共查询到20条相似文献，搜索用时 15 毫秒
1.
《Coastal Engineering》1999,38(3):167-176
An existing 2D method for separating incident and reflected waves over a horizontal bed [Frigaard, P., Brorsen, M., 1995. A time domain method for separating incident and reflected irregular waves. Coastal Eng., 24, 205–215.] is modified to account for normally incident linear waves propagating over a bed with arbitrary 2D bathymetry. Linear shoaling is used to determine the amplitude and phase change between two measurement positions; thereafter the existing technique can be applied. Comparisons between the existing and modified methods are made using numerically simulated data. Errors in the reflection coefficient are found to be small for large reflection coefficients, but may become large if reflection is low. However, if an accurate assessment of the amplitude of the incident and reflected wave trains is required, the bathymetry must be accounted for in order to avoid significant errors (up to 90% for cases considered). 相似文献
2.
CHANG Hsien-Kuo 《中国海洋工程》2002,16(4):499-511
This study presents a three-point method for separating incident and reflected waves to explain normally incident waves' propagating over a sloping bed. Linear wave shoaling is used to determine changes in wave amplitude and phase in response to variations of bathymetry. The wave reflection coefficient and incident amplitude are estimated from wave heights measured at three fixed wave gauges with unequal spacing. Sensitivity analysis demonstrates that the proposed method can predict the reflection and amplitude of waves over a sloping bed more accurately than the two-point method. 相似文献
3.
This paper describes a simple method for determining the wavelength of small amplitude waves under laboratory conditions where reflected wave components are present both with and without a mean current flow superimposed. It assumes a locally horizontal bed but requires no a priori assumption concerning the form of the dispersion relation with a coexisting current. Synchronous measurements of the water surface recorded along any straight line are analysed to yield Fourier coefficients at each location. It is then shown that for all practical conditions excluding a perfect standing wave, the average rate of change of wave phase in the chosen direction can be related directly to the component of incident wave number in that direction, irrespective of reflection coefficient or relative current strength. The technique has been applied to regular and bichromatic waves in a flume with an absorbing wave generator, and can also be applied in 3-D wave basins where waves and currents intersect at arbitrary angles. In combined wave–current experiments, by assuming the linear dispersion relation, it is also possible to estimate the effective current velocity. 相似文献
4.
The analytical method (AM) for separation of composite waves is presented based on the Hilbert transform. It is ap-plicable to both regular and irregular trains of waves. The wave data series measured with two wave gauges in the experi-ments are separated into two series of incident and reflected waves. Then, the reflection coefficient can be easily ob-tained. The arrival of reflected waves can also be detected for improveraent of the accuracy of the reflection coefficient. The reflection performance of the physical model can be estimated exactly without calculation of wave height and phase difference. Numerical samples developed to test the method are proved to be accurate. Physical experiments are conduct-ed and compared with Goda s method and satisfactory results are obtained. 相似文献
5.
Hilbert Transform Applied to Separation of Waves 总被引：1，自引：0，他引：1
The analytical method (AM) for separation of composite waves is presented based on the Hilbert transform. It is ap-plicable to both regular and irregular trains of waves. The wave data series measured with two wave gauges in the experi-ments are separated into two series of incident and reflected waves. Then, the reflection coefficient can be easily ob-tained. The arrival of reflected waves can also be detected for improvement of the accuracy of the reflection coefficient.The reflection performance of the physical model can be estimated exactly without calculation of wave height and phasedifference. Numerical samples developed to test the method are proved to be accurate. Physical experiments are conduct-ed and compared with Goda‘s method and satisfactory results are obtained. 相似文献
6.
A third-order perturbation approximation for the partial reflection from a vertical wall is presented in this paper. The wave parameters are expressed in terms of the amplitude of incident waves. The reflection coefficient is defined as the ratio of the height of reflected waves to incident waves. The numerical results demonstrate the significant influences of reflected coefficient on the wave profile and wave frequency bifurcation. For example, the critical angle of wave frequency bifurcation with partial reflection is about 7.5 degrees, not 21 degrees as reported previously for fully reflection. 相似文献
7.
1 .ＩｎｔｒｏｄｕｃｔｉｏｎＴｏｍｅａｓｕｒｅｔｈｅｒｅｆｌｅｃｔｉｏｎｏｆｉｎｃｉｄｅｎｔｗａｖｅｓｐｒｏｄｕｃｅｄｂｙａｐｈｙｓｉｃａｌｍｏｄｅｌｉｎａｗａｖｅｆｌｕｍｅｉｓａｃｏｍｍｏｎｐｒｏｂｌｅｍｗｉｔｈｐｈｙｓｉｃａｌｔｅｓｔｓｏｆｗａｖｅａｃｔｉｏｎｏｎｃｏａｓｔａｌｓｔｒｕｃｔｕｒｅｓ .Ｗａｖｅｓｇｅｎｅｒａｔｅｄｂｙｔｈｅｗａｖｅ ｍａｋｅｒｐｒｏｐａｇａｔｅｆｏｒｗａｒｄｉｎｔｈｅｗａｖｅｆｌｕｍｅａｎｄａｒｅｒｅｆｌｅｃｔｅｄｂｙｔｈｅｐｈｙｓｉｃａｌｍｏｄｅｌ,ａｎｄｔｈｅ… 相似文献
8.
This work presents a frequency-domain method for estimating incident and reflected waves when normally incident waves’ propagating over a sloping beach in a wave flume is considered. Linear wave shoaling is applied to determine changes of the wave amplitude and phase due to variations of the bathymetry. The wave reflection coefficient is estimated using wave heights measured at two fixed wave gauges with a distance. The present model demonstrates a high capacity of estimating reflection and shoaling coefficients from synthetic wave-amplitude data. Sensitivity tests for the present model due to measurement errors of wave amplitudes and distance of two probes can more accurately predict the reflection coefficients. The measurement error of wave amplitude affects more significantly than measurement error of distance of two probes on calculating reflection coefficient of waves over a sloping bed. 相似文献
9.
The Goda's method of separating the frequency spectrum of the unidirectional incident and reflected waves is improved. The proposed method can be applied to the separation of oblique incident and reflected waves and the two wave gauges can be arranged in an arbitrary angle in front of a structure. When the projected distance of the two probes on the incident wave direction is the multiple ofthe half length of the incident waves, the singular problem will emerge by using the method. It is advised that when the projected distance of the two measured points on the incident wave direction is 0.05～0.45 times the wave length of peak frequency wave, good results can be obtained. The simulated resultant waves are separated by the method of numerical simulation and the separated wave spectra are basically corresponding to the target spectra input. The wave trains calculated by the separated incident and reflected wave frequency spectrum are approximated to the input wave trains and the reflected coefficient can be derived correctly. Therefore, the method proposed in this paper is reliable. 相似文献
10.
A three-point method for estimating wave reflection is proposed to account for monochromatic oblique incident waves propagating over a sloping beach. The amplitudes of reflected wave and incident wave are separated using wave amplitudes measured at three fixed wave gauges with a distance. The applicability of the theory is verified by comparing the simulated results with the available theoretical, numerical and experimental results for the estimation of wave reflection. The sensitivity is also tested to provide a more accurate prediction of the reflection coefficient. 相似文献
11.
In the nearshore,the wave field contains reflected and incident waves in which there iscorrelation between their phases due to the effect of reflection by some obstacles.Based on the extendedeigenvector method(EEV)derived by Guan et al.,a modified method(MEEV)is proposed as a generaland practical approach to estimating directional spectra for the co-existent field of incident and reflectedwaves and a formula is given for direct calculation of the reflection coefficient.The results of numericalsimulations show that MEEV is superior to EEV in resolution power,and the computed reflectioncoefficient agrees well with the real value within a certain range of incident angle. 相似文献
12.
Zuo Qihua Yang Zhengji .
Senior Engieer River Harbour Department Nanjing Hydraulic Research Institute Nanjing 《中国海洋工程》1996,(3)
- The variation of the amplitude of waves with varying incident angles when waves propagate through a typical approach channel is discussed by a numerical calculation method, the result of which shows that the influence of the channel on wave propagation is obvious. When the wave propagation direction is in coincidence with the channel axis, the wave amplitude ratio will decrease with the increase of propagation distance. When the incident angle is 15 - 30 , there appears an area of larger wave amplitude ratio on the side slope facing the waves, but at the another side, the wave amplitude ratio is generally small, indicating that the channel has a shielding effect. When waves propagate across the channel perpendicularly, the wave amplitude ratio can be calculated with the shallow water coefficient. 相似文献
13.
Shutang Zhu 《Ocean Engineering》1999,26(12):535
This paper presents a transfer function method (TFM) which can separate a regular wave field into incident and reflected waves based on the linear wave theory. The TFM uses specific transfer functions and corresponding convolution integrals to separate time series data measured in a combined partial standing wave system into incident and reflected waves. After this separation, estimation of the reflection coefficient becomes very easy. All manipulations have been performed in time domain. Furthermore, this method does not involve the calculation of wave heights and/or phase differences. The present method is demonstrated through numerical sample and physical model experiments carried out in a wave flume. Compared with other methods, the TFM gives much better estimates of the incident wave heights for physical model experiments in this study. 相似文献
14.
Hiroshi Kagemoto 《Ocean Engineering》2011,38(8-9):976-982
When two 2-D vertical surface-piercing plates are fixed with a certain distance in incident regular waves, it is known that complete wave transmission and reflection could take place, at least in a linear wave theory, depending on the wave period of the incident waves. This paper revisits the same subject from the viewpoint of the hydrodynamic interaction between the two plates induced by the waves transmitted and reflected due to the plates, which is enabled by accounting for the hydrodynamic interactions between the two plates while decomposing the waves into component waves. In doing so, some new insight into the mechanism of the complete transmission and the complete reflection has been obtained. 相似文献
15.
Zuo Qihua Yao Guoquan
Engineer Nanjing Hydraulic Research Institute Nanjing
Senior Engineer Nanjing Hydraulic Research Institute Nanjing 《中国海洋工程》1991,(2)
The second order long waves of the mean water free surface displacement induced by the wave groups over a trench are discussed in this paper. The incident wave groups are supposed to be superposed by 2 linear waves with different amplitudes, phases and slightly different frequencies. Some of the theoretical formulas and numerical results are presented. 相似文献
16.
斜向入反射波分离的数值模拟研究 总被引：1，自引：0，他引：1
改进了Goda分离单向入反射波频谱的方法，给出的新方法可应用于斜向入反射波的分离，且测波仪器对的方向可按任意角度布置。当两测点在入射波方向上的投影距离为入射波半波长的倍数时，该方法会出现奇异问题。建议取两测点在入射波方向上投影距离为峰频波长的0．05－0．45倍。这时可得到较好的结果。文中采用数值模拟的方法对模拟波列进行了分离，分离出的波谱与输入的靶谱基本一致，通过分离出的入反射波频谱计算出的各波面过程与输入的各过程线也基本相近，并能较准确地给出结构的反射系数，由此说明该方法是可靠的。 相似文献
17.
斜向入射波与反射波的分离 总被引：7，自引：0，他引：7
提出了一种分离斜向入射波和反射波的方法,波浪可以是规则波、不规则波,波向可以任意.在一定的限制条件下,采用两点浪高仪的波浪信号就可将斜向入射波和反射波分离. 相似文献
18.
In this paper, the modified Bayesian method for the analysis of directional wave spectra and reflection coefficients is verified by numerical and physical simulation of waves. The results show that the method can basically separate the incident and reflected directional spectra. In addition, the effect of the type of wave gage arrays, the number of measured wave properties, and the distance between the wave gage array and the reflection line on the resolution of the method are investigated. Some suggestions are proposed for practical application. 相似文献
19.