共查询到19条相似文献，搜索用时 125 毫秒
1.
本文介绍了钢质固定平台导管架浮运时总强度分析的准静力法,并以渤海埕北油田A平台导管架的计算为例说明了该方法的应用。准静力法虽然并没有考虑导管架在实际海况中所受到的载荷的随机特性,但其计算简单,在工程实际中仍被广泛的采用。文中介绍的方法及其相应的计算程序可用于中、小型导管架浮运的强度分析。 相似文献
2.
现有服役海洋平台正逐步走向老龄化,海洋平台拆除成为海洋工程新的经济增长点。针对达到服役年限的导管架平台,基于数值分析方法模拟拆除过程,开展平台在不同拆除阶段和环境载荷等参数下的稳定性及影响规律研究。基于钢结构整体稳定性理论,以导管架平台拆除过程中顶点位移为参考,定义导管架平台拆除作业稳定性指标,提出拆除作业阶段划分方法,通过分析导管架平台在不同影响因素作用下拆除过程稳定性响应,给出拆除作业建议。选取我国南海某4裙12腿进行实例分析,结果表明:主桩腿对导管架平台起决定性承载作用,拆除部分主桩腿后需要引入外部支撑力,以保证拆除作业安全进行;拆除构件越多,来浪方向和环境载荷大小对平台影响越加显著。研究结果可为导管架平台拆除作业提供参考。 相似文献
3.
设计了一种新型网箱浮架系统,利用SESAM对其进行了频域水动力分析以及考虑不规则波浪、风、流载荷和系泊共同作用的时域耦合分析,并与传统双浮管网箱浮架系统进行了分析对比,得到方形网箱与圆形网箱的水动力特性的差异以及各自的优缺点,对实际中网箱的开发设计有一定的借鉴意义;通过计算,证明新型网箱浮架系统在工作海况能正常工作,在极端海况下也能满足安全性的要求;最后对4种常见系泊方式进行了时域耦合分析,得到了四种系泊方式的系泊特性,对实际工程中系泊方式的选择有一定的参考意义。 相似文献
4.
单点系泊海洋导管架平台结构体系可靠性分析 总被引：3，自引：1，他引：3
采用非线性逐步倒塌分析方法，考虑桩-土-结构的非线性相互作用，研究了单点系泊海洋导管架平台在极端荷载作用下的承载能力计算模型，在此基础上结合蒙特卡洛随机抽样法，提出了单点系泊海洋导管架平台结构体系可靠度计算方法。最后对工程实例BZ28-1SPM单点系?白海洋导管架平台结构在20年设计基准期和50年重现期进行了体系可靠性分析：研究结果表明：用50年重现期的环境荷载参数来进行BZ28-1SPM单点系泊海洋导管架平台结构的设计是合理的；在环境荷载中起主导作用的是由波浪引起的系泊力；在海洋平台结构的设计及对已服役平台结构的评估中运用体系可靠度理论，可以为海洋平台结构的设计、维护和评估提供理论依据。 相似文献
5.
浮托安装法广泛应用于大型组块海上安装。导管架平台上部组块浮托安装进船过程中,风、浪、流引起的浮托驳船横向运动造成浮托驳船与导管架桩腿的碰撞,碰撞力可能会对导管架结构造成损伤。陆丰7-2上部组块浮托安装中,为了监测碰撞力大小,设计了碰撞力海上监测系统。通过在导管架外侧四个桩腿上安装光纤光栅应变传感器对碰撞过程中导管架桩腿进行应力监测,进而计算碰撞力。对碰撞过程,载荷作用位置、方向进行简化,并对载荷大小及垂向作用位置对计算的影响进行了研究。结构分析模型简化后,测点von-Mises应力与碰撞力大小成正比,对导管架整体结构建模计算并取局部结构计算比例系数,结合应力实测数据计算出进船过程中驳船对导管架桩腿碰撞力。 相似文献
6.
7.
8.
针对在役老龄导管架平台进行倒塌计算分析,确定极限承载力进而评估老龄导管架的安全裕度。采用非线性有限元方法,考虑平台的波流载荷及桩-土的非线性相互作用,利用SACS软件建立导管架整体三维有限元计算分析模型,并用逐步加载的方式,对南海某导管架平台进行了全过程非线性倒塌分析。计算分析表明,该导管架平台极限强度很高,具有较大的安全裕度;导管架倒塌过程呈逐步破坏形式,先是撑杆屈服,造成局部结构破坏,然后是钢桩发生屈服,降低结构承载力,最后节点逐步失效,造成结构倒塌。揭示了导管架平台结构失效倒塌的机理,给出了倒塌分析的可行方法和步骤。 相似文献
9.
10.
11.
浮筒辅助大型导管架结构整体拆除作业是一个连续过程，作业过程中拆除系统的动力荷载及动力参数均会发生显著变化，传统基于某一稳定状态的结构动力响应分析方法不能准确预测拆除系统上浮过程中的动力响应。通过建立浮筒辅助大型导管架结构整体拆除上浮过程动态分析模型，对拆除系统上浮过程的动力响应特性进行研究。结果表明，整体拆除动态分析模型可以准确描述拆除系统上浮过程中浮筒及导管架浮力变化对上浮高度的影响机制，拆除系统上浮高度约为不考虑浮筒和导管架浮力变化时的90%。此外，浮筒辅助大型导管架整体拆除方法的动态稳定性较强，四级海况下拆除系统的最大偏移量仅为4.2 m，有较好的工程应用前景。 相似文献
12.
基于我国南海海域环境条件,对一座深水圆筒型钻井平台设计一套张紧式系泊定位系统,利用SESAM软件对平台运动响应和缆索张力进行分析计算,得到主要运动响应为纵荡、纵摇和垂荡。分别考虑0°和180°的环境载荷方向,对比得到0°方向的缆索张力更大,且6号和7号缆承受了主要的环境力。分析了平台运动的影响因素,认为缆索夹角设定为35°时较优,适度增大系泊缆初始长度和减小两端锚链长度可较为有效地降低系泊缆受力,系泊缆总根数保持12时（4根×3组）为最优方案。根据分析结果对初始系泊方案进行了优化,在风暴工况下系泊缆最大受力减小了约14.8%。钻井作业工况和一根系泊缆破断工况下,系泊缆受力和平台位移均能满足规范要求。 相似文献
13.
针对单点系泊(SPM)网箱系泊力大于传统网箱,离岸环境承受风浪时风险更高的问题,研究设计了一种相较传统圆形网箱拥有更小系泊力的船型网箱,运用正交原理制定了三因素三水平的试验方案,对网箱浮架进行了计算机数值模拟,分析网箱在波流共同作用下的水动力特性变化。研究表明,在兼顾经济成本与网箱安全性的条件下,长24 m,宽9 m,头部角度为60°的网箱浮架具有较优良的水动力性能和相对较低的养殖成本。该网箱系统能随着潮流改变方向而在锚点周围移动,从而极大减小网箱底部的养殖残渣堆积并降低锚固安装成本,可为我国深水网箱的发展提供一定的理论参考依据。 相似文献
14.
15.
A.K. AgarwalA.K. Jain 《Ocean Engineering》2003,30(4):487-516
Many innovative floating offshore structures have been proposed for cost effectiveness of oil and gas exploration and production in water depths exceeding one thousand meters in recent years. One such type of platform is the offshore floating Spar platform. The Spar platform is modelled as a rigid body with six degrees-of-freedom, connected to the sea floor by multi-component catenary mooring lines, which are attached to the Spar platform at the fairleads. The response dependent stiffness matrix consists of two parts (a) the hydrostatics provide restoring force in heave, roll and pitch, (b) the mooring lines provide the restoring force which are represented here by nonlinear horizontal springs. A unidirectional regular wave model is used for computing the incident wave kinematics by Airy’s wave theory and force by Morison’s equation. The response analysis is performed in time domain to solve the dynamic behavior of the moored Spar platform as an integrated system using the iterative incremental Newmark’s Beta approach. Numerical studies are conducted for sea state conditions with and without coupling of degrees-of-freedom. 相似文献
16.
17.
Hybrid model testing technique is widely used in verification of a deepwater floating structure and its mooring system,but the design of the truncated mooring systems which can reproduce both static and dynamic response same as the full-depth mooring system is still a big challenge,especially for the mooting systems with large truncation.A Cell-Tress Spar operated in 1500 m water depth is verified in a wave basin with 4 m water depth.A large truncation factor arises even though a small model scale 1:100 is adopted.Computer program modules for analyzing the static and frequency domain dynamic response of mooting line are combined with multi-objective genetic algorithm NSGA-II to optimize the truncared mooting system.Considering the asymmetry of layout of mooring hnes,two different truncated mooring systems are respectively designed for both directions in which the restoring forces of the.mooting system are quite,different.Not only the static characteristics of the mooting systems are calibrated,but also the dynamic responses of the single truncated mooting line are evaluated through time domain numerical simulation and model tests.The model test results of 100-year storm in the GOM are reconstructed and extrapolated to a full depth.It is found that the experimental and numerical resuits of Spar wave frequency motion agree well,and the dynamic responses of the full-depth mooring lines are better reproduced,but the low frequency surge motion is overestimated due to the smaller mooring-induced damping.It is a feasible method adopting different truncated mooring systems for different directions in which the restoring force characteristics are quite different and cannot be simulated by one truncated mooring system.Hybrid verification of a deepwater platform in wave basin with shallow water depth is still feasible if the truncated mooring systems are properly designed,and numerical extrapolation is necessary. 相似文献
18.
Many innovative floating offshore structures have been proposed for cost effectiveness of oil and gas exploration and production in water depths exceeding one thousand meters in recent years. One such type of platform is the offshore floating Spar platform. The Spar platform is modelled as a rigid body with six degrees-of-freedom, connected to the sea floor by multi-component catenary mooring lines, which are attached to the Spar platform at the fairleads. The response dependent stiffness matrix consists of two parts (a) the hydrostatics provide restoring force in heave, roll and pitch, (b) the mooring lines provide the restoring force which are represented here by nonlinear horizontal springs. A unidirectional regular wave model is used for computing the incident wave kinematics by Airy’s wave theory and force by Morison’s equation. The response analysis is performed in time domain to solve the dynamic behavior of the moored Spar platform as an integrated system using the iterative incremental Newmark’s Beta approach. Numerical studies are conducted for sea state conditions with and without coupling of degrees-of-freedom. 相似文献
19.
In this paper, the dynamic response simulation of heavy cargo suspended by a floating crane is performed. The dynamic equations of the motions of the floating crane and the heavy cargo must be considered by the coupled equations because the floating crane and the heavy cargo are connected by wire ropes and provide force and a moment for each other. Hence, the dynamic equations of motion are set up for considering the 6-degrees-of-freedom floating crane and the 6-degrees-of-freedom cargo based on multibody system dynamics. The nonlinear terms in the equations of motion are considered. In addition, the nonlinear hydrostatic force, the linear hydrodynamic force, the wire rope force, and the mooring force are considered as the external forces. Finally, we estimate the motion of the floating crane and the heavy cargo and also calculate the tension of the wire rope between the two. 相似文献