共查询到19条相似文献，搜索用时 98 毫秒
1.
2.
3.
单点系泊船舶在受到风、流等外力作用下通常会产生大幅周期性艏摇运动，称为“鱼尾运动”。剧烈的鱼尾运动可能会导致系泊系统的锚链承受过大的张力从而遭到破坏。为了充分认识单点系泊状态下养殖工船的鱼尾运动，针对一艘十万吨级单链式系泊养殖工船进行了数值分析及模型试验研究。首先，通过风洞模型试验测得养殖工船的风、流载荷系数，以此作为输入对风、流联合作用下养殖工船的动力响应进行了数值模拟分析；同时，开展水池模型试验验证了数值计算结果的准确性和可靠性；最后，通过数值计算研究了不同风速和流速下单链式系泊养殖工船鱼尾运动的特性和规律，为实际工程设计提供一定的参考。 相似文献
4.
软刚臂系泊系统是一种利用压载质量为浮式生产储油装置(FPSO)提供回复力的单点系泊方式。为快速准确地评估多铰接组成的软刚臂系统的受力状态,避免应用高复杂度的有限元软件,进而快速完成优化设计等任务,建立一种静力计算方法十分有必要。因此,针对由刚臂(YOKE)、柔性系泊腿和压载舱组成的刚柔多体系统,以分解组合的方式,提出一种二维静力计算方法,用以研究FPSO软刚臂系泊系统的静力特性。该方法主要依靠软刚臂的几何构型,在有限铰接约束下,形成非线性静力平衡方程,建立了压载舱式水上软刚臂单点系泊系统二维静力平衡计算算法。采用OrcaFlex、SESAM等软件开展了理论和数值对比分析,同时与系泊试验结果开展验证分析。对比结果表明,文中所提方法计算精度较高,可为软刚臂单点系泊系统的研究提供可靠支持。 相似文献
5.
基于多体动力分析方法进行FPSO和水下软钢臂系泊系统的运动特性研究。相较于非线性弹簧模拟软钢臂系泊系统或者其他近似模拟方法,多体分析方法可以充分考虑系泊系统具体结构形式及其动力项对FPSO运动性能的影响,更好的预报系统运动响应和系泊力。本文将FPSO和水下钢臂结构模拟成2个具有6自由度的独立结构,两者用系泊链组进行连接。基于三维势流理论应用汇源分布法,首先在频域内进行FPSO的水动力参数分析,进而在时域内对系统进行耦合动力分析。本文重点讨论系泊系统黏性力和二阶波浪力对系统响应的影响,计算结果发现系泊系统黏性力对系泊力有一定影响,而在浅水条件下二阶波浪力的计算对准确预报系统运动及系泊力非常重要。 相似文献
6.
7.
8.
9.
在时域内建立了单锚腿系泊系统在风、浪、流联合作用下动力响应的计算方法。在分析波浪荷载时，使用了设计波法和非线性Stokes五阶波，并由经验公式求出了船舶的风、流荷载作用力。系统的动力初始条件由准静态方法求得。由静态方法得到系泊力后，使用了四阶Runge-Kutta方法求解船舶的运动时历，并作为立管和浮筒动力计算的边界条件。由二维梁柱单元和集中质量法构建了立管和浮简的数学模型，立管的运动方程用Wilson-θ法求解。模拟计算结果和试验结果进行了比较，吻合得较好,表明本方法能够用于计算单锚腿系泊系统的动力响应。 相似文献
10.
系泊系统的定位能力是浅水油田作业的软刚臂式单点系泊FPSO安全作业的重要保障,为研究不同水深/吃水比下单点系泊系统的受力性能,针对一艘16万吨级软刚臂单点系泊FPSO,在线性三维势流理论的基础上,基于多体动力学方法,建立FPSO-系泊腿-软刚臂的耦合模型,采用Newman近似法和Pinkster近似法分析了FPSO所受二阶波浪力,在时域内计算了不同水深/吃水比对系泊系统动力响应性能的影响。结果表明,随着水深/吃水比的增加,Newman近似法计算得到二阶波浪力先增大后减小,引起单点系泊系统载荷先增大后减小;而Pinkster近似法计算得到的二阶波浪力逐渐减下,引起单点载荷逐渐减下。在浅水条件下,Pinkster近似法具有较好的适用性,Newman近似法严重低估了FPSO所受的二阶波浪力;在深水条件下,Newman近似法能满足工程计算的要求;适用两种方法的临界水深/吃水比为1.64。 相似文献
11.
Hydrodynamic performance of an ultra deep turret-moored Floating Liquefied Natural Gas(FLNG) system is investigated.Hydrodynamic modeling of a turret-moored FLNG system,in consideration of the coupling effects of the vessel and its mooring lines,has been addressed in details.Based on the boundary element method,a 3-D panel model of the FLNG vessel and the related free water surface model are established,and the first-order and second-order mean-drift wave loads and other hydrodynamic coefficients are calculated.A systematic model test program consisting of the white noise wave test,offset test and irregular wave test combined with current and wind,etc.is performed to verify the numerical model.Owing to the depth limit of the water basin,the model test is carried out for the hydrodynamics of the FLNG coupled with only the truncated mooring system.The numerical simulation model features well the hydrodynamic performance of the FLNG system obtained from the model tests.The hydrodynamic characteristics presented in both the numerical simulations and the physical model tests would serve as the guidance for the ongoing project of FLNG system. 相似文献
12.
As a popular solution for mooring an FPSO （Floating Production, Storage and Offloading） permanently in shallow water, the soft yoke mooring system has been widely used in ocean oil production activities in the Bohai Bay of China. In order to simulate the interaction mechanism and conduct dynamic analysis of the soft yoke mooring system, a theoretical model with basic dynamic equations is established. A numerical iteration algorithm based on error estimation is developed to solve the equations and calculate the dynanfic response of the mooring system due to FPSO motions. Validation is conducted by wave basin experimentation. It is shown that the numerical simulation takes only a few iteration times and the final errors are small. Furthermore, the calculated results of both the static and dynamic responses agree well with those ones obtained by the model test. It indicates that the efficiency, the precision, the reliability and the validity of the developed numerical algorithm and program are rather good. It is proposed to develop a real-time monitoring system to further monitor the dynamic performance of the FPSO with a soft yoke mooring system under various real sea environments. 相似文献
13.
An experimental set-up is developed and proved to be effective for laboratory study of an underwater towed system. The experimental technique gives a practical method for monitoring the kinematic and dynamic performance of an underwater towed system in a ship towing tank. Both the theoretical and experimental results in the investigation indicate that the hydrodynamic response of a towed vehicle to the wave induced motion of a towing ship can be significantly reduced by applying a two-part tow method. A comparison of the numerical and experimental results in the investigation demonstrates that the numerical simulation results are close to the experimental data, overall agreement between experimental and theoretical results is satisfactory. The results qualitatively verify the mathematical model of a two-part underwater towed system proposed by Wu and Chwang [Wu, J., Chwang, A.T., 2000. A hydrodynamic model of a two-part underwater towed system. Ocean Engineering 27 (5), 455–472]. 相似文献
14.
全被动式振荡水翼是振荡水翼式潮流能装置的主要型式之一。对全被动式振荡水翼进行了数值模拟研究,构建了二维数值模型,研究了雷诺数及升沉刚度对全被动式振荡水翼水动力性能的影响。通过流场结构及水动力性能分析研究了典型参量对全被动式振荡水翼获能性能的影响机理,确定了维持其良好水动力性能的参数范围。研究发现,水翼的水动力性能对雷诺数及升沉刚度的变化较为敏感。雷诺数增大,水翼所需升沉刚度随之增加,且水翼可以在更大的参数范围下获得较优的水动力性能。另外,水翼可以在没有升沉刚度的情况下实现周期性运动,其获能甚至优于一些有升沉刚度的情况。最优工况下,平均功率系数和能量转换效率分别为1.07和27.48%。 相似文献
15.
16.
Dan Obreja Radoslav Nabergoj Liviu Crudu Săndiţa Păcuraru-Popoiu 《Ocean Engineering》2010,37(8-9):678-687
The results of numerical and experimental investigations on the manoeuvring performance of a fishing vessel, typical for Mediterranean Sea, are here presented. PMM experiments were used for evaluating hydrodynamic derivatives and implementing the theoretical model. The simulation model was validated, both with zig-zag and spiral experimental model tests results in still water and compared with Tribon Initial Design module results. 相似文献
17.
On the motions of the underwater remotely operated vehicle with the umbilical cable effect 总被引：1，自引：0，他引：1
In this paper, a hydrodynamic model is developed to simulate the six degrees of freedom motions of the underwater remotely operated vehicle (ROV) including the umbilical cable effect. The corresponding hydrodynamic forces on the underwater vehicle are obtained by the planar motion mechanism test technique. With the relevant hydrodynamic coefficients, the 4th-order Runge–Kutta numerical method is then adopted to solve the equations of motions of the ROV and the configuration of the umbilical cable. The multi-step shooting method is also suggested to solve the two-end boundary-value problem on the umbilical cable with respect to a set of first-order ordinary differential equation system. All operation simulations for the ROV including forward moving, ascending, descending, sideward moving and turning motions can be analyzed, either with or without umbilical cable effect. The current effect is also taken into consideration. The present results reveal that the umbilical cable indeed significantly affects the motion of the ROV and should not be neglected in the simulation. 相似文献
18.
Sensitivity Analysis of Air Gap Motion with Respect to Wind Load and Mooring System for Semi-Submersible Platform Design 总被引：1，自引：1，他引：0
A design of semi-submersible platform is mainly based on the extreme response analysis due to the forces experienced by the components during lifetime. The external loads can induce the extreme air gap response and potential deck impact to the semi-submersible platform. It is important to predict air gap response of platforms accurately in order to check the strength of local structures which withstand the wave slamming due to negative air gap. The wind load cannot be simulated easily by model test in towing tank whereas it can be simulated accurately in wind tunnel test. Furthermore, full scale simulation of the mooring system in model test is still a tuff work especially the stiffness of the mooring system. Owing to the above mentioned problem, the model test results are not accurate enough for air gap evaluation. The aim of this paper is to present sensitivity analysis results of air gap motion with respect to the mooring system and wind load for the design of semi-submersible platform. Though the model test results are not suitable for the direct evaluation of air gap, they can be used as a good basis for tuning the radiation damping and viscous drag in numerical simulation. In the presented design example, a numerical model is tuned and validated by ANSYS AQWA based on the model test results with a simple 4 line symmetrical horizontal soft mooring system. According to the tuned numerical model, sensitivity analysis studies of air gap motion with respect to the mooring system and wind load are performed in time domain. Three mooring systems and five simulation cases about the presented platform are simulated based on the results of wind tunnel tests and sea-keeping tests. The sensitivity analysis results are valuable for the floating platform design. 相似文献
19.
针对单点系泊(SPM)网箱系泊力大于传统网箱,离岸环境承受风浪时风险更高的问题,研究设计了一种相较传统圆形网箱拥有更小系泊力的船型网箱,运用正交原理制定了三因素三水平的试验方案,对网箱浮架进行了计算机数值模拟,分析网箱在波流共同作用下的水动力特性变化。研究表明,在兼顾经济成本与网箱安全性的条件下,长24 m,宽9 m,头部角度为60°的网箱浮架具有较优良的水动力性能和相对较低的养殖成本。该网箱系统能随着潮流改变方向而在锚点周围移动,从而极大减小网箱底部的养殖残渣堆积并降低锚固安装成本,可为我国深水网箱的发展提供一定的理论参考依据。 相似文献