Evaluation of two satellite-based products against ground-based observation for drought analysis in the southern part of Iran     

Jafari  Seyedeh Mahboobeh  Nikoo  Mohammad Reza  Dehghani  Maryam  Alijanian  Mohammadali 《Natural Hazards》2020,102(3):1249-1267

Natural Hazards - Water stress or more specifically drought assessment plays a key role in water management, especially in extreme climate conditions. Basically, globally gridded satellite-based...  相似文献   

An Introduction to MODISI and SCMOD Methods for Correction of the MODIS Snow Assessment Algorithm   总被引：1，自引：0，他引：1  

Mohammad Reza Mobasheri  Hossein Shafizadeh Moghadam  Siavosh Shayan 《Journal of the Indian Society of Remote Sensing》2010,38(4):674-685

Detection, monitoring and precise assessment of the snow covered regions is an important issue. Snow cover area and consequently the amount of runoff generated from snowmelt have a significant effect on water supply management. To precisely detect and monitor the snow covered area we need satellite images with suitable spatial and temporal resolutions where we usually lose one for the other. In this study, products of two sensors MODIS and ASTER both on board of TERRA platform having low and high spatial resolution respectively were used. The objective of the study was to modify the snow products of MODIS by using simultaneous images of ASTER. For this, MODIS snow index image with high temporal resolution were compared with that of ASTER, using regression and correlation analysis. To improve NDSI index two methods were developed. The first method generated from direct comparison of ASTER averaged NDSI with those of MODIS (MODISI). The second method generated by dividing MODIS NDSI index into 10 codes according to their percentage of surface cover and then compared the results with the difference between ASTER averaged and MODIS snow indices (SCMOD). Both methods were tested against some 16 MODIS pixels. It is found that the precision of the MODISI method was more than 96%. This for SCMOD was about 98%. The RMSE of both methods were as good as 0.02.  相似文献   

Location of Areas Prone to Flood Spreading Using GIS (Ilam Province,Iran)     

Nourollah Teimouri  Derikvand  Ehsan  Kharazi  Hossein Ghorbanizadeh  Eslami  Hossein  Jafari  Mohammad Reza 《Water Resources》2020,47(3):421-429

Water Resources - The present study aimed to locate the areas prone to flood spreading in order to manage surface water resources. Therefore, the information layers of slope, land capability,...  相似文献   

Seismic performance and damage incurred by monolithic concrete self-centering rocking walls under the effect of axial stress ratio     

Abouzar Jafari  Mohammad Reza Ghasemi  Habib Akbarzadeh Bengar  Behrooz Hassani 《Bulletin of Earthquake Engineering》2018,16(2):831-858

Self-centering rocking walls offer the possibility of minimizing repair costs and downtimes, and also nullify the residual drift after seismic events, thanks to their self-centering properties. In this paper, the effect of axial stress ratio on the behavior of monolithic self-centering rocking walls is investigated by utilizing a developed finite element model. To verify the validity of the finite element model, results and observed damage in the model are compared with those of a full-scale wall test. The axial stress ratio is varied from 0.024 to 0.30 while keeping the other structural parameters constant. For qualitative damage evaluation, the observed damage in the model compared with expected damage states of desired performance levels. In order to evaluate the incurred damage quantitatively, the amount of crushing and damage in the wall is calculated by utilizing several ratios (crushing ratio and damage ratio). Furthermore, seismic response factors (i.e., μ, R and C_d) are calculated for different axial stress ratio values. The obtained results showed that, in order to satisfy the requirements of desired performance levels, the maximum axial stress ratio should be approximately within the range of 0.10–0.15. In addition, the maximum overall damage ratio and crushing ratio are suggested to be less than 5%. For axial stress ratio higher than 0.15, the flag-shaped pattern of hysteresis curves completely disappeared and the variation of displacement ductility is less sensitive to axial stress ratio. Considering the maximum axial stress ratio limited to 0.150, values of 4 and 3.5 are conservatively proposed as a period-independent response modification factor and displacement modification factor of the investigated structural wall, respectively.  相似文献   

Random vibration of nonlinear structures with stiffness and strength deterioration by modified tail equivalent linearization method     

Raoufi  Reza  Ghafory-Ashtiany  Mohsen 《地震工程与工程振动(英文版)》2019,18(3):597-610

In this research the tail equivalent linearization method(TELM) has been extended to study structures with degrading materials. The responses of such structures to excitations are non-stationary, even if the excitations are stationary. Non-stationary behavior of the system cannot be considered by conventional TELM. Applying the conventional TELM, the only distinction in the design point excitation for two stationary excitations with different durations is in the addition of a zero value part at the beginning of the design point of the longer excitation. This means that the failure probability is the same for the non-stationary systems under excitations with different durations. Therefore, this solution cannot be correct. In this study, in using TELM for systems with degrading materials, hysteretic energy is replaced by average hysteretic energy, calculated by averaging the obtained hysteretic energy of the structure subjected to a few random sample load realization. In this way, the degradation parameters under design point coincide with those under sample load realizations. Since the average of the hysteretic energy is converges very fast, the modified TELM only requires about tens to hundreds solutions of the response in addition to the ordinary calculations of conventional TELM.  相似文献   

A new boundary element solution to evaluate the geometric effects of the canyon site on the displacement response spectrum     

Tarinejad  Reza  Isari  Mohsen  Taghavi Ghalesari  Abbasali 《地震工程与工程振动(英文版)》2019,18(2):267-284

This paper presents a step-by-step procedure using the three-dimensional boundary element approach to study the behavior of semi-circular canyons under seismic shear waves. The boundary element code TDASC allows utilization for various canyon geometries, evaluation of concurrent seismic waves and calculation of the ground motions on canyons due to an excitation at any arbitrary point of the incident field. Considering the widening ratio of the canyon(including prismatic, semi-prismatic and non-prismatic canyons), wave characteristics(wavelength, dimensionless period, direction) and maximum amplification pattern, the solution was applied to carry out a series of parametric studies. It was shown that canyon form can significantly affect the displacement amplification, especially at the points located on its edges. By increasing the wave dimensionless frequency(η 1), the amplification pattern becomes more complex. On the basis of the results from a variety of considered cases, a new expression has been presented for the limiting wavelength beyond which the widening of the canyon will not have a major effect on the displacement amplification. To verify the reliability of the proposed approach, the obtained results, expressed in terms of displacement amplitude, were compared with those from the available published literature and a reasonably good agreement was observed.  相似文献   

Spatially-Weighted Factor Analysis for Extraction of Source-Oriented Mineralization Feature in 3D Coordinates of Surface Geochemical Signal     

Esmaeiloghli  Saeid  Tabatabaei  Seyed Hassan  Carranza  Emmanuel John M.  Hosseini  Shahram  Deville  Yannick 《Natural Resources Research》2021,30(6):3925-3953

Natural Resources Research - This contribution proposes a spatially weighted factor analysis (SWFA) to recognize effectively the underlying mineralization-related feature(s) in geochemical signals....  相似文献   

The relationship among environmental variables,jellyfish and non‐gelatinous zooplankton: A case study in the north of the Gulf of Oman          下载免费PDF全文

Fatemeh Pourjomeh  Mohammad Reza Shokri  Hamid Rezai  Hassan Rajabi‐Maham  Elham Maghsoudlou 《Marine Ecology》2017,38(6)

Processes underlying the temporal and spatial variations observed in the distribution of jellyfish and non‐gelatinous zooplankton in the Gulf of Oman are not well understood. This information gap is clearly a major issue in controlling the harmful blooms of jellyfish and non‐gelatinous zooplankton. Samples of jellyfish and non‐gelatinous zooplankton were collected from six stations in Chabahar Bay and three stations in Pozm Bay within four seasons. At each station, environmental variables were also recorded from bottom and surface water. A total of 83 individuals of medusae representing four species of Scyphozoa (i.e., Cyanea nozakii, Chrysaora sp., Pelagia noctiluca, Catostylus tagi) and species of Hydrozoa (i.e., Diphyes sp., Rhacostoma sp., Aequorea spp.) were observed in the study area. A total of 70,727.25 individuals/m^?3 of non‐gelatinous zooplankton dominated by copepods and cladocerans were collected in nine stations within the four seasons. The results of a RELATE analysis yielded no significant association between species composition for jellyfish and non‐gelatinous zooplankton. Among environmental variables, water transparency, nitrite concentration, water depth and temperature were better associated with the total variation in jellyfish species composition than with that of non‐gelatinous zooplankton. Dissolved oxygen, pH, and phosphate concentration were significant environmental variables associated with the variation in the spatial and temporal distribution patterns of non‐gelatinous zooplankton assemblages. Although some jellyfish species (i.e., Rhacostoma sp., Pelagia noctiluca, Catostylus tagi) occur independently of non‐gelatinous zooplankton assemblages, other jellyfish (i.e., Chrysaora sp., Aequorea spp., Cyanea nozakii, Diphyes sp.) are strongly correlated with non‐gelatinous zooplankton assemblages.  相似文献   

Application of the coral health chart to determine bleaching status of <Emphasis Type="Italic">Acropora downingi</Emphasis> in a subtropical coral reef     

Mahshid Oladi  Mohammad Reza Shokri  Hassan Rajabi-Maham 《Ocean Science Journal》2017,52(2):267-275

The ‘Coral Health Chart’ has become a popular tool for monitoring coral bleaching worldwide. The scleractinian coral Acropora downingi (Wallace 1999) is highly vulnerable to temperature anomalies in the Persian Gulf. Our study tested the reliability of Coral Health Chart scores for the assessment of bleaching-related changes in the mitotic index (MI) and density of zooxanthellae cells in A. downingi in Qeshm Island, the Persian Gulf. The results revealed that, at least under severe conditions, it can be used as an effective proxy for detecting changes in the density of normal, transparent, or degraded zooxanthellae and MI. However, its ability to discern changes in pigment concentration and total zooxanthellae density should be viewed with some caution in the Gulf region, probably because the high levels of environmental variability in this region result in inherent variations in the characteristics of zooxanthellae among “healthy” looking corals.  相似文献   

A unified formulation for generalized oilfield development optimization     

Shiva Navabi  Reza Khaninezhad  Behnam Jafarpour 《Computational Geosciences》2017,21(1):47-74

Oilfield development involves several key decisions, including the number, type (injection/production), location, drilling schedule, and operating control trajectories of the wells. Without considering the coupling between these decision variables, any optimization problem formulation is bound to find suboptimal solutions. This paper presents a unified formulation for oilfield development optimization that seeks to simultaneously optimize these decision variables. We show that the source/sink term of the governing multiphase flow equations includes all the above decision variables. This insight leads to a novel and unified formulation of the field development optimization problem that considers the source/sink term in reservoir simulation equations as optimization decision variables. Therefore, a single optimization problem is formulated to simultaneously search for optimal decision variables by determining the complete dynamic form of the source/sink terms. The optimization objective function is the project net present value (NPV), which involves discounted revenue from oil production, operating costs (e.g. water injection and recycling), and capital costs (e.g., cost of drilling wells). A major difficulty after formulating the generalized field development optimization problem is finding an efficient solution approach. Since the total number of cells in a reservoir model far exceeds the number of cells that are intersected by wells, the source/sink terms tend to be sparse. In fact, the drilling cost in the NPV objective function serves as a sparsity-promoting penalty to minimize the number of wells while maximizing the NPV. Inspired by this insight, we solve the optimization problem using an efficient gradient-based method based on recent algorithmic developments in sparse reconstruction literature. The gradients of the NPV function with respect to the source/sink terms is readily computed using well-established adjoint methods. Numerical experiments are presented to evaluate the feasibility and performance of the generalized field development formulation for simultaneous optimization of the number, location, type, controls, and drilling schedule of the wells.  相似文献