling-crystallization process of a granitic melt caused by latent heat of crystallization as follows：△tL=QL×△tcol/（TM-TC）×CP where TM is initial temperature of the granite melt, Tc crystallization temperature of the granite melt, Cp specific heat, △tcol cooling period of a granite melt from its initial temperature （TM） to its crystallization temperature （Tc）, QL latent heat of the granite melt.
The cooling period of the melt for the Fanshan granodiorite from its initial temperature （900℃） to crystallization temperature （600℃） could be estimated -210,000 years if latent heat was not considered. Calculation for the Fanshan melt using the above formula yields a AtL value of -190,000 years, which implies that the actual cooling period within the temperature range of 900°-600℃ should be 400,000 years. This demonstrates that the latent heat produced from crystallization of the granitic melt is a key factor influencing the cooling-crystallization process of a granitic melt, prolongating the period of crystallization and resulting in the large emplacement-crystallization time difference （ECTD） in granite batholith.  相似文献   

Jurassic Tectonics of North China: A Synthetic View   总被引：21，自引：1，他引：20  

ZHANG Yueqiao  DONG Shuwen  ZHAO Yue  ZHANG Tian 《《地质学报》英文版》2008,82(2):310-326

This paper gives a synthetic view on the Jurassic tectonics of North China, with an attempt to propose a framework for the stepwise tectonic evolution history. Jurassic sedimentation, deformation and magmatism in North China have been divided into three stages. The earliest Jurassic is marked by a period of magmatism quiescence （in 205-190 Ma） and regional uplift, which are considered to be the continuation of the “Indosinian movement” characterized by continent-continent collision between the North and South China blocks. The Early to Middle Jurassic （in 190-170 Ma） was predominated by weak lithospheric extension expressed by mantle-derived plutonism and volcanism along the Yanshan belt and alongside the Tan-Lu fault zone, normal faulting and graben formation along the Yinshan- Yanshan tectonic belt, depression and resuming of coal-bearing sedimentation in vast regions of the North China block （NCB）. The Middle to Late Jurassic stage started at 165y.5 Ma and ended up before 136 Ma; it was dominated by intensive intraplate deformation resulting from multi-directional compressions. Two major deformation events have been identified. One is marked by stratigraphic unconformity beneath the thick Upper Jurassic molasic series in the foreland zones of the western Ordos thrust-fold belt and along the Yinshan-Yanshan belt; it was predated 160 Ma. The other one is indicated by stratigraphic unconformity at the base of the Lower Cretaceous and predated 135 Ma. During this last stage, two latitudinal tectonic belts, the Yinshan-Yanshan belt in the north and the Qinling-Dabie belt in the south, and the western margin of the Ordos basin were all activated by thrusting; the NCB itself was deformed by the NE to NNE-trending structural system involving thrusting, associated folding and sinistral strike-slip faulting, which were spatially partitioned. Foliated S-type granitic plutons aged 160-150 Ma were massively emplaced in the Jiao-Liao massif east of the Tan-Lu fault zone and indicate important crustal thicken  相似文献   

Distribution of Palygorskite in the Lingtai Profile of Chinese Loess Plateau: Its Paleoclimatic Implications     

XIE Qiaoqin  CHEN Tianhu  Chen Jun  Ji Junfeng  XU Huifang  XU Xiaochun 《《地质学报》英文版》2008,82(5):967-974

Palygorskite is a typical indicator mineral of the arid and strong evaporation environment. Distribution of palygorskite in loess-red clay sequences may act as an important indicator for reconstruction of the paleoenvironment and paleoclimate. In this paper, field emission scanning electron microscope and high-resolution transmission electron microscope observations on the red clay-loess-paleosol of the Renjiapo profile at Lingtai, Gansu Province indicate that palygorskite occurs widely in red clay sequences formed before 3.6 Ma, but no occurrence has been found in eolian sediments since 3.2 Ma. Micromorphological features and microstructure of palygorskite show that it is an autogenic mineral formed during pedogenesis, and transformed from iilite-montmorilionite under the pore water action. In the Lingtai profile, the disappearance horizon of palygorskite is consistent with those of increasing magnetic susceptibility, dust flux and depositional rate. The distribution of palygorskite in the profile indicates that the interval of around 3.6 Ma was an important transformation period of the East Asian paleomonsoon, when changes took place in the East Asia paleoclimate pattern, i.e. a high-frequency strong fluctuation alternative evolution of the environment. Therefore, palygorskite is a key indicator mineral of the East Asian paleomonsoon evolution of that time.  相似文献   

浙江五亩山地区钨矿容矿构造及找矿方向   总被引：1，自引：0，他引：1       下载免费PDF全文

李春海  吴昌志  郭坤一  包超民  邢光福 《地质找矿论丛》2008,23(1):22-26

五亩山地区燕山期花岗岩侵入活动后,形成了高温热液裂隙石英脉型黑钨矿(白钨矿)矿床.矿化脉体多分布在区域断裂的裂隙构造中,矿化体在地表以中(或低)角度产出,向下以高角度产出,或者两者交替产出形成类似于倾斜的"阶梯"状.通过对含矿裂隙的测量和统计,确定了成矿前或成矿期的裂隙,NE向裂隙为钨矿的容矿构造,并提出了找矿方向.  相似文献   

水文时间序列周期识别的新思路与两种新方法   总被引：3，自引：0，他引：3       下载免费PDF全文

桑燕芳  王栋 《水科学进展》2008,19(3):412-417

针对水文序列周期识别的困难,提出首先对原序列处理,再识别周期的新思路,同时提出两种新方法:一种是模拟延长序列法,即通过建模延长原序列,再应用最大熵谱分析法(MESA)对延长序列识别周期;另一种方法是构建主频序列法,应用小波重构法重构原序列主频部分,然后应用MESA对重构序列进行周期识别。结合实例,运用多种方法对同一序列进行周期识别。分析结果表明:由于受序列长度偏短、偏态性、复杂随机成分等因素的影响,传统单一处理方法(周期图法、FFT、MESA、小波分析)周期识别效果并不理想,而使用两种新方法可以有效地减小或消除上述因素的影响,周期识别效果有明显改善。  相似文献   

某公路路基填土工程地质性质研究     

梁清雨  阎长虹  夏文俊  崔大伟  张睿  周欣  陈明珠  郑军 《工程地质学报》2008,16(2):228-232

盱眙地区软土成因复杂,矿物成分特殊,本文通过对其矿物成分、化学成分、颗粒分析、物理指标、膨胀性、压缩性等试验研究,对该软土的工程性质取得一些认识。结果认为该类软土中粘土矿物含量高、亲水性强,填土液塑限高、有机质含量高;在含水量高时碾压成饼状,含水量低时坚硬难以破碎,不能直接做路基填料,采用常规的掺灰处理效果不理想,是一种特殊性软土。  相似文献   

地质和岩土工程光纤传感监测技术综述   总被引：3，自引：0，他引：3  

隋海波  施斌  张丹  王宝军  魏广庆  朴春德 《工程地质学报》2008,16(1):135-143

光纤传感器与常规传感器相比具有很大的优越性,已经成为地质和岩土工程监测领域中的研究热点。本文介绍了光纤传感监测系统的种类、基本测量原理和目前国内外的研究发展状况,并对各种传感技术的性能和特点进行了比较,指出了光纤传感监测技术应用于地质和岩土工程监测尚需研究的相关课题。  相似文献   

江西金山金矿含金黄铁矿的Rb-Sr年龄   总被引：6，自引：0，他引：6  

毛光周  华仁民  高剑峰  龙光明  陆慧娟 《地球学报》2008,29(5):599-606

前人对江西金山金矿的成矿时代有许多不同的认识,笔者通过对江西金山蚀变岩型矿石中的含金黄铁矿Rb-Sr年龄的测定得出,含金黄铁矿的Rb-Sr等时线年龄为(838±110)Ma,initial87Sr/86Sr=0.7045±0.0020。由此可以推测晋宁期是蚀变岩型金矿体形成的主要时期。黄铁矿Rb-Sr所得的Sr同位素初始比(87Sr/86Sr)i小于陆源硅酸盐的值(0.720),而与玄武岩的值(0.704)接近,结合前人有关的同位素及稀土、微量元素研究,笔者认为金山金矿变质岩型矿体的成矿物质源于变质围岩,成矿流体为来源于深部的变质水。  相似文献