Methane content in coal seam is an essential parameter for the assessment of coalbed gas reserves and is a threat to underground coal mining activities. Compared with the adsorption-isotherm-based indirect method, the direct method by sampling methane-bearing coal seams is apparently more accurate for predicting coalbed methane content. However, the traditional sampling method by using an opened sample tube or collecting drill cuttings with air drilling operation would lead to serious loss of coalbed methane in the sampling process. The pressurized sampling method by employing mechanical-valve-based pressure corer is expected to reduce the loss of coalbed methane, whereas it usually results in failure due to the wear of the mechanical valve. Sampling of methane-bearing coal seams by freezing was proposed in this study, and the coalbed gas desorption characteristics under freezing temperature were studied to verify the feasibility of this method. Results show that low temperature does not only improve the adsorption velocity of the coalbed gas, but also extend the adsorption process and increase the total adsorbed gas. The total adsorbed methane gas increased linearly with decreasing temperature, which was considered to be attributed to the decreased Gibbs free energy and molecular average free path of the coalbed gas molecular caused by low temperature. In contrast, the desorption velocity and total desorbed gas are significantly deceased under lower temperatures. The process of desorption can be divided into three phases. Desorption velocity decreases linearly at the first phase, and then, it shows a slow decreases at the second phase. Finally, the velocity of desorption levels off to a constant value at the third phase. The desorbed coalbed gas shows a parabolic relation to temperature at each phase, and it increases with increasing temperature at the first phase, and then, it poses a declining trend with increasing temperature at the rest phases. The experimental results show that decreasing the system temperature can restrain desorption of coalbed methane effectively, and it is proven to be a feasible way of sampling methane-bearing coal seams.
A model integrating geo-information and self-organizing map (SOM) for exploring the database of soil environmental surveys was established. The dataset of 5 heavy metals (As, Cd, Cr, Hg, and Pb) was built by the regular grid sampling in Hechi, Guangxi Zhuang Autonomous Region in southern China. Auxiliary datasets were collected throughout the study area to help interpret the potential causes of pollution. The main findings are as follows: (1) Soil samples of 5 elements exhibited strong variation and high skewness. High pollution risk existed in the case study area, especially Hg and Cd. (2) As and Pb had a similar topo-logical distribution pattern, meaning they behaved similarly in the soil environment. Cr had behaviours in soil different from those of the other 4 elements. (3) From the U-matrix of SOM networks, 3 levels of SEQ were identified, and 11 high risk areas of soil heavy metal-contaminated were found throughout the study area, which were basically near rivers, factories, and ore zones. (4) The variations of contamination index (CI) followed the trend of construction land (1.353) > forestland (1.267) > cropland (1.175) > grassland (1.056), which suggest that decision makers should focus more on the problem of soil pollution surrounding industrial and mining enterprises and farmland.
Effectively estimating groundwater recharge is critical to manage water resources, especially in arid and semi-arid regions as impacted by intensive human activities and climate changes. Rare insights have been gained into groundwater recharge since direct observation is hard to carry out. Although several methods are currently available to estimate groundwater recharge, the estimated results may cover noticeable bias. The behaviours of different methods based on different conceptual frameworks and exhibiting different levels of complexity should be examined to estimate actual groundwater recharge. This study aims to assess the performance of four common methods to estimate groundwater recharge. For this end, large-scale lysimeters equipped with soil water content sensors and water table sensors were set up at a research site established in Guanzhong Basin of China. The data achieved by 1-year observation were employed to compare four estimation methods. As revealed from the results, the following findings are drawn. (a) Groundwater level fluctuation (GLF) method is simple, whereas its accuracy is determined by specific yield, and adopting a water balance method to estimate specific yield can considerably enhance the accuracy of GLF. (b) The calibrated numerical model can obtain the optimal result compared with the other methods, whereas long-term observation data are required for parameter calibration. (c) In the water balance method, the maximum entropy production (MEP) model and a practical method (estimating evaporation between two rainfall events) were used to calculate evaporation. As indicated by the results, water balance method combined with MEP is capable of obtaining more reliable results of groundwater recharge compared with the practical method. (d) With an analytical model based on linearized Richards' equation, accurate results can be achieved. What is more, the analytical model only needs the measurement of soil moisture near the surface. The limitation of this method is that it is difficult to determine the maximal water flux. The mentioned findings are of critical implications to the management and sustainable development of groundwater. 相似文献
Acta Geotechnica - In this paper, a simple but feasible approach is proposed to predict the time-dependent load carrying behaviours of jacked piles from CPTu measurements. The corrected cone... 相似文献
Migmatites are predominant in the North Qinling (NQ) orogen, but their formation ages are poorly constrained. This paper presents a combined study of cathodoluminescence imaging, U–Pb age, trace element and Hf isotopes of zircon in migmatites from the NQ unit. In the migmatites, most zircon grains occur as new, homogeneous crystals, while some are present as overgrowth rims around inherited cores. Morphological and trace element features suggest that the zircon crystals are metamorphic and formed during partial melting. The inherited cores have oscillatory zoning and yield U–Pb ages of c. 900 Ma, representing their protolith ages. The early Neoproterozoic protoliths probably formed in an active continental margin, being a response to the assembly of the supercontinent Rodinia. The migmatite zircon yields Hf model ages of 1911 ± 20 to 990 ± 22 Ma, indicating that the protoliths were derived from reworking of Palaeoproterozoic to Neoproterozoic crustal materials. The anatexis zircon yields formation ages ranging from 455 ± 5 to 420 ± 4 Ma, with a peak at c. 435 Ma. Combined with previous results, we suggest that the migmatization of the NQ terrane occurred at c. 455–400 Ma. The migmatization was c. 50 Ma later than the c. 490 Ma ultra‐high‐P (UHP) metamorphism, indicating that they occurred in two independent tectonic events. By contrast, the migmatization was coeval with the granulite facies metamorphism and the granitic magmatism in the NQ unit, which collectively argue for their formation due to the northward subduction of the Shangdan Ocean. UHP rocks were distributed mainly along the northern margin and occasionally in the inner part of the NQ unit, indicating that they were exhumed along the northern edge and detached from the basement by the subsequent migmatization process. 相似文献