共查询到19条相似文献,搜索用时 186 毫秒
1.
2.
3.
系统介绍了国内外各类抗震设计规范和导则中关于设计地震动时程方面的规定。分别从时程分析范围、时程组数以及天然时程所占比例、设计地震动时程的峰值和反应谱特性、设计地震动时程的持时特性以及设计地震动时程的相关性等5个方面,对比了不同行业抗震设计规范中关于地震动时程相关规定的异同。以我国现行《建筑抗震设计规范》为例,给出了满足相关要求的设计地震动时程,并针对设计地震动时程确定过程中需要关注的问题进行了讨论,以期为我国地震安全性评价工作中设计反应的确定谱提供参考。 相似文献
4.
本文回顾了地震反应分析理论发展的三个阶段,指出反应谱理论仍然是许多国家现阶段抗震设计的理论依据,我国规范也主要采用反应谱法进行抗震设计分析。进一步讨论了反应谱与抗震设计反应谱的联系和区别。把我国《建筑抗震设计规范(GB50011—2001)》中有关地震影响系数分别与ISO 3010:2001(E)和美国的建筑抗震设计规范中的地震影响系数做了对比,发现我国规范有些地方考虑得还不够全面,还需要不断地完善。提出在抗震设计中运用地震动参数代替地震烈度来进行计算能更好地反映工程实际情况。 相似文献
5.
6.
7.
8.
9.
10.
关于上海市<建筑抗震设计规程>中长周期设计反应谱的讨论 总被引:11,自引:1,他引:10
在上海市地方标准《建筑抗震设计规程》(DBJ08-9-92)及其1996年局部修订增补版本中、对上海市类场地建筑结构的地震影响系数进行了特殊规定,并将结构自振 周期延长到10s,同时给出了三条加速度时程用于时程分析。本文主要针对《建筑抗震设计规程》中有关长周期反应谱部分的规定,根据国内外的研究现状,进行一些探讨,指出所提供的一条人造地震动时程和两条国外加速度记录用于上海市IV类场地长周期建筑结构的 相似文献
11.
考虑支撑变形时安装非线性粘滞消能器结构的抗震设计方法 总被引:5,自引:0,他引:5
通过理论分析和大量数值模拟,揭示了线性和非线性粘滞消能器两端的相对水平位移幅值与所在层的层间位移幅值之间的关系,总结提出了考虑支撑变形时安装非线性粘滞消能器结构的实用抗震设计步骤。上述研究结果拓展了现行《建筑抗震设计规范》中有关粘滞消能器部分的设计规定。 相似文献
12.
13.
14.
高层建筑时程分析中地震动时程选择和修改方法研究 总被引:2,自引:1,他引:1
合理的地震动时程选择与修改方法对于高层结构的抗震设计具有重要意义,有着广泛的工程应用.本文回顾了建筑抗震设计规范对于输入地震动时程的规定,通过对现有的地震动时程选择与修改方法进行分类和定性分析,挑选了两种与规范要求衔接较好的方法.结合具体算例对两种方法进行了定量分析,结果表明以安评设计谱作为选择指标,利用最小二乘法对选择的地震动时程进行修改,可以得到离散较小且符合规范要求的地震动时程,该成果能够在现行规范要求下为结构的抗震设计提供合理可靠的依据.同时,本文也对未来地震动时程选择与修改方法的研究和发展方向进行了展望,指出条件均值谱和非弹性反应谱将是该领域未来主要的研究方向. 相似文献
15.
在《建筑抗震设计规范》(GB50011-2001)中,反应谱在长周期区段出现了大阻尼比曲线值大于小阻尼比曲线值的反超现象。分析认为,《规范》的多阻尼比反应谱在3.39~6s的长周期区段可能不适用,而用虚拟等值点法修正后所得参数简单且易于使用。反超现象是因计算误差引起,还是因特定的物理背景造成,值得深究。 相似文献
16.
17.
Lei Jiancheng 《中国地震研究》2003,17(1):63-72
Based on the calculation of the bedrock effective peak acceleration (EPA) zoning map in the Panxi area, the ratios of EPA with exceedance probabilities of 63%, 5%, 3%, 2% and 1% over 50 years to that of 10% in 50 years are 0.302, 1.30, 1.55, 1.76 and 2.14, respectively. The seismic effect will be conservative and safe if taking this zoning map as the earthquake-resistant fortification level and following the relevant rules of the Code for Seismic Design of Buildings (GBJ11-89) to calculate the seismic effect. Furthermore, the main factors that influence the A10/A63 ratios have been found to be the attenuation relationship of seismic ground motion, the division of seismic potential source regions and the seismicity parameters. These achievements are helpful to the spreading and applying of the zoning map. 相似文献
18.
19.
<正>This paper describes shaking table tests of a 1:12 scale model of a special concentrically braced steel frame with pinned connections,which was fabricated according to a one-bay braced frame selected from a typical main factory building of a large thermal power plant.In order to investigate the seismic performance of this type of structure,several ground motion accelerations with different levels for seismic intensityⅧ,based on the Chinese Code for Seismic Design of Buildings,were selected to excite the model.The results show that the design methods of the members and the connections are adequate and that the structural system will perform well in regions of high seismicity.In addition to the tests,numerical simulations were also conducted and the results showed good agreement with the test results.Thus,the numerical model is shown to be accurate and the beam element can be used to model this structural system. 相似文献