Early Identification of the Jiangdingya Landslide of Zhouqu Based on SBAS-InSAR Technology   总被引：1，自引：1，他引：0  

YU Haihu  CAI Guolin  GAN Quan  SHEN Dong 《中国地震研究》2020,34(4):510-522

SBAS-InSAR technology is characterized by the advantages of reducing the influence of terrain-simulation error, time-space decorrelation, atmospheric error, thereby improving the reliability of surface-deformation monitoring. This paper studies the early landslide identification method based on SBAS-InSAR technology. Selecting the Jiangdingya landslide area in Zhouqu County, Gansu Province as the research area, 84 ascending-orbit Sentinel-1A SAR images from 2015 to 2019 are collected. In addition, using SBAS-InSAR technology, the rate and time-series results of surface deformation of the landslide area in Jiangdingya during this period are extracted, and potential landslides are identified. The results show that the early landslide identification method based on SBAS-InSAR technology is highly feasible and is a better tool for identifying potential landslides in large areas.  相似文献   

考虑冲刷影响的筒型基础竖向极限承载力研究     

陆罗观  刘润  练继建  陈广思 《海洋工程》2019,37(3):69-77

大直径宽浅式筒型基础,阻水宽度大,在位工作期间受波浪海流作用,其周围土体易被冲刷。为研究单侧地基土体受冲刷后筒型基础的竖向极限承载力变化,通过引进冲刷率的概念,采用有限元方法研究了不同冲刷率下筒型基础的竖向极限承载力;并基于Meyerhof理论建立了计算不同冲刷率下筒型基础竖向极限承载力的极限平衡方法。研究结果表明,随着冲刷率增大,筒型基础的极限承载力出现不同程度的下降,当冲刷率为0.8时,即筒型基础单侧土体冲刷深度达6.4 m时,筒型基础的竖向极限承载力折减率为3.28%。建立的极限平衡算法可准确计算冲刷条件下筒型基础的竖向极限承载力。  相似文献   

Undrained lower bound solutions for end bearing capacity of shallow circular piles in non-homogeneous and anisotropic clays     

Boonchai Ukritchon  Suraparb Keawsawasvong 《国际地质力学数值与分析法杂志》2020,44(5):596-632

The undrained bearing capacity of shallow circular piles in non-homogeneous and anisotropic clay is investigated by the lower bound (LB) finite element limit analysis (FELA) under two-dimensional (2D) axisymmetric condition using second-order cone programming, and the new solution of the problem is presented. Modified from the isotropic von Mises yield criterion, a cross-anisotropic undrained strength criterion of clays under the axisymmetric state of stress requiring three input shear strengths in triaxial compression, direct simple shear, and triaxial extension is employed in the 2D axisymmetric LB FELA. Parametric studies on the effects of pile embedment ratio, dimensionless strength gradient, anisotropic strength ratio, and pile roughness are investigated extensively, while the predicted failure mechanisms associated with these parameters are discussed and compared. Numerical results of undrained end bearing capacity of shallow circular piles are summarized in the form of design tables that are useful for design practice and represent a new contribution to the field of pile capacity considering the combined effects of undrained strength non-homogeneity and anisotropy.  相似文献   

可替换式桥梁横向防落梁限位装置抗震性能研究          下载免费PDF全文

闫磊  安康  岳克锋  李果  尹修城  姜渝  付亚男 《世界地震工程》2020,(3):172-180

针对目前桥梁结构横向防落梁限位装置损毁后修复困难的问题，提出一种新型的带可更换耗能段的桥梁横向防落梁限位装置。分别以可更换耗能段的腹板厚度、腹板高度及安装位置等为参数，采用有限元软件ABAQUS建立了10个不同参数的装置模型并对其开展拟静力仿真试验，探讨其工作机理，验证其可更换的设计思想并剖析其破坏机理，研究各参数对装置滞回曲线、承载力、延性和耗能能力的影响规律。结果表明:该装置可通过先可更换耗能段破坏再竖板破坏达到多道设防和分级耗能的目的，且整个加载过程中装置的滞回曲线饱满、稳定、无明显捏拢，表现出良好的耗能能力；随着可更换耗能段腹板厚度的增加，装置屈服承载力、极限承载力、屈服位移、极限位移以及延性系数逐渐增大，耗能能力逐渐增强；可更换耗能段高度对装置屈服承载力影响不显著；随着可更换耗能段高度的增加，装置极限承载力逐渐增大，装置屈服位移先增大后减小，装置极限位移整体呈下降趋势，装置的延性系数和耗能能力逐渐减小；可更换耗能段的安装高度对装置屈服承载力和耗能能力的影响无统一规律，但与装置的屈服位移、极限位移及延性系数成负相关。基于本析结果，建议装置在满足承载力要求的前提下，应尽量选取可更换耗能段腹板厚度较厚、高度较小和安装位置较低的参数进行设计。  相似文献   

Analysis of resistance factors for LRFD of soil nail pullout limit state using default FHWA load and resistance models     

Hui Hu 《Marine Georesources & Geotechnology》2020,38(3):332-348

Abstract

Resistance factors for load and resistance factor design (LRFD) of pullout limit state of both permanent and temporary soil nails are calibrated against a wide design space using the current Federal Highway Administration (FHWA) nail load and resistance models. The calculated resistance factors were shown to scatter broadly among design scenarios that differ in wall face batter, soil friction angle, nail ultimate bond strength, and surcharge live load. An important lesson learned from the analysis results is that the current practice of using a single resistance factor for LRFD of nail pullout limit state could not result in uniform reliabilities across different design scenarios. Simple artificial neural network (ANN) models were developed for computation of resistance factors. Design examples demonstrated the ability of the ANN models in providing resistance factors that yield satisfactory and consistent reliabilities in different nail pullout designs.  相似文献   

珊瑚颗粒形状对钙质粗粒土的压缩性能影响     

张斌  柴寿喜  魏厚振  孟庆山  陈杨 《工程地质学报》2020,28(1):85-93

珊瑚颗粒形状不规则是其显著区别于陆源土的一大特征。为揭示珊瑚颗粒形状对钙质粗粒土压缩性能的影响,人工挑选出不同形状(块状、枝状、棒状、片状)的珊瑚颗粒,以块状颗粒为基础,与其他3种不同形状的粗颗粒任意一种混合,控制不同颗粒形状配比制成钙质粗粒土试样,完成室内压缩试验,对比分析试验前后珊瑚颗粒的圆度、长宽比、扁平度和凹凸度等形状参数,评价颗粒形状对压缩性能的影响。结果表明:(1)粒径为10~20 mm钙质粗粒土的压缩模量是4~5. 5 MPa,回弹系数为42~53;(2)随枝状、棒状或片状颗粒掺量的增加(0、10%、20%、30%),试样压缩模量呈小幅波状变化,回弹系数呈持续减小趋势;(3)各加载区间应力-应变曲线包括应力快速增长阶段、应力-应变同步增长阶段、应变增长阶段共3个阶段和1个稳定点;(4)随枝状颗粒掺量的增加,试样的长宽比和凹凸度逐渐增加,圆度和扁平度基本无变化;因颗粒破碎的影响,试验后试样的长宽比及扁平度有所增加,圆度及凹凸度则有所减小。选择钙质粗粒土地基时,应考虑其压缩性能,避免施工初期的快速加载。  相似文献   

Damage assessment for submarine photoelectric composite cable under anchor impact     

《Applied Ocean Research》2018

The impact of dropped anchor on submarine photoelectric composite cables may possibly cause electrical faults, i.e. electricity and optical signal transmission failure. In order to study the impact capacity and structural impact failure mechanism, a test setup is designed originally to examine the structural and functional integrity. A detailed finite element model (FEM) is created, considering material nonlinearity and component interaction. A parametric analysis has been performed to predict the deformation of components and impact forces, under different impact velocities and collision directions. Relationships between the armor layer indentation rate and that of internal power and optical units are achieved. The impact deformation of internal entities can be evaluated intuitively by armor layer indentation. The proposed experimental and numerical methods are well correlated, suitable to assess the impact capacity of subsea power cables and assist the protection design of subsea power cables in engineering.  相似文献   

潮流界以下河段航道整治水位确定方法研究——以长江江阴以下河段为例     

徐元  贾雨少 《海洋工程》2018,36(2):64-72

在总结分析现有整治水位确定方法的基础上,根据潮流界以下河段的水沙运动特性,本文提出一种基于输沙能力的航道整治水位确定方法。考虑上游来水、下游潮汐为独立事件,统计潮流界以下河段上游来水、下游潮汐不同等级组合出现的频率,采用数学模型计算相应组合下河段沿程的潮位、流速过程,以流速四次方代表水流的输沙能力,统计不同潮位等级对应的综合净输沙能力,确定最大综合净输沙能力对应的水位为(最优)航道整治水位。以长江下游白茆沙水道和福姜沙水道为例,计算了所在河段的航道整治水位,并探讨了起动流速对整治水位计算的影响和最高整治水位概念对工程的意义。  相似文献   

Factors influencing undrained strength of fine-grained soils at high water contents     

H. B. Nagaraj  M. V. Sravan  B. S. Deepa 《Geomechanics and Geoengineering》2018,13(4):276-287

Understanding the undrained strength of fine-grained soils has been of interest to geotechnical researchers from many practical considerations. In several civil engineering applications, water content of soil is quite high being near or above the liquid limit of soils, and understanding the factors responsible for imparting the strength of soil at high water contents is of great significance. Recently, it has been reported in the literature that the shear strength of soils at these limiting water contents has significant variation. However, the reasons and the factors that probably influence for this variation have not been reported in the literature. This experimental investigation is an attempt in the direction of understanding the reasons for the variation in the undrained strength at higher limiting water content, namely liquid limit considering the various influencing factors like clay mineralogy and fine-sand content present in soil used for determining liquid limit. The results from this study are quite revealing and have been explained based on the mechanisms controlling the undrained strength at liquid limit.  相似文献   

丹阳天王寺边坡稳定性评价及防治措施     

余成  葛伟亚  常晓军 《江苏地质》2018,42(2):345-348

针对苏南地区典型露采边坡的地层岩性及地质构造特点,以极限平衡理论为基础,运用GeoStudio软件中的SLOPE/W模块和VADOSE/W模块计算分析江苏丹阳天王寺边坡在天然工况、暴雨工况及地震工况下的稳定性。结果表明:天然工况下,潜在滑动面分布范围最小,稳定性最高,存在滑动的危险性;暴雨工况下,潜在滑动面分布范围有所增大,稳定性降低,边坡滑动的可能性较大;地震工况下,潜在滑动面分布范围最广,稳定性最低,边坡滑动的可能性很大。基于上述结果,提出防治措施。  相似文献