预应力混凝土连续梁桥振动特性变异及舒适度评价   总被引：1，自引：1，他引：1  

宗周红  赖苍林  夏樟华 《地震工程与工程振动》2006,26(1):71-77

由于预应力损失、混凝土收缩徐变、超载等原因,预应力混凝土桥梁出现了较强的振动。本文通过对福建省福州市闽江三桥全桥环境振动试验和正常运营条件下24小时的监测,研究预应力混凝土连续梁桥的动力特性及其变异和振动舒适度,结果表明:在较为稳定的风和温湿度环境下,固有频率在一天内的最大变化为3.06%,模态阻尼比的最大变化为37.93%,舒适度的狄克曼指标降到“能忍受短时间振动”的区域。  相似文献   

改善钢筋混凝土短柱抗震性能的研究     

宋义平  曹万林  张建伟  王新杰  范燕飞  王志惠 《世界地震工程》2007,23(1):17-20

简要介绍了改善钢筋混凝土短柱抗震性能的若干措施。为进一步提高短柱的抗震性能，本文提出了内藏“斜向劲性核心束”矩形截面混凝土短柱，并进行了7根短柱的抗震性能试验研究，试验表明，内藏“斜向劲性核心束”矩形截面混凝土短柱比普通矩形截面短柱的抗震性能显著提高。  相似文献   

型钢高强混凝土柱轴压比限值的试验研究   总被引：2，自引：0，他引：2  

李俊华  薛建阳  王新堂  赵鸿铁 《世界地震工程》2007,23(2):154-160

通过20个型钢高强混凝土柱的低周反复加载试验对其受力性能进行了研究，分析了剪跨比、轴压比、配箍率以及混凝土强度对型钢高强混凝土柱延性的影响，提出了不同剪跨比、不同配箍率的型钢高强混凝土柱的轴压比限值。其中，剪跨比大于2．0的型钢高强混凝土柱的轴压比限值由大、小偏心界限破坏时力的平衡条件并结合试验结果确定，而剪跨比小于2．0的型钢高强混凝土柱的轴压比限值则通过与剪跨比大于2．0的型钢高强混凝土柱的延性对比加以确定。  相似文献   

Pre‐ and post‐test mathematical modelling of a plan‐asymmetric reinforced concrete frame building     

Peter Fajfar  Matja Dol&#x;ek  Damjan Maru&#x;i&#x;  Aurel Stratan 《地震工程与结构动力学》2006,35(11):1359-1379

Pre‐ and post‐test analyses of the structural response of a three‐storey asymmetric reinforced concrete frame building were performed, aimed at supporting test preparation and performance as well as studying mathematical modelling. The building was designed for gravity loads only. Full‐scale pseudo‐dynamic tests were performed in the ELSA laboratory in Ispra. In the paper the results of initial parametric studies, of the blind pre‐test predictions, and of the post‐test analysis are summarized. In all studies a simple mathematical model, with one‐component member models with concentrated plasticity was employed. The pre‐test analyses were performed using the CANNY program. After the test results became available, the mathematical model was improved using an approach based on a displacement‐controlled analysis. Basically, the same mathematical model was used as in pre‐test analyses, except that the values of some of the parameters were changed. The OpenSees program was employed. Fair agreement between the test and numerical results was obtained. The results prove that relatively simple mathematical models are able to adequately simulate the detailed seismic response of reinforced concrete frame structures to a known ground motion, provided that the input parameters are properly determined. Copyright © 2006 John Wiley & Sons, Ltd.  相似文献   

Mechanical compression release device in steel bracing system for retrofitting RC frames     

H. Ghaffarzadeh M.R. Maheri 《地震工程与工程振动(英文版)》2006,5(1):151-158

1 Introduction Braced steel frames are commonly used to resist seismic loads. Their seismic behavior was extensively studied during the past decades (Bertero et al.., 1989; Roeder, 1989; Jain, 1978). Their design is governed by the buckling behavior of the bracing members (ASCE, 1994,2002; CSA, 1994). To prevent or delay the seismic buckling of compressive members in concentrically braced frames in steel structures, a great number of methods have been proposed. These include the use of sp…  相似文献   

An evaluation of force-based design vs. direct displacement-based design of jointed precast post-tensioned wall systems     

M. Ataur Rahman Sri Sritharan 《地震工程与工程振动(英文版)》2006,5(2):285-296

The unique features of jointed post-tensioned wall systems, which include minimum structural damage and re-centering capability when subjected to earthquake lateral loads, are the result of using unbonded post-tensioning to attach the walls to the foundation, along with employing energy dissipating shear connectors between the walls. Using acceptance criteria defined in terms of inter-story drift, residual drift, and floor acceleration, this study presents a multiplelevel performance-based seismic evaluation of two five-story unbonded post-tensioned jointed precast wall systems. The design and analysis of these two wall systems, established as the direct displacement-based and force-based solutions for a prototype building used in the PREcast Seismic Structural Systems （PRESSS） program, were performed at 60% scale so that the analysis model could be validated using the PRESSS test data. Both buildings satisfied the performance criteria at four levels of earthquake motions although the design base shear of the direct displacement-based jointed wall system was 50% of that demanded by the force-based design method. The study also investigated the feasibility of controlling the maximum transient inter-story drift in a jointed wall system by increasing the number of energy dissipating shear connectors between the walls but without significantly affecting its re-centering capability.  相似文献   

FRP约束混凝土柱抗震性能若干问题的探讨   总被引：3，自引：0，他引：3  

于清  陶忠  高献 《地震工程与工程振动》2006,26(4):75-82

基于实验研究和理论分析结果,对纤维增强复合材料(FRP)约束混凝土柱抗震性能研究中存在的若干关键问题进行了探讨,包括FRP约束混凝土构件在往复荷载作用下的受力特点、破坏特征、荷载-位移关系、弯矩-曲率关系、耗能及延性变化规律等,最后重点探讨了FRP约束混凝土柱在往复荷载作用下的刚度特性。  相似文献   

轴压比对中等高度LC结构剪力墙抗震性能的影响   总被引：2，自引：0，他引：2  

汪明栋  王铁成  于庆荣  孙晔 《地震工程与工程振动》2006,26(4):96-100

轻骨料混凝土(L ight-we ight concrete,简称LC)剪力墙的轴压比是剪力墙抗震设计时一个重要的控制因素,直接关系到其延性性能。为使设计规程具有足够的理论依据,本文通过对六榀轻骨料混凝土剪力墙试件的试验,研究了在低周反复荷载作用下,着重考虑不同轴压比对中等高度有边框剪力墙的破坏形态和变形性能的影响效应,对其滞回特性进行分析,计算了各剪力墙的刚度退化率与延性系数,并将无竖缝剪力墙与带竖缝剪力墙的抗震性能进行了对比。  相似文献   

消能减震高层方钢管混凝土框架结构振动台试验研究和弹塑性时程分析   总被引：2，自引：0，他引：2  

吕西林  孟春光  田野 《地震工程与工程振动》2006,26(4):231-238

本文首先介绍了一幢安装了粘滞阻尼器的复杂体型高层方钢管混凝土框架结构的1/15缩尺模型的模拟地震振动台试验结果;在此基础上,建立了梁、柱构件的多弹簧模型并组建了整体结构的计算分析模型,运用此计算模型首先对试验模型结构进行了动力弹塑性时程分析,计算结果和试验结果吻合较好,验证了计算模型的正确性;最后,以同样方法对原型结构进行了计算分析,并结合试验结果研究探讨了此结构的抗震性能和阻尼器的消能减震效果。结果表明:该结构未出现明显的薄弱层,能够满足规范的抗震设防要求,阻尼器发挥了一定的消能减震效果,进一步提高了结构的抗震性能。  相似文献   

建立回弹现场测强曲线的位置参数法     

胡寿康  陈海彬  高静  李素娟 《地震工程与工程振动》2006,26(4):244-246

工程上迫切需要在现场数据较少的情况下,建立高精度和高可靠度的现场测强曲线(经验公式)。本文利用位置参数法,提出了一种回弹法现场测强曲线(经验公式)。此曲线(经验公式)仍运用原有的幂函数形式并保持回归参数不变,通过增加位置参数反映现场试验的个性信息。此曲线(经验公式)融合了所在地区混凝土强度值、回弹值、碳化深度值之间的共性趋势和现场检测得到的反映现场情况的个性信息,而且解决了地区测强曲线(经验公式)不能完全描述现场的实际情况,而现场检测数据一般不能满足制定现场专用测强曲线(经验公式)要求的问题。在建筑结构无损检测中,利用本文提出的测强曲线(经验公式)可以极大地提高检测精度和检测结果的可靠性,使检测结果更加符合施工现场的实际情况。  相似文献