排序方式： 共有15条查询结果，搜索用时 15 毫秒
1.
煤矿冲击矿压现象日益严峻,作为矿山动力灾害的主要监测手段,微震监测系统已在许多矿井广泛使用,为保证矿震定位和能量计算的准确,提高预测预报煤矿冲击矿压的可行性,应建立一套台网布设优化及评价系统.应用微震定位和D值优化设计理论,结合煤矿实际条件研究了影响矿震定位精度的主要因素和不利条件,并提出了采用综合指数法确定煤矿高微震活动区域和区域内矿震发生的概率,制定了台站候选点和监测区域确定的一般原则.通过理论分析震中和震源标准差反映台网定位能力的不足,建立基于数值仿真实验方法的震中与震源误差期望值模型,最终形成台网布设优化及评价系统.实验和现场应用结果表明,该系统能够快速确定台网最优布设方案,准确评价台网定位能力,满足煤矿微震监测的需要. 相似文献
2.
R. P. Young D. A. Hutchins S. Talebi T. Chow S. Falls L. Farrell D. Jansen J. McGaughey J. Towers T. Urbancic 《Pure and Applied Geophysics》1989,129(3-4):647-659
The progress made on three phases of a research project, started in 1986 to investigate mining induced seismicity/rockburst phenomena using concurrent geotomographic imaging and microseismic monitoring techniques, is described. Phase I is the geotomographic software development and laboratory calibration trials. Phase II is the enhancement of traditional microseismic monitoring instrumentation with a waveform acquisition system, so that source mechanism studies can be carried out on mining induced seismic events. Phase III is the field trials of the hybrid technique which will be used to monitor changing rock mass physical properties, in response to mining. Preliminary results from all three phases are given, together with an outline of current and future research planned.Presented at the Fred Leighton Memorial Workshop on Mining Induced Seismicity, Montreal 1987. 相似文献
3.
二朗山公路隧道岩爆特征与预测研究 总被引：6，自引：1，他引：5
根据二郎山公路隧道施工中记录的２００多次岩爆资料,总结隧道的岩爆特征,并采用“地质超前预报法”和“σθ／Ｒｂ判断现场测定预测法”两种方法,对岩爆预测问题进行有益探讨。 相似文献
4.
为指导施工,提高施工的安全性和经济性,对西周岭隧道进行了钻孔水压致裂法地应力测量.测试结果表明:西周岭隧道深埋段地应力场以水平应力为主,在测试深度内最大水平主应力值为10.57～19.39MPa,具中等偏高应力水平;最大水平主应力方向为近N33°W,与隧道走向的夹角较小,即地应力对隧道围岩稳定性较为有利.基于地应力实测... 相似文献
5.
利用TDS-6微震采集系统测试了忻州窑煤矿组合煤岩试样变形破裂直至冲击破坏过程中的微震信号,特别是冲击破坏前后微震频谱的变化规律.采用SOS微震监测系统,对忻州窑煤矿8929工作面冲击矿压的微震活动规律进行了监测,结果表明：（1）冲击前兆信号呈现低频特征,随着与主震间隔的时间越短,主频越低.主震信号频谱较宽,但低频（0～50 Hz）成份增加,余震信号呈现高频特性.（2）微震信号的频次、累积能量与主频之间呈负相关关系.尤其当工作面顶板来压以及诱发冲击矿压时,微震信号的主频达到最低值.（3）现场监测表明,冲击前兆微震信号的主频为0～50 Hz,且振幅较低.冲击主震信号频谱较宽,但较低频（0～20 Hz）成份明显增加,同时振幅达到极值.余震信号主频为0～200 Hz,呈现高频、低振幅特征. 相似文献
6.
鉴于地下工程中岩爆预测的各种方法的局限性以及预报准确率低的现状,提出了地下工程岩爆综合集成预测的学术思路。这种学术思路将定性预测与定量预测相结合、单因素预测与多因素预测相结合,引入处理复杂性问题行之有效的非线性科学理论,对岩爆进行综合集成预测。详细介绍了岩爆预测的综合集成方法,包括：地质分析预测法、应力强度比法、层次分析—模糊评判法和神经网络法,并将其应用于雅砻江某水电站交通隧道岩爆预测中,取得了较好的效果。 相似文献
7.
Richard McCreary John McGaughey Yves Potvin Dave Ecobichon Marty Hudyma Harald Kanduth Alain Coulombe 《Pure and Applied Geophysics》1992,139(3-4):349-373
Located in northern Québec, the Lac Shortt Mine was a small gold mine consisting of a thin subvertical orebody which was mined in three main phases. High stress and rockbursting conditions were experienced when ore was extracted in the upper zone between the surface and a depth of 500 metres during the first two phases of mining. Severe rockbursts were experienced in late 1989 near the shaft and in the footwall development following a deepening of the mine shaft to a depth of 830 m and partial development of footwall drift access for the third phase of mining (the mining of the lower zone starting at a depth of 830 m moving upward toward a depth of 500 m). A 16-channel Electrolab MP250 microseismic system, with a Queen's University Full-Waveform piggy-back system, was installed underground at the site due to these problems.It was expected that the thinning sill would be subjected to an ever-increasing load as the thickness of the 500 m sill pillar decreased in the face of the mining excavation from below. A monitoring program consisting of the microseismic monitoring system, a range of conventional geomechanics monitoring tools as well as the undertaking of periodic seismic tomography surveys to assess the ongoing state of stress and rock mass condition within the sill was therefore warranted.The anomalously high-magnitude stress field and the brittle rockmass created a situation in which rockmass failure was common and violent. In the creation and thinning of the sill pillar, the location of banded microseismic activity was crucial in tracing rockmass failure and the associated ground control problems. Reliable source-location determination enabled the identification of areas of stress increase. The movement of the rockmass failure front could be followed, and was responsible for stope dilution, footwall and orebody development deterioration, and caving.Source-mechanism analyses gave accurate double-couple solutions for approximately forty percent of these events having at least ten recognizable polarities. Results suggested movement along vertical north-south striking or vertical east-west striking features. Underground observation of damaged access points showed that vertical north-south striking joints were experiencing failure.The microseismic activity, which was consistently concentrated close to the southwest and northeast corners of current production stopes, could be explained by a stress field oriented obliquely to the strike of the orebody, as measured prior to shrinkage of the sill pillar byin situ stress measurements and observed borehole overbreaks. The orientations of theP andT axes for the microseismic activity further confirmed that the stress field oriented obliquely to strike.While an increase in compressional-wave velocity of 2.3 percent, corresponding to a measured stress increase of approximately 10 MPa could be measured by repeated tomographic surveys, it was relatively small and only a factor of two or so above the velocity measured uncertainty. The relative insensitivity of thein situ rock mass modulus to the applied stress is believed to be largely due to the rockmass discontinuities being relatively closed prior to stress increase, as substantiated by the small deformations seen by the extensometer and borehole camera. This situation existed because of the very high pre-mining stress level.The experimental demonstration that the rock could not absorb substantially increased load through the mechanism of discontinuity closure or tightening (which would be reflected in the modulus) may be evidence in itself of potentially burst-prone ground, such as encountered at Lac Shortt. 相似文献
8.
Possible mechanism of rockbursts in coal mines 总被引：1，自引：0，他引：1
One of the important questions of rockburst prevention is the understanding of the mechanism of rockburst source. This question can be effectively studied by direct seismic observations in the rockburst regions. For this purpose, the distribution ofP-wave onset signs and the inversion of first motion amplitudes were utilized as the basic method. In such a way the coal mine regions in Poland (Upper Silesia) and in Czechoslovakia (Kladno coal mine district) were studied as part of the Polish-Czechoslovak rockburst investigation project. More than 250 rockburst events were recorded here in the decade 1977–1983, and analyzed. The results of the statistical analysis of these data allow us to formulate and introduce a model of the rockburst source with an implosion component. The suitability of this conception was verified by laboratory simulation conditions; it was confirmed that the seismoactive displacements with a clear implosive component were recorded in the neighbourhood of a stress concentrator weakened by holes. The results of both the field observations and laboratory tests were in good agreement with the theoretically derived radiation patterns for a combined shear-implosive source and also with the theoretical conception of such a source based on real geometrical configurations of mine excavations and tectonic dislocations.The rockbursts treated exhibit a dominant shear component, the magnitude of the additional implosive component not exceeding 10 percent of the shear component. 相似文献
9.
岩爆预测一直是地下工程领域中的世界性难题。本文以西南某隧道工程为例,从岩爆形成的3个条件:岩石岩爆倾向性、岩体完整性和高地应力环境3个方面着手,应用最大储存弹性应变能指标Es和岩石脆性系数B,对深埋隧道区段内可能发生岩爆的石英砂岩、灰岩岩体进行岩爆倾向性分析预测; 基于地应力测量数据资料,采用地质过程动态模拟的有限元分析方法,反演分析隧道工程区岩体地应力场,对隧道高应力区段作出判断; 根据现场所取样品试验结果综合分析隧道围岩的物理力学性质、岩石单轴抗压强度等。在分析和总结前人岩爆预测预报方法的基础上,以工程地质分析为基础,详细阐明隧道岩爆发生的条件,并以岩体力学和非线性科学理论为指导,采用地质综合分析、应力强度比法对隧道可能发生岩爆的部位及其强度进行综合预测。 相似文献
10.
W. D. Ortlepp 《Pure and Applied Geophysics》1992,139(3-4):677-695
Mining of a highly-stressed remnant in a deep South African gold mine was accompanied by considerable seismic activity and some significant rockbursts. The larger seismic events were registered some 60 km away at a WSSN station and several shear ruptures corresponding to these events were encountered during mining operations.A careful study based on detailed exploration of two of these ruptures proved them to be the source of two of the larger rockbursts.Certain striking features revealed by a scanning electron microscopic study of some of the fresh cataclastic rock-flour forming part of the comminuted filling of these ruptures provide strong evidence of violent shock rebound phenomena in the faulting process. This interpretation could provide useful insight into earthquake source mechanisms and also has practical significance in the understanding of mine rockbursts. 相似文献