喜马拉雅山脉中段土地覆被的垂直分异特征     

张镱锂  吴雪  郑度 《地理学报》2020,75(5):931-948

喜马拉雅山脉中段的珠穆朗玛峰等地,海拔高差巨大、生境复杂多变、土地覆被类型多样且植被垂直带谱完整,是全球范围内研究土地覆被垂直变化的理想场所。本文基于30 m空间分辨率的土地覆被数据（2010年）和DEM数据,在ArcGIS和Matlab平台的支持下,提出并运用脊线法、样带法和扇区法3种山地南北坡划分方法,研究了喜马拉雅山土地覆被垂直分布与结构差异。结果表明：① 山地土地覆被分布具有明确的垂直地带性结构特征,喜马拉雅中部土地覆被垂直带谱为南六北四式,土地覆被垂直带谱中具有人类活动的特点。② 南北坡之间的土地覆被垂直带谱差异明显,南坡土地覆被类型完整多样,北坡相对简单;对同类型土地覆被而言,南坡较北坡分布高程低、幅度宽。③ 依据各类型分布面积比随海拔变化情况,土地覆被类型在南北坡上的垂直分布可分为4种模式：冰川雪被、稀疏植被和草地为单峰分布型,裸地为南单峰北双峰分布型。④ 3种划分方法中,南坡的土地覆被垂直带结构具有相似性,而北坡的土地覆被垂直带结构存在差异,扇区法较好地反映了土地覆被自然分布格局。  相似文献   

Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis     

Ramin Pakzad  Shanyong Wang  Scott W. Sloan 《国际地质力学数值与分析法杂志》2020,44(10):1472-1494

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.  相似文献   

Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials          下载免费PDF全文

Chao Jiang  Gao‐Feng Zhao 《国际地质力学数值与分析法杂志》2018,42(4):674-693

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.  相似文献   

鄂尔多斯地块周缘垂直形变场负位错反演与应变积累研究     

张希  刘立炜  郝明  白卓立 《大地测量与地球动力学》2019,39(6):551-556

利用鄂尔多斯地块及其周缘1970～2014年的垂直形变速率场资料，借助负位错反演研究该区域长期应变积累。结果表明，地块东北缘山西断陷带中北段年均能量积累增量、剪应力强度都较高，西南缘六盘山断裂与渭河断裂西段次之；山西断陷带中南段至晋陕交界处年均剪应力强度较高且显示一定程度的能量积累；西秦岭构造区尤其西秦岭北缘断裂西段、晋冀蒙交界区也反映一定程度的能量积累特性。  相似文献   

铜藻(Sargassum horneri)在营养限制胁迫后对NH₄-N的超补偿吸收研究     

李大鹏  马增岭  李慧  丁刚  辛美丽  吴海一  郭文 《海洋与湖沼》2018,49(4):904-909

以经济马尾藻铜藻(Sargassum horneri)为研究材料,研究了其在营养限制胁迫后对NH_4-N的超补偿吸收情况。实验分营养限制和恢复营养两个阶段进行,每个阶段均设置饥饿处理组、饱和处理组和正常对照组。铜藻在低营养限制胁迫(饥饿)下培养10天后,恢复营养盐培养3天,分别采用次溴酸盐氧化法和锌镉还原法测定培养液中的NH_4-N和NO_3-N的浓度。本文研究发现,饥饿处理组中铜藻吸收氨氮的速率远高于正常对照组和饱和处理组,在恢复培养第一天时,饥饿处理组对NH_4-N的吸收速率最高为14.94μmol/(g·h),与正常对照组及饱和处理组间差异显著。在恢复培养的后两天,三个处理组中铜藻对NH_4-N的吸收速率差异慢慢变小,直至最后几乎相同。三组对NO_3-N没有表现出较高的吸收,最高仅为6.15μmol/(g·h),结果表明:氮源包括NH_4-N和NO_3-N时,铜藻优先选择吸收NH_4-N。实验后称重测定生长速率:对照组、饥饿处理组和饱和组生长率(SGR)分别为8.48%、8.86%、8.01%,ANOVA方差分析表明,三者存在显著差异(P=0.0320.05),从而证实了铜藻也存在超补偿生长的现象。  相似文献   

鄂尔多斯盆地宜川地区二叠纪孢粉化石组合特征          下载免费PDF全文

高存山 《山东国土资源》2018,34(11)

通过对延长油矿延223井晚古生代孢粉组合研究以及古植被的恢复,探讨了该区晚古生代孢粉植物化石组合的地层学和古气候意义。根据孢粉化石主要属种的时代分布及其在各样品中百分含量的规律性变化,自下而上建立了3个孢粉组合:Gulisporites cochlearius-Laevigatosporites minimus组合、Sinulatisporites-Florinites组合和Lueckeisporites permianus-Platysaccus radialis组合。根据对划分孢粉组合的特征分析,通过与邻区及华北地区晚古生代孢粉组合的对比,探讨了孢粉组合的时代意义。通过孢粉组合,推测了相应时期的古植被类型,并与前人在相同地质时期所建立的大植物化石带进行了对比,分析了各地质时期植被的兴起、发展、繁盛以及衰退绝灭的历史过程,研究区二叠纪植物群属于典型的华夏植物群,反映了一种温暖潮湿的热带雨林气候,二叠纪晚期随着松柏类植物所占比例的增加,气候有变干旱的趋势。  相似文献   

Explicit stress–strain equations for modeling frictional materials     

Kenneth J. Xu  Martin D. Liu  Buddhima Indraratna 《Marine Georesources & Geotechnology》2018,36(6):722-734

In this paper, a comprehensive study on simulating the shearing behavior of frictional materials is performed. A set of two explicit equations, describing the relationship among the shear stress ratio and the distortional strain and the volumetric strain, are formulated independently. The equations contain three stress parameters and three strain parameters and another parameter representing the nonuniformity of stress and strain during softening. All the parameters have clear physical significance and can be determined experimentally. It is demonstrated that the proposed equations have the capacity of simulating the complicated shearing behavior of many types of frictional materials including geomaterials. The proposed equations are used to simulate the stress–strain behavior for 27 frictional materials with 98 tests. These materials include soft and stiff clays in both reconstituted and structured states, silicon sands and calcareous sands, silts, compacted fill materials, volcanic soils, decomposed granite soils, cemented soils (both artificially and naturally cemented), partially saturated soils, ballast, rocks, reinforced soils, tire chips, sugar, wheat, and rapeseed. It has been demonstrated that the proposed explicit constitutive equations have the capacity to capture accurately the shearing behavior of frictional materials both qualitatively and quantitatively. A study on model parameters has been performed.  相似文献   

基于圆柱多段拟合的隧道中轴线提取方法研究     

荆海峰  李广云  王力  杨文锋 《大地测量与地球动力学》2018,38(2):211-215

提出基于圆柱多段拟合的隧道中轴线提取方法。首先对隧道点云数据进行预处理，并将点云按隧道走向分成不同区段；然后对各区段依据轴线与表面点云法线垂直关系，提取精度较低的中轴线；最后对各区段利用圆柱多段拟合，提取精度较高的中轴线。实验表明，隧道中轴线的提取在一定的采样区间具有较高的稳定性，对直线和弯曲的圆形隧道有良好的适用性，算法可靠，精度较高。  相似文献   

A multiscale work-analysis approach for geotechnical structures     

Hao Xiong  Zhen-Yu Yin  François Nicot 《国际地质力学数值与分析法杂志》2019,43(6):1230-1250

This paper presents a second-order work analysis in application to geotechnical problems by using a novel effective multiscale approach. To abandon complicated equations involved in conventional phenomenological models, this multiscale approach employs a micromechanically-based formulation, in which only four parameters are involved. The multiscale approach makes it possible a coupling of the finite element method (FEM) and the micromechanically-based model. The FEM is used to solve the boundary value problem (BVP) while the micromechanically-based model is utilized at the Gauss point of the FEM. Then, the multiscale approach is used to simulate a three-dimensional triaxial test and a plain-strain footing. On the basis of the simulations, material instabilities are analyzed at both mesoscale and global scale. The second-order work criterion is then used to analyze the numerical results. It opens a road to interpret and understand the micromechanisms hiding behind the occurrence of failure in geotechnical issues.  相似文献   

利用短期静态PPP结果反演海潮负荷位移     

魏国光  王琪洁  彭葳  郭良琦 《大地测量与地球动力学》2019,39(6):607-612

采用香港11个GPS测站的观测资料进行1 h、2 h、3 h和4h静态PPP解算，获得4组PPP坐标序列，利用调和分析求取11个测站处8个主要分潮的负荷位移参数（振幅和相位），将其与海潮模型计算的负荷位移参数进行对比，并比较分析PPP反演值与海潮模型值改正海潮负荷信号的效果。结果表明，垂直和水平方向上，不同PPP结果反演8个分潮的负荷位移分别具有约5 mm和7 mm的差异；PPP反演8个分潮垂向负荷位移优于全球海潮模型，但水平方向上的反演效果稍弱。  相似文献